高效厌氧产甲烷颗粒污泥中微生物多样性及定量化研究

以小试高效厌氧反应器不同运行阶段的颗粒污泥为对象,利用变性梯度凝胶电泳(DGGE)、荧光原位杂交(FISH)和实时定量链式聚合酶反应(RTQ-PCR)等技术研究了其中微生物种群的多样性、特征微生物的空间分布和定量关系,结果表明:随着反应器有机负荷逐渐提高,颗粒污泥中古菌的群落结构的变化较细菌更为明显;细菌多分布在颗粒外层,而古菌则主要分布在颗粒内层;古菌含量略少于细菌,但有逐渐增多的趋势;产甲烷丝菌在古菌中的含量增加明显.     

Analysis of chemical compositions contributable to chemical oxygen demand (COD) of oilfield produced water

This work was to give a comprehensive estimation for the chemical compositions contributable to COD of the produced water treatment system. For this purpose, the wastewater samples were collected from an onshore wastewater treatment plant. The chemical compositions of the wastewater were investigated, and the COD contributed by each component was estimated. The results showed that the COD levels of O&G and SS presented decreasing trends during the whole process and achieved total removal percentages of 95.1% and 62.3%, respectively. The final COD of organic acids and low-molecular-weight carbonyl compounds were respectively lowered to nearly 64% and 35% of their initial levels, and no regular trends were found for the COD of these chemicals during the whole treatment process. The COD of inorganic components presented minor variations at all sampling spots. The majority of COD was originated from O&G in raw wastewater. The COD contributed by O&G decreased greatly with continuous treatment and finally was lower than 17% of measured COD. At each sampling spot, the ratios of COD contributed by SS did not exceed 7.6% of measured COD. Other measured chemicals, including organic acids, carbonyl compounds, volatile phenols, reductive anions, metals and TDP were not the main sources of COD during the whole treatment process, and the ratio of COD was below 9% at each sampling spot. Most of the soluble components contributable to residual COD were still unknown after biological treatment, and the COD contributed by these components was greater than 57% of measured COD.     

Prediction for energy content of Taiwan municipal solid waste using multilayer perceptron neural networks

In the past decade, the treatment amount of municipal solid waste (MSW) by incineration has increased significantly in Taiwan. By year 2008, approximately 70% of the total MSW generated will be incinerated. The energy content (usually expressed by lower heating value [LHV]) of MSW is an important parameter for the selection of incinerator capacity. In this work, wastes from 55 sampling sites, including villages, towns, cities, and remote islands in the Taiwan area, were sampled and analyzed once a season from April 2002 to March 2003 to determine the waste characteristics. The LHV of MSW in Taiwan was predicted by the multilayer perceptron (MLP) neural networks model using the input parameters of elemental analysis and dry- or wet-base physical compositions. Although all three of the models predicted LHV values rather accurately, the elemental analysis model provided the most accurate prediction of LHV values. Additionally, the wet-base physical composition model was the easiest and most economical. Therefore, the waste treatment operators can choose the more appropriate analysis method considering situations themselves, such as time, equipment, technology, and cost.     

Pyrolysis behavior of tire-derived fuels at different temperatures and heating rates

Pyrolytic product distribution rates and pyrolysis behavior of tire-derived fuels (TDF) were investigated using thermogravimetric analyzer (TGA) techniques. A TGA was designed and built to investigate the behavior and products of pyrolysis of typical TDF specimens. The fundamental knowledge of TGA analysis and principal fuel analysis are applied in this study. Thermogravimetry of the degradation temperature of the TDF confirms the overall decomposition rate of the volatile products during the depolymerization reaction. The principal fuel analysis (proximate and ultimate analysis) of the pyrolytic char products show the correlation of volatilization into the gas and liquid phases and the existence of fixed carbon and other compounds that remain as a solid char. The kinetic parameters were calculated using least square with minimizing sum of error square technique. The results show that the average kinetic parameters of TDF are the activation energy, E = 1322 +/- 244 kJ/mol, a pre-exponential constant of A = 2.06 +/- 3.47 x 10(10) min(-1), and a reaction order n = 1.62 +/- 0.31. The model-predicted rate equations agree with the experimental data. The overall TDF weight conversion represents the carbon weight conversion in the sample.     

仓库计算机网络系统的防雷管理

通过雷电危害及侵入途径的分析,根据仓库建设网络建设实际,探讨了仓库计算机网络雷电防护措施。     

Quantitative indicator of homeostatic risk perception in car following

Driving behavior is largely affected by the risk perception of drivers. On the basis of risk homeostasis theory, we regard that drivers may adjust car movement according to the perceived risks fluctuating around a target level. However, the manner by which risk perception is quantified remains unclear. We propose assumptions on the quantitative indicators of risk perception and identify a suitable quantitative indicator of risk perception in car-following process. Three risk indicators are discussed, i.e. time-to-collision (TTC), time headway (TH), and safety margin (SM). Using homeostatic features as bases, we found that SM more suitably quantifies homeostatic risk perception than TTC or TH does. Data collected from video drive recorders installed in taxis operating in Beijing are used to analyze the target risk level of SM (desired SM, or DSM) of professional drivers during the car-following process. The data collected by Ahn et al. (2004) to verify Newell’s model are converted into DSM data to further analyze the target risk level of general drivers. The DSM histogram of professional drivers shows that the standard deviation of the DSM value is 0.115, with a mean value of 0.862 and a total distribution close to the normal distribution. For a general driver, the mean value of DSM is 0.896, which is higher than that of professional drivers. This research may shed lights on the understanding of driving behavior.     

一种验证可变速电梯变速功能安全性的检验方法

在分析可变速电梯原理的基础上,研究了可变速电梯变速功能安全性对其正常运行产生的影响,提出了验证可变速电梯变速功能安全性的检验内容与检验方法。试验采用了普通累积法作为测量数据的处理方法,完成了对称重系统的误差评定。试验证明,该检验方法可以有效地反映可变速电梯变速功能的安全状态。     

阻挡放电联合金属氧化物催化降解H2S的研究

采用介质阻挡放电联合金属氧化物催化降解气态H2S,考察了单组分及复合金属氧化物催化剂、催化剂与低温等离子体结合方式对H2S及副产物O3去除性能的影响,分析了等离子体联合Mn复合金属氧化物催化降解H2S机理。结果表明,金属负载量相同条件下,电压低于22kV时,Mn复合金属氧化物对H2S的催化活性高于单组分Mn金属氧化物,催化活性及对O3的分解能力从大到小依次为:Ag+Mn、Cu+Mn、Fe+Mn、Mn。当电压为18 kV时,Ag+Mn、Cu+Mn、Fe+Mn复合催化剂分别比单组分Mn催化剂对H2S的去除效率提高了近10%、6%、4%。等离子体后催化区域中Mn催化剂催化氧化H2S的效率明显低于等离子体催化区域。Mn催化剂在等离子体后催化区域中能有效催化分解O3。随着电压的升高,Mn金属氧化物在等离子体后催化区域对H2S催化作用逐渐增强。在电压22 kV时,等离子体联合后催化比单独等离子体作用时,H2S去除效率提高了近11%。     

基于Matlab的火灾探测报警系统可靠度Monte Carlo仿真

介绍了火灾探测报警系统的结构,指出了火灾探测报警系统失效原因,针对火灾探测报警系统的特点,确定了蒙特卡洛可靠度分析法.给出了系统的概率模型,确定了在Matlab下应用Monte Carlo方法对火灾探测报警系统的可靠度进行仿真的具体步骤,得到火灾探测报警系统可靠度仿真曲线.将仿真结果与试验结果相比较,基本一致,验证了该仿真方法能正确描述火灾探测报警系统的可靠度随使用寿命的变化规律,为进一步应用该方法来分析火灾探测报警系统的的各可靠性指标提供了理论基础.     

橡胶黏土混合土动剪切模量及阻尼比试验研究

为了研究橡胶黏土混合土动力特性,将橡胶掺入黏土,在4种围压下对5种不同配比橡胶黏土混合土进行室内动三轴试验以研究橡胶含量及围压对混合土动剪切模量和阻尼比的影响。结果表明,相同围压下,混合土动剪切模量较素土有很大降低,随着橡胶含量的增多而逐渐降低且降低速度由快变慢,动剪切模量与动应变关系曲线非线性特征减弱。阻尼比随着橡胶含量增加逐渐增加,且均较素土有显著提高。相同橡胶含量时,动剪切模量随着围压增大而增大,动剪切模量与动应变关系曲线线性特征增强,阻尼比随围压增大而减小。橡胶黏土动剪切模量与动应变关系可以用H-D模型表示,最大动剪切模量与围压之间的关系可以用线性函数表示,阻尼比与动应变关系可以用修正的陈国兴模型表示。结果证明,橡胶黏土混合土具备较好的隔震减震性能。