Structural and electrochemical properties of annealed La1-xYxNi3.55Mno.4Alo.3Coo.75 hydrogen storage alloys

The effects of the annealing and partial substitution of Y for La on the structural and electrochemical properties of La_1-xY_xNi_3.55Mn_o.4Al_o.3Cr_o.75 (x = 0, 0.1 and 0.2) alloys were reported in the present work. The single-phased CaCu₅-type structure was retained after La was partially substituted by Y. However, the increase of Y content leads to decrease of the lattice parameters and the unit-cell volume. The annealed La_o.9Y_o.1Ni_3.55Mn_o.4Al_o.3Co_o.75 alloys shows typical isometric microstructure, indicating that the composition segregation is improved by annealing. Y substitution for La in the alloys is effective to improve the electrochemical properties at both room temperature and high temperature. A critical substitution content of Y is found at x = 0.1.     

Cadmium removal from wastewater by sponge iron sphere prepared by hydrogen reduction

A new type of sponge iron sphere (NSIS) with 1-5 mm diameter, made of concentrated iron powder and possessed high activity and intension, was prepared by mini-pellet sintering integrated with H₂ direct reduction. Static state experiment has been carried on to investigate the Cd²⁺ removal efficiency from wastewater by the NSIS and to explore the Cd²⁺ removal reaction kinetics. It was suggested that initial pH value and Cd²⁺ original concentration had significant influence on Cd²⁺ removal percentage. Cd²⁺ removal percentage decreased significantly with the increasing of Cd²⁺original concentration whether the original pH value be adjusted to 3.0 or without adjustment. The results showed that the Cd²⁺ removal process followed the first order reaction because the reaction order was from 0.803 to 0.996. The apparent reaction rate constant between Cd²⁺ and NSIS was from 0.0025 to 0.1000 (mg·L^?1)^1-n·min^?1. Compared with SIS reduced by charcoal reduction, NSIS deoxided by hydrogen possessed higher activity, and could remove the same quantity of Cd²⁺ within a shorter period of time.     

基于服务式GIS的流域水质目标管理技术平台架构设计

针对流域水质目标管理与GIS集成技术,对比分析传统模式与服务式GIS模式的优劣,提出了基于服务式GIS的流域水质目标管理技术平台的层次结构、总体架构及建设步骤;基于具体建设需求分析,构建了辽河流域水质目标管理技术平台的详细架构。     

基于REOF方法的辽宁气候舒适度区域特征分析

基于辽宁省50个气象站1964-2008年的气象资料,采用适应东北地区的人体舒适度计算公式及分级标准,得出辽宁省近45年历年人体各舒适度级别日数,使用旋转经验正交分解法(REOF),对辽宁省气候舒适度进行区域划分,并分析了各区域气候舒适度的空间分布特征和变化趋势.结果表明:(1)根据前4个旋转倚载向量场高载荷区分布,将...     

低温等离子体-催化协同降解挥发性有机废气

低温等离子体-催化协同技术适合于各类挥发性有机物的治理,特别是大气量低浓度的有机废气的处理.高效催化剂的加入可 以显著提高等离子体反应中有机废气的降解效率,减少有害副产物的生成以及提高反应器的能量利用率.从反应器、催化剂以及背景气体等方面探讨了该技术实现产业化需要解决的问题,结合低温等离子体与催化剂的相互作用、等离子体...     

一株氯苯降解新菌株的分离鉴定及其降解特性研究

采集某净化氯苯废气的生物滴滤床填料表面的生物膜,分离纯化后得到1株能高效降解氯苯的菌株L2,基于菌株生理生化特征、16S rDNA序列系统学分析和Biolog鉴定,可确定该菌株为皮氏罗尔斯顿菌(Ralstonia pickettii),其为新发现的具有氯苯降解性能的菌株.该菌株最佳生长温度和pH分别为30 ℃和7,在最...     

不同进水条件对SBR工艺脱氮除磷效能的影响

采用人工配水,研究进水在不同pH值,碳源类型,碳氮比条件下,厌氧/好氧/缺氧(A/O/A)sBR工艺对生物法脱氮除磷效能的影响.结果表明:不同的进水条件对反应器的影响较大,当pH值为7.5,乙酸钠为碳源,碳氮比为1.4时,反应器运行效果最佳,系统对PO43--P,NH4+-N的去除率分别达到97.28%,99.5%.N...     

利用泰乐菌素菌渣生产复合酶制剂及效果研究

发酵法生产抗生素过程中会产生大量废弃菌渣,这些菌渣因有机质含量高,堆放极易发生霉变,给当地环境造成危害.文章采用固体发酵法,以微生物降解处理后的泰乐菌素菌渣为主要原料,生产复合酶制剂,并对其在肉鸡上的使用效果进行研究.结果表明:在水含量50％～60％、干物质中麸皮含量不低于40％的泰乐菌素菌渣培养基中,接入5％～10％...     

土壤阴离子表面活性剂总量亚甲基蓝法研究

文章通过设计正交试验,针对提取的主要因素提取液配比、提取时间、提取温度和提取剂用量确定最优的前处理方法,建立与国标《水质阴离子表面活性剂亚甲基蓝分光光度法》(GB7494-87)对应的土壤阴离子表而活性剂(LAS)的亚甲基蓝分光光度法.土壤样品烘干后经20 mL乙醇水溶液(70％)提取,水浴恒温振荡仪45℃下振荡2h,...