Determination of Volatile Organic Compounds in the Atmosphere Using Two Complementary Analysis Techniques

ABSTRACT

During a preliminary field campaign of volatile organic compound (VOC) measurements carried out in an urban area, two complementary analysis techniques were applied to establish the technical and scientific bases for a strategy to monitor and control VOCs and photochemical oxidants in the Autonomous Community of the Basque Country. Integrated sampling was conducted using Tenax sorbent tubes and laboratory analysis by gas chromatography, and grab sampling and in situ analysis also were conducted using a portable gas chromatograph. With the first technique, monocyclic aromatic hydrocarbons appeared as the compounds with the higher mean concentrations. The second technique allowed the systematic analysis of eight chlorinated and aromatic hydrocarbons. Results of comparing both techniques, as well as the additional information obtained with the second technique, are included.     

Electrostatic Precipitation of Ultrafine Particles Enhanced by Simultaneous Diffusional Deposition on Wire Screens

Abstract

A laboratory-scale electrostatic precipitator has been designed and constructed in which the grounded collector plate has been substituted by a set of wire screens placed perpendicularly to the gas flow. Particles are deposited onto the screens by two mechanisms—electrostatic deposition and diffusional deposition—which act simultaneously. On the one hand, electrostatic deposition is effective for relatively large particles, but it is quite ineffective for the smallest ones because their charging probability in the corona field is too low. On the other hand, the diffusional collection efficiency of particles on fibers is high for small particles but low for the larger ones. Therefore, the simultaneous diffusional-electrostatic precipitation may become a useful technique for efficient filtration of particles below 0.1 μm. A preliminary experimental evaluation of this filtering device has shown that submicrometer particles with diameters down to a few nanometers can be collected with number efficiencies greater than 99%.     

Influence of particle location on the number of charges per charged nanoparticle at the outlet of a needle charger

This study has investigated numerically the influence of particle location on the number of charges per charged particle in the 10–40 nm size range at the outlet of a needle charger by simulating flow field, electric field, particle charging, and particle trajectory at various conditions. The results show that the total (i.e., diffusion + field charging) number of charges per particle increase with decreasing ratio values of radial location at the outlet of the charger due to the particle position close to the needle tip. It has also been shown that in the outlet region of the charger there is a critical radial location at which the number of charges per particle is a maximum; this critical radial location represents the point at which the charged particle trajectory becomes closest to the needle electrode. The maximum value of number of charges increases with increasing Reynolds number and slightly increases with decreasing applied voltage for particle diameter larger than 20 nm. The maximum number of charges per charged nanoparticle increases with increasing particle diameter. In addition, the minimum ratio value of radial particle location decreases with increasing Reynolds number for various particle diameters.

Implications: In this work, the influence of particle location on the number of charges per charged nanoparticle at the outlet of a needle charger has been investigated using numerical models under different conditions. The results demonstrate that the radial location affects the number of charges per particle at the outlet of the charger. The maximum number of charges increases with increasing particle diameter, and the minimum ratio value of radial particle location decreases with increasing Reynolds number. The numerical models explain and quantify the number of charges on the charged particle in the 10–40 nm size range from the outlet of the needle charger at various conditions.     

Pesticide residue dynamics in passion fruits: Comparing field trial and modelling results

We evaluated the exposure to pesticides from the consumption of passion fruits and subsequent human health risks by combining several methods: (i) experimental field studies including the determination of pesticide residues in/on passion fruits, (ii) dynamic plant uptake modelling, and (iii) human health risk assessment concepts. Eight commonly used pesticides were applied onto passion fruits cultivated in Colombia. Pesticide concentrations were measured periodically (between application and harvest) in whole fruits and fruit pulp. Measured concentrations were compared with predicted residues calculated with a dynamic and crop-specific pesticide uptake model, namely dynamiCROP. The model accounts for the time between pesticide application and harvest, the time between harvest and consumption, the amount of spray deposition on plant surfaces, uptake processes, dilution due to crop growth, degradation in plant components, and reduction due to food processing (peeling). Measured and modelled residues correspond well (r² = 0.88-0.99), with all predictions falling within the 90% confidence interval of the measured values. A mean error of 43% over all studied pesticides was observed between model estimates and measurements. The fraction of pesticide applied during cultivation that is eventually ingested by humans is on average 10⁻⁴-10⁻⁶, depending on the time period between application and ingestion and the processing step considered. Model calculations and intake fractions via fruit consumption based on experimental data corresponded well for all pesticides with a deviation of less than a factor of 2. Pesticide residues in fruits measured at recommended harvest dates were all below European Maximum Residue Limits (MRLs) and therefore do not indicate any violation of international regulatory thresholds.     

Assessment of exposure to DDT and metabolites after indoor residual spraying through the analysis of thatch material from rural African dwellings

Introduction  

We report on the analysis of 4,4′-dichlorodiphenyltrichloroethane (4,4′-DDT) and its metabolites in thatch and branch samples constituting the wall materials of dwellings from South African subtropical areas. This approach was used to assess the exposure to DDT in the residents of the dwellings after indoor residual spraying (IRS) following recommended sanitation practices against malaria vectors.     

Seasonal variation of pharmaceutically active compounds in surface (Tagus River) and tap water (Central Spain)

Numerous studies have shown the presence of pharmaceutically active compounds (PhACs) in different environmental compartments, for example, in surface water or wastewater ranging from nanograms per litre to micrograms per litre. Likewise, some recent studies have pointed to seasonal variability, thus indicating that PhAcs concentrations in the aquatic environment may depend on the time of year. This work intended to find out (1) whether Tagus fluvial and drinking water were polluted with different groups of PhACs and (2) if their concentrations differed between winter and summer seasons. From the 58 substances analysed, 41 were found belonging to the main therapeutic groups. Statistical differences were seen for antibacterials, antidepressants, anxiolytics, antiepileptics, and cardiovascular drugs, with higher concentrations being detected in winter than in summer. These results might indicate that the PhACs analysed in this study undergo lower environmental degradation in winter than in summer. In order to confirm these initial results, a continuous monitoring should be performed especially on those PhACs that either because of an elevated consumption or an intrinsic chemical persistence are poorly degraded during winter months due to low temperatures and solar irradiation. It is especially important to identify which of these specific PhACs are in order to recommend their substitution by equally effective and safe substances but also environmentally friendly.     

Semi-parametric statistical approaches for space-time process prediction

The problem of estimation and prediction of a spatial-temporal stochastic process, observed at regular times and irregularly in space, is considered. A mixed formulation involving a non- parametric component, accounting for a deterministic trend and the effect of exogenous variables, and a parametric component representing the purely spatio-temporal random variation is proposed. Correspondingly, a two-step procedure, first addressing the estimation of the non- parametric component, and then the estimation of the parametric component is developed from the residual series obtained, with spatial-temporal prediction being performed in terms of suitable spatial interpolation of the temporal variation structure. The proposed model formula-tion, together with the estimation and prediction procedure, are applied using a Gaussian ARMA structure for temporal modelling to space-time forecasting from real data of air pollution concentration levels in the region surrounding a power station in northwest Spain.     

An assessment of heavy metal contamination in surface sediment using statistical analysis

The distribution and accumulation of heavy metals in the sediments, especially those nearest of wastewater discharges of south of Spain, were investigated. Sediment samples from 14 locations were collected and characterised for metal content (e.g. Ni, Cu, Zn, Cr, Pb, Mn, Cd and Hg), organic carbon, total nitrogen, total phosphorous, n-hexane-extractable material, carbonates and grain size. Concentration data were processed using correlation analysis and factor analysis. The correlation analysis of concentrations data showed important positive correlations among organic carbon, total phosphorus, Cu, Zn, Cd and Hg, otherwise weak correlations among Mn, Cr, Ni and CO₃ ^2???, indicating that these metals have complicated geochemical behaviours. The use of statistical factor analysis also confirmed these results. Sediments pollution assessment was carried out using geoaccumulation and metal pollution indexes (MPI₈). The results revealed that sediments of Cádiz bay and Sancti Petri channel were uncontaminated with the studied metals.     

Changes in bird‐migration patterns associated with human‐induced mortality

Many bird populations have recently changed their migratory behavior in response to alterations of the environment. We collected data over 16 years on male Great Bustards (Otis tarda), a species showing a partial migratory pattern (sedentary and migratory birds coexisting in the same breeding groups). We conducted population counts and radio tracked 180 individuals to examine differences in survival rates between migratory and sedentary individuals and evaluate possible effects of these differences on the migratory pattern of the population. Overall, 65% of individuals migrated and 35% did not. The average distance between breeding and postbreeding areas of migrant individuals was 89.9 km, and the longest average movement of sedentary males was 3.8 km. Breeding group and migration distance had no effect on survival. However, mortality of migrants was 2.4 to 3.5 times higher than mortality of sedentary birds. For marked males, collision with power lines was the main cause of death from unnatural causes (37.6% of all deaths), and migratory birds died in collisions with power lines more frequently than sedentary birds (21.3% vs 6.3%). The percentage of sedentary individuals increased from 17% in 1997 to 45% in 2012. These results were consistent with data collected from radio‐tracked individuals: The proportion of migratory individuals decreased from 86% in 1997–1999 to 44% in 2006–2010. The observed decrease in the migratory tendency was not related to climatic changes (temperatures did not change over the study period) or improvements in habitat quality (dry cereal farmland area decreased in the main study area). Our findings suggest that human‐induced mortality during migration may be an important factor shaping the migration patterns of species inhabiting humanized landscapes.     

A MATHEMATICAL MODEL OF SALMONID SPAWNING HABITAT1

ABSTRACT: A simulation model [Salmonid Spawning Analysis Model (SSAM)] was developed as a management tool to evaluate the relative impacts of stream sediment load and water temperature on salmonid egg survival. The model is useful for estimating acceptable sediment loads to spawning habitat that may result from upland development, such as logging and agriculture. Software in common use in the USA were adapted for use in gravel bedded rivers and linked to simulate water temperature (the USFWS Instream Water Temperature, SNTEMP model) and water and sediment routing (the USAE Scour and Deposition in Rivers and Reservoirs, HEC-6 model, version 3.2). These models drive the redd (spawning nest) model (the USDA-ABS Sediment Intrusion Dissolved Oxygen SIDO model) which simulates sediment intrusion and dissolved oxygen concentration in the redd environment. The SSAM model predictions of dissolved oxygen and water temperature compared favorably with field data from artificial redds containing hatchery chinook salmon eggs.