椰壳活性炭吸附消除VOCs

对一种椰壳活性炭对甲基丙烯酸甲酯的吸附消除行为进行了研究,重点考察了甲基丙烯酸甲酯的浓度、流速和吸附温度等条件以及水汽存在时对活性炭吸附行为的影响。结果表明,该颗粒活性炭对甲基丙烯酸甲酯有良好的吸附效果,甲基丙烯酸甲酯进口浓度和进气量的改变均会影响吸附饱和时间,导致其增加或减少。通过变温吸附实验确定降低环境温度对其吸附有促进作用。湿度为50%时吸附量相对干气饱和吸附量影响较小,说明该活性炭抗水汽能力较好。经多次重复再生实验,其饱和吸附量未见明显下降。     

印染废水污染物在曝气生物滤池中的沿程去除规律

主要研究了曝气生物滤池（BAF）对印染废水中污染物的沿程去除规律。研究表明：BAF对印染废水污染物的去除沿高程有着不同的变化规律：在BAF总高度为300 cm,填料层高度为200 cm,气水比3∶1,停留时间11.8 h,的情况下, BAF对COD的去除主要集中在<160 cm的填料层部分,在总的去除率为63.1%时,此区域去除率可达56.60%;对NH3N的去除主要集中在填料层100～160 cm段,在总NH₃-N去除率为85.09%时,此区域NH₃-N去除率达38.28%。BAF对浊度的去除主要集中在填料层小于100 cm的部分,在总去除率为94.04%,区域去除率达到61.90%。印染废水经过BAF的前100 cm填料层后,pH值由10降至7.6后基本维持不变。     

滇池湖湾大水域种养水葫芦对水质的影响分析

为了探讨大水域种养水葫芦对滇池湖湾水质的影响,于2010年8—10月对滇池白山湾约70 hm2水葫芦种养区域的水质特征进行动态监测。结果表明,水葫芦区水体中总磷、总氮及高锰酸钾指数从9月中旬后开始逐步上升。水葫芦区水体溶解氧、pH较近水葫芦区和远水葫芦区显著降低,但水葫芦区溶解氧仍维持在较高水平;总磷、总氮及高锰酸钾指数较近水葫芦区和远水葫芦区显著升高;在水葫芦周围水体（近水葫芦区）水质得到明显改善,表现为水体透明度显著高于水葫芦区及远水葫芦区,总磷、正磷酸盐、总氮及叶绿素a明显低于水葫芦区及远水葫芦区。     

WRF-Chem simulation of East Asian air quality: Sensitivity to temporal and vertical emissions distributions

This study develops fine temporal (seasonal, day-of-week, diurnal) and vertical allocations of anthropogenic emissions for the TRACE-P inventory and evaluates their impacts on the East Asian air quality prediction using WRF-Chem simulations in July 2001 at 30-km grid spacing against available surface measurements from EANET and NEMCC. For NO₂ and SO₂, the diurnal and vertical redistributions of emissions play essential roles, while the day-of-week variation is less important. When all incorporated, WRF-Chem best simulates observations of surface NO₂ and SO₂ concentrations, while using the default emissions produces the worst result. The sensitivity is especially large over major cities and industrial areas, where surface NO₂ and SO₂ concentrations are reduced by respectively 3–7 and 6–12 ppbv when using the scaled emissions. The incorporation of all the three redistributions of emissions simulates surface O₃ concentrations higher by 4–8 ppbv at night and 2–4 ppbv in daytime over broad areas of northern, eastern and central China. To this sensitivity, the diurnal redistribution contributes more than the other two.     

Development of a composite line source emission model for traffic interrupted microenvironments and its application in particle number emissions at a bus station

A composite line source emission (CLSE) model was developed to specifically quantify exposure levels and describe the spatial variability of vehicle emissions in traffic interrupted microenvironments. This model took into account the complexity of vehicle movements in the queue, as well as different emission rates relevant to various driving conditions (cruise, decelerate, idle and accelerate), and it utilised multi-representative segments to capture the accurate emission distribution for real vehicle flow. Hence, this model was able to quickly quantify the time spent in each segment within the considered zone, as well as the composition and position of the requisite segments based on the vehicle fleet information, which not only helped to quantify the enhanced emissions at critical locations, but it also helped to define the emission source distribution of the disrupted steady flow for further dispersion modelling. The model then was applied to estimate particle number emissions at a bi-directional bus station used by diesel and compressed natural gas fuelled buses. It was found that the acceleration distance was of critical importance when estimating particle number emission, since the highest emissions occurred in sections where most of the buses were accelerating and no significant increases were observed at locations where they idled. It was also shown that emissions at the front end of the platform were 43 times greater than at the rear of the platform. Although the CLSE model is intended to be applied in traffic management and transport analysis systems for the evaluation of exposure, as well as the simulation of vehicle emissions in traffic interrupted microenvironments, the bus station model can also be used for the input of initial source definitions in future dispersion models.     

异波折板水解酸化-A~2O一体化反应器实验研究

设计了异波折板水解酸化-A2O一体化反应器,进行生活污水处理的实验研究。10个月的实验结果表明,系统的最佳水力停留时间(HRT)为8 h时,最适COD进水浓度为240~600 mg/L,最佳混合液回流比(r)-污泥回流比(R)为250%~100%。控制反应器于以上运行参数下,25±2℃所对应的COD、TN和TP去除率分别为96.84%、67.55%和81.92%。当温度降至7℃时,其COD、TP和TN分别降至86.35%、50.25%和65.68%。基于实验分析结果,阐明了一体化反应器高效性的机理在于异波折板水解酸化段具有高效传质特性和A2O段具有复合式活性污泥-接触氧化好氧池的特点。     

多孔富铁填料曝气过滤除磷机理研究

采用多孔富铁填料的曝气过滤装置具有优良的除磷性能,理论分析研究了多孔富铁填料的除磷机理,通过铁细菌测定、电镜扫描、红外光谱分析等实验对其除磷机理进行了验证。结果表明,多孔富铁填料除磷为化学除磷过程,铁的形态转化中存在铁细菌的氧化作用,沉淀物以碱式磷酸铁为主。     

PEM式臭氧消毒在地上游泳池水处理中的应用

采用臭氧法水处理系统对地上游泳池的循环水进行灭菌消毒,研究了臭氧用量、循环水流量和运行时间等因素对臭氧法灭菌效果的影响。结果表明,3组PEM臭氧发生器应用于21.2 m3的地上游泳池,在4 m3/h的循环水流量下运行12 h后,水中的细菌总数与大肠杆菌群数达到国家标准,去除率均在99%以上。与盐电解法水处理系统相比较,臭氧法水处理系统的优势在于:杀菌快速高效、出水水质的理化指标较好和运行费用低廉。     

超声协同TiO_2光催化降解4,4′-二溴联苯

以纳米TiO2膜为光催化剂,对4,4′-二溴联苯水溶液进行了超声光催化(US+UV)、光催化(UV)和超声(US)降解,探讨了初始浓度、超声的声强和频率等对降解4,4′-二溴联苯的影响。结果表明,4,4′-二溴联苯的超声光催化降解存在协同效应,降解率随4,4′-二溴联苯初始浓度的增大而下降,随声强和频率的增大而增大。超声光催化过程符合一级动力学方程,反应数率常数为0.011 min-1。超声光催化与光催化的降解产物不同。     

微观福利视角下的库区移民搬迁意愿调查

三峡地区社会经济的发展受到资源、环境的限制,又面临再次移民的规划.为有效的缓解由于搬迁中搬迁主体与搬迁规划向左而产生的社会矛盾,优化搬迁政策制度,实现社会的和谐,就应分析库区移民自身的福利状态与搬迁意愿之间的关系.本文在福利理论分析框架下建立理论模型并设计问卷,在多层随机抽样调查的基础上,对理论模型进行验证,运用Logit模型建立三个逐次包含的模型,进行回归分析,试图找到对移民搬迁意愿产生较大影响的福利影响因素,并分析其原因.研究表明,对于库区人口搬迁的自身福利的变化而言,最重要的影响因素为:居住环境、居住方式、教育程度、饮水方式、政策了解程度、环境满意度等;收入、承包地面积、工作等因素也起着一定的影响作用;年龄及基础设施建设中的电话和教育建设对于搬迁意愿的影响则不明显.