A Thermodynamic Geography: Night-Time Satellite Imagery as a Proxy Measure of Emergy

Night-time satellite imagery enables the measurement, visualization, and mapping of energy consumption in an area. In this paper, an index of the “sum of lights” as observed by night-time satellite imagery within national boundaries is compared with the emergy of the nations. Emergy is a measure of the solar energy equivalent used, directly or indirectly, to support the processes that characterize the economic activity in a country. Emergy has renewable and non-renewable components. Our results show that the non-renewable component of national emergy use is positively correlated with night-time satellite imagery. This relationship can be used to produce emergy density maps which enable the incorporation of spatially explicit representations of emergy in geographic information systems. The region of Abruzzo (Italy) is used to demonstrate this relationship as a spatially disaggregate case.     

Socioeconomic development and vulnerability to land degradation in Italy

In recent years, the surface area affected by land degradation (LD) has significantly increased in southern European regions where the socioeconomic development has been proposed as a basic factor underlying the degree of vulnerability to LD. This paper investigates the correlation between several socioeconomic indicators and the level of vulnerability to LD in Italy, expressed as changes (1990–2000) in a composite index of land vulnerability (ΔLVI). The analysis was carried out over 784 local districts. The impact of per capita value added, agricultural intensity, industrial and tourism concentration, and urban growth was separately tested on ΔLVI. Results indicate that a lower district value added, crop intensification, irrigation, and the level of land vulnerability to degradation are strongly associated with the increasing level of land vulnerability over time, highlighting the role of the socioeconomic development as a main process underlying LD. In this framework, spatially equitable sustainable development may represent the effective strategy to mitigate the detrimental effects of economic growth and regional disparities on Mediterranean LD.     

Optimal deployment of emissions reduction technologies for construction equipment

The objective of this research was to develop a multiobjective optimization model to deploy emissions reduction technologies for nonroad construction equipment to reduce emissions in a cost-effective and optimal manner. Given a fleet of construction equipment emitting different pollutants in the nonattainment (NA) and near -nonattainment (NNA) counties of a state and a set of emissions reduction technologies available for installation on equipment to control pollution/emissions, the model assists in determining the mix of technologies to be deployed so that maximum emissions reduction and fuel savings are achieved within a given budget. Three technologies considered for emissions reduction were designated as X, Y, and Z to keep the model formulation general so that it can be applied for any other set of technologies. Two alternative methods of deploying these technologies on a fleet of equipment were investigated with the methods differing in the technology deployment preference in the NA and NNA counties. The model having a weighted objective function containing emissions reduction benefits and fuel-saving benefits was programmed with C++ and ILOG-CPLEX. For demonstration purposes, the model was applied for a selected construction equipment fleet owned by the Texas Department of Transportation, located in NA and NNA counties of Texas, assuming the three emissions reduction technologies X, Y, and Z to represent, respectively, hydrogen enrichment, selective catalytic reduction, and fuel additive technologies. Model solutions were obtained for varying budget amounts to test the sensitivity of emissions reductions and fuel-savings benefits with increasing the budget. Different mixes of technologies producing maximum oxides of nitrogen (NO(x)) reductions and total combined benefits (emissions reductions plus fuel savings) were indicated at different budget ranges. The initial steep portion of the plots for NO(x) reductions and total combined benefits against budgets for different combinations of emissions reduction technologies indicated a high benefit-cost ratio at lower budget amounts. The rate of NO(x) reductions and the increase of combined benefits decreased with increasing the budget, and with the budget exceeding certain limits neither further NO(x) reductions nor increased combined benefits were observed. Finally, the Pareto front obtained would enable the decision-maker to achieve a noninferior optimal combination of total NO(x) reductions and fuel-savings benefits for a given budget.     

Convergence or divergence in desertification risk? Scale-based assessment and policy implications in a Mediterranean country

This paper explores changes (1990–2000) in two environmental indexes with the aim of providing empirical evidence on regional and local convergence in an increasing-impact phenomenon such as Land Degradation (LD) in Italy. Convergence analysis for ESAI (Environmental Sensitive Area Index) and LVI (Land Vulnerability Index) was developed at five different geographical scales. Results indicate that territorial disparities in land vulnerability tend to increase during the investigated period following a defined spatial pattern that depends on land quality, the environmental context and the economic performance of regional systems. Finally, the implications this process has on policy strategies aimed at mitigating desertification risk are discussed.     

Use of biosurfactants from urban wastes compost in textile dyeing and soil remediation

A compost isolated humic acid-like (cHAL) material was pointed out in previous work for its potential as auxiliary in chemical technology. Its potential is based on its relatively low 0.4gL(-1) critical micellar concentration (cmc) in water, which enables cHAL to enhance the water solubility of hydrophobic substances, like phenanthrene, when used at higher concentrations than 0.4gL(-1). This material could be obtained from a 1:1 v/v mixture of municipal solid and lignocellulosic wastes composted for 15 days. The compost, containing 69.3% volatile solids, 39.6% total organic C and 21C/N ratio, was extracted for 24h at 65 degrees C under N2 with aqueous 0.1molL(-1) NaOH and 0.1molL(-1) Na4P2O7, and the solution was acidified to separate the precipitated cHAL in 12% yield from soluble carbohydrates and other humic and non-humic substances. In this work two typical applications of surfactants, i.e., textile dyeing (TD) and soil remediation by washing (SW), were chosen as grounds for testing the performance of the cHAL biosurfactant against the one of sodium dodecylsulfate (SDS), which is a well established commercial synthetic surfactant. The TD trials were carried out with nylon 6 microfiber and a water insoluble dye, while the SW tests were performed with two soils contaminated by polycyclic aromatic hydrocarbons (PAH) for several decades. Performances were rated in the TD experiments based on the fabric colour intensity (DeltaE) and uniformity (sigmaDeltaE), and in the SW experiments based on the total hydrocarbons concentration (CWPAH) and on the residual surfactant (Cre) concentrations in the washing solution equilibrated with the contaminated soils. The results show that both cHAL and SDS exhibit enhanced performance when applied above their cmc values. However, while in the TD case a significant performance effect was observed at the surfactants cmc value, in the SW case the required surfactants concentration values were equivalent to 25-125xcmc for cHAL and to 4-22xcmc for SDS. The vis-a-vis comparison of the two surfactants gave the following results: in the TD case the cHAL biosurfactant at 0.4gL(-1) yields good colour intensity and equal colour uniformity as SDS at 5gL(-1), in the SW case cHAL was found to enhance CWPAH by a factor of 2-4 relative to SDS with one soil, whereas with the other soil the two surfactants behaved similarly. The Cre data, however, showed that both soils absorbed by far more SDS (68-95%) than cHAL (12-54%). The results point out intriguing technological and environmental perspectives deriving from the use of compost isolated biosurfactants in the place of synthetic surfactants.     

Prevalence of chromosomal aberrations in Argentinean agricultural workers

Environmental Science and Pollution Research - Little is known about biosecurity measures and toxic effects during pesticide application in the province of Jujuy, Argentina, particularly concerning...     

PBDEs and PCBs in sediments of the Thi Nai Lagoon (Central Vietnam) and soils from its mainland

Concentration and distribution of PCBs, PCB 11, and PBDEs in both surficial sediment and soil samples, taken from a zone subject to recent accelerated development, were investigated to assess the environmental quality and understand both natural and anthropogenic processes that influence contaminant behaviors. Values of PCB and PBDE are in the lower range of those reported in literature, typical of low impacted coastal zones. This could be due to efficient processes of resuspension and removal. Contaminants in the lagoon showed higher concentrations in sediments from sites close to the city and the outfalls of the industrial area, while soils showed maximum values in the northern samples. In addition, congener patterns and statistical analyses suggest the presence of effective degradation processes, especially for PBDEs, with the exception of the most concentrated samples that may indicate a direct input. PCB 11 is a significant component (up to 18%) in most lagoon sediments. Its presence is strongly associated with fine particles, thus the distribution seems to be driven mainly by the system hydrodynamic and does not trace the sources. Due to evaporation, only flooded agricultural soils show a similar relative abundance of this congener.     

The adaptive response of lichens to mercury exposure involves changes in the photosynthetic machinery

Lichens are an excellent model to study the bioaccumulation of heavy metals but limited information is available on the molecular mechanisms occurring during bioaccumulation. We investigated the changes of the lichen proteome during exposure to constant concentrations of mercury. We found that most of changes involves proteins of the photosynthetic pathway, such as the chloroplastic photosystem I reaction center subunit II, the oxygen-evolving protein and the chloroplastic ATP synthase β-subunit. This suggests that photosynthesis is a target of the toxic effects of mercury. These findings are also supported by changes in the content of photosynthetic pigments (chlorophyll a and b, and β-carotene). Alterations to the photosynthetic machinery also reflect on the structure of thylakoid membranes of algal cells. Response of lichens to mercury also involves stress-related proteins (such as Hsp70) but not cytoskeletal proteins. Results suggest that lichens adapt to mercury exposure by changing the metabolic production of energy.     

Effects of TiO2 based photocatalytic paint on concentrations and emissions of pollutants and on animal performance in a swine weaning unit

The beneficial effect of a TiO2-based photocatalytic treatment on the indoor air purification of a swine farm has been evaluated in a trial performed in two identical mechanically ventilated traditional weaning units, with 391 animals lodged in each of them. One unit was used as reference, whereas the walls of the second unit (260 m2) were coated with ca. 70 g m(-2) of TiO2 and irradiated with ten UV-A lamps. The environmental parameters (i.e. the ventilation rate, the internal and external temperature and relative humidity), together with NH3, CH4, CO2 and N2O concentrations in the exhaust ducts and PM10 emissions, were monitored in the two units throughout all of the production cycle (75 days). Significant decreases in CH4 concentration (ca. 27%, P < 0.05) and PM10 emission (ca. 17%, P < 0.01) were observed, together with an increase of the piglets' productive performance in the treated unit with respect to the reference one. Indeed, the ADG (Average Daily Gain of piglets) was 424 g vs. 414 g for the piglets lodged in the two units, respectively, with a significantly better feed conversion ratio (FCR, ratio between the food ingested by the animals and their weight gain) of 2.18 vs. 2.44 (P < 0.001). Therefore, the photocatalytic treatment with TiO2 coating had positive effects not only on methane concentration and particulate matter concentration and emission, but also significantly improved the feed conversion ratio of growing piglets, very likely due to the increased quality of indoor air, with positive economic repercussions for the farmer. Internal photocatalytic treatment in swine husbandry could thus be considered as a potential Best Available Technology (BAT).     

Kinetics of monomer biodegradation in soil

In modern intensive agriculture, plastics are used in several applications (i.e. mulch films, drip irrigation tubes, string, clips, pots, etc.). Interest towards applying biodegradable plastics to replace the conventional plastics is promising. Ten monomers, which can be applied in the synthesis of potentially biodegradable polyesters, were tested according to ASTM 5988-96 (standard respirometric test to evaluate aerobic biodegradation in soil by measuring the carbon dioxide evolution): adipic acid, azelaic acid, 1,4-butanediol, 1,2-ethanediol, 1,6-hexanediol, lactic acid, glucose, sebacic acid, succinic acid and terephthalic acid. Eight replicates were carried out for each monomer for 27-45 days. The numerical code AQUASIM was applied to process the CO? experimental data in order to estimate values for the parameters describing the different mechanisms occurring to the monomers in soil: i) the first order solubilization kinetic constant, K(sol) (d?1); ii) the first order biodegradation kinetic constant, K(b) (d?1); iii) the lag time in biodegradation, t(lag) (d); and iv) the carbon fraction biodegraded but not transformed into CO?, Y (-). The following range of values were obtained: [0.006 d?1, 6.9 d?1] for K(sol), [0.1 d?1, 1.2 d?1] for K(b), and [0.32-0.58] for Y; t(lag) was observed for azelaic acid, 1,2-ethanediol, and terephthalic acid, with estimated values between 3.0 e 4.9 d.