PVA降解混合菌系生长和产酶的营养条件分析

研究碳源、氮源以及不同金属离子对PVA降解混合菌系生长和产酶的影响。结果表明,混合菌系生长过程中无机氮源优于有机氮源;补充碳源可促进混合菌系的生长,但酶活比不添加时稍有降低。金属离子对酶活影响的正交实验表明Mg2＋浓度影响最大,其次是Fe2＋和K＋浓度,Ca2＋、Mn2＋、Zn2＋和Cu2＋浓度影响较小;最佳浓度分别为Mg2＋0.05 g/L、Fe2＋0.04 g/L、K＋2 g/L和Ca2＋0.05 g/L。     

厌氧膨胀床处理低浓度污水的污泥颗粒和生物活性变化

污泥的聚集形态和活性,是影响厌氧反应器处理效率的关键因素。通过对厌氧膨胀床反应器（anaerobicex—pandedblanketreactor,AEBR）处理低浓度城镇污水在启动和稳定运行期的污泥活性研究,AEBR在启动运行期内,接种颗粒污泥为适应低浓度基质条件,污泥粒径经历从大变小,再重新颗粒化粒径变大的过程。在运行期第103天,粒径小于1000μm污泥的体积比达到44．7％,平均粒径为952μm,到运行期第173天,粒径小于1000μm污泥的体积比降为28％,平均粒径达1179μm,污泥重新颗粒化完成。颗粒污泥适应新的环境后,单位重量污泥的最大比产甲烷活性（specificmetha．nogensisactivity,SMA）值和胞外聚合物含量增加,分别达到112mLCH4／（gVSS·d）和215mg／gVSS。在处理实际城镇污水的AEBR反应器内,辅酶F420含量可以有效指示污泥样品的产甲烷活性,AEBR反应器不同高度位置的污泥活性不一样,反应器底部污泥活性低于中上部区域污泥的活性。     

曝气强度对同时硝化反硝化（SND）脱氮过程中N2O排放的影响

为了控制污水脱氮中N2O排放,在不同曝气强度下研究了好氧硝化段同时硝化反硝化（SND）系统的N2O排放特性,并采用PCR—DGGE技术分析微生物群落特征。结果发现,随着曝气强度的增强,系统总氮去除率下降,但脱氮中N2O—N所占比例则上升,实验中从低到高3个曝气强度下,总氮去除率分别为80．01％、65．28％和58．62％,脱氮中N2O—N所占的比例为1．89％、7．84％和9．20％。PCR—DGGE分析显示,和低曝气强度下相比中、高曝气强度下系统微生物群落发生明显变化,但中曝气强度和高曝气强度下系统微生物群落表现出较高相似性。这表明,不同曝气强度下系统N2O排放受到氮素转化和微生物群落变化的影响。适宜曝气强度不仅提高总氮去除率,还可有效控制N2O排放。     

Comparison of semi-aerobic and anaerobic degradation of refuse with recirculation after leachate treatment by aged refuse bioreactor

Two fresh refuse bioreactors (F1 and F2) were operated under semi-aerobic and anaerobic conditions, respectively. The leachate from the bioreactors F1 and F2 was introduced into the aged refuse bioreactors (A1 and A2), and the effluent from A1 and A2 was subsequently recirculated into F1 and F2, respectively. The effect of the semi-aerobic recirculation process on refuse degradation was investigated, comparing it with that of the anaerobic recirculation process. Results indicate that the semi-aerobic recirculation process can increase the accumulated net production of leachate and promote evaporation. The accumulated net production of refuse in F1 is 320 mL/kg and that of F2 is 248 mL/kg, with leachate reduction amounting to 315 and 244 mL/kg refuse, respectively. The leachate quantity reduction of semi-aerobic and anaerobic leachate recirculation process accounted for 98.4% and 98.3% of the accumulated net production of leachate, respectively. The semi-aerobic leachate recirculation process can improve the biodegradation of organic matter from fresh refuse and the reduction rate of the pollutant concentration in leachate. This should shorten considerably the time required to meet the discharge standard and the time of stabilization of the refuse as observed in the anaerobic recirculation process. It was predicted that the COD concentration of leachate from the anaerobic recirculation process would reach 1000 mg/L in the anaerobic recirculation process after 2.2 years, as for semi-aerobic leachate recirculation process it is about 100 days. Compared with anaerobic recirculation process, the semi-aerobic recirculation process is more effective on NH₃-N transformation and TN removal. The NH₃-N and TN concentration of F1 is far below those of F2 at the end of our experiment. Refuse settlement in the semi-aerobic recirculation process was faster than that in the anaerobic recirculation process. At the end of the experiment, refuse settlement ratios in the semi-aerobic and anaerobic bioreactors were 33.5% and 18%, respectively.     

Utilization of municipal solid waste incineration (MSWI) fly ash in ceramic brick: product characterization and environmental toxicity

In this study, municipal solid waste incineration (MSWI) fly ash was used as a blending in making ceramic brick based on its characterization and an orthogonal test was performed to determine the optimal mixture ratio of the materials. Besides, the fired bricks made in accordance with the optimal mixture ratio were characterized for performance, phase transformation, microstructure, leaching toxicity of the heavy metals in accordance with GB/T 2542-92 (Detection methods for bricks analysis, China) and by means of XRD, SEM and leaching toxicity analysis. It was found that the optimal mixture ratio of materials (MSWI fly ash:red ceramic clay:feldspar:gang sand) was 20:60:10:10 by mass, and the optimal sintering temperature was 950 °C. Leaching results of heavy metals from sintered bricks were reduced considerably in comparison with those from green bricks prior to sintering process. The results as a whole suggested that utilization of MSWI fly ash in ceramic brick constituted a potential means of adding value.     

XAFS study of starch-stabilized magnetite nanoparticles and surface speciation of arsenate

It has been shown that starch can effectively stabilize nanoscale magnetite particles, and starch-stabilized magnetite nanoparticles (SMNP) are promising for in situ remediation of arsenic-contaminated soils. However, a molecular level understanding has been lacking. Here, we carried out XAFS studies to bridge this knowledge gap. Fe K-edge XAFS spectra indicated that the Fe-O and Fe-Fe coordination numbers of SMNP were lower than those for bare magnetite particles, and these coordination numbers decreased with increasing starch concentration. The decrease in the average coordination number at elevated stabilizer concentration was attributed to the increase in the surface-to-volume ratio. Arsenic K-edge XAFS spectra indicated that adsorbed arsenate on SMNP consisted primarily of binuclear bidentate (BB) complexes and monodentate mononuclear (MM) complexes. More BB complexes (energetically more favorable) were observed at higher starch concentrations, indicating that SMNP not only offered greater adsorption surface area, but also stronger adsorption affinity toward arsenate.     

Arsenic release from arsenic-bearing Fe-Mn binary oxide: effects of E(h) condition

Ferric and manganese binary oxide (FMBO) has been successfully used to remediate arsenic-polluted river, but there still lacks sufficient data to evaluate its effects on environments. The release behaviors of iron (Fe), manganese (Mn), and arsenic (As) in different E_h ranges were investigated for As-bearing FMBO sediment after remediating As-polluted DaSha River by FMBO. Under high E_h range (+550 to +400 mV), slight dissolution of Fe and Mn, which corresponded to 12.2% and 25.6%, and less than 5% of As release were observed in 336 h. Under lower E_h range (+50 to −100 mV), elevated extent of the dissolution of Mn and Fe were observed, which corresponded to as high as 61.3% and 70.1%. Under such conditions, the dissolution rate of Mn was higher than that of Fe. Furthermore, from the established relationship of As release and the dissolution of Fe and Mn, the release of As seemed dominated by the dissolution of Fe. X-ray photoelectron spectroscopy (XPS) analysis demonstrated the release of Fe, Mn, As(III), and As(V) after sodium ascorbate-treatment, and the re-adsorption of As(V), as indicated from the increased binding energy of As 3d from 44.78 to 45.83 eV. Surface element composition analysis indicated significant decrease of Mn from 3.22% to 0.54%, slight increase of Fe from 12.45% to 13.67%, and elevated ratio of As from 0.11% to 0.32% accordingly. The main reactions of Fe and Mn dissolution and the pathways of As release under different E_h ranges were also proposed.     

Polybrominated diphenyl ethers (PBDEs) and indicator polychlorinated biphenyls (PCBs) in marine fish from four areas of China

The levels of polybrominated diphenyl ethers (PBDEs) and indicator polychlorinated biphenyls (PCBs) were determined in marine fish from four areas of China (South China Sea, Bohai Sea, East China Sea, and Yellow Sea) using GC/NCI-MS and GC/ITMS, respectively. Total concentrations of eight PBDEs (BDE-28, 47, 99, 100, 153, 154, 183 and 209) in all samples ranged from 0.3 ng g⁻¹ ww (wet weight) to 700 ng g⁻¹ ww, with median and mean values of 85 ng g⁻¹ ww and 200 ng g⁻¹ ww, respectively. BDE-209 and BDE-47 were the major congeners in all samples, contributing 54% and 19% to the total concentration, respectively. The sum of seven indicator PCB levels (CB-28, 52, 101, 118, 138, 153, and 180) ranged from 0.3 ng g⁻¹ ww to 3.1 μg g⁻¹ ww, with median and mean values of 6.4 ng g⁻¹ ww and 398 ng g⁻¹ ww, respectively. High contributions of CB-138 (32%) and CB-153 (25%) were found in all samples. In general, pollutants measured in this study were at high levels when compared with previous studies from other regions in the world. The relative abundance of BDE-209 may suggest that deca-BDE sources existed in studied area. And principal component analysis (PCA) showed that there were other PBDE sources in Yellow Sea. The pattern and PCA showed that PCB pollutions came from similar sources in the studied areas. In addition, concentrations of ∑₇PBDEs (u/209) were strongly correlated with those of ∑₇PCBs in all fish (r = 0.907, n = 44).     

杂多酸水溶液脱除烟气中SO2的性能研究

合成了H3PMo12O40、H4SiW12O40、H3PW12O40、H4PMo11VO40、H5PMo10V2O40和H6PMo9V3O406种杂多酸,分别采用红外光谱（FT-IR）和X射线衍射（XRD）表征杂多酸的结构,并采用气相色谱仪对6种杂多酸水溶液进行脱硫实验测试。实验结果表明：制备的6种杂多酸具有良好的Keggin型结构;H3PMo12O40、H3PW12O40和H4SiW12O40的3种水溶液中,磷钼杂多酸的脱硫性能最好,脱硫率在120 min时可达到16.38%;不同比例的多原子也会使杂多酸有不同的脱硫性能,脱硫性能顺序为：H6PMo9V3O40〉H5PMo10V2O40〉H4PMo11VO40;且6种杂多酸的脱硫稳定性的顺序为：H4PMo11VO40〉H6PMo9V3O40〉H3PMo12O40〉H5PMo10V2O40〉H4SiW12O40≈H3PW12O40。     

废水反硝化除磷技术研究进展

结合近年来国内外最新研究成果,综述了反硝化除磷机理及工艺.重点介绍了反硝化聚磷菌的微生物学特性和除磷特性,以及不同种类的反硝化除磷工艺,并对反硝化除磷技术进行了展望.