基于SBR反应器的ANAMMOX工艺的启动运行

采用SBR反应器,接种好氧硝化污泥,在142 d内于较高负荷下成功启动了厌氧氨氧化反应器.反应器总氮容积负荷(以N计)为0.43 kg/m3·d,总氮去除率最高达到93.3%,平均为80.5%;氨氮和亚硝酸盐氮的去除率最高达到93.9%和99.8%,平均去除率为81.2%和85.7%.在稳定运行阶段,氨氮去除量、亚硝酸盐氮去除量、硝酸盐氮生成量三者之间的比值为1:1.38:0.18.反应器启动过程中,出水、进水pH差值的变化趋势由负到正,然后稳定在一定范围内;且污泥性状有较大变化,污泥中微生物所占比率有所提高,整个反应器中适应厌氧氨氧化运行方式的菌种增殖较快.     

Fenton试剂法处理甘氨酸废水中COD的研究

通过正交试验的方法用Fenton试剂对甘氨酸生产中的工业废水进行了试验研究,分析了各因素影响程度及各影响因子的作用机理,得出了最佳的操作条件为:H2O2:COD=1.8,[Fe2 ]=40 mmol/L,反应温度40℃,pH值为3,反应时间为80 min,最终的COD去除率为68%左右.     

高浓度焦化废水湿式氧化铜系催化剂的研制

通过共沉淀法制备了铜系催化剂 ,用于催化湿式氧化处理高浓度焦化废水。结果表明 ,铜氧化物催化剂的催化活性明显优于其他过渡金属氧化物 ;优化催化剂的设计和制备方法 ,可有效地改善Cu2 +的溶出问题 ,使该类催化剂具有广阔的应用前景     

某电厂堆灰场附近浅层地下水中Cr6+的成因及治理措施

分析了焦作某电厂堆灰场附近浅层地下水中Cr6+ 的形成原因。根据该区水文地质背景 ,提出在地下污染水羽的下游建可渗透反应墙的漏斗 -通道系统 ,用对Cr6+ 有很高去除效率的风化煤作为反应材料 ,使污染水羽流经此系统时有效去除地下水中的Cr6+ ,达到净化的目的     

Quantification of joint effect for hydrogen bond and development of QSARs for predicting mixture toxicity

A QSAR model is successfully proposed to predict the toxicity effect on Photobacterium phosphoreum by nonpolar-narcotic-chemical mixtures and/or polar-narcotic-chemical mixtures. For nonpolar-narcotic-chemical mixtures and polar-narcotic-chemical mixtures, their corresponding hydrophobicity-based QSAR models are derived from regression analysis. Comparison of these two QSAR models make us believe that it is the joint effect of hydrogen bond in polar-narcotic-chemical mixture that leads to the difference between these two models. Such joint effect of hydrogen bond can be quantified as AMH and BMH by using the different partition coefficients of mixtures in various organic phase/water systems. And the regression analysis results convinced us that the introduction of AMH does improve the quality of the QSAR model with r2=0.948, S.E.=0.166 and F=745.201 at P=0.000 for total 84 mixtures.     

Spatial and temporal organic and heavy metal pollution at Mai Po Marshes Nature Reserve,Hong Kong

An intensive monthly sampling of water and sediments from 12 sites over 8 months covering wet and dry seasons at Mai Po Marshes Nature Reserve was conducted during June 1997-February 1998. Major organic (C, N and P) and heavy metal pollutants (Cd, Cr, Cu, Ni, Pb, Zn) water and sediment samples were examined. The results showed that Mai Po Marshes were severely polluted by organic matter and heavy metals, and the water from Deep Bay appeared to be the source of pollution. Up to 13-55% chance that the sediments of Mai Po Marshes were classified as moderately to seriously metal contaminated materials, according to the guideline set by Hong Kong Government. Empirical models describing organic matter and heavy metal spatial and seasonal dynamics in the water and sediments were formulated, based on data analysis. During wet season (June-October), more than 58% variations of total P can be explained by ortho-P in water, while ammonia-N explained up to 90% variations of total Kjeldahl nitrogen in water. Throughout the whole sampling period (June-February), there were significant correlations (p<0.01) between total organic C in water. pH in the sediments and salinity in water appeared to be important factors determining heavy metal mobility in sediments, while potential metal release from the sediments is a concern when any oxidizing processes such as flooding or dredging are imposed on sediments.     

柱生物曝气法吸附处理含铬废水

利用复合生物吸附剂FY01与活性污泥作为吸附材料，探讨了柱式生物曝气法对高浓度含铬电镀废水的生物吸附效果。研究结果表明，FY01性能稳定，耐进水pH冲击能力较强。当进水pH=2—5、流速为500mL／h时，10gFY01和5g活性污泥联合处理60．4mg／L含铬电镀废水2h后，铬的去除率达78％以上；在4℃冰箱和23—28℃实验室保存50d的FY01对铬的去除分别在78％～83％和77％-84％之间。柱式生物曝气吸附法对含铬废水的处理效果理想，运行稳定。串联处理2000mL总Cr、Cu^2＋和COD浓度分别为60．4、4．51和48．2mg／L的电镀废水2h后，去除率分别高达92．1％、99．2％和71．4％。     

MnO2负载树脂的制备及对As（V）的去除效果

制备了大孔和DH302 2种MnO2的负载树脂。并用SEM、EDS手段表征了负载树脂，实验了负载MnO2后树脂对As（V）的去除效果。结果表明：负载树脂对As（V）的去除效果比原树脂有很大提高；吸附As（V）后的2种负载树脂，均能较好地解吸并可重新用于对As（V）的吸附实验。     

微絮凝-超滤工艺处理微污染水源水的中试研究

进行了微絮凝．超滤工艺处理微污染水源水的中试研究。试验结果表明：在微絮凝-超滤工艺中，相同混凝剂投加量（相同金属摩尔浓度）下铁盐比铝盐的混凝效果好；微絮凝-超滤工艺的最佳絮凝时间为120s左右；最佳混凝剂投加量为2．2mg／L（以Fe计）。微絮凝-超滤工艺在改善出水水质和缓解膜污染方面均优于直接超滤工艺。微絮凝-超滤工艺的出水水质均符合建设部《城市供水水质标准》（CJ／T206-2005）要求。     

不同比例乙酸和丙酸对活性污泥微生物合成聚羟基脂肪酸酯的影响

聚羟基脂肪酸酯（PHA）是一种生物可降解塑料,利用活性污泥合成PHA具有节约成本、操作方便的优点。研究选择污泥发酵液挥发性脂肪酸（VFAs）中比重相对较高的乙酸和丙酸作为碳源自配营养液,深入研究不同质量浓度比对PHA合成的影响。结果表明,乙酸为主要碳源时更有利于PHA的合成,最大合成量12.3%出现在乙酸作为唯一碳源的条件下。此外,PHA合成量随着底物中有机酸比重的增加而增加,充分展现了利用挥发性脂肪酸大量合成PHA的良好前景。