全文获取类型
收费全文 | 2221篇 |
免费 | 150篇 |
国内免费 | 739篇 |
专业分类
安全科学 | 183篇 |
废物处理 | 142篇 |
环保管理 | 167篇 |
综合类 | 1247篇 |
基础理论 | 359篇 |
污染及防治 | 747篇 |
评价与监测 | 97篇 |
社会与环境 | 96篇 |
灾害及防治 | 72篇 |
出版年
2024年 | 4篇 |
2023年 | 52篇 |
2022年 | 137篇 |
2021年 | 134篇 |
2020年 | 81篇 |
2019年 | 83篇 |
2018年 | 101篇 |
2017年 | 111篇 |
2016年 | 105篇 |
2015年 | 121篇 |
2014年 | 183篇 |
2013年 | 207篇 |
2012年 | 164篇 |
2011年 | 193篇 |
2010年 | 146篇 |
2009年 | 166篇 |
2008年 | 138篇 |
2007年 | 131篇 |
2006年 | 100篇 |
2005年 | 88篇 |
2004年 | 76篇 |
2003年 | 74篇 |
2002年 | 54篇 |
2001年 | 64篇 |
2000年 | 65篇 |
1999年 | 50篇 |
1998年 | 38篇 |
1997年 | 31篇 |
1996年 | 33篇 |
1995年 | 28篇 |
1994年 | 24篇 |
1993年 | 23篇 |
1992年 | 17篇 |
1991年 | 21篇 |
1990年 | 19篇 |
1989年 | 9篇 |
1988年 | 12篇 |
1987年 | 4篇 |
1986年 | 4篇 |
1985年 | 3篇 |
1983年 | 2篇 |
1982年 | 2篇 |
1981年 | 2篇 |
1980年 | 1篇 |
1979年 | 1篇 |
1978年 | 3篇 |
1975年 | 1篇 |
1972年 | 1篇 |
1970年 | 1篇 |
1968年 | 1篇 |
排序方式: 共有3110条查询结果,搜索用时 156 毫秒
121.
122.
利用透射电子显微镜观察分析白腐真菌(黄孢原毛平革菌)在处理染料废水活性艳红X-3B过程中,染料和盐度对黄孢原毛平革菌的细胞结构产生的毒性作用.结果表明:活性艳红X-3B染料对黄孢原毛平革菌产生生物毒性作用,且随着染料浓度的增加,细胞受损伤程度不断加深.加入100 mg/L的染料活性艳红X-3B后,黄孢原毛平革菌菌丝细胞形态发生变化,出现质壁分离现象;染料浓度进一步加大,菌丝细胞超微结构受到损伤逐渐严重.染料废水中的盐度对黄孢原毛平革菌细胞也会造成损伤,且损伤程度随盐度增大而增大.NaCl浓度为3 g/L时,菌丝细胞发生质壁分离;而当NaCl加入量高于8 g/L时,细胞膜受损,线粒体、细胞核呈现空泡化,表现为受到不可逆的损伤.染料和盐双因子对黄孢原毛平革菌细胞的损伤效应表现为其损伤程度与单因子作用一致,且染料的影响作用占主导. 相似文献
123.
Fenton法氧化处理水中土霉素的研究 总被引:2,自引:0,他引:2
为了评价Fenton法预处理抗生素生产废水中残留的高浓度土霉素的可行性,对Fenton试剂(Fe2 -H2O2)法催化氧化降解水溶液中的土霉素进行了研究.探讨了H2O2与Fe2 投加比例、投加量以及起始pH值对降解效果的影响,同时考察了土霉素废水中大量共存的草酸根离子对氧化过程的影响.结果表明,当H2O2与Fe2 按照5:1的比例投加时降解效率最高,最佳初始pH值在3.0-4.0之间.在最佳投加比例下,H2O2投加量为0.9 mmol/L,100 mg/L的土霉素可在10 min内得到完全降解.最佳反应条件下经过处理后土霉素水溶液TOC的去除率达40%左右,可生化性(BOD5/COD)也得到明显的改善.水中共存的草酸根离子对氧化效率具有明显的影响,但通过增加亚铁离子的量可以消除草酸的影响. 相似文献
124.
Pb/Zn冶炼废渣中重金属的生物浸出-盐浸处理 总被引:3,自引:0,他引:3
利用中温嗜热菌对某铅锌冶炼废渣进行生物浸出盐浸处理研究,并根据国家固体废物浸出毒性方法(HJ/T299-2007)对盐浸后余渣进行毒性分析。研究结果表明,在pH 1.5、温度65℃、矿浆浓度5%的优化条件下生物浸出3 d后,废渣中Cu、In、Ga和Zn的浸出率分别达到了91.5%、91.8%、84.9%和93.4%;盐浸生物浸出渣,其浸出液中Ag、Pb浓度分别为7.6和247.5 mg/L,可从废渣中有效回收Cu、In、Ga、Zn、Ag和Pb。生物浸出盐浸处理后余渣约为原渣量的70%;毒性分析浸出液中重金属元素Ag、As、Cd、Cu、Pb和Zn浓度分别为2~3.5、2~3、0.3~0.5、30~50、2~4、20~60 mg/L,低于国家危险废物鉴别标准(GB5085.3-2007)。根据试验结果,提出了针对冶炼废渣资源化、减量化、无害化的生物浸出盐浸联用工艺。 相似文献
125.
126.
水动力条件下蓝藻水华生消的模拟实验研究与探讨 总被引:2,自引:0,他引:2
蓝藻水华是当今世界共同面临的重大水污染问题之一。通过室内模拟实验,在温度、光照、初始pH值和营养盐等基本条件相同的前提下模拟水流流速分别为10cm/s、20cm/s、30cm/s、40cm/s时铜绿微囊藻(Microcystis aeruginosa)水华的产生与消亡过程,在10~40cm/s流速区间里藻类生长周期随流速增大而变长,藻类最大现存量在40cm/s流速下最大,在10cm/s流速下最小,流速为30cm/s时藻类比增率最大,较适合藻类生存,在整个水华暴发过程中水体氮磷营养浓度呈下降趋势,水体的pH、DO和Ec变化不大。 相似文献
127.
128.
Non-aromatic hydrocarbons in surface sediments near the Pearl River estuary in the South China Sea 总被引:1,自引:0,他引:1
Surface sediment samples at 4 sites along an offshore transect from outer continental shelf off the Pearl River estuary to the shelf slope region of the northern South China Sea, have been analyzed for total organic carbon (TOC), total nitrogen (TN), solvent extractable organic matter (EOM) and non-aromatic hydrocarbons. TOC, TN and EOM show distinct spatial variations. Their highest values are all recorded at the shelf slope region. EOM varies from 18.70-38.58 microgg(-1) dry sediment and accounts for 0.20-0.72% of the TOC contents. The non-aromatic hydrocarbons are an important fraction of EOM. Their contents range from 3.43-7.06 microgg(-1) dry sediment. n-Alkanes with carbon number ranging from 15-38 are identified. They derive from both biogenic and petrogenic sources in different proportions. Results of isoprenoid hydrocarbons, hopanes and steranes also suggest possible petroleum contamination. 相似文献
129.
130.
The degradation of polyacrylamide (PAM) in simulate wastewater was studied in UV/Fenton/C4H4O62? system. The factors such as molecular ratio of H2O2/Fe2+/C4H4O62?, pH, and the dosage of Fenton reagent that could affect the PAM degradation in the UV/Fenton/C4H4O62? system were investigated. The experimental results showed that adding C4H4O62? to UV/Fenton system could form photosensitive ferrous complexes, which led to higher degradation efficiency of PAM. The degradation rate of PAM could be up to 95.2% under the following conditions: the concentration of H2O2, Fe2+, and C4H4O62? were 22.5, 2.25, and 2.25 mmol/L, respectively (i.e., molecular ratio of H2O2/Fe2+/C4H4O62? was 10:1:1), the pH value was 3.0. 相似文献