Modeling porosity reductions caused by mineral fouling in continuous-wall permeable reactive barriers

A study was conducted to assess key factors to include when modeling porosity reductions caused by mineral fouling in permeable reactive barriers (PRBs) containing granular zero valent iron. The public domain codes MODFLOW and RT3D were used and a geochemical algorithm was developed for RT3D to simulate geochemical reactions occurring in PRBs. Results of simulations conducted with the model show that the largest porosity reductions occur between the entrance and mid-plane of the PRB as a result of precipitation of carbonate minerals and that smaller porosity reductions occur between the mid-plane and exit face due to precipitation of ferrous hydroxide. These findings are consistent with field and laboratory observations, as well as modeling predictions made by others. Parametric studies were conducted to identify the most important variables to include in a model evaluating porosity reduction. These studies showed that three minerals (CaCO3, FeCO3, and Fe(OH)2 (am)) account for more than 99% of the porosity reductions that were predicted. The porosity reduction is sensitive to influent concentrations of HCO3-, Ca2+, CO3(2-), and dissolved oxygen, the anaerobic iron corrosion rate, and the rates of CaCO3 and FeCO3 formation. The predictions also show that porosity reductions in PRBs can be spatially variable and mineral forming ions penetrate deeper into the PRB as a result of flow heterogeneities, which reflects the balance between the rate of mass transport and geochemical reaction rates. Level of aquifer heterogeneity and the contrast in hydraulic conductivity between the aquifer and PRB are the most important hydraulic variables affecting porosity reduction. Spatial continuity of aquifer hydraulic conductivity is less significant.     

竹炭-微生物联合法对沼液中氨氮的去除

采用竹炭-微生物联合法,考察了竹炭用量、菌液用量、进水氨氮浓度、pH、DO、HRT等因素对氨氮废水处理效果的影响;同时采用对比实验,初步探讨了竹炭-微生物联合法处理沼液的作用机理。结果表明,竹炭-微生物法去除沼液氨氮的最优条件推荐为:竹炭用量30 g/L,微生物活性液用量3%,pH 7.0～8.0,DO为2 mg/L,HRT为48 h。竹炭-微生物法对沼液氨氮的去除过程可用一级反应动力学模型C=272.56e-0.0148描述,其去除效果来源于竹炭吸附和生物降解的协同作用,协同程度为48.45%。     

The sedimentation capabilities of hexadecyltrimethylammonium-modified montmorillonites

Natural montmorillonite was modified with a quaternary ammonium compound, hexadecyltrimethylammonium (HDTMA). The sedimentation capabilities of unmodified and modified montmorillonites were then investigated. The sedimentation velocity of modified montmorillonites increased if the amounts of adsorbed HDTMA were from 0.3 to 1.0 times the cation exchange capacitity (CEC). It also emerged that the sedimentation capability of modified montmorillonites was improved and that the variously CEC-modified montmorillonites had similar sedimentation capabilities after they had sorbed organic matter from oily wastewater. Thus, modified montmorillonites (especially 0.5 CEC treatment) had good sedimentation capabilities for sorbing organic substance and can act as carriers in wastewater biotreatment.     

温度及外加碳源对生物脱氮除磷过程的影响

针对污水处理厂普遍面临的进水碳源不足及冬季低温时出水氮磷不能稳定达标的问题,研究了温度(21、15和10℃)和外加碳源(乙酸)对活性污泥缺氧条件下反硝化及释磷过程的影响。结果表明,在缺氧条件下投加乙酸,释磷与反硝化反应可同时进行,且乙酸投量的增加仅延长快速碳源反硝化阶段及缺氧释磷阶段的反应时间;温度降低为15℃和10℃时,快速碳源反硝化阶段反硝化速率及缺氧释磷速率较21℃分别降低了约29.2%、42.2%和26.1%、32.3%。当硝态氮目标去除量与磷酸盐目标释放量之比超过5时,乙酸的最优投量以满足反硝化要求为准,计算得出21、15和10℃时常州某城镇污水处理厂乙酸最优投加量计算值约为30、39和46 mg/L。     

污水低氧脱氮机制及其应用研究进展

阐述了污水低氧脱氮的基本原理,即抑制或去除亚硝酸盐氧化菌(NOB),同时保留氨氧化菌(AOB),并保持其活性;探讨了污水低氧脱氮实现途径;详细介绍了几种典型的污水低氧脱氮工艺(短程硝化(SHARON)工艺、厌氧氨氧化(ANAMMOX)工艺、好氧反氨化(DEMON)工艺、低氧自养硝化反硝化(OLAND)工艺、甲烷营养型硝化反硝化工艺和亚硝酸盐型完全自养脱氮(CANNON)工艺)的应用研究进展;最后对污水低氧脱氮处理工艺的工程运用进行了展望.     

负载型纳米TiO2光催化降解水中微量溶解性间二甲苯

以高压汞灯为光源 ,采用浸涂 -烧结法制备的负载型纳米TiO2 作为光催化剂 ,通过对水中微量溶解性间二甲苯的光催化氧化过程的研究表明 ,初始浓度在 6 .6 8— 17.36mg/L的范围内 ,间二甲苯的光催化反应遵循表观一级反应动力学规律 ,反应的表观速率常数随溶液初始浓度的增大而减小 ,半衰期则随初始浓度的增大而增加 ,经 1.5h反应后 ,溶液中间二甲苯的去除率从 17.36mg/L的 5 4 .4 4 %增加到 6 .6 8mg/L的 75 .90 %。     

炭纤维载体固定床厌氧发酵启动运行效果实验

以开发高效率、抗冲击性能强的高浓度有机废水沼气发酵技术为目的,用传统的 UASB反应器作为对照,研究了以炭纤维为生物膜载体的固定床厌氧反应器的启动运行效果。反应器进口废水 COD 为 5 000 mg/L, 水力停留时间 (HRT) 由213 h 逐步缩短为35 h,进水有机容积负荷(OLR)由0.56 kg COD/ (m³·d)提到3.45 kg COD/(m³·d)。结果表明,固定床反应器厌氧发酵的效率比对照高,出水 pH 值也比对照稳定;运行到第 50 d 时,固定床厌氧反应器和对照的 COD去除率分别由第 7 d 的36.56%和33.58%上升到87.9%和62.6%;固定床厌氧反应器的容积比产气率最高为1.16 m³/(m³·d),累计产气量为415.59 L,而对照的容积比产气率最高值仅为0.31 m³ /(m³·d),累计产气量为 71.66 L,前者最高容积比产气率和累计产气量分别是后者的3.74倍和5.78倍。固定床厌氧反应器的启动速度、COD 去除率和产甲烷效率显著地高于对照反应器。     

Adsorption of Pb(II) on variable charge soils amended with rice-straw derived biochar

Two Ultisols and one Oxisol from tropical regions of southern China were incubated with rice straw biochar to investigate the effect of biochar on their surface charge and Pb(II) adsorption using batch methods. The incorporation of biochar induced a remarkable increase in soil cation exchange capacity after 30 d of incubation. The incorporation of biochar significantly increased the adsorption of Pb(II) by these variable charge soils; the enhancement of adsorption of Pb(II) by these soils increased with the addition level of biochar. Adsorption of Pb(II) involved both electrostatic and non-electrostatic mechanisms; however, biochar mainly increased Pb(II) adsorption through the non-electrostatic mechanism via the formation of surface complexes between Pb²⁺ and functional groups on biochar. There was greater enhancement of biochar on the non-electrostatic adsorption of Pb(II) by the variable charge soils at relatively low pH. Therefore, the incorporation of biochar decreased the activity and availability of Pb(II) to plants through increased non-electrostatic adsorption of Pb(II) by acidic variable charge soils.     

关于企业安全评价的思考

我国安全评价工作,从无到有、从小到大,期间经历了曲曲折折,安全评价体系为保障我国的安全生产工作发挥了巨大的作用,但也要注意到安全评价后企业的安全状况、职工的安全意识、安全技术水平没有得到根本性的改变及安全评价机构的地位、安全的科学定义不明确等,这就很值得安全监管和安全科技工作人员思考.     

Improvements of nano-SiO2 on sludge/fly ash mortar

Sewage sludge ash has been widely applied to cementitious materials. In this study, in order to determine effects of nano-SiO(2) additives on properties of sludge/fly ash mortar, different amounts of nano-SiO(2) were added to sludge/fly ash mortar specimens to investigate their physical properties and micro-structures. A water-binding ratio of 0.7 was assigned to the mix. Substitution amounts of 0%, 10%, 20%, and 30% of sludge/fly ash (1:1 ratio) were proposed. Moreover, 0%, 1%, 2%, and 3% of nano-SiO(2) was added to the mix. Tests, including SEM and compressive strength, were carried out on mortar specimens cured at 3, 7, and 28 days. Results showed that sludge/fly ash can make the crystals of cement hydration product finer. Moreover, crystals increased after nano-SiO(2) was added. Hence, nano-SiO(2) can improve the effects of sludge/fly ash on the hydration of mortar. Further, due to the low pozzolanic reaction active index of sludge ash, early compressive strengths of sludge/fly ash mortar were decreased. Yet, nano-SiO(2) could help produce hydration crystals, which implies that the addition of nano-SiO(2) to mortar can improve the influence of sludge/fly ash on the development of the early strength of the mortar.