扬州市城区地表水底泥重金属污染现状与风险评价

对扬州市城区地表水底泥进行等距离布点采样.分析cd、Cu、Pb、Zn 4种重金属的含量,并应用潜在生态危害指数法对重金属潜在生态风险进行了评价.结果表明:4种重金属的潜在生态风险由高到低的顺序为Cd>Pb>Cu>Zn,其中Cd的潜在生态风险程度已达很强;扬州市城区地表水底泥重金属潜在生态风险程度为强.各条河流底泥重金属潜在生态风险程度由强到弱顺序为古运河>二道河>宝带河>小秦淮河>新城河>水院池塘(对照);从空间上看,扬州市城区东部的地表水底泥重金属潜在生态风险程度高于西部,北部高于南部.     

炭纤维载体固定床厌氧发酵启动运行效果实验

以开发高效率、抗冲击性能强的高浓度有机废水沼气发酵技术为目的,用传统的 UASB反应器作为对照,研究了以炭纤维为生物膜载体的固定床厌氧反应器的启动运行效果。反应器进口废水 COD 为 5 000 mg/L, 水力停留时间 (HRT) 由213 h 逐步缩短为35 h,进水有机容积负荷(OLR)由0.56 kg COD/ (m³·d)提到3.45 kg COD/(m³·d)。结果表明,固定床反应器厌氧发酵的效率比对照高,出水 pH 值也比对照稳定;运行到第 50 d 时,固定床厌氧反应器和对照的 COD去除率分别由第 7 d 的36.56%和33.58%上升到87.9%和62.6%;固定床厌氧反应器的容积比产气率最高为1.16 m³/(m³·d),累计产气量为415.59 L,而对照的容积比产气率最高值仅为0.31 m³ /(m³·d),累计产气量为 71.66 L,前者最高容积比产气率和累计产气量分别是后者的3.74倍和5.78倍。固定床厌氧反应器的启动速度、COD 去除率和产甲烷效率显著地高于对照反应器。     

DGGE、T-RFLP、LH-PCR对两种活性污泥的微生物种群多样性分析的比较

采用基于PCR扩增的分子生态技术DGGE、T-RFLP和LH-PCR,对2种典型污水处理系统中的活性污泥（生活污泥、焦化污泥）进行微生物种群多样性分析;并以此比较3种技术的优劣,提出不同应用条件下研究方法的选择依据。根据实验结果：DGGE得到的条带较多,但误差来源也最多;T-RFLP技术较为灵敏,但需要选择适当的内切酶,严格控制酶切条件,并且文库比对误差较大;而LH-PCR操作简单,结果稳定性较高。虽然目前尚无法判断3种方法的准确性,但LH-PCR在活性污泥的微生物种群多样性分析中已显示出潜在优势。     

三槽式切换氧化沟运行工况数学模式及应用

三槽式切换氧化沟运行工况呈周期性的变化。根据理论分析，建立了各槽活性污泥浓度变化及相互关系的数学模式，并进行了验证。同时就数字模式在周期程序设置及排泥方式选择时的应用做了说明。     

Development of highly efficient and reusable magnetic nitrogen-doped carbon nanotubes for chlorophenol removal

Environmental Science and Pollution Research - Nitrogen-doped carbon nanotubes (N-CNTs) were synthesized via a hydrothermal method and further modified with magnetic Co0.5Cu0.5Fe2O4 nanoparticles...     

Desorption of CO2, SO2, and NH3 in the vacuum evaporation of desulfurization wastewater

Environmental Science and Pollution Research - Mechanical vapor compression and multi-effect evaporation have been widely used in achieving zero discharge of desulfurization wastewater as they are...     

适用于废水处理的DSA电极的研究进展

电化学氧化技术因其具有氧化能力强、可控性高、运行费用低及对环境友好的特点,引起了人们极大的关注。处于核心地位的DSA（Dimensionally Stable Anodes）电极是电化学工作者研究的重点。Ti基氧化铅、氧化铱、锡锑氧化物等电极是目前最有研究价值的DSA电极,文章介绍了这些电极的一些最新的研究成果。     

Concentrations and accumulation rates of polychlorinated biphenyls in soil along an urban–rural gradient in Shanghai

Environmental Science and Pollution Research - This study proposed an in situ soil experimental system to quantify concentration and accumulation rates of polychlorinated biphenyl (PCB) congeners...     

Study on the denitrification performance of FexLayOz/activated coke for NH3-SCR and the effect of CO escaped from activated coke at mid-high temperature on catalytic activity

Currently, activated coke is widely used in the removal of multiple pollutants from industrial flue gas. In this paper, a series of novel Fe_xLa_yO_z/AC catalysts was prepared by the incipient wetness impregnation for NH₃-SCR denitrification reaction. The introduction of Fe-La bimetal oxides significantly improved the denitrification performance of activated coke at mid-high temperature, and 4% Fe_0.3La_0.7O_1.5/AC exhibited a superior NO_x conversion efficiency of 90.1% at 400 °C. The catalysts were further characterized by BET, SEM, XRD, Raman, EPR, XPS, FTIR, NH₃-TPD, H₂-TPR, et al., whose results showed that the perovskite-type oxide of LaFeO₃ and oxygen vacancies were produced on the catalysts’ surfaces during roasting. Fe-La doping enhanced the amount of acid sites (mainly Lewis and other stronger acid sites) and the content of multifarious oxygen species, which were beneficial for NO_x removal at mid-high temperature. Moreover, it was investigated that the effect of released CO from activated coke at mid-high temperature on the NO_x removal through the lifetime test, in which it was found that a large amount of CO produced by pyrolysis of activated coke could promote the NO_x removal, and long-term escaping of CO on the activated coke carrier did not have a significant negative impact on catalytic performance. The results of the TG-IR test showed that volatile matter is released from the activated coke while TG results showed that the weight loss rate of 4% Fe_0.3La_0.7O_1.5/AC only was 0.0015~0.007%/min at 300–400 °C. Hence, 4% Fe_0.3La_0.7O_1.5/AC had excellent thermal stability and denitrification performance to be continuously used at mid-high temperature. Finally, the mechanisms were proposed on the basis of experiments and characterization results.

     

有毒气体危害区域划分之临界浓度标准研究

通过研究毒物伤害准则进而界定有毒气体危害浓度,对有毒气体泄漏扩散后的危害区域进行分级划分,以采取相应的防护措施,最大限度的即时有效的减轻有毒气体对人员的伤害.最后,以氯为例,对比其在不同伤害准则下危害区域划分临界浓度标准值,数值差别较大,因此在使用时应根据实际情况加以判断,选择最适当的标准来划分危害区域.