Enhanced electrokinetic remediation of lead-contaminated soil by complexing agents and approaching anodes

Optimizing process parameters that affect the remediation time and power consumption can improve the treatment efficiency of the electrokinetic remediation as well as determine the cost of a remediation action. Lab-scale electrokinetic remediation of Pb-contaminated soils was investigated for the effect of complexant ethylenediaminetetraacetic acid (EDTA) and acetic acid and approaching anode on the removal efficiency of Pb. When EDTA was added to the catholyte, EDTA dissolved insoluble Pb in soils to form soluble Pb–EDTA complexes, increasing Pb mobility and accordingly removal efficiency. The removal efficiency was enhanced from 47.8 to 61.5 % when the EDTA concentration was increased from 0.1 to 0.2 M, showing that EDTA played an important role in remediation. And the migration rate of Pb was increased to 72.3 % when both EDTA and acetic acid were used in the catholyte. The “approaching anode electrokinetic remediation” process in the presence of both EDTA and acetic acid had a higher Pb-removal efficiency with an average efficiency of 83.8 %. The efficiency of electrokinetic remediation was closely related to Pb speciation. Exchangeable and carbonate-bounded Pb were likely the forms which could be removed. All results indicate that the approaching anode method in the presence of EDTA and acetic acid is an advisable choice for electrokinetic remediation of Pb-contaminated soil.     

碳纳米管电极原位产生过氧化氢及其对亚甲基蓝脱色效果简

将碳纳米管固定化制成多孔疏水性导电薄膜构建电化学阴极还原体系,实现过氧化氢在阴极的原位产生。电极特性研究表明,电极在较宽的电压范围内均具有较好的活性。考察了阴极电位、电极成分、氧气流量和电解质浓度对过氧化氢原位产生的影响,在优化条件下经过120 min后过氧化氢达到66.17 mg/L,并探讨过氧化氢原位产生的机理。在此基础上考察原位过氧化氢氧化工艺下对亚甲基蓝的脱色效果,并分析其脱色机理。     

Ni2 +对活性污泥活性及群落多样性的影响简

通过检测活性污泥的电子传递体系活性以及生物多样性,研究Ni²⁺对活性污泥微生物活性及群落多样性的影响。结果表明：与对照系统相比,5 mg/L的Ni²⁺对2,3,5-triphenylteltrazolium chloride（TTC-ETS）活性未产生显著的影响;但当Ni²⁺的浓度进一步增大到10、20和40 mg/L后,其对序批式反应器内活性污泥TTC-ETS活性的抑制率分别达到（36.79±11.14）%、（55.88±13.90）%和（70.97±6.78）%。低浓度Ni²⁺能增强活性污泥微生物对碳源的利用,但高于10 mg/L的Ni²⁺则显著抑制了活性污泥微生物对碳源的利用。各个SBR系统中微生物群落最常见的物种相近,物种丰富度和均一性则均有所不同,其中群落物种丰富度随着Ni²⁺浓度的增加而逐渐减小。TTC-ETS活性、平均每孔颜色变化率、Shannon指数和Simpson指数,与Ni²⁺的胁迫浓度之间的显著相关性表明,它们均可有效地表征Ni²⁺胁迫对活性污泥微生物活性及群落多样性的影响程度。     

基于智能优化算法的河流水质模型参数的优化简

为探索河流水质模型参数新的求解方法,根据有限的实测数据,分别应用免疫进化优化算法和免疫进化优选的捕食搜索算法,对河流水质模型计算公式中的多参数进行优化。将优化得到的计算公式用于国内外若干河流的河段中DO浓度值的拟合,并与实测结果进行了比较。结果表明,将免疫进化优化算法或免疫进化优选的捕食搜索算法优化得到的水质模型参数精度不仅较高,而且相对稳定,从而为河流水质模型参数的优化提供了一种新方法。     

MCM-41介孔分子筛的合成及其对铜离子的吸附性能简

以微硅粉为硅源,CTAB和PEG-6000为模板剂,合成MCM-41介孔分子筛。采用XRD、N₂吸附-脱附曲线、FTIR以及TEM表征了其结构、比表面积、孔径分布及晶体形貌,并且以该样品为吸附剂,对含Cu²⁺的溶液进行了静态吸附实验。结果表明,以微硅粉为硅源成功合成了具有典型六方排列孔道结构的MCM-41,其比表面积为869.5 m²/g,孔容为0.97 cm³/g,平均孔径为3.3 nm;溶液pH为5~6时,MCM-41对Cu²⁺的去除效果最好;MCM-41对Cu²⁺的最大吸附吸附容量36.3 mg/g;MCM-41对Cu²⁺的吸附性能符合Langmuir吸附方程的特征。动力学研究表明,该过程符合准二级动力学模型。     

水生植物酸碱预处理对厌氧发酵联产氢气-甲烷的影响简

采用酸碱预处理乌梁素海典型沉水植物龙须眼子菜和挺水植物芦苇,通过厌氧发酵动力学分析、还原糖变化及微观结构解析,研究酸碱预处理对水生植物厌氧发酵联产氢气-甲烷的影响。实验结果表明,酸碱预处理后水生植物厌氧发酵联产氢气-甲烷两阶段累积产气量、氢气及甲烷含量均显著提高,酸处理效果优于碱处理。采用0.5 mol/L HCl预处理龙须眼子菜效果最佳,最大氢气、甲烷含量分别达42.65%和52.82%,产氢气速率为4.118 mL/h,产甲烷速率最高达14.199 mL/h。芦苇经1 mol/L HCl预处理效果最佳,最高氢气、甲烷含量分别为32.22%和65.26%。扫描电镜微观结构分析表明,酸碱预处理可显著破坏芦苇、龙须眼子菜的纤维素结构,有效增加植物与微生物接触面积,有利于厌氧发酵联产氢气-甲烷工艺的快速启动和稳定运行。     

氯化镁复配硫酸铝混凝性能及絮体特性

在研究氢氧化镁混凝特性的基础上,复配氯化镁和硫酸铝作为混凝剂,以高岭土配水水样为研究对象,运用iPDA在线监测技术对混凝过程絮体形成进行监测,探讨了单独使用氯化镁和硫酸铝以及二者复配使用的混凝效果和絮体特性,确定复配使用的各种条件。结果表明,对于浊度20 NTU,pH 11.5的高岭土配水水样,氯化镁、硫酸铝最佳投加量分别为7.2 mg/L(Mg2+计)和3 mg/L(Al3+计);硫酸铝跟氯化镁复配使用时,先投加硫酸铝,间隔30 s后投加氯化镁,混凝效果较好;在镁离子最佳投加量7.2 mg/L时,铝和镁最佳质量比在1∶3~1∶2之间;镁铝复配时其FI值明显大于单独作用时,即絮体尺寸大小:二者复配硫酸铝氯化镁,而且复配条件下Zeta电位值在零电势左右浮动,浮动范围小,更利于聚集沉淀;镁铝复配时发生了协同效应,弥补了单独使用氯化镁混凝过程的不足。     

Effect of temperature and particle size on the thermal desorption of PCBs from contaminated soil

Thermal desorption is widely used for remediation of soil contaminated with volatiles, such as solvents and distillates. In this study, a soil contaminated with semivolatile polychlorinated biphenyls (PCBs) was sampled at an interim storage point for waste PCB transformers and heated to temperatures from 300 to 600 °C in a flow of nitrogen to investigate the effect of temperature and particle size on thermal desorption. Two size fractions were tested: coarse soil of 420–841 μm and fine soil with particles <250 μm. A PCB removal efficiency of 98.0 % was attained after 1 h of thermal treatment at 600 °C. The residual amount of PCBs in this soil decreased with rising thermal treatment temperature while the amount transferred to the gas phase increased up to 550 °C; at 600 °C, destruction of PCBs became more obvious. At low temperature, the thermally treated soil still had a similar PCB homologue distribution as raw soil, indicating thermal desorption as a main mechanism in removal. Dechlorination and decomposition increasingly occurred at high temperature, since shifts in average chlorination level were observed, from 3.34 in the raw soil to 2.75 in soil treated at 600 °C. Fine soil particles showed higher removal efficiency and destruction efficiency than coarse particles, suggesting that desorption from coarse particles is influenced by mass transfer.     

Probing the distribution and contamination levels of 10 trace metal/metalloids in soils near a Pb/Zn smelter in Middle China

The horizontal and vertical distribution patterns and contamination status of ten trace metal/metalloids (Ag, Bi, Co, Cr, Ge, In, Ni, Sb, Sn, Tl) in soils around one of the largest Chinese Pb–Zn smelter in Zhuzhou City, Central China, were revealed. Different soil samples were collected from 11 areas, including ten agricultural areas and one city park area, with a total of 83 surface soil samples and six soil cores obtained. Trace metal/metalloids were determined by inductively coupled plasma–mass spectrometry after digestion by an acid mixture of HF and HNO₃. The results showed that Ag, Bi, In, Sb, Sn, and Tl contents decreased both with the distance to the Pb–Zn smelter as well as the soil depth, hinting that these elements were mainly originated from the Pb–Zn smelting operations and were introduced into soils through atmospheric deposition. Soil Ge was influenced by the smelter at a less extent, while the distributions of Co, Cr, and Ni were roughly even among most sampling sites and soil depths, suggesting that they were primarily derived from natural sources. The contamination status, as revealed by the geo-accumulation index (I _geo), indicated that In and Ag were the most enriched elements, followed by Sb, Bi, and Sn. In general, Cr, Tl, Co, Ni, and Ge were of an uncontaminated status.     

As(V)在金红石TiO_2颗粒表面吸附特性及机理

通过静态动力学和热力学吸附实验,研究了温度、共存离子以及溶质的初始浓度对As(V)在金红石TiO2颗粒表面吸附的影响,探讨了As(V)在金红石TiO2颗粒表面吸附特性及机理。结果表明,在As(V)初始浓度为10 mg/L,pH为7的条件下,25℃时的吸附量0.41 mg/g高于30℃时的吸附量0.31 mg/g,As(V)在金红石TiO2上的吸附为放热过程。CaCl2和MgCl2的添加对As(V)在金红石TiO2表面吸附起到明显的促进作用。T=25℃,Ca2+或Mg2+浓度为10 mmol/L时,As(V)吸附量分别为0.64和0.56 mg/g,Ca2+比Mg2+对As(V)吸附促进作用强。As(V)在金红石TiO2的吸附等温线符合Frendlich方程,Lagergren二级动力学方程能较好地描述As(V)在金红石TiO2颗粒表面吸附的动力学过程。