赤霉酸暴露对SD大鼠青春期发育的影响

赤霉酸是目前国内外使用极其广泛的一种植物生长调节剂,但是针对其发育毒性的数据依然较少。本文探讨了赤霉酸暴露对SD大鼠青春期发育的影响。参考国内外环境内分泌干扰物危害的评价方法,将144只初断乳SD大鼠按体重随机分为4组,分别为对照组和1、10、100 mg·kg-1bw剂量组,采用经口灌胃方式对雄鼠连续染毒28 d,雌鼠连续染毒21 d。暴露结束后检测大鼠的体重、食物利用率、雄鼠包皮分离时间/雌鼠阴道开口时间、血清生化指标、脏器系数及组织病理学的变化。研究结果表明,与对照组相比,仅10和100 mg·kg-1bw剂量组雄鼠的肌酐水平显著升高(P<0.01),100 mg·kg-1bw剂量组雌鼠谷丙转氨酶水平有显著升高(P<0.01)。而与对照组相比,所有剂量组均未观察到大鼠的体重、食物利用率、雄鼠包皮分离时间/雌鼠阴道开口时间、脏器系数等指标有显著性差异的改变(P>0.05),组织病理学结果亦显示大鼠重要器官无损害性改变。因此,在本试验给予的剂量范围内赤霉酸染毒不会对SD大鼠青春期发育产生显著影响。     

苏北浅滩腰沙围填海控制线研究

围填海控制线是在工程可行的前提下,不显著改变区域海洋动力格局和岸滩演变趋势的最大围填外包络线,能够最大限度地协调围填海与海洋资源环境保护之间的关系。以苏北浅滩腰沙为例,在对围填海控制性因素进行筛选、识别与分析的基础上,根据各控制性因素的控制要求,设计了围填海控制性指标。应用潮流数值模拟和泥沙回淤预测技术,采用分层次筛选和迭代逼近的方法,构建围填海控制线迭代优选模型,分析不同围填海方案对海洋动力格局演变的影响,计算得到腰沙的围填海控制线为理论基面+28 m。提出的研究方法和迭代优选模型可为沿海省市围填海控制线的制定提供参考和方法借鉴,为制定围填海规模总量控制指标提供科学依据     

陕北能源化工基地某工业园区水污染物排放总量控制研究

基于水污染物总量控制思路,以陕北能源化工基地某工业园区为研究对象,分析工业园区主要水环境问题及原因,分别对园区企业和集中污水处理厂提出排水水量、水质控制要求,从工程技术措施和管理手段上提出了明确的解决方案和要求。结果表明,各项减排措施实施后,COD、氨氮、石油类物质分别削减49.4%、71.0%、72.6%,园区排水总量控制在1.18万t/d,最终保证园区水污染物总量控制目标的实现。     

非饱和土壤渗透系数空间不确定性对溶质运移的影响

包气带渗透系数的不确定性是影响非饱和带溶质运移的主要因素。应用贝叶斯方法对非饱和土壤渗透系数进行前处理,使用Monte-Carlo方法模拟其空间不确定性,并通过HYDRUS-1D模型对溶质运移进行数值模拟,研究包气带渗透系数的空间不确定性对溶质运移的影响。结果表明,由于包气带渗透性的不确定性使得溶质浓度分布呈现明显的不确定性,包气带内不同点的浓度值相差很大。与忽略包气带土性参数空间不确定性的模拟结果相对比,考虑包气带渗透系数不确定性的模拟结果与实际情况更加接近,更具合理性和科学性。同时,根据模拟结果,对实际工作中进行地下水数值模拟时溶质初始浓度输入值的确定提出相应建议。     

北京市建筑废弃物资源化利用研究与项目示范

针对北京市建筑废弃物产量大、资源化利用率低的问题,分析了北京市建筑废弃物的来源、产量、组分及处理现状,阐述了建筑废弃物资源化利用途径和资源化利用工艺,介绍了朝阳区建筑废弃物资源化示范项目建设情况,给出了北京市建筑废弃物资源化利用设施建设合理建议。     

Effect of temperature and particle size on the thermal desorption of PCBs from contaminated soil

Thermal desorption is widely used for remediation of soil contaminated with volatiles, such as solvents and distillates. In this study, a soil contaminated with semivolatile polychlorinated biphenyls (PCBs) was sampled at an interim storage point for waste PCB transformers and heated to temperatures from 300 to 600 °C in a flow of nitrogen to investigate the effect of temperature and particle size on thermal desorption. Two size fractions were tested: coarse soil of 420–841 μm and fine soil with particles <250 μm. A PCB removal efficiency of 98.0 % was attained after 1 h of thermal treatment at 600 °C. The residual amount of PCBs in this soil decreased with rising thermal treatment temperature while the amount transferred to the gas phase increased up to 550 °C; at 600 °C, destruction of PCBs became more obvious. At low temperature, the thermally treated soil still had a similar PCB homologue distribution as raw soil, indicating thermal desorption as a main mechanism in removal. Dechlorination and decomposition increasingly occurred at high temperature, since shifts in average chlorination level were observed, from 3.34 in the raw soil to 2.75 in soil treated at 600 °C. Fine soil particles showed higher removal efficiency and destruction efficiency than coarse particles, suggesting that desorption from coarse particles is influenced by mass transfer.     

Soil carbon and nitrogen dynamics in the first year following herbicide and scalping in a revegetation trial in south-east Queensland,Australia

During revegetation, the maintenance of soil carbon (C) pools and nitrogen (N) availability is considered essential for soil fertility and this study aimed to evaluate contrasting methods of site preparation (herbicide and scalping) with respect to the effects on soil organic matter (SOM) during the critical early establishment phase. Soil total C (TC), total N (TN), hot-water extractable organic C (HWEOC), hot-water extractable total N (HWETN), microbial biomass C and N (MBC and MBN), total inorganic N (TIN) and potentially mineralizable N (PMN) were measured over 53 weeks. MBC and MBN were the only variables affected by herbicide application. Scalping caused an immediate reduction in all variables, and the values remained low without any sign of recovery for the period of the study. The impact of scalping on HWETN and TIN lasted 22 weeks and stabilised afterwards. MBC and MBN were affected by both herbicide and scalping after initial treatment application and remained lower than control during the period of the study but did not decrease over time. While scalping had an inevitable impact on all soil properties that were measured, that impact did not worsen over time, and actually improved plant growth (unpublished data) while reducing site establishment costs. Therefore, it provides a useful alternative for weed control in revegetation projects where it is applied only once at site establishment and where SOM would be expected to recover as canopy closure is obtained and nutrient cycling through litterfall commences.     

炼油废水污泥脱水工艺条件的优化

采用化学除油降黏—污泥调理—离心脱水工艺处理某炼油厂废水处理系统的混合污泥,并对工艺条件进行优化。实验结果表明,最佳的工艺条件为：化学除油降黏阶段处理体系的pH=4,反应温度35 ℃,H₂O₂加入量 2 g/L,m（H₂O₂）∶ m（Fe²⁺）=4,反应时间 60 min;污泥调理反应阶段的CaO加入量7.0 g/L;离心脱水阶段在分离因数为1 558时脱水5 min。在此条件下,得到的泥饼的含水率为70.0%~75.0%（w）,含油率小于2%（w）,污泥比阻约为3.0×10⁷ s²/g。     

用于石油污染土壤降解的高效降解菌的筛选及其降解条件优化

经过富集、分离优选出高效石油降解菌L-1,根据形态观察和生理生化特征初步鉴定为琼氏不动杆菌;采用单因素花盆实验模拟微生物原位修复并对其降解条件进行优化。结果表明,将高效石油降解菌应用于修复石油污染土壤,适宜接种量、表面活性剂浓度、CNP比、翻耕频率分别为15%、0.1%、100∶10∶1和1 d 1次;在该降解条件下修复28 d,可达到16.80%的石油降解率,远远高于土著微生物6.92%的降解率。     

罐底含油泥热解动力学参数计算方法的优选

在化学反应设计中反应动力学是较重要的因素。为得到更合理的污泥热解动力学参数计算方法,利用热重分析仪,在氮气气氛下对罐底含油污泥的热解特性进行研究。根据热重实验数据,分别采用Coats-Redfern法、Kissinger法、FWO法和Popescu法计算污泥热解动力学参数,并获取罐底泥热解制油的主要阶段(第2阶段)的反应活化能E、频率因子A并分析各种方法反应机理。通过对比不同计算方法得到动力学参数及拟合曲线与实验曲线的相关性,确定了最佳罐底含油污泥热解动力学参数计算方法。研究表明,Popescu法得到罐底泥的热解过程符合Jander方程,活化能E为101.43 kJ/mol,与FWO法得到的91.20 kJ/mol相近,且预测曲线与实验曲线有较好的相关性(0.9816),说明Popescu法计算罐底泥热解动力学参数更合适。