Effects of butachlor on microbial populations and enzyme activities in paddy soil

This paper reports the influences of the herbicide butachlor (n-butoxymethlchloro -2', 6'-diethylacetnilide) on microbial populations, respiration, nitrogen fixation and nitrification, and on the activities of dehydrogenase and hydrogen peroxidase in paddy soil. The results showed that the number of actinomycetes declined significantly after the application of butachlor at different concentrations ranging from 5.5 microg g(-1) to 22.0 microg g(-1) dried soil, while that of bacteria and fungi increased. Fungi were easily affected by butachlor compared to the bacteria. The growth of fungi was retarded by butachlor at higher concentrations. Butachlor however, stimulated the growth of anaerobic hydrolytic fermentative bacteria, sulfate-reducing bacteria (SRB) and denitrifying bacteria. The increased concentration of butachlor applied resulted in the higher number of SRB. Butachlor inhibited the growth of hydrogen-producing acetogenic bacteria. The effect of butachlor varied on methane-producing bacteria (MPB) at different concentrations. Butachlor at the concentration of 1.0 microg g(-1) dried soil or less than this concentration accelerated the growth of MPB, while at 22.0 microg g(-1) dried soil showed an inhibition. Butachlor enhanced the activity of dehydrogenase at increasing concentrations. The soil dehydrogenase showed the highest activity on the 16th day after application of 22.0 microg g(-1) dried soil of butachlor. The hydrogen peroxidase could be stimulated by butachlor. The soil respiration was depressed during the period from several days to more than 20 days, depending on concentrations of butachlor applied. Both the nitrogen fixation and nitrification were stimulated in the beginning but reduced greatly afterwards in paddy soil.     

汽车尾气催化转化器模型研究进展

本文主要介绍汽车尾气催化转化器模型的研究进展 ,包括反应器内气体流动特性、单通道反应器内的传递现象和反应动力学、通道间的热传递和反应行为的模拟 ;并指出认识反应器内的各种特性和规律对设计汽车尾气催化转化器的必要性和意义     

Synergetic effects of anodic-cathodic electrocatalysis for phenol degradation in the presence of iron(II)

A novel electrocatalysis method for phenol degradation was described using a β-PbO₂ anode modified with fluorine resin and a Ni–Cr–Ti alloy cathode. In case of air sparging at the cathodic zone, the techniques of anodic–cathodic electrocatalysis (ACEC) and ferrous ion catalyzed anodic–cathodic electrocatalysis (FACEC) in the presence of iron(II) were developed. Both of ACEC and FACEC were more effective than anodic electrocatalysis (AEC). The percentage of phenol eliminated by FACEC could increase by nearly 30% compared with that of AEC, and the current efficiency could reach to 70%. Important operating factors such as ferrous ion concentration, air-sparging rate and applied current were investigated and it was found that such beneficial effects could be achieved at a suitable current and ratio of the concentration of ferrous ion to the air sparged. The mechanism of phenol degradation is proposed to be the generation of hydroxyl radicals concerned with the two electrodes. Results also indicated that the process provided an efficient way to regenerate ferrous ion compared with the conventional Fenton's system.     

Characterization of metal adsorption kinetic properties in batch and fixed-bed reactors

Copper adsorption kinetic properties in batch and fixed-bed reactors were studied in this paper. The isothermal adsorption experiments showed that the copper adsorption capacity of a granular activated carbon (Filtrasorb 200) increased when ionic strength was higher. The presence of EDTA diminished the adsorption. An intraparticle diffusion model and a fixed-bed model were successfully used to describe the batch kinetic and fixed-bed operation behaviors. The kinetics became faster when the solution pH was not controlled, implying that the surface precipitation caused some metal uptake. The external mass transfer coefficient, the diffusivity and the dispersion coefficient were obtained from the modeling. It was found that both external mass transfer and dispersion coefficients increased when the flow rate was higher. Finally effects of kinetic parameters on simulation of fixed-bed operation were conducted.     

Abatement of sulfur hexafluoride emissions from the semiconductor manufacturing process by atmospheric-pressure plasmas

Sulfur hexafluoride (SF6) is an important gas for plasma etching processes in the semiconductor industry. SF6 intensely absorbs infrared radiation and, consequently, aggravates global warming. This study investigates SF6 abatement by nonthermal plasma technologies under atmospheric pressure. Two kinds of nonthermal plasma processes--dielectric barrier discharge (DBD) and combined plasma catalysis (CPC)--were employed and evaluated. Experimental results indicated that as much as 91% of SF6 was removed with DBDs at 20 kV of applied voltage and 150 Hz of discharge frequency for the gas stream containing 300 ppm SF6, 12% oxygen (O2), and 40% argon (Ar), with nitrogen (N2) as the carrier gas. Four additives, including Ar, O2, ethylene (C2H4), and H2O(g), are effective in enhancing SF6 abatement in the range of conditions studied. DBD achieves a higher SF6 removal efficiency than does CPC at the same operation condition. But CPC achieves a higher electrical energy utilization compared with DBD. However, poisoning of catalysts by sulfur (S)-containing species needs further investigation. SF6 is mainly converted to SOF2, SO2F4, sulfur dioxide (SO2), oxygen difluoride (OF2), and fluoride (F2). They do not cause global warming and can be captured by either wet scrubbing or adsorption. This study indicates that DBD and CPC are feasible control technologies for reducing SF6 emissions.     

Removal of BTEX vapor from waste gases by a trickle bed biofilter

The system performance of a trickle bed biofilter for treating single and mixed benzene, toluene, ethylbenzene, and o-xylene (BTEX) vapors from waste gases was investigated under different gas flow rates and influent BTEX concentrations. When a single substrate was fed, removal efficiencies of greater than 90% could be achieved for the loads below 64 g benzene/m3/hr, 110 g toluene/m3/hr, 53 g ethylbenzene/m3/hr, and 55 g o-xylene/m3/hr. When a mixed substrate was fed, removal efficiencies of each compound could be above 90% at BTEX loads below 96 g/m3/hr. The trickle bed biofilter appears to be an effective treatment process for removing both single and mixed BTEX vapors with low to high loads. Under similar substrate loads, BTEX vapors were preferentially biodegraded in the order of toluene, benzene, o-xylene, and ethylbenzene. The volumetric removal rates (elimination capacities) of BTEX vapors for a single-substrate feed were higher than those for a mixed-substrate feed under similar substrate loads; these differences were enhanced at higher substrate loads and less significant for a preferred substrate.     

Effects of tri-o-cresyl phosphate on serum estrogen and progesterone concentration and ATPase activity in the shell gland of adult hens

The activities of calcium-activated ATPase (Ca2+-ATPase) and calcium magnesium-activated ATPase (Ca2+-Mg2+-ATPase) in the shell gland, and concentrations of 17beta-estradiol (E2) and progesterone in serum were monitored, respectively, from hens orally dosed with tri-o-cresyl phosphate (TOCP) (750 mg/kg). Treated birds were monitored daily for laying and development of delayed neurotoxicity, and activities of Ca2+-ATPase and Ca2+-Mg2+-ATPase were measured at 7 and 10 days after dosing. TOCP-treated birds manifested motor deficit by 7-9 days postdosing, while hens administered vehicle exhibited no signs of delayed neurotoxicity. Ca2+-ATPase and Ca2+-Mg2+-ATPase activities of shell glands from TOCP-dosed hens were not significantly affected (P > 0.05). The serum E2 concentration was significantly reduced in TOCP-treated hens (P < 0.01); however, progesterone levels were unaffected.     

Comparison of particulate mass, chemical species for urban, suburban and rural areas in central Taiwan, Taichung

Aerosol samples for PM2.5, PM(2.5-10) and TSP were collected from June to September 1998 and from February to March 1999 in central Taiwan. Ion chromatography was used to analyze the acidic anions: sulfate, nitrate and chloride in the Universal samples. The ratios of fine particle concentrations to coarse particle concentrations displayed that the fine particle concentrations are almost greater than that of coarse particle concentrations in Taichung area. The average concentrations of PM2.5, PM(2.5-10) and TSP in urban sites are higher than in suburban and rural sites at both daytime and night-time. Chloride dominated in the coarse mode in daytime and in fine mode in night-time. Nitrate can be found in both the coarse and fine modes. Sulfate dominated in fine mode in both daytime and night-time.     

滇池铜绿微囊藻（Microcystis aeruginosa kutz）对小白鼠肝脏和肝脏微结构毒害的研究

本文研究滇池水体富营养化时，产生“水华”的铜绿微囊藻可使小白鼠肝脏增重及肝脏超微结构发生明显变化，致使小白鼠中毒死亡。     

Partition coefficients of organochlorine pesticides on soil and on the dissolved organic matter in water

The partition coefficients of organochlorine pesticides (OCPs) between the organic matter of Taichung soil and water (K_oc) were evaluated with batch-type experiments. The partition coefficients of OCPs between Aldrich humic acid and water (K_doc) were estimated with solubility enhancement method as well. In this study, the K_ocs of aldrin, heptachlor, and p,p′-DDT are greater than their K_docs, and the relationship of dieldrin and heptachlor epoxide are opposite. The variations of partition coefficients are discussed. For predicting K_doc, a log-log regression relationship of K_doc and K_ow is determined.