Carbon emission reduction and cost–benefit of methane digester systems on hog farms in China

Three different sizes of hog farms were selected to analyze the carbon emissions reduction and the cost–benefit of three methane digester systems. The sizes of the digesters are 2,200, 2,200 and 800 m³, respectively. The sales of slaughter hogs from them are 50,000, 35,000 and 10,000 head, respectively. The carbon emissions reductions were 5,237, 4,017, and 1,334 tons, respectively. The results show that while the methane digester systems have a significant effect on carbon emissions reduction, it is difficult to operate the systems sustainably. If the carbon emissions reduction can be traded at high enough prices in the carbon offset markets, then the systems will be profitable and sustainable. Newly established China's domestic carbon offset market could provide this possibility, but more government support is needed. In addition, this study shows that scale economies make the digester adoption relatively more profitable for larger farms than smaller ones.     

热解含油污泥制备吸附材料浅析

介绍了含油污泥热解技术及热解实验方法,提出热解产生的残渣进行适当处理可成为具有吸附性的材料。进行了含油污泥热解正交实验,得出影响最大的因素分别是热解温度、热解时间、升温速率,并得出最佳的热解温度、热解时间、升温速率等。分析了含油污泥热解的机理,探讨了热解含油污泥制备吸附材料的活化改性,并在此基础上对所制备吸附材料的脱硫性和除油性进行了研究。     

钙钛矿型催化剂催化湿式氧化处理煤气化废水纳滤浓缩液

采用溶胶-凝胶法制备了Mn掺杂钙钛矿型催化剂LaFexMn1-xO3,并以其为催化剂催化湿式双氧水氧化处理煤气化废水纳滤浓缩液。采用XRD,SEM,FTIR技术对催化剂进行了表征。表征结果显示：制备的催化剂均具有标准的钙钛矿型结构,其中,LaFe0.9Mn0.1O3的结构稳定,比表面积大。实验结果表明：制备的催化剂中LaFe0.9Mn0.1O3的催化活性最高,且稳定性好,连续使用5次后催化活性未见明显减弱;在H2O2投加量3.0 g/L、n（H2O2）∶n（LaFe0.9Mn0.1O3）=12∶1、反应温度160 ℃、反应压力1 MPa、浓缩液pH 3、反应时间60 min的最优条件下,COD、UV254和TOC的去除率分别达到80.9%、95.2%和68.0%,BOD5/COD由0.02提升至0.40,可生化性大幅提高。     

高含盐废水脱盐处理技术研究进展

综述了几种常见的高含盐废水脱盐处理技术的发展历程、工艺原理、优缺点及目前的研究进展,分析了热分离、膜分离、电渗析、离子交换、电吸附、微生物脱盐等方法的优缺点,展望了未来废水脱盐工艺的发展方向。指出：脱盐方法将根据各类水体的水质特点更加精细化;多种脱盐技术联合应用也是今后废水脱盐的发展方向。     

Effects of Compounded Curing Agents on Properties and Performance of Urea Formaldehyde Resin

The effects of three compounded curing agents on the properties and performance of the urea-formaldehyde (UF) resin were investigated in this study. The compounded curing agents were prepared by mixing ammonium chloride with hexamethylenetetramine, citric acid, and oxalic acid respectively at a ratio of 1:1, named N-H, N–CA, and N–OA, respectively. The curing process, crystallinity, and physical properties were measured, and the three-ply plywood was fabricated to measure its prepress strength, wet shear strength, and formaldehyde emission. Results showed that the compounded curing agents N–CA and N–OA enhanced the initial viscosity, crosslinking density and thermal stability of UF resin. Additionally, the prepress strength of the plywood bonded by UF resin with N–CA and N–OA increased by 82 and 111% respectively compared to the UF resin with NH₄Cl, and the wet shear strength increased by 14 and 16%, the formaldehyde emission decreased by 19 and 42% respectively. However, owing to the short pot-life of these curing agent limited their storage time, the curing agents N–CA and N–OA should be applied to fabricate plywood in winter for obtaining a better bond strength and a lower formaldehyde emission. While the UF resin with N–HT showed a suitable pot-life, so it could be applied to fabricate plywood in summer for long time storage and avoiding procuring problem.     

A panel study on the relationship between biofuels production and sustainable development

Biomass is one of the renewable energy sources on which policy makers are greatly dependent on since it is a flexible feedstock capable of conversion into electricity, transport liquid fuels and heat by chemical and biological processes on demand. Though numerous publications have examined the relationship of economic growth with renewable energy and other parameters, biomass energy has never been included in these studies. Then, this study examines the causal relationship within a multivariate panel cointegration/error correction framework which combines the cross-section and time series data while allowing for heterogeneity across different provinces. After employing panel data regression model ranging from 2003 through 2012 to examine the relationships of biofuels production with sustainable development in China, the paper concludes that the development of biofuel energy production integrated with the consideration of the improvement of income per capita, and the attraction of more capital investment, does make a significant contribution to economic growth. However, some negative side effects including the increase of greenhouse emissions and the decrease of marginal land still coexist with the economic development. Of course, the importance of these findings lies on their implications and their adoption on strategic policies.     

Current status and historical variations of phthalate ester (PAE) contamination in the sediments from a large Chinese lake (Lake Chaohu)

The residual levels of phthalate esters (PAEs) in the surface and two core sediments from Lake Chaohu were measured with a gas chromatograph–mass spectrometer (GC–MS). The temporal–spatial distributions, compositions of PAEs, and their effecting factors were investigated. The results indicated that di-n-butyl phthalate (DnBP), diisobutyl phthalate (DIBP), and di(2-ethylhexyl) phthalate (DEHP) were three dominant PAE components in both the surface and core sediments. The residual level of total detected PAEs (∑PAEs) in the surface sediments (2.146?±?2.255 μg/g dw) was lower than that in the western core sediments (10.615?±?9.733 μg/g) and in the eastern core sediments (5.109?±?4.741 μg/g). The average content of ∑PAEs in the surface sediments from the inflow rivers (4.128?±?1.738 μg/g dw) was an order of magnitude higher than those from the lake (0.323?±?0.093 μg/g dw), and there were similar PAE compositions between the lake and inflow rivers. This finding means that there were important effects of PAE input from the inflow rivers on the compositions and distributions of PAEs in the surface sediments. An increasing trend was found for the residual levels of ΣPAEs, DnBP, and DIBP from the bottom to the surface in both the western and eastern core sediments. Increasing PAE usage with the population growth, urbanization, and industrial and agricultural development in Lake Chaohu watershed would result in the increasing production of PAEs and their resulting presence in the sediments. The significant positive relationships were also found between the PAE contents and the percentage of sand particles, as well as TOC contents in the sediment cores.     

Increasing the recovery of heavy metal ions using two microbial fuel cells operating in parallel with no power output

The present study aimed to improve the performance of microbial fuel cells (MFCs) by using an intermittent connection period without power output. Connecting two MFCs in parallel improved the voltage output of both MFCs until the voltage stabilized. Electric energy was accumulated in two MFCs containing heavy metal ions copper, zinc, and cadmium as electron acceptors by connection in parallel for several hours. The system was then switched to discharge mode with single MFCs with a 1000-Ω resistor connected between anode and cathode. This method successfully achieved highly efficient removal of heavy metal ions. Even when the anolyte was run in sequencing batch mode, the insufficient voltage and power needed to recover heavy metals from the cathode of MFCs can be complemented by the developed method. The average removal ratio of heavy metal ions in sequencing batch mode was 67 % after 10 h. When the discharge time was 20 h, the removal ratios of zinc, copper, and cadmium were 91.5, 86.7, and 83.57 %, respectively; the average removal ratio of these ions after 20 h was only 52.1 % for the control group. Therefore, the average removal efficiency of heavy metal ions increased by 1.75 times using the electrons stored from the bacteria under the open-circuit conditions in parallel mode. Electrochemical impedance data showed that the anode had lower solution resistance and polarization resistance in the parallel stage than as a single MFC, and capacitance increased with the length of time in parallel.