Tank atmosphere perturbation: a procedure for assessing flashing losses from oil storage tanks

A new procedure to measure the total volume of emissions from heavy crude oil storage tanks is described. Tank flashing losses, which are difficult to measure, can be determined by correcting this value for working and breathing losses. The procedure uses a fan or blower to vent the headspace of the storage tank, with subsequent monitoring of the change in concentrations of oxygen or other gases. Combined with a separate determination of the reactive organic carbon (ROC) fraction in the gas, this method allows the evaluation of the total amount of ROC emitted. The operation of the system is described, and results from measurement of several storage tanks in California oil fields are presented. Our measurements are compared with those obtained using the California Air Resources Board (CARB) 150 method.     

Study of fractionation and potential mobility of metal in sludge from pyrite mining and affected river sediments: changes in mobility over time and use of artificial ageing as a tool in environmental impact assessment

Sludge from mining exploitation can be a source of land and water contamination in the adjacent zone. Accidents such as the break of waste mining pools in the Aznalcollar Mine (Seville, Spain) in 1998 produce important ecological disasters. In this work is presented a study of the evolution of aqua regia leachable concentration and mobility of metals in sediment samples of Guadiamar River basin from the accident date up to 2001. The application of BCR standard extraction procedures provides valuable information about the mobility and toxicity of the spill and the metal mobility in Guadiamar River polluted sediments. As a rule, themobility of several metals in the initial sludge (sulphides) is low, except for copper. Otherwise, the results of aqua regia leachable concentration and mobility of metal obtained for sediments samples indicate that the cleaning and inertisation works carried out in the zone have been adequate but insufficient, being the metal levels observed in the zone are higher than natural levels. To establish the initial impact of the spill and the mobility changes with time, mineralogical composition of the pyritic sludge and its evolution after the natural weathering and after the induction, of accelerated ageing processes by light and temperature was studied in the laboratory. Oxidation of initial sulphides to sulphates was observed. Both environmental and laboratory oxidation of the metallic sulphides increase the mobility of all metals, especially of copper, zinc and lead. The proposed laboratory procedure allows to predict the changes in mobility and therefore in toxicity that can occur at short or long term after exposure of sludge at environ-mental conditions. The mobility results in sludge and sediment samples are interpreted in terms of the mineral composition of the samples.     

Effects of various temperature cycles on the larval development of the gastropod molluscCrepidula fornicata

Veligers ofCrepidula fornicata (L.) were reared for 12 days at constant temperatures of 15°, 20°, 25°, 30° and 35°C, and at 5 C° daily cycles of equal periodicity (COEP) over the temperature ranges 15° to 20°C, 20° to 25°C, 25° to 30°C and 30° to 35°C. COEP consisted of equal periods (6 h) of maximum temperature, minimum temperature, and uniformly increasing and decreasing temperature each 24 h period. Survival was high and not influenced by cyclic or constant temperature from 15° to 30°C. At 35°C and COEP 30° to 35°C, all larvae died before Day 6. Shell growth rate increased markedly over the range 15° to 25°C, and growth rates at cyclic temperatures in this range were intermediate between growth rates at the corresponding constant temperatures. Larvae reared at COEP 15° to 20°C and COEP 30° to 35°C had discontinuities in their shells due to inhibition of shell secretion during the adverse part of each temperature cycle. Groups ofc. fornicata veligers were exposed for 2 days to daily temperature cycles of equal and unequal periodicity in the critical 30° to 35°C range. [Cycles of unequal periodicity (COUP) consisted of unequal periods (varying between 3 and 15 h) of maximum and minimum temperature and uniformly increasing and decreasing temperature each 24 h period.] These veligers showed shell growth although their body tissue declined, as indicated by decreasing carbon content per larva. Least shell growth and most body tissue loss occurred in those cycles with the longest exposure to higher temperature. Larvae exposed for arious days to the mildest 30° to 35°C COUP (15 h at 30°C, 3 h increasing temperature, 3 h at 35°C and 3 h decreasing temperature) recovered and resumed normal growth when transferred to constant 30°C, but their growth was retarded in proportion to the number of days in the temperature cycle. Rates of shell growth of veligers in temperature cycles show an immediate effect of environmental temperature, while changes in carbon content per larva better reflect the effects of temperature on general metabolism and survival.     

Convergent validity between willingness to pay elicitation methods: an application to Grand Canyon whitewater boaters

We directly compare trip willingness to pay (WTP) values between dichotomous choice contingent valuation (DCCV) and discrete choice experiment (DCE) stated preference surveys of private party Grand Canyon whitewater boaters. The consistency of DCCV and DCE estimates is debated in the literature, and this study contributes to the body of work comparing the methods. Comparisons were made of mean WTP estimates for four hypothetical Colorado River flow-level scenarios. Boaters were found to most highly value mid-range flows, with very low and very high flows eliciting lower WTP estimates across both DCE and DCCV surveys. Mean WTP precision was estimated through simulation. No statistically significant differences were detected between the two methods at three of the four hypothetical flow levels.     

Quantifying the relative irreplaceability of important bird and biodiversity areas

World governments have committed to increase the global protected areas coverage by 2020, but the effectiveness of this commitment for protecting biodiversity depends on where new protected areas are located. Threshold‐ and complementarity‐based approaches have been independently used to identify important sites for biodiversity. We brought together these approaches by performing a complementarity‐based analysis of irreplaceability in important bird and biodiversity areas (IBAs), which are sites identified using a threshold‐based approach. We determined whether irreplaceability values are higher inside than outside IBAs and whether any observed difference depends on known characteristics of the IBAs. We focused on 3 regions with comprehensive IBA inventories and bird distribution atlases: Australia, southern Africa, and Europe. Irreplaceability values were significantly higher inside than outside IBAs, although differences were much smaller in Europe than elsewhere. Higher irreplaceability values in IBAs were associated with the presence and number of restricted‐range species; number of criteria under which the site was identified; and mean geographic range size of the species for which the site was identified (trigger species). In addition, IBAs were characterized by higher irreplaceability values when using proportional species representation targets, rather than fixed targets. There were broadly comparable results when measuring irreplaceability for trigger species and when considering all bird species, which indicates a good surrogacy effect of the former. Recently, the International Union for Conservation of Nature has convened a consultation to consolidate global standards for the identification of key biodiversity areas (KBAs), building from existing approaches such as IBAs. Our results informed this consultation, and in particular a proposed irreplaceability criterion that will allow the new KBA standard to draw on the strengths of both threshold‐ and complementarity‐based approaches.     

Modelling pesticide volatilization after soil application using the mechanistic model Volt'Air

Volatilization of pesticides participates in atmospheric contamination and affects environmental ecosystems including human welfare. Modelling at relevant time and spatial scales is needed to better understand the complex processes involved in pesticide volatilization. Volt'Air-Pesticides has been developed following a two-step procedure to study pesticide volatilization at the field scale and at a quarter time step. Firstly, Volt'Air-NH₃ was adapted by extending the initial transfer of solutes to pesticides and by adding specific calculations for physico-chemical equilibriums as well as for the degradation of pesticides in soil. Secondly, the model was evaluated in terms of 3 pesticides applied on bare soil (atrazine, alachlor, and trifluralin) which display a wide range of volatilization rates. A sensitivity analysis confirmed the relevance of tuning to K_h. Then, using Volt'Air-Pesticides, environmental conditions and emission fluxes of the pesticides were compared to fluxes measured under 2 environmental conditions. The model fairly well described water temporal dynamics, soil surface temperature, and energy budget. Overall, Volt'Air-Pesticides estimates of the order of magnitude of the volatilization flux of all three compounds were in good agreement with the field measurements. The model also satisfactorily simulated the decrease in the volatilization rate of the three pesticides during night-time as well as the decrease in the soil surface residue of trifluralin before and after incorporation. However, the timing of the maximum flux rate during the day was not correctly described, thought to be linked to an increased adsorption under dry soil conditions. Thanks to Volt'Air's capacity to deal with pedo-climatic conditions, several existing parameterizations describing adsorption as a function of soil water content could be tested. However, this point requires further investigation. Practically speaking, Volt'Air-Pesticides can be a useful tool to make decision about agricultural practices such as incorporation or for the estimation of overall pesticide volatilization rates, and it holds promise for time specific dynamics.