宝钢焦化废水处理脱氮研究与实践

针对上海提高新排放标准中总氮(TN)≤35 mg/L的要求,对焦化废水进行了脱氮研究。选取现场缺氧-好氧-好氧(A-O-O)工艺中前两段的A-O生化沉淀池1出水,在SBR内进行反硝化脱氮实验,考察葡萄糖、葡萄糖+乙酸钠、甲醇和甲醇+乙酸钠单一或复合碳源及投加反硝化菌种对脱氮的影响,确定最佳碳源为甲醇+乙酸钠,最佳反硝化水力停留时间为16 h。当反硝化菌液投加浓度为1 mg/L时,SBR出水TN满足达标排放要求。结合实验结果对宝钢焦化废水原有AO-O工艺改造升级为A-O-A-O二段脱氮工艺,并对生化出水实施进一步的物化混凝处理。改造后,工艺长期运行稳定,最终出水完全达到上海市污水综合排放标准(DB 31/199-2009)TN≤35 mg/L的要求,并满足氰化物、氟化物以及COD的排放要求。     

鼠李糖脂洗脱氯丹和灭蚁灵污染场地土壤的工艺参数

优化了鼠李糖脂洗脱氯丹、灭蚁灵污染土壤的工艺条件,为开展有机氯农药污染场地土壤洗脱修复工程实践提供科学依据和技术参数。实验结果表明,随着洗脱剂———鼠李糖脂浓度的增加,氯丹和灭蚁灵的洗脱量呈现先增加后降低的趋势;洗脱时间和液固比对洗脱效果的影响趋势与浓度相同;在0~120 r/min范围内,氯丹和灭蚁灵洗脱量随着搅拌速度的增加而增大,80、120和200 r/min的洗脱量间差异不显著;单次洗脱量随洗脱次数的增加而降低,累计洗脱量则逐渐增大。综上所述,氯丹、灭蚁灵污染场地土壤鼠李糖脂洗脱的适宜工艺参数为鼠李糖浓度10 mmol/L,搅拌速度80 r/min,固液比1∶10,洗脱时间20 min,洗脱3次。     

电镀污泥的热处理特性以及对金属回收的影响

焙烧-酸浸法可有效回收电镀污泥中的有价金属,而污泥的热处理特性是决定能否采用焙烧预处理的重要因素。研究了氧化焙烧和还原焙烧对污泥成分和金属浸出性的影响,并对焙烧前后的污泥进行了金属形态分析和X射线衍射(XRD)分析。结果表明,焙烧预处理实现了污泥减量和金属富集;ES1经氧化焙烧后金属浸出率接近原泥,Cu的浸出率达99%;ES2的还原焙烧效果优于氧化焙烧,特别是Cu的浸出率超过97%,XRD分析发现,还原焙烧过程中金属Cu被还原为铁铜合金;2种焙烧均造成了ES3中目标金属Ni的浸出率的降低;金属浸出性的下降与残渣态的形成有关。     

A full-scale sequencing batch reactor system for swine wastewater treatment

A full-scale sequencing batch reactor (SBR) system was evaluated for its ability to remove carbon and nitrogen from swine wastewater. The SBR was operated on four, six-hour cycles each day, with each cycle consisting of 4.5 hours of “React,” 0.75 hours of “Settling”, 0.75 hours for “Draw” and “Fill.” Within each cycle, an amount of wastewater equivalent to about 5% of the reactor volume (5,500 litres) was removed and added. The SBR system was able to remove 82% of biochemical oxygen demand (BOD) and more than 75% of nitrogen. Even though the SBR effluent, with an average effluent BOD₅ of about 588 mg L^{? 1}, did not meet the discharge criteria, it enabled a reduction of the land base required for land application of swine wastewater by about 75%. Results indicated that the SBR system was a viable method for the treatment of swine wastewater.     

Treating solid dairy manure using microwave-enhanced advanced oxidation process

The microwave enhanced advanced oxidation process (MW/H₂O₂-AOP) was used to treat separated solid dairy manure for nutrient release and solids reduction. The MW/H₂O₂-AOP was conducted at a microwave temperature of 120°C for 10 minutes, and at three pH conditions of 3.5, 7.3 and 12. The hydrogen peroxide dosage at approximately 2 mL per 1% TS for a 30 mL sample was used in this study, reflecting a range of 0.53–0.75 g H₂O₂/g dry sludge. The results indicated that substantial quantities of nutrients could be released into the solution at pH of 3.5. However, at neutral and basic conditions only volatile fatty acids and soluble chemical oxygen demand could be released. The analyses on orthophosphate, soluble chemical oxygen demands and volatile fatty acids were re-examined for dairy manure. It was found that the orthophosphate concentration for untreated samples at a higher % total solids (TS) was suppressed and lesser than actual. To overcome this difficulty, the initial orthophosphate concentration had to be measured at 0.5% TS.     

Microwave enhanced advanced oxidation process for treating dairy manure at low pH

This study investigated the treatment of dairy manure using the microwave enhanced advanced oxidation process (MW-AOP) at pH 2. An experimental design was developed based on a statistical program using response surface methodology to explore the effects of temperature, hydrogen peroxide dosage and heating time on sugar production, nutrient release and solids destruction. Temperature, hydrogen peroxide dosage and acid concentration were key factors affecting reducing sugar production. The highest reducing sugar yield of 7.4% was obtained at 160°C, 0 mL, 15 min heating time, and no H₂O₂ addition. Temperature was a dominant factor for an increase of soluble chemical oxygen demand (SCOD) in the treated dairy manure. The important factors for volatile fatty acids (VFA) production were microwave temperature and hydrogen peroxide dosage. Temperature was the most important parameter, and heating time, to a lesser extent affecting orthophosphate release. Heating time, hydrogen peroxide dosage and temperature were significant factors for ammonia release. There was a maximum of 96% and 196% increase in orthophosphate and ammonia concentration, respectively at 160°C, 0.5 mL H₂O₂ and 15 min heating time. The MW-AOP is an effective method in dairy manure treatment for sugar production, nutrient solubilisation, and solids disintegration.     

The characteristics of nitrate removal by the psychrotolerant denitrifying bacterium Acinetobacter johnonii DBP-3, isolated from a low-temperature eutrophic body of water

A psychrotolerant denitrifying bacterial strain, DBP-3, was isolated from a eutrophic body of water by low-temperature-oriented acclimation culture. Based on its morphologicalandbiochemicalcharacteristics and 16S rDNA gene sequence, the bacterium was identified as belonging to the genus Acinetobacter and closely related to A. johnonii. The satisfactory growth of DBP-3 was observed at 10–30°C and pH 7–9. Strain DBP-3 was able to utilize three types of carbon sources (sodium acetate > sodium citrate > glucose) to support growth and denitrification. DBP-3 grew faster, but with lower nitrate removal efficiency and higher nitrite accumulation, under aerobic conditions than under anoxic conditions. DBP-3 was extremely susceptible to tetracycline and rifampicine and less sensitive to ampicillin and penicillin. The growth of DBP-3 was significantly affected by Hg (II), Cr (VI), Pb (II), Cd (II), and As (III) at 0.32, 0.63, 1.25, 2.5, and 25.0 mg L^?1, respectively. Interestingly, chromium (VI) significantly promoted DBP-3 growth at concentrations lower than 0.32 mg L^?1. These data may be helpful to support the use of strain DBP-3 in the purification of eutrophic water bodies at low temperatures.     

Influences of adding easily degradable organic waste on the minimization and humification of organic matter during straw composting

To find a better composting process with low greenhouse gas emission and high humus production, the effect of adding kitchen waste on reduction and humification of organic matter during straw composting was studied. Three processes were compared, consisting of different ratios of straw and kitchen waste (1:2, 1:1, and 2:1). At four time points over a 62-d incubation, the reduction and humification of compost was evaluated by measuring the total mass, carbon content, and humic material content of the compost. Treatment 1 (straw/kitchen waste ratio of 1:2) reduced the total mass of compost the most. Treatment 2 (straw/kitchen waste ratio of 1:1) reduced the total carbon content the most, reflecting the highest emission of greenhouse gas. Treatment 3 produced the most humic acid material and released the lowest amount of carbon. Hence, from the point of view of reducing greenhouse gas emissions and increasing stable organic matter such as humus and humic acid during composting, treatment #3 was optimal. The three treatments resulted in significant differences in microbial biomass and enzyme activity during composting. The highest amount of active microbial biomass was associated with the largest reduction in compost mass (treatment 1). Higher proportions of straw (treatments 2 and 3), which contains more lignin, were associated with greater β-glycosidase activity, which may generate more humus that can improve soil quality. Dehydrogenase activity seemed to be the most important microbial factor in organic carbon catabolism or humification.     

Hydrothermal treatment for inactivating some hygienic microbial indicators from food waste–amended animal feed

To achieve the hygienic safety of food waste used as animal feed, a hydrothermal treatment process of 60–110 °C for 10–60 min was applied on the separated food waste from a university canteen. Based on the microbial analysis of raw waste, the inactivation of hygienic indicators of Staphylococcus aureus (SA), total coliform (TC), total aerobic plate counts (TPC), and molds and yeast (MY) were analyzed during the hydrothermal process. Results showed that indicators' concentrations were substantially reduced after hydrothermal treatment, with a greater reduction observed when the waste was treated with a higher temperature and pressure and a longer ramping time. The 110 °C hydrothermal treatment for 60 min was sufficient to disinfect food waste as animal feed from the viewpoint of hygienic safety. Results obtained so far indicate that hydrothermal treatment can significantly decrease microbial indicators' concentrations but does not lead to complete sterilization, because MY survived even after 60 min treatment at 110 °C. The information from the present study will contribute to the microbial risk control of food waste–amended animal feed, to cope with legislation on food or feed safety.

Implications: Reduction of microbial indicators at ramping time and holding time during the hydrothermal process showed that hydrothermal treatment is an effective method to achieve hygienic feed from food waste to a certain extent, but the conditions researched in this study were not enough for the complete sterilization of food waste, because of the different heat resistance of bacteria and spores.     

Chemical characteristics of fine particulate matters measured during severe winter haze events in Ulaanbaatar,Mongolia

In order to investigate the chemical characteristics of atmospheric aerosol measured during a severe winter haze event, 12-hr PM_2.5 (particulate matter with an aerodynamic diameter ≤2.5 μm) samples were collected at an urban site in Ulaanbaatar, Mongolia, from January 9 to February 17, 2008. On average, 12-hr PM_2.5 mass concentration was 105.1 ± 34.9 μg/m³. Low PM_2.5 mass concentrations were measured when low pressure developed over central Mongolia. The 12-hr average organic mass by carbon (OMC) varied from 6.4 to 132.3 μg/m³, with a mean of 54.9 ± 25.4 μg/m³, whereas elemental carbon (EC) concentration ranged from 0.1 to 3.6 μgC/m³, with a mean of 1.5 ± 0.8 μgC/m³. Ammonium sulfate was found to be the most abundant water-soluble ionic component in Ulaanbaatar during the sampling period, with an average concentration of 11.3 ± 5.0 μg/m³. In order to characterize the effect of air mass pathway on fine particulate matter characteristics, 5-day back-trajectory analysis was conducted, using the Hybrid Single-Particle Lagrangian Integrated Trajectory (HYSPLIT) model. The haze level was classified into three categories, based on the 5-day air mass back trajectories, as Stagnant (ST), Continental (CT), and Low Pressure (LP) cases. PM_2.5 mass concentration during the Stagnant condition was approximately 2.5 times higher than that during the Low Pressure condition, mainly due to increased pollutant concentration of OMC and secondary ammonium sulfate.

Implications: Mongolia is experiencing rapid rates of urbanization similar to other Asian countries, resulting in air pollution problems by the growing number of automobiles and industrialization. Ulaanbaatar, capital of Mongolia, is inherently vulnerable to air pollution because of its emission sources, topography, and meteorological characteristics. Very limited measurements on chemical characteristics of particulate matter have been carried out in Ulaanbaatar, Mongolia.