1025t/h四角切圆煤粉炉内空气过量系数对NO生成的影响

文章采用计算流体力学软件Fluent数值模拟了1 025 t/h四角切圆煤粉炉内的湍流扩散燃烧,分析了空气过量系数对炉内烟气速度、烟气温度和氮氧化物组分的影响。结果表明:空气过量系数会对炉内流场的空气动力学特性和温度场分布均匀性产生显著影响。煤粉炉膛最佳空气过量系数为1.07,此时炉内温度场、速度场和浓度场的分布可使燃烧中间产物HCN和NH_3较好的将燃料型NO还原为N_2,来充分发挥空气分级燃烧降低NO排放的功效。     

美国市政污水处理排放标准制定对中国的启示

在概述美国市政污水处理排放标准制度体系的基础上,介绍了其制定基于技术的排放限值和基于水质的排放限值的方法,阐述了其制定的科学性,并指出了中国市政污水处理排放标准中存在的相应问题。最后,根据美国制定排放标准限值的经验,对我国污水处理排放标准进行了思考,并提出了科学制定排放标准的方法和建议。     

基于格网GIS的重点生态功能区生态系统敏感性研究:以贵州省雷山县为例

为了科学地诊断出存在的环境问题,实现对生态环境的保护,以重点生态功能区雷山县为例,结合地形、地貌与气候等数据,以格网为评价单元,构建生态系统敏感性评价指标体系。采用层次分析法、区域综合法及格网GIS技术,对评价体系中各指标进行10 m×10 m尺度下的格网化表达,运用栅格数据的空间叠加方法及生态系统敏感性评价模型,综合评价雷山县生态系统敏感性空间格局。结果表明:雷山县生态系统敏感性较高,其中非敏感区和轻度敏感区面积较小,仅占总面积的5%和13.4%;其次是中度敏感区和极度敏感区,分别占总面积的26.3%和17%;高度敏感区面积最大,占总面积的38.3%。     

成都市污染边界层高度的演变特征分析

基于2014年1月21日至2月5日成都市人民南路四段逐时PM_(2.5)质量浓度、大气能见度资料以及同期Mie散射激光雷达探测数据,遵循消光系数与细颗粒物质量浓度之间的关系,探讨污染边界层高度的演变特征。结果表明:污染时段内的污染边界层高度偏低,平均为221m;污染边界层高度与地面PM_(2.5)浓度的变化具有明显相关性,但污染边界层高度改变在前,地面PM_(2.5)浓度响应在后;污染边界层高度的日变化表现为单峰单谷型,峰值和谷值分别出现在08:00时和14:00时前后。     

青藏高原土壤柴油降解菌的筛选及降解实验研究

青藏高原北麓河地区土壤为典型的低温土壤环境,夏季高温季节表层土壤(5 cm处)温度仅为9℃,中层(20 cm处)为7.5℃,而40 cm处仅为4℃左右。土壤高温季节为7月中旬至9月上旬,而10月至来年6月土壤日平均温度下降为0℃以下。针对青藏高原低温土壤环境,在北麓河试验现场进行人工模拟柴油污染,16个月后采集污染土样,进行土著低温菌的复合筛选,柴油菌的筛选驯化温度为10℃。经过4次转接复合培养驯化后,菌液中微生物数量可达2.7×1012CFU/mL。筛选后的柴油降解菌90%以上为杆状菌,长度为2~3μm,少见球菌,其直径约为0.5μm。通过柴油摇瓶模拟降解实验,17 d后柴油去除率可达到62%。研究为青藏高原低温条件下的土壤柴油污染土著微生物修复提供了研究基础。     

微藻生物富集重金属的研究进展

环境中的重金属来源广泛,在环境中有稳定、迁移、累积的特性,已严重危胁到人类健康。控制和消除重金属污染是当今世界环境面临的紧迫问题和巨大挑战。以水环境中的重金属修复为要点,介绍了利用微藻作为吸附材料的创新型生物修复技术在污水修复领域的可行性和优势,根据微藻富集重金属的主要机制,详述了生物富集的过程以及影响吸附行为的主要因素(pH、温度、离子强度、溶解性有机质),并指出了现阶段微藻生物富集重金属的研究重点和趋势。     

On the effect of Fe(III) on proliferation of Microcystis aeruginosa at high nitrate and low chlorophyll condition

The impact of Fe concentrations on the growth of Microcystisaeruginosa in aquatic systems under high nitrate and low chlorophyll conditions was studied. The responses of cell density, total and cell chlorophyll-a intracellular Fe content and organic elemental composition of M. aeruginosa to different concentration gradients of Fe(III) in the solutions were analysed. The results showed that the proliferation speeds of M. aeruginosa were: (1) decelerated when the Fe(III) concentration was lower than 50 μg/L in the solutions, (2) promoted and positively related to the increase of Fe(III) concentration from 100 to 500 μg/L in the solutions over the experimental period, and (3) promoted in the early stage but decelerated in later stages by excess adsorption of Fe by cells when the Fe(III) concentration was higher than 500 μg/L in the solutions. The maximum cell density, total and cell chlorophyll-a were all observed at 500 μg Fe(III)/L concentration. The organic elemental composition of M. aeruginosa was also affected by the concentration of Fe(III) in the solutions, and the molecular formula of M. aeruginosa should be expressed as C_7–7.5H₁₄O_0.8–1.3N_3.5–5 according to the functions for different Fe(III) concentrations. Cell carbon and oxygen content appeared to increase slightly, while cell nitrogen content appeared to decrease as Fe(III) concentrations increased from 100 to 500 μg/L in the solutions. This was attributed to the competition of photosynthesis and nitrogen adsorption under varying cell Fe content.     

Ambient volatile organic compounds pollution in China

Owing to rapid economic and industrial development, China has been suffering from degraded air quality and visibility. Volatile organic compounds (VOCs) are important precursors to the formation of ground-level ozone and hence photochemical smog. Some VOCs adversely affect human health. Therefore, VOCs have recently elicited public concern and given new impetus to scientific interest. China is now implementing a series of polices to control VOCs pollution. The key to formulating policy is understanding the ambient VOCs pollution status. This paper mainly analyzes the species, levels, sources, and spatial distributions of VOCs in ambient air. The results show that the concentrations of ambient VOCs in China are much higher than those of developed countries such as the United States and Japan, especial benzene, which exceeds available standards. At the same time, the ozone formation potential (OFP) and secondary organic aerosol formation potential (SOAFP) of various VOCs are calculated. Aromatics and alkenes have much higher OFPs, while aromatics have higher SOAFP. The OFPs of ambient VOCs in the cities of Beijing, Guangzhou and Changchun are very high, and the SOAFP of ambient VOCs in the cities of Hangzhou, Guangzhou and Changchun are higher.     

制备参数对Mn-Ce/TiO2催化剂脱硝性能的影响

以锐钛矿型TiO₂为载体,采用分步共混法制备了Mn-Ce/TiO₂催化剂,通过考察不同活性组分前驱体、焙烧温度以及活性组分负载量对催化剂样品脱硝性能的影响,以确定最佳制备参数;结合XRD（X射线衍射）、XPS（X射线光电子能谱分析）、BET比表积等表征手段研究制备参数对催化剂性能的影响.结果表明:无定型态MnO₂含量越多,越有利于提高催化剂的脱硝活性;催化剂样品表面原子浓度比Mn/Ti[或（Mn+Ce）/Ti]越高,催化剂表面有效活性组分越多,催化剂脱硝活性越好.以自制Mn盐（MX）为前驱体,在Mn-Ce活性组分负载量为16%时,经500℃焙烧的催化剂样品脱硝活性最高;反应空速为10000 h-1,反应温度为80℃时,其脱硝效率可达80%,150℃时脱硝效效率可达99%.      

恶臭污染排放源指纹谱编制及初步应用

为了识别恶臭污染源排放特征以及了解不同行业恶臭物质排放差异,对恶臭污染排放源指纹谱指标物质进行了筛选,并依据筛选结果对6家典型恶臭排放企业进行样品采集及分析,绘制了各家企业的指纹谱图.结果表明:①通过物质嗅觉阈值与AMGE（ambient multimedia environmental goals,周围环境目标值）和RfC（reference concentration,健康风险参考浓度）对比以及结合国内外恶臭标准受控物质和现有的标准检测方法,最终确定了包括三甲胺、硫化氢、甲硫醇等典型恶臭物质在内的19种物质作为指纹谱指标物质.②依据我国现行的标准监测分析方法对19种恶臭指标物进行检测,初步得到了各家企业的恶臭物质指纹谱数据,绘制了各家企业的指纹谱图.③指纹谱成分分析结果显示,污水处理厂主要的恶臭物质是硫化氢,ρ（硫化氢）为44.566 mg/m3;涂料企业ρ（甲基乙基酮）、ρ（丁醛）和ρ（乙酸乙酯）较高,分别为39.037、28.757、27.840 mg/m3;制药企业ρ（丙醛）较高,为4.791 mg/m3;汽车和家具制造企业ρ（二甲苯）较高,分别为15.209和2.081 mg/m3.④应用分歧系数法分析不同企业指纹谱之间的相似程度,分析结果显示,分歧系数在0.331~0.809之间,不同企业之间指纹谱存在较大差异.研究显示,建立恶臭污染排放源指纹谱可进行恶臭源排放特征识别,为恶臭污染溯源提供基础数据和科学依据.