Sequential extractions of selenium soils from Stewart Lake: total selenium and speciation measurements with ICP-MS detection

Different techniques have been employed in order to evaluate the most efficient procedure for the extraction of selenium from soil as required for speciation. Selenium contaminated sediments from Stewart Lake Wetland, California were used. A strong acid mineralization of the samples gives quantitative total selenium, which is then used to estimate recoveries for the milder extraction methods. The different extraction methodologies involve the sequential use of water, buffer (phosphate, pH 7) and either acid solution (e.g. HNO3 or HCl) or basic solutions (e.g. ammonium acetate, NaOH or TMAH). Pyrophosphate extraction was also evaluated and showed that selenium was not associated with humic acids. The extractants were subsequently analyzed by size exclusion chromatography (SEC) with UV (254 and 400 nm) and on-line ICP-MS detection; anion exchange chromatography, and ion-pair reversed phase chromatography with ICP-MS detection. For sequential extractions the extraction efficiencies showed that the basic extractions were more efficient than the acidic. The difference between the acidic and the basic extraction efficiency is carried to the sulfite extraction, suggesting that whatever is not extracted by the acid is subsequently extracted by the sulfite. The species identified with the different chromatographies were selenate, selenite, elemental selenium and some organic selenium.     

Chromium redox speciation in natural waters

Dissolved hexavalent chromium concentrations were determined in river, estuarine and coastal waters of the Humber catchment in north-east England. Samples were collected, filtered, extracted on site and after storage for up to eight days. Hexavalent chromium concentrations did not change by more than 0.05 microg l(-1) (not significant, p = 0.05) over this period. Total chromium concentrations in the catchment were less than 1.0 microg l(-1). This is low in relation to the proposed Environmental Quality Standard. Hexavalent chromium accounted for between 27% and 100% of the total dissolved concentration, with an average of approximately 50%. The proportion of Cr(III) and Cr(VI) in the rivers and estuary were of the same range as previously measured in 1993. The addition of Cr(III) and Cr(VI) to fresh and saline water samples illustrates the complexity of the factors controlling chromium speciation in natural waters. The presence of oxidisable organic matter and the stabilising role of complexing organic ligands are proposed as the main controlling influences of redox speciation in filtered samples.     

Organotin compounds in the marine environment of the Bay of Piran,northern Adriatic Sea

In the year 2000, organotin pollution was investigated in the Bay of Piran, Slovenia, at the northern extremity of the Adriatic Sea. Gas chromatography-mass spectrometry with single ion monitoring GC/MS-SIM was applied for speciation analysis of pentylated organotin compounds in water and mussels. Sampling of marine waters was performed in summer and autumn at 8 locations. Mussels Mytilus galloprovincialis were collected only in summer at 3 locations. The highest concentrations of tributyltin (TBT) in marine water ranged from 500 to 630 ng L(-1) (as Sn) in summer and from 180 to 230 ng L(-1) (as Sn) in autumn. TBT concentration in mussels varied from 500 to 3500 ng g(-1) dry weight (d.w.) (as Sn). The study indicated remarkable butyltin pollution of the Slovenian coastline. Accuracy of the analytical procedure was verified by BCR CRM 477.     

SI-traceable certification of Cu, Cr, Cd and Pb in sediment and fly ash candidate reference materials

Many fields in environmental analytical chemistry deal with very low limits and thresholds as set by governmental legislations or transnational regulations. The need for the accuracy, comparability and traceability of analytical measurements in environmental analytical chemistry has significantly increased and total uncertainties are even asked for by accreditation bodies of environmental laboratories. This paper addresses achieving these goals to guarantee accuracy, quality control, quality assurance or validation of a method by means of certified reference materials. The assessment of analytical results in certified reference materials must be as accurate as possible and every single step has to be fully evaluated. This paper presents the SI-traceable certification of Cu, Cr, Cd and Pb contents in geological and environmentally relevant matrices (three sediments and one fly ash sample). Certification was achieved using isotope dilution (ID) ICPMS as a primary method of measurement. In order to reduce significantly the number of analytical steps and intermediate samples a multiple spiking approach was developed. The full methodology is documented and total uncertainty budgets are calculated for all certified values. A non-element specific sample digestion process was optimised. All wet chemical digestion methods examined resulted in a more or less pronounced amount of precipitate. It is demonstrated that these precipitates originate mainly from secondary formation of fluorides (essentially CaF2) and that their formation takes place after isotopic equilibration. The contribution to the total uncertainty of the final values resulting from the formation of such precipitates was in general < 0.1% for all investigated elements. Other sources of uncertainty scrutinised included the moisture content determination, procedural blank determination, cross-contamination from the different spike materials, correction for spectral interferences, instrumental background and deadtime effects, as well as the use of either certified values or IUPAC data in the IDMS equation. The average elemental content in the sediment samples was 30-130 micrograms g-1 for Pb, 0.5-3 micrograms g-1 for Cd and 50-70 micrograms g-1 for Cu. Cr was measured in one sample and was about 60 micrograms g-1. The concentrations in the fly ash sample were up to 2 orders of magnitude higher. Expanded uncertainty for the investigated elements was about 3% (coverae factor k = 2) except for Cr, (measured by high resolution ICPMS), for which the expanded uncertainty was about 7% (k = 2).     

The interaction between physical and social-psychological factors in indoor environmental health

Indoor environmental health is now recognized as an important factor in preventing respiratory health problems in the United States. It is also a concern in Canada due to the amount of time that Canadians spend indoors because of cold weather and the potential for increased time indoors during the summer if theclimate warms. The negative health effects are often labeled assick building syndrome, but diagnosing a building or itsoccupants as sick is complicated by the variety of symptoms, thepresence of chronic versus acute symptoms and social andpsychological (socio-psychological) factors that may reduce theeffectiveness of an engineering solution. As a case study, thecontribution of various factors to indoor environmental health,in three buildings at the University of Toronto, was examinedusing five different methods. The results indicate that theinhabitants of the buildings consider features other than airquality in considering building health such as design,maintenance, funding cuts and socio-psychological factors.     

Biotreatability and kinetics of UASB reactor to mixtures of chlorophenol pollutants

In most natural ecosystems heterotrophic microorganisms encountercomplex mixtures of carbon sources, each of which is present at aconcentration of few micrograms per litre. This study examined the biotreatability and kinetics of an upflow anaerobic sludge blanket (UASB) reactor to complex mixtures of chlorophenols encountered in environmental conditions using on-line and off-line experimental studies. Results indicate that (1) steady-state concentration was quite lower (98.3 mg L^-1) with complex mixture of chlorophenols than steady-state concentration achieved when only 2.4 dichlorophenol (124 mg L^-1) was studied alone on the same reactor; (2) that toxiceffects of chlorophenols increase with increasing concentrationsof toxicant. (Onset of the inhibitory effect occurred at a lowerconcentration in multi-substrate than in single substrate utilization); (3) addition of alternative utilizable substrate can mitigate toxic effects and enhance degradation; (4) the relative concentration of substrate was critical in determiningutilization patterns. HPLC analysis of off-line experimental samples resulted in a steady-state treatment efficiency of68% for COD, 36% for 2-hlorophenol, 40.5% for 4-chlorophenol, 70.7% for 2,4-dichlorophenol, 53.2% for 2,4,6-trichlorophenol and 42% for pentachlorophenol in presence of glucose. Kinetic constant in terms of V _max and K _s were determined. K _s for the five chlorophenols ranged between 0.016 and 0.117 kg m^-3 day^-1 while V _max ranged between 0.056 and 0.244 kg m^-3 day^-1.     

Atrazine and Alachlor Inputs to Surface and Ground Waters in Irrigated Corn Cultivation Areas of Castilla-Leon Region, Spain

The inputs of atrazine and alachlor herbicides to surface and ground waters from irrigated areas dedicated to corn cultivation in the Castilla-León (C-L) region (Spain) as related to the application of both herbicides were studied. Enzyme-linked immunosorbent assays (ELISA) were used for monitoring the atrazine and alachlor concentrations in 98 water samples taken from these areas. Seventy-nine of the samples were of ground waters and 19 were of surface waters. The concentration ranges of the herbicides detected in the study period (October 1997–October 1998) were 0.04–25.3 g L^–1 in the surface waters and 0.04–3.45 g L^–1 in the ground waters for atrazine, and 0.06–31.9 g L^–1 in the surface waters and 0.05–4.85 g L^–1 in the ground waters in the case of alachlor. The highly significant correlation observed between the concentrations of both herbicides in the surface waters (r = 0.89, p < 0.001) pointed to a parallel transport of atrazine and alachlor to these waters. A study was made of the temporal evolution of the concentrations of both herbicides, and it was found a maximum recharge of atrazine in the ground waters for April 1998 and of alachlor in October 1997 and October 1998. The temporal evolution of the concentrations of both herbicides in surface waters was parallel. The highly significant correlations observed between atrazine concentrations determined by ELISA and by HPLC (r = 0.92, p < 0.001) and between alachlor concentrations also determined by both methods (r = 0.96, p < 0.001) confirmed the usefulness of ELISA for monitoring both herbicides in an elevated number of samples. Using HPLC, the presence in some waters of the alachlor ethanesulfonate (ESA) metabolite was found at a concentration range of 0.52–4.01 g L^–1. However the interference of ESA in the determination of alachlor by ELISA was negligible. The inputs of atrazine and alachlor to waters found in this study, especially the inputs to ground waters, could pose a risk for human health considering that some waters, though sporadically, are even used for human consumption.     

IMPACTS OF VISITORS ON SOIL AND VEGETATION OF THE RECREATIONAL AREA “NACIMIENTO DEL RÍO MUNDO” (CASTILLA-LA MANCHA, SPAIN)

This study examines the effects of recreational use on the soil and vegetation at a site of ecological importance (Nacimiento del Río Mundo, Albacete, Spain). The most visited sites showed increased soil compaction of approximately 50%, bare ground increase to 61 ± 10% and a decrease in richness (from 25 ± 2 to 15 ± 2 species), diversity (from 4.0 ± 0.1 to 2.7 ± 0.4) and stratification of plant species (from 80 ± 11 to 21 ± 4%). The most visited sites had 90% less plant species as compared to the least visited. Intense use was associated with the presence of nitrophilous plant and vegetal species with a morphology adapted to heavy trampling. The recreational areas showed a distribution pattern of impact radiating outwards from the most used and degraded point. At the most visited point, Los Chorros (the spring of the river), the impact radiated outwards for about 20 m. A pilot experiment examining the effects of one-year restriction to visitors for access to a formerly impacted area showed a plant cover increase by anthropic and not by native species of 57 percent units.     

Pool of Dust Particles over the Asian Continent: Balloon-borne Optical Particle Counter and Ground-based Lidar Measurements at Dunhuang, China

Measurements of aerosols were made in 2001 and 2002 at Dunhuang (40 degrees 00'N, 94 degrees 30'E), China to understand the nature of atmospheric particles over the desert areas in the Asian continent. Balloon-borne measurements with an optical particle counter suggested that particle size and concentration had noticeable peaks in super micron size range not only in the boundary mixing layer but also in the free troposphere. Super-micron particle concentration largely decreased in the mid tropopause (from 5 to 10 km; above sea level, a.s.l.). Lidar measurements made during August 2002 at Dunhuang suggested the possibility that mixing of dust particles occurred from near the ground to about 6 km even under calm weather conditions, and a large depolarization ratio of particulate matter was found in the aerosol layer. The top of the aerosol layer was found at heights of nearly 6 km (a.s.l.). It is strongly suggested that nonspherical dust particles (Kosa particles) frequently diffused in the free atmosphere over the Taklamakan desert through small-scale turbulences and are possible sources of dust particles of weak Kosa events that have been identified in the free troposphere not only in spring but also in summer over Japanese archipelago. Electron microscopic experiments of the particles collected in the free troposphere confirmed that coarse and nonspherical particles observed by the mineral particle were major components of coarse mode (diameter larger than 1 microm) below about 5 km over Dunhuang, China.