Fenton氧化-序批式膜生物反应器耦合处理干法腈纶废水

采用Fenton氧化-序批式膜生物反应器(SBMBR)组合工艺处理干法腈纶废水。结果表明,在废水初始pH值为3.0,H2O2投加量为90.0 mmol/L,Fe2+投加量为20.0 mmol/L,反应时间为2.0 h的条件下,Fenton氧化预处理对腈纶生产废水的COD去除率达到47.0%以上,COD由1 091 mg/L降至560 mg/L,废水的BOD5/COD由0.32升至0.69,废水的可生化性得到显著提高。Fenton处理出水与丙烯腈废水等比例混合后,采用SBMBR进行生化处理,在水力停留时间为24 h,90 min缺氧/150 min好氧交替运行的条件下,COD、NH4+-N和TN的平均去除率分别为71.7%、97.2%和47.4%,碳源不足是限制TN去除效果的主要影响因素。在无外加碳源的条件下,组合工艺处理后出水COD和NH4+-N浓度分别为117 mg/L和1.7 mg/L,出水水质可以稳定达到国家一级排放标准(GB8978-1996)。     

PAFC对水体中持久性有机污染物PFOA的混凝效果

针对含全氟辛酸(PFOA)的工业废水及应对PFOA的污染突发事件,采用PAFC及其复配粘土矿物凹凸棒和沸石进行混凝实验,并对几个影响因素进行了考察。结果表明,在PAFC的最佳投加量10 mg/L时,PFOA和浊度的去除率分别达到70.25%和99.42%,PAFC混凝处理PFOA的效果优于PAC;pH值对PAFC去除PFOA有一定的影响,当pH大于6时有利于PFOA的去除;PFOA和浊度的去除率随原始浊度的增加而增加;活性炭、盐酸改性凹凸棒、盐酸改性沸石、CT-MAB改性的沸石复配PAFC均可提高PFOA的去除率;改性处理后的沸石应用于PFOA的处理中,有望降低处理成本。     

物化-生物组合工艺处理TNT红水

采用酸析+微电解+混凝沉淀+减压蒸馏+固定化微生物滤池+活性焦吸附组合工艺处理兵器八○五厂(襄樊分部)的TNT红水,出水中的硝基化合物浓度多小于0.8 mg/L,且多次未检出;COD最高值为76 mg/L,平均值为51.6 mg/L;色度为20°;苯胺浓度全部小于1 mg/L,达到了中试方案提出的要求,出水水质指标符合《兵器工业水污染物排放标准火炸药》(GB14470.1-2002)的要求.中试期间设备没有发生堵塞、燃烧等事故,减压蒸馏装置正常稳定运行,证实了减压蒸馏法处理TNT红水的安全可靠性.     

铁炭微电解法降解TAIC废水

TAIC（三烯丙基异氰脲酸酯）作为过氧化物交联或自由基反应交联的助交联剂被广泛应用。由于TAIC性质稳定难于生物降解,采用铁炭微电解法处理TAIC生产废水,并考察了铁炭比、进水pH值、反应时间对处理效果的影响,以及TAIC降解机理和反应动力学过程。结果表明,影响微电解工艺的因素主次关系为：pH>Fe/C质量比>反应时间;在最佳条件进水pH值为5,铁炭质量比为2：1,反应时间为135 min时,COD的去除率达到46%以上,TAIC的去除率达到48%以上。TAIC去除机理研究表明,微电解对TAIC废水的作用主要通过·H的还原和铁离子的絮凝作用,其中·H的还原作用是TAIC降解的主要原因。反应动力学分析表明,铁炭微电解法处理TAIC的降解过程基本符合二级反应动力学规律,通过建立模型并拟合出了TAIC降解的二级反应动力学方程。     

A2O工艺中雌激素的行为变化和去除机理

研究了厌氧-缺氧-好氧(A2O)活性污泥工艺对生活污水中天然雌激素雌酮(Estrone,E1)、17β-雌二醇(17β-Estradiol,E2)以及17α-乙炔基雌二醇(17α-Ethynylestradiol,EE2)的去除性能。在对COD、N和P具有良好去除效果的前提下,对E1、E2和EE2的去除率可分别达到92.7%、100%和62.7%。通过对各反应单元内3种雌激素的物料平衡分析,表明A2O工艺对雌激素的去除主要发生在厌氧段和好氧段。以失活污泥作为对照组,好氧硝化过程中雌激素去除的小试实验发现,好氧过程中E1、E2的去除主要依靠生物降解作用,而EE2的去除则主要依赖于活性污泥对其的吸附作用。     

酸析法和碱析法处理草浆造纸黑液的效果对比

对比了酸析法和碱析法对碱法草浆造纸黑液中木质素的去除效果,并分析了聚合氯化铝(PAC)絮凝剂对酸析和碱析后木质素的絮凝效果。实验结果表明:酸析法和碱析法都能有效析出造纸黑液中的木质素,酸析法对色度的去除效果要优于碱析法;当造纸黑液pH为3时,COD去除率达到72.0%,色度去除率为97.7%;当造纸黑液pH为13时,COD去除率达到55.0%,色度去除率为22.3%;PAC对于酸析后木质素有较好的絮凝效果,当废水温度为55℃、PAC加入量为45mL/L时,COD去除率可以达到79.5%,色度去除率为98.5%;PAC絮凝剂对于碱析后的造纸黑液色度的去除效果较差。     

Dechlorination of PCBs in the simulative transformer oil by microwave-hydrothermal reaction with zero-valent iron involved

The conventional hydrothermal reaction with iron powder, NaOH and H₂O as reactants was reported to occur at temperature above 423 K, and iron oxides (Fe₃O₄ and NaFeO₂) and hydrogen were produced. In this study, microwave heating was adopted to take the place of conventional heating to induce the hydrothermal reaction. Under microwave irradiation, NaOH and H₂O absorbed microwave energy by space charge polarization and dipolar polarization and instantly converted it into thermal energy, which initiated the hydrothermal reaction that involved with zero-valent iron. X-ray diffraction (XRD) analysis found Fe₃O₄/NaFeO₂ and confirmed the occurrence of microwave-induced hydrothermal reaction. The developed microwave-hydrothermal reaction was employed for the dechlorination of PCBs. Hexadecane containing 100 mg L⁻¹ of Aroclor1254 was used as simulative transformer oil, and the dechlorination of PCBs was evaluated by GC/ECD, GC/MS and ion chromatography. For PCBs in 10 mL simulative transformer oil, almost complete dechlorination was achieved by 750 W microwave irradiation for 10 min, with 0.3 g iron powder, 0.3 g NaOH and 0.6 mL H₂O added. The effects of important factors including microwave power and the amounts of reactants added, on the dechlorination degree were investigated, moreover, the dechlorination mechanism was suggested. Microwave irradiation combined with the common and cheap materials, iron powder, NaOH and H₂O, might provide a fast and cost-effective method for the treatment of PCBs-containing wastes.     

Spatial distribution of polychlorinated biphenyls (PCBs) and polybrominated biphenyl ethers (PBDEs) in an e-waste dismantling region in Southeast China: Use of apple snail (Ampullariidae) as a bioindicator

Fengjiang is a large e-waste dismantling site located in southeast China. In this paper, apple snail and soil samples were collected from this e-waste dismantling site and 25 vicinal towns to investigate the contamination status, spatial distributions and congener patterns of polychlorinated biphenyls (PCBs) and polybrominated biphenyl ethers (PBDEs). Total PCB concentrations in apple snails (3.78-1812 ng g⁻¹ dry weight (dw)) were significant higher than that in soil samples (0.48-90.1 ng g⁻¹ dw). PBDE (excluding BDE 209) concentrations in apple snail and soil samples ranged from 0.09 to 27.7 ng g⁻¹ dw and 0.06 to 31.2 ng g⁻¹ dw, respectively. Concentrations of PCBs and PBDEs in snails and soils correlated negatively with the distance from Fengjiang. Both the concentrations and profiles of the pollutants were significantly correlated (p < 0.05) between the snail and soil samples, indicating the suitability of apple snail as a reliable bioindicator for PCBs and PBDEs contamination in this region. Relatively high concentrations of PCBs and PBDEs at locations far from e-waste dismantling sites implied that these pollutants have been transported to surrounding regions.     

Levels and distribution of Dechlorane Plus in coastal sediments of the Yellow Sea, North China

Dechlorane Plus (DP) has been determined in surface sediments from three Chinese coastal bays, e.g. Jiaozhou, Sishili and Taozi Bay in North China. DP concentrations ranged from <1.2 to 187 pg g⁻¹ dry weight (dw) (mean: 24.7 pg g⁻¹ dw) in Jiaozhou Bay, <1.2 to 135 pg g⁻¹ dw (mean 69.9 pg g⁻¹ dw) in Sishili Bay and <1.2 to 66.7 pg g⁻¹ dw (mean: 40.4 pg g⁻¹ dw) in Taozi Bay, respectively. Additionally, two dechlorinated species were quantified, which accounted for 0.6-5.1% of the ∑DP concentration.The f_syn values (syn-isomer/(syn- + anti-isomer)) in sediments from Jiaozhou Bay (mean 0.29) were close to the technical DP mixture (0.2-0.4), probably indicating local inputs of DP. In contrast, sediments in Sishili and Taozi Bay showed much lower f_syn values (mean 0.16). During transportation the DP isomers are subject to stereo selective degradation which partly resulted in the relative enrichment of anti-DP in coastal sediments.     

Analysis of pesticide residues using the Quick Easy Cheap Effective Rugged and Safe (QuEChERS) pesticide multiresidue method in traditional Chinese medicine by gas chromatography with electron capture detection

The Quick Easy Cheap Effective Rugged and Safe multiresidue method (QuEChERS) has been validated for the extraction of 15 organochlorine pesticides (OCPs) in completely different matrices of traditional Chinese medicine (TCM). The method employed a rapid, simple and cost-effective procedure. The spiking levels for the recovery experiments were 0.1, 0.5 and 2.0 mg kg⁻¹. Mean recoveries mostly ranged between 76.0% and 114.0% (96.0% on average), and relative standard deviations (RSD) were generally below 10% (4.72% on average). Based on these results, the methodology has been proven to be highly efficient and robust and thus suitable for monitoring the MRL compliance of a wide range of commodity. The contamination status of 15 OCPs on 80 different TCMs marketed in China, and a total of 400 samples were also performed using a previously validated method. 15 OCPs were benzene hexachloride (BHC, including α-BHC, β-BHC, γ-BHC, δ-BHC), hexachlorobenzene, heptachlor, heptachlor epoxide, aldrin, p, p′-DDE, p, p′-DDD, o, p′-DDT, p, p′-DDT, mirex, endrin, dieldrin. This study indicates that the proposed method is useful for analyzing OCPs in TCM.