长江源区水文气象要素变化及其与大尺度环流因子关系研究

长江源区水文气象要素变化及其归因研究一直备受全球关注,现阶段研究多侧重于水文气象要素时空变化特征分析,针对长江源区水文气象要素与大尺度环流因子相互关系的研究不足。论文利用Mann-Kendall法、去趋势波动分析法和小波分析法,探究长江源区1957—2012年水文气象要素趋势性、波动性和周期性变化规律,分析水文气象要素与大尺度环流因子的相关关系,通过研究水汽通量揭示大尺度环流因子对水文气象要素变化的驱动机制。结果表明：20世纪90年代,长江源区气候暖干化,进入21世纪后,长江源区气候暖湿化趋势明显;长江源区水文气象要素序列具有正长程相关性,长江源区气候未来会继续呈现暖湿化变化趋势。长江源区水文气象要素都存在着1~5、10~24和25~45 a三种时间尺度周期变化规律。南亚季风是影响长江源区降水量和流量较为重要的大气环流因子,南亚季风驱动下的西南方向气流是长江源区主导气流和水汽来源。     

新型Fe3O4@α-MnO2活化过一硫酸盐降解水中偶氮染料

采用两步水热法制备了新型磁性纳米Fe₃O₄@α-MnO₂复合材料作为催化剂,用于活化过一硫酸盐（PMS）产生强氧化性的硫酸根自由基（SO₄^-·）氧化降解偶氮染料活性黑5（RBK5）.采用透射电子显微镜（TEM）,X射线粉末衍射仪（XRD）和振动样品磁强计（VSM）对制备的催化剂进行表征,证明成功合成了纳米α-MnO₂包覆Fe₃O₄形态的Fe₃O₄@α-MnO₂催化剂,催化剂的饱和磁化强度为39.89emu/g.Fe₃O₄@α-MnO₂催化剂活化PMS与单一的Fe₃O₄和α-MnO₂活化PMS相比,具有更高的催化效率,说明铁锰双金属存在协同作用.同时研究了催化剂的投加量、PMS的浓度和初始pH值等各种因素对RBK5的降解效率以及反应动力学的影响.实验结果表明,Fe₃O₄@α-MnO₂催化剂活化PMS降解RBK5的过程符合准一级反应动力学,在催化剂投加量为1.2g/L,PMS的浓度为4mmol/L,初始pH值为7.0,反应时间为60min的情况下,浓度为30mg/L的RBK5的降解效率可达到91%,此时RBK5的降解速率常数也达到最高值0.023min^-1.此外,通过加入自由基淬灭剂甲醇、叔丁醇和硝基苯判断了Fe₃O₄@α-MnO₂/PMS体系中起主要氧化降解作用的活性物种为SO₄^-·.     

Effect of TiO2 nanoparticle aggregation on marine microalgae Isochrysis galbana

TiO_2 nanoparticles(NPs) could adversely impact aquatic ecosystems. However, the aggregation of these NPs could attenuate this effect. In this work, the biological effects of TiO_2 NPs on a marine microalgae Isochrysis galbana were investigated. The aggregation kinetics of TiO_2 NPs under different conditions was also investigated to determine and understand these effects. Results showed that, though TiO_2 NPs had no obvious impact on the size and reproducibility of algal cells under testing conditions, they caused a negative effect on algal chlorophyll, which led to a reduction in photosynthesis. Furthermore, fast aggregation of TiO_2 NPs occurred under all conditions, especially at the pH close to the p Hzpc. Increasing ionic strength and NP concentration also enhanced the aggregation rate.The aggregation and the following sedimentation of TiO_2 NPs reduced their adverse effects on I. galbana.     

Relationship between physicochemical properties and dewaterability of hydrothermal sludge derived from different source

Sewage sludge (SS) and deinking sludge (DS) were used to comparatively study the hydrothermal dewatering of sludge with different components. For a better overview, an insight into the relationship between physicochemical properties and dewaterability of hydrothermal sludge was provided. Results found that not all kinds of sludge were suitably conditioned by hydrothermal treatment (HT) in term of the elevation of dewaterability. Higher hydrothermal temperature tended to enhance the dewaterability of SS rather than DS, which was supported by the variation of their physicochemical properties (including water distribution, bonding energy, extracellular polymeric substance (EPS), particles size, acid functional groups and zeta potential in this study). In addition, the changes in surface morphology suggested that the reverse effect of HT on sludge dewaterability was mainly due to their dewatering behavior. For SS, the destruction of EPS structure leaded to the release of bound water, thereby strengthening sludge dewatering. Conversely, “Bridging effect” generated by lignocellulose in DS was beneficial for sludge dewatering; however, the increasing hydrothermal temperature degraded part of lignocellulose and weakened “bridging effect”, finally resulting in worse dewaterability of DS.     

Investigating the bacterial community and amoebae population in rural domestic wastewater reclamation for irrigation

Reclamation of domestic wastewater for agricultural irrigation is viewed as a sustainable option to create an alternative water source and address water scarcity. Free-living amoebae(FLA), which are amphizoic protozoa, are widely distributed in various environmental sources. The FLA could cause considerable environmental and health risks. However, little information is available on the risk of these protozoa. In this study, we evaluated the feasibility using rural domestic wastewater for agricultural irrigation, and analyzed dynamic changes of the microbial community structure and FLA populations in raw and treated wastewater, as well as the phyllosphere and rhizosphere of lettuce production sites that were irrigated with different water sources. The bacterial community dynamics were analyzed by terminal restriction fragment length polymorphism(T-RFLP). The bacterial community structures in the influent were similar to that in the effluent, while in some cases relative abundances varied significantly. The populations of Acanthamoeba spp. and Hartmannella vermiformis in the anaerobically treated wastewater were significantly higher than in the raw wastewater. The vegetables could harbor diverse amoebae, and the abundances of Acanthamoeba spp. and H. vermiformis in the rhizosphere were significantly higher than in the phyllosphere. Accordingly, our studies show insight into the distribution and dissemination of amoebae in wastewater treatment and irrigation practices.     

Ecotoxicity evaluation of Cu- and Fe-CNT complexes based on the activity of bacterial bioluminescence and seed germination

The toxic effects of the composites of Fe~0 and Cu~0 with different percentages of CNTs were examined based on the activity of bacterial bioluminescence and seed germination. In terms of the EC_50 values, the toxic effects of Cu~0 on bacterial bioluminescence and seed germination were approximately 2 and 180 times greater than that of Fe~0, respectively. The toxicity increased with increasing CNT content in the Cu-CNT mixtures for both organisms,whereas opposite results were observed with Fe-CNT mixtures. The mean toxic effects of Cu-CNT(6%) were approximately 1.3–1.4 times greater than that of Cu-CNT(0%), whereas the toxic effects of Fe-CNT(6%) were approximately 2.1–2.5 times lower than that of Fe-CNT(0%) for both the bioluminescence activity and seed germination. The causes of this phenomenon are unclear at this point. More research will be needed to elucidate the mechanism of the toxicity of nano-mixture materials and the causes of the different patterns of toxicity with Cu-and Fe-CNT mixtures.     

海水中阴极极化对X80钢应力腐蚀及氢脆敏感性的影响

目的研究不同p H值海水中阴极极化对X80管线钢应力腐蚀及氢脆的抑制作用。方法采用慢应变速率拉伸试验、电化学测试、微观组织观察等分析方法。结果 X80钢在天然海水中的析氢电位约为-940m V(vs.SCE,下同),海水p H为3.5时析氢电位发生正移。其应力腐蚀敏感性与极化电位有很大关系,随着极化电位负移,X80钢的氢脆敏感性增加。天然海水中当极化电位负于-950 m V时,断口出现准解理断裂特征形貌。在-1050 m V极化电位下,钢材进入氢脆断裂区发生脆性断裂。海水p H为3.5时,-900 m V钢材有发生氢脆的危险。结论与天然海水相比,X80钢在p H为3.5的酸性海水中具有较高的应力腐蚀敏感性,两种海水介质中X80钢的应力腐蚀敏感性均随极化电位负移而增加。     

7B04铝合金和30CrMnSiA钢短期腐蚀的电化学行为研究

目的研究7B04铝合金和30CrMnSiA合金钢试样的电化学性能。方法采用电化学实验、扫描电子显微镜(SEM)、腐蚀坑深度测试分别对7B04铝合金和30CrMnSiA合金钢试样在是否经过天然海水浸泡的情况下进行测试分析,得到微观腐蚀形貌和腐蚀坑深度以及试样表面不带锈和带锈时的电化学性能。结果随着Na Cl浓度增大,7B04铝合金和30CrMnSiA钢的自腐蚀电流变大,两者之间存在明显的电位差,接触后会发生电偶腐蚀。电偶电流与阴阳极面积比和Na Cl浓度有关,阴阳极面积比增大或Na Cl浓度升高均会导致电偶效应增强。经过海水短期浸泡后,7B04铝合金表面的锈层不仅没有起到抑制腐蚀的作用,反而使自腐蚀加重,但电偶效应确实有所减弱。结论沿海设备在使用过程中应竭力避免铝合金在锈层下工作。     

舰空导弹杀伤概率随机化检验方法

目的充分有效利用生产方风险,在既定的生产方风险和有限的试验样本条件下,合理分配舰空导弹杀伤概率假设检验中的双方风险。方法通过似然函数推导检验问题的最优势检验,设计一种随机化检验方法,在检验完成后且必要时进行一次Bernoulli试验,以确定是否接受原假设。结果计算结果显示,相对经典假设检验方法,随机化检验方法可以保证实际生产方风险不超过既定的生产方风险上限,同时可使军方风险更小。结论该方法能够合理利用生产方风险,在不增加试验样本的条件下,降低军方风险,具有很好的工程实践意义。     

反舰导弹射击精度评估研究

分析了反舰导弹射击精度评估领域命中概率与圆概率偏差、命中区域圆概率偏差的分歧,提出了制导概率椭圆偏差和制导概率圆偏差的新概念。将反舰导弹飞行末段雷达导引头波束覆盖区域与打击目标水面舰艇轮廓大小进行了比对,根据比对结果划分为雷达导引头波束完全覆盖、部分覆盖和内嵌于目标三个等级,对应提出了命中概率评估方法、制导概率椭圆偏差评估方法和制导概率圆偏差评估方法。通过反舰导弹对快艇、驱护舰和航母三类目标射击精度评估算例验证了反舰导弹射击精度评估总体方案的全面性和三类方法的适用性。