十六烷基三甲基氯化铵与荧蒽对小球藻的联合毒性及其作用机制

以普通小球藻(Chlorella vulgaris)为受试生物,采用批量培养方法研究了阳离子表面活性剂十六烷基三甲基氯化铵(CTAC)与多环芳烃荧蒽(Flu)的联合毒性及其作用机制.结果表明,当CTAC初始浓度固定为100μg/L时,随Flu浓度的升高(0~100.84μg/L), CTAC与Flu的联合毒性由协同效应(0~22.50μg/L)转为拮抗效应(22.50~100.84μg/L).当Flu浓度为1.13μg/L时,协同效应达到最大(RI＝2.01),与对照组相比,生物量抑制率从37.5%增加至80.9%;对氮和铁单位吸收量分别从0.27mg和9.18μg降至0.09mg和2.14μg;藻细胞Zeta电位从-10.0mV提高至-8.3mV;叶绿素a和可溶性蛋白质含量分别从5.00mg/L和80.65μg/mg降为2.57mg/L和50.36μg/mg.根据实验结果分析, CTAC与Flu复合污染体系提高了藻细胞Zeta电位,抑制了小球藻对氮和铁的吸收,降低了藻细胞体内叶绿素和蛋白质的含量.     

Effects of alfalfa coverage on runoff, erosion and hydraulic characteristics of overland flow on loess slope plots

An evaluation of the interactions between vegetation, overland and soil erosion can provide valuable insight for the conservation of soil and water. An experiment was conducted to study water infiltration, runoff generation process, rate of sediment erosion, and hydrodynamic characteristics of overland flow from a sloping hillside with different draw-off discharges from alfalfa and control plots with 20° slope. The effect of alfalfa on runoff and sediment transport reduction was quantitatively analyzed. Alfalfa was discussed for its ability to reduce the overland flow scouring force or change the runoff movement. Compared to the bare-soil plots, alfalfa plots generated a 1.77 times increase in infiltration rate. Furthermore, the down-slope water infiltration rate for the bare soil plots was higher than in the up-slope, while the opposite was found in the alfalfa plots. In addition, alfalfa had a significant effect on runoff and sediment yield. In comparison to the control, the runoff coefficient and sediment transportation rate decreased by 28.3% and 78.4% in the grass slope, respectively. The runoff generated from the alfalfa and bare-soil plots had similar trends with an initial increase and subsequent leveling to a steady-state rate. The transport of sediment reduced with time as a consequence of the depletion of loose surface materials. The maximum sediment concentration was recorded within the first few minutes of each event. The alfalfa plots had subcritical flow while the bare-soil plots had supercritical flow, which indicate that the capability of the alfalfa slope for resisting soil erosion and sediment movement was greater than for bare soil plots. Moreover, the flow resistance coefficient and roughness coefficient for the alfalfa plots were both higher than for the bare-soil plots, which indicate that overland flow in alfalfa plots had retarded and was blocked, and the flow energy along the runoff path had gradually dissipated. Finally, the ability to erode and transport sediment had decreased.     

Continuous biohydrogen production from diluted molasses in an anaerobic contact reactor

An anaerobic contact reactor (ACR) system comprising a continuous flow stirred tank reactor (CSTR) with settler to decouple the hydraulic retention time (HRT) from solids retention time (SRT) was developed for fermentative hydrogen production from diluted molasses by mixed microbial cultures. The ACR was operated at various volumetric loading rates (VLRs) of 20–44 kgCOD·m^-3·d^-1 with constant HRT of 6 h under mesophilic conditions of 35°C. The SRT was maintained at about 46–50 h in the system. At the initial VLR of 20 kgCOD·m^-3·d^-1, the hydrogen production rate dropped from 22.6 to 1.58 L·d^-1 as the hydrogen was consumed by the hydrogentrophic methanogen. After increasing the VLR to 28 kgCOD·m^-3·d^-1 and discharging the sludge for 6 consecutive times, the hydrogentrophic methanogens were eliminated, and the hydrogen content reached 36.4%. As the VLR was increased to 44 kgCOD·m^-3·d^-1, the hydrogen production rate and hydrogen yield increased to 42.1 L·d^-1 and 1.40 mol H₂·molglucose-consumed^-1, respectively. The results showed that a stable ethanol-type fermentation that favored hydrogen production in the reactor was thus established with the sludge loading rate (SLR) of 2.0–2.5 kgCOD·kgMLVSS^-1·d^-1. It was found that the ethanol increased more than other liquid fermentation products, and the ethanol/acetic acid (mol/mol) ratio increased from 1.27 to 2.45 when the VLR increased from 28 to 44 kgCOD·m^-3·d^-1, whereas the hydrogen composition decreased from 40.4% to 36.4%. The results suggested that the anaerobic contact reactor was a promising bioprocess for fermentative hydrogen production.     

Co-fermentation of waste activated sludge with food waste for short-chain fatty acids production: effect of pH at ambient temperature

Effect of pH ranging from 4.0 to 11.0 on co-fermentation of waste activated sludge (WAS) with food waste for short-chain fatty acids (SCFAs) production at ambient temperature was investigated in this study. Experimental results showed that the addition of food waste significantly improved the performance of WAS fermentation system, which resulted in the increases of SCFAs production and substrate reduction. The SCFAs production at pH 6.0, 7.0, 8.0, and 9.0 and fermentation time of 4 d was respectively 5022.7, 6540.5, 8236.6, and 7911.7 mg COD·L^-1, whereas in the blank tests (no pH adjustment, pH 8.0 (blank test 1), no food waste addition, pH 8.0 (blank test 2), and no WAS addition (blank test 3)) it was only 1006.9, 971.1, and 1468.5 mg COD·L^-1, respectively. The composition of SCFAs at pH from 6.0 to 9.0 was also different from other conditions and propionic acid was the most prevalent SCFA, which was followed by acetic and n-butyric acids, while acetic acid was the top product under other conditions. At pH 8.0 a higher volatile suspended solids (VSS) reduction of 16.6% for the mixture of WAS and food waste than the sole WAS indicated a synergistic effect existing in fermentation system with WAS and food waste. The influence of pH on the variations of nutrient content was also studied during anaerobic fermentation of the mixture of WAS and food waste at different pH conditions. The release of NH4+-N increased with fermentation time at all pH values investigated except 4.0, 5.0 and in blank test one. The concentrations of soluble phosphorus at acidic pHs and in the blank test one were higher than those obtained at alkaline pHs. Ammonia and phosphorus need to be removed before the SCFAs-enriched fermentation liquid from WAS and food waste was used as the carbon source.     

Enhancing soil aggregation and acetamiprid adsorption by ecofriendly polysaccharides hydrogel based on Ca2+- amphiphilic sodium alginate

Soil aggregation plays an important role in agricultural production activities. However, the structure of soil aggregation is destroyed by the natural environment and unreasonable farming management, resulting in the loss of water, fertilizers and pesticides in soil. At present, hydrogels have been widely reported to promote the formation of soil aggregation. In this paper, amphiphilic calcium alginate (ASA/Ca²⁺) was applied to promote the formation of soil aggregation and enhance pesticide retention. Initially, an ASA was obtained through the one-pot Ugi condensation (a four-component green chemical reaction). Then, ASA/Ca²⁺ hydrogel is prepared by Ca²⁺ cross-linking. The formation of soil aggregation was determined through the Turbiscan Lab Expert stability analyzer, Confocal Laser Scanning Microscope (CLSM), and Transmission Electron Microscope (TEM). And the effect of soil aggregation on acetamiprid environmental behavior was investigated by adsorption kinetics, adsorption isotherms, and leaching. The results shown that the three-dimensional network structure of ASA/Ca²⁺ hydrogel can promote the formation of soil aggregation. Aggregate durability index (ADI) was 0.55 in the presence of ASA/Ca²⁺ hydrogel, indicating that amphiphilic hydrogel can enhance the stability of soil aggregation. The adsorbing capacity of acetamiprid was 1.58 times higher than pure soil, and the release of acetamiprid only about 20% in the presence of ASA/Ca²⁺ hydrogel. These results would be helpful for the formation of soil aggregation and pesticides adsorption on soil aggregation. Thus, ASA/Ca²⁺ hydrogel is likely to improve soil quality, simultaneously it can minimize the mobility of pesticides in the agricultural system.     

基于ANSYS的界面化核电站取水构筑物配筋程序开发

在实际工程应用中,对于结构复杂安全等级高的核电水工结构,相关的通用设计软件尚未形成。利用ANSYS二次开发工具APDL、UIDL以及Tcl/Tk可视化工具命令语言,针对核电站取水构筑物开发了一整套程序,包括了建模、计算以及后处理,后处理部分为内力计算和配筋可视化程序,简化了操作流程。算例表明,内力提取程序运算结果精度良好,可以用于配筋设计,利用配筋可视化程序对工程实例进行的配筋及裂缝验算,结果符合工程要求,针对配筋结果提出了墙体优化设计的建议。通过在ANSYS中实现内力计算和可视化配筋程序,可用于解决核电水工结构设计问题,有良好的工程适用性。     

基于机组受扰轨迹同调分群的实际电网解列配置

针对大型电网中区域性电网失稳的失步振荡问题,以华北2020年规划电网和东北电网2013年500 kV线路相间短路故障为研究对象,根据同调分群解列原理,提出了基于机组受扰轨迹同调分群的解列配置流程。结果表明:基于机组受扰轨迹同调分群的解列配置方法与常规解列配置方法相比,解列断面的设置思路更加清晰,并且,可以有效地解决多群振荡问题。     

二三道防线中切机措施对失步振荡中心的影响

电网多重故障下,二三道防线切机措施可能对失步振荡中心产生影响,并严重影响电力系统安全稳定运行。本文先从理论上分析得到二三道防线切机措施影响失步振荡中心迁移的规律,再以实际电网为研究对象,基于BPA仿真计算,研究多重故障下不同切机措施机组类型、位置、数量等差异对失步振荡中心的影响,并提出安控切机建议措施和高频切机优化方案。分析结果表明:在失步振荡过程中,二三道防线切机措施会影响失步振荡中心朝切机侧迁移。因此,在安控切机措施中应尽量避免切除振荡中心附近大容量火电机组,在高频切机方案中应先切除稳定性能较差的机组。     

Mechanical Properties and Morphology of Polypropylene/Poly(ethylene-co-octene) Blends

The polypropylene (PP)/poly(ethylene-co-octene) (POE) blends was prepared by means of a twin screw extruder in a range of temperature from 185 to 195 °C. The mechanical properties including tensile, flexural and impact of the PP/POE blends were measured at room temperature to identify the effect of the POE content on the mechanical properties. It was found that the Young’s modulus, tensile strength and tensile elongation at break decreased nonlinearly with increasing the POE weight fraction. While the V-notched and unnotched impact fracture strength increased nonlinearly with an increase of the POE weight fraction. The flexural modulus and strength decreased roughly linearly with increasing the POE weight fraction. Furthermore, the impact fracture surface of the blends was observed by using a scanning electronic microscope and the toughening mechanisms were discussed.     

海藻酸钠/锆@钙水凝胶的制备及其对磷的吸附研究

利用简便的方法制备了一种新型的海藻酸钠/锆@钙(SA/Zr@Ca)水凝胶材料,采用SEM、XRD对该材料进行了表征,并通过拟合吸附等温模型及吸附动力学模型,结合XPS和Zeta电位分析,研究了该材料对磷酸盐吸附的性能和机理.结果表明,该材料为非晶态的无定型材料.在溶液初始pH为2～7时,SA/Zr@Ca对磷酸盐(以PO...