活性污泥法处理矿区生活污水剩余污泥量探讨

由于矿区生活污水中有机污染物浓度较低,采用活性污泥法处理工艺,有机污染物在生物氧化池内得到较彻底地降解,剩余污泥量少,每千吨生活污水产生剩余污泥量为2～3t。     

氯氰菊酯降解菌的筛选鉴定及其降解特性研究

从农药厂废水排放口附近的污泥中分离到1株能降解氯氰菊酯的细菌LQ-3.根据其形态、生理生化特征和16S rDNA(GenBank Accession No.FJ222585)序列分析,将该菌株鉴定为Starkeya sp..LQ-3菌株只能以共代谢方式降解氯氰菊酯,在有酵母粉、蛋白胨、葡萄糖等营养物质存在的条件下,5 d内对20 mg·L-1氯氰菊酯的降解率达到72.1%.LQ-3菌株降解氯氰菊酯的最适温度为30 ℃左右,pH值为7～8.LQ-3菌株还能降解功夫菊酯、甲氰菊酯、联苯菊酯和溴氰菊酯.酶的定域试验表明,LQ-3菌株降解氯氰菊酯的酶属于胞外酶.     

Polycyclic aromatic hydrocarbon (PAH) deposition to and exchange at the air-water interface of Luhu, an urban lake in Guangzhou, China

Urban lakes are vulnerable to the accumulation of semivolatile organic compounds, such as PAHs from wet and dry atmospheric deposition. Little was reported on the seasonal patterns of atmospheric deposition of PAHs under Asian monsoon climate. Bulk (dry + wet) particle deposition, air-water diffusion exchange, and vapour wet deposition of PAHs in a small urban lake in Guangzhou were estimated based on a year-round monitoring. The total PAH particle deposition fluxes observed were 0.44-3.46 μg m⁻² day⁻¹. The mean air-water diffusive exchange flux was 20.7 μg m⁻² day⁻¹. The vapour deposition fluxes of PAHs ranged 0.15-8.26 μg m⁻² day⁻¹. Remarkable seasonal variations of particulate PAH deposition, air-water exchange fluxes and vapour wet deposition were influenced by seasonal changes in meteorological parameters. The deposition fluxes were predominantly controlled by the precipitation intensity in wet season whereas by atmospheric concentration in dry season.     

多孔硅酸钙滤料吸附床除磷试验研究

以多孔硅酸钙滤料为吸附载体处理含磷的二沉池出水.通过静态吸附试验和动态吸附试验,研究了滤料粒径及投加量、初始pH、反应时间、温度以及滤料填充高度对除磷效果的影响.在静态吸附试验中,取初始磷质量浓度为4.98 mg/L的含磷废水100 mL,当多孔硅酸钙滤料粒径为4～14目,投加量为1.0g,吸附时间为2.5h,温度为25℃,溶液初始pH为7.0～9.0时,磷的去除率可达95％以上,出水磷满足《城镇污水处理厂污染物排放标准》(GB 18918-2002)的一级A标准(≤0.5 mg/L).动态吸附试验表明,在长期运行条件下,多孔硅酸钙滤料吸附床能持续有效地去除污水中的磷,综合考虑吸附率和运行费用,选择水力停留时间为30 min,滤料填充高度为60 cm为宜.     

Adsorption of Pb(II) on variable charge soils amended with rice-straw derived biochar

Two Ultisols and one Oxisol from tropical regions of southern China were incubated with rice straw biochar to investigate the effect of biochar on their surface charge and Pb(II) adsorption using batch methods. The incorporation of biochar induced a remarkable increase in soil cation exchange capacity after 30 d of incubation. The incorporation of biochar significantly increased the adsorption of Pb(II) by these variable charge soils; the enhancement of adsorption of Pb(II) by these soils increased with the addition level of biochar. Adsorption of Pb(II) involved both electrostatic and non-electrostatic mechanisms; however, biochar mainly increased Pb(II) adsorption through the non-electrostatic mechanism via the formation of surface complexes between Pb²⁺ and functional groups on biochar. There was greater enhancement of biochar on the non-electrostatic adsorption of Pb(II) by the variable charge soils at relatively low pH. Therefore, the incorporation of biochar decreased the activity and availability of Pb(II) to plants through increased non-electrostatic adsorption of Pb(II) by acidic variable charge soils.     

Influence of clay minerals on the reduction of Cr6+ by citric acid

The influence of clay minerals on the reduction of Cr6+ by citric acid was investigated at pH values 4.0, 4.5 and 5.0 at 25 degrees C. The results indicate that montmorillonite and illite greatly accelerate the reduction reactions at pH 4.0 and 4.5, but their effects are dramatically reduced at pH 5.0. The role of clay minerals in accelerating the reactions is in the order: illite>montmorillonite>kaolinite, which has a positive correlation with the amount of Mn2+ adsorbed on the surfaces of these minerals. With light, Fe(3+) also significantly increases reaction rates. Ethylenediaminetetraacetic acid (EDTA) greatly suppresses the acceleration of the reduction reactions by these minerals, indicating that EDTA competes with citric acid for Mn2+. Thus, the formation of complexes between Mn(2+) and citric acid could be a prerequisite for the acceleration of the reductions of Cr6+ by clay minerals. In addition, there is no relationship between the specific surface area of clay minerals and the reduction rate of Cr6+ by citric acid.     

江苏省一次典型沙尘污染过程分析

2021年4月16日至4月18日江苏省经历了一次受沙尘影响的重污染过程.本次过程沙源地为蒙古国中南部及中国内蒙古中西部地区,在蒙古气旋后部西北大风影响下,沙尘气团自西北向东南影响了中国多个省市和地区.江苏省自16日起逐渐受到沙尘过程影响,苏北城市ρ(PM10)从凌晨开始迅速升高,浓度最高达569μg/m3,空气质量达严...     

不同温湿度条件下微米硼的氧化过程研究

目的 探究不同温湿度条件下微米硼的氧化层结构特征。方法 利用高温水浴浸泡处理去除原料微米硼的表面氧化层,然后在恒温恒湿条件下对微米硼进行加速氧化,利用扫描电子显微镜、透射电子显微镜和X射线光电子能谱对加速氧化后硼颗粒的氧化层厚度及组成进行分析,总结表面氧化层结构及成分组成变化规律,揭示温湿度条件下微米硼的氧化机制。结果 微米硼经高温水浴浸泡处理后,表面氧化层去除率达到50%。随着加速氧化时间的延长,硼颗粒氧化层的厚度逐渐增大,由内向外硼颗粒表面可以用B-BxOy-B2O3三层结构来表示,BxOy总是伴随着B2O3同时出现的,且随着氧化反应的进行,颗粒表面BxOy的含量将超过B的含量。结论 不同温湿度条件下微米硼的氧化机制为O2向B颗粒内部单向扩散的反应机制,B先与O2反应,形成低氧化物BxOy,BxOy进而与O2反应生成B2O3。随着氧化层厚度的增加,O2向B颗粒内部扩散的阻力增大,氧化反应速率随之降低。相比湿度的影响,温度的升高可显著加快硼表面氧化层的形成;温度一定时,湿度的增加可促进硼氧化层的形成。     

基于Arrhenius模型和Peck模型的分段非线性加速模型

目的 解决Arrhenius模型无法估计湿度应力敏感产品和Peck模型试验时间较长的问题。方法 考虑温度应力和湿度应力对产品贮存寿命的综合影响,在产品激活能不变的假设下,将Arrhenius模型对产品激活能的估计和Peck模型对湿度应力参数的估计相结合,建立Arrhenius&Peck分段非线性加速寿命估计模型。基于此模型,在双应力恒加试验条件下,得到产品的寿命估计方程。结果 以弹上电子产品的恒定应力加速贮存试验为例,进行仿真分析,得到产品寿命的估计,并对比产品实际寿命。Arrhenius&Peck模型的寿命误差和失效率误差均控制在5%以内,准确度高于Arrhenius模型和Peck模型。结论 构建的Arrhenius&Peck分段非线性加速寿命模型可以充分利用温度和湿度条件下的试验数据,对温湿敏感产品的寿命估计有较好的应用效果,为导弹产品的寿命估计提供一种可选方法。     

安庆市城区主要大气污染物时空特征分析

根据安庆市环境监测站近6年大气污染的主要监测数据,选取SO2、NOx、PM30等污染物指标,应用统计分析方法与GIS制图技术分析了安庆市城区污染物的年变化、季度变化、区域分布等污染特征及其变化规律。结果表明,安庆市区大气环境质量整体状况较良好,东部的大气质量明显优于西部,主要污染物为可吸入颗粒物,各类污染物表现为冬春季高,夏秋季低的季节性变化规律。