淀粉-g-丙烯酸/凹凸棒土复合物制备及其吸附废水中NH_4~＋-N性能

采用反相乳液聚合法以凹凸棒土为原料,合成了新型NH4＋-N吸附剂淀粉-g-丙烯酸/凹凸棒土,并进行了氨氮吸附对比实验。结果表明：凹凸棒土氨氮单位吸附量为4.243 mg/g;淀粉-g-丙烯酸/凹凸棒土氨氮单位吸附量为5.301 mg/g,吸附能力比未改性的凹凸棒土提高了25%。淀粉-g-丙烯酸/凹凸棒土的氨氮吸附过程比凹凸棒土更符合Freundlich等温吸附模型。随着pH、温度的升高,凹凸棒土和淀粉-g-丙烯酸/凹凸棒土对NH4＋-N吸附量逐渐增大。     

生物预处理/常规与常规工艺处理西江原水的对比

采用生物预处理／常规与常规工艺处理西江微污染原水,对主要污染物的去除效果工艺进行了比较。结果表明,生物预处理／常规工艺对COD_Mn、氨氮的平均去除率达48.9%、62.3%,比常规工艺提高了18.9%、28.4%。2种工艺对浊度的去除率相当,皆为95％左右。生物预处理采用高速给水曝气生物滤池工艺,反冲洗采用气水联合方式,48 h过滤水头损失＜2 kPa,冲洗前后过滤水头损失变化量均值＜0.4 kPa。     

给水曝气生物滤池内置粉末活性炭复合净水效果的研究

在给水曝气生物滤池内置粉末活性炭,对比分析其对各工艺单元水质净化效果的影响,确定给水曝气生物滤池内置粉末活性炭的作用与最佳投加量,研究表明,给水曝气生物滤池将活性炭截留在滤池内,大幅度提高了粉末活性炭利用率,部分未饱和粉末活性炭通过反冲洗排入后续常规处理系统,作为生物载体仍能够进一步发挥生物强化作用。当粉末活性炭的投加量为8 mg/L时,砂滤出水氨氮、CODMn、浊度和色度均值分别为：0.02 mg/L,1.82 mg/L0,.46 NTU和6度,去除率分别达到99.6%、71.2%、99.1%和80.6%,出水指标达到《生活饮用水卫生标准（》GB5749-2006）和《饮用净水水质标准（》CJ94-2005）规定的标准。与常规工艺相比,投加量降低了20%～60%。     

不同营养水平下悬浮细菌数量对生物粘泥性质的影响

循环水系统中的微生物有悬浮态和附着态,悬浮细菌的存在对附着态生物粘泥的生长及特性有明显影响。通过向模拟循环冷却水系统中投加不同数量初始悬浮细菌,考察在营养水平不同的情况下,悬浮细菌数量对生物粘泥化学组成和脱氢酶活性的影响。结果表明,营养水平不同,初始悬浮细菌数量对生物粘泥的化学组成和脱氢酶活性的影响程度不同;在不同营养水平下,应分别控制初始悬浮细菌数量。贫营养下,初始悬浮细菌数量应控制在6×105个/mL左右;中营养下,初始悬浮细菌数量应控制在1×105～2.6×105个/mL之间;富营养下,初始悬浮细菌数量应控制在0.11×105～2.6×105个/mL之间最不利于生物粘泥的生长。     

垂直流人工湿地水力学特性研究

通过示踪剂实验从停留时间分布（RTD）曲线及其统计特征值等方面对垂直流人工湿地的水力学特性进行了定性和定量的分析。研究表明水流在垂直流人工湿地中的流动是一种非理想的不均匀流动,存在一定的死区和水流的扩散;垂直流人工湿地较大的死区率与其表面布水的不均匀性有关,这也可能是其死区率大于表流人工湿地的最主要的原因。实验还表明,进水流量对垂直流人工湿地停留时间分布影响较大,随着进水流量的增加,平均停留时间减小,但标准平均停留时间增大,死区率减小;当进水流量为15L／h（水力负荷为620mm／d）时,水流在湿地中的散度最大,水流更接近全混流,不利于污染物的降解。     

膜生物反应器(MBR)-反渗透(RO)工艺深度处理印染废水的实验研究

采用膜生物反应器（MBR）-反渗透（RO）工艺对印染废水进行了深度处理实验。原水经MBR系统处理后,COD去除率、ss去除率和色度去除率分别达89．9％、100％和87．5％。MBR系统处理出水进入反渗透（RO）系统进行处理,硬度去除率和除盐率分别达99．62％和99．64％,同时可进一步除去剩余的COD、色度。系统出水水质满足生产回用的要求。     

Composition analysis and application of degradation products of whole feathers through a large scale of fermentation

Purpose

Feathers are one of the most abundant bioresources. They are discarded as waste in most cases and could cause environmental pollution. On the other hand, keratin constituted by amino acids is the main component of feathers. In this article, we reported on biorefined feathers and integrants and application of degraded products.

Materials and methods

The fermentation of whole chicken feathers with Stenotrophomonas maltophilia DHHJ in a scale-up of a 5-L bioreactor was investigated in this article. The fermentation process was controlled at 0.08 MPa pressure, 2.5 L/min airflow, and 300 rpm as 100% oxygen saturation level, 40°C, and pH 7.8.

Results

Feathers were almost completely degraded in the tested fermentation reaction with the following conditions: 80 g of whole feathers in 3 L fermentation broth for 72 h, seed age of 16 h, 100 mL inoculation amount, and 50% oxygen saturation level. The degraded products contain 397.1 mg/L soluble protein that has mass weight ranging from 10 to 160 kD, 336.9 mg/L amino acids, and many kinds of metal ions. The fermentation broth was evaluated as leaf fertilizer and found to increase plant growth to 82% or 66% for two- or fourfold dilutions, respectively. In addition, in a hair care assay, the broth showed a hair protective function by increasing weight, flexibility, and strength of the treated hair.

Conclusions

The whole feathers were degraded completely by S. maltophilia DHHJ. The degraded product includes many factors to life, such as peptides, amino acids, and mineral elements. It could be applied as leaf fertilizer and hair care product.     

Combined inverse modeling approach and load duration curve method for variable nitrogen total maximum daily load development in an agricultural watershed

Purpose  

Nonpoint sources (NPS) pollution has been an important cause for water quality impairment worldwide. To take the temporal variations of both NPS pollution and in-stream attenuation into consideration, an inverse modeling approach and the load duration curve (LDC) method were combined for variable nutrient total maximum daily load (TMDL) development.     

Uptake and distribution of metals by water lettuce (<Emphasis Type="Italic">Pistia stratiotes</Emphasis> L.)

Background, aim and scope  

Water quality impairment by heavy metal contamination is on the rise worldwide. Phytoremediation technology has been increasingly applied to remediate wastewater and stormwater polluted by heavy metals.     

甲基氯硅烷生产废液制备氯化氢和有机硅树脂

研究了将高、低沸点甲基氯硅烷生产废液分别通过醇解和水解反应制备HCl和有机硅树脂的工艺方法,考察了醇解时间、醇解温度和m(废液)∶m(甲醇)等因素对产物收率的影响.实验得到最佳反应条件为:m(废液)∶m(甲醇)=1∶0.5,醇解温度65℃,醇解时间2h.在该条件下由高、低沸点废液制得的有机硅树脂收率分别为43.2％和40.6％.将制得的有机硅树脂经500℃干燥处理后,可作为填料,制备有机硅树脂-聚氯乙烯复合材料.该材料的力学性能与SiO2 -聚氯乙烯复合材料接近.