环境污染物导致氧化应激的关键信号通路及其检测方法

环境污染物能够以多种途径进入生物体内,在体内产生含氧自由基等活性氧物质,并通过多种信号通路及酶反应引起氧化应激,造成生物体内的脂质过氧化、蛋白质损伤、DNA表达改变、酶失活等,从而引发心血管疾病、风湿类疾病、感染及癌症等的发生。本文对环境污染物致氧化应激产生的原因、涉及的信号通路及酶反应、造成的危害,以及常见的基于细胞模型的氧化应激检测方法进行了综述,期望为评价环境污染物和检测氧化损伤提供参考。     

Individual and combined inhibition of phenol and thiocyanate on microbial activity of partial nitritation

This study evaluated the individual and interactive effect of phenol and thiocyanate (SCN⁻) on partial nitritation (PN) activity using batch test and response surface methodology. The IC₅₀ of phenol and SCN⁻ on PN sludge were 5.6 and 351 mg L⁻¹, respectively. The PN sludge was insensitive to phenol and SCN⁻ at levels lower than 1.77 and 43.3 mg L⁻¹, respectively. A regression model equation was developed and validated to predict the relative specific respiration rate (RSRR) of PN sludge exposed to different phenol and SCN⁻ concentrations. In the range of independent variables, the most severe inhibition was observed with a valley value (17%) for RSRR, when the phenol and SCN⁻ concentrations were 4.08 and 198 mg L⁻¹, respectively. An isobole plot was used to judge the combined toxicity of phenol and SCN⁻, and the joint inhibitory effect was variable depending on the composition and concentration of the toxic components. Furthermore, the toxic compounds showed independent effects, which is the most common type of combined toxicity.

     

Multiple copper adsorption and regeneration by zeolite 4A synthesized from bauxite tailings

Copper ions were first adsorbed by zeolite 4A synthesized from bauxite tailings, the desorption of Cu(II) using Na₂EDTA solutions was performed, and the recycling of zeolite 4A in adsorption and desorption was systematically investigated. It was observed that the Cu(II) removal efficiency was directly dependent on the initial pH value. The maximum removal efficiency of Cu(II) was 96.2% with zeolite 4A when the initial pH value was 5.0. Cu(II) was completely absorbed in the first 30 min. It was also observed that the desorption efficiency and zeolite recovery were highly dependent on the initial pH and concentration of Na₂EDTA in the solution. The desorption efficiency and percent of zeolite recovered were 73.6 and 85.9%, respectively, when the Na₂EDTA solution concentration was 0.05 mol L^?1 and the pH value was 8. The recovered zeolites were pure single phase and highly crystalline. After 3 cycles, the removal efficiency of Cu(II) was as high as 78.9%, and the zeolite recovery was 46.9%, indicating that the recovered zeolites have good adsorption capacity and can repeatedly absorb Cu(II).

     

电路板组件随机振动试验的仿真实现

简述电路板组件随机振动试验仿真实现的原理和方法。通过有限元软件对电路板组件模型进行随机振动仿真分析,结合电路板组件随机振动试验的频率响应特性结果验证了仿真分析的有效性。     

羧酸盐型双子表面活性剂的合成及性能研究

以月桂酰氯、乙二胺与丁二酸酐为原料合成了一种羧酸盐型双子(gemini)表面活性剂。采用IR、1 HNMR对中间产物和目标产物进行结构表征,并考察了合成所得羧酸盐型gemini表面活性剂的表面活性。结果表明:合成产物即为目标产物。合成产物的临界胶束浓度为0.027mmol/L,比普通单链表面活性剂低2～3个数量级,表面张力最低可降至29.5mN/m。     

新农村建设污水处理工程实例

山海关区新民居污水治理工程采用水解酸化+接触氧化+曝气生物滤池为主的工艺进行污水治理,实际运行结果表明:系统运行稳定,处理出水COD≤48 mg.L-1,BOD5≤9 mg.L-1,SS≤10 mg.L-1,NH3-N≤4.5 mg.L-1,TP≤0.47 mg.L-1,处理出水达到《城镇污水处理厂污染物排放标准》(GB 18918-2002)一级A标准,出水用于农村绿化和农灌,经济效益和环境效益明显。     

一株产絮酵母菌废菌体对Cd2+的吸附特性

将一株产絮酵母菌(编号B-02号)发酵后的废菌体制成生物吸附剂,研究该生物吸附剂对废水中Cd2+的生物吸附特性。结果表明:(1)pH值对Cd2+会产生较大的影响,偏酸性(pH=4～6)条件利于吸附;该吸附剂对Cd2+吸附速率较快,8～10 min就可达到吸附平衡;(2)吸附剂的吸附动力学符合二级动力学模型,吸附Cd2+的实验数据对Langmuir等温式的拟合情况良好,吸附剂吸附Cd2+的最大吸附量为70.752 mg/g。用0.5 mol/L HNO3对吸附Cd2+的酵母菌进行解吸,解吸率可达89.7%。     

玉米深加工废水的混凝实验

在室温条件下,分别选用聚合氯化铝(PAC)、聚合氯化铝铁(PAFC)及三氯化铁(FeCl3)对玉米深加工废水进行混凝实验。综合考虑各种混凝剂对磷、COD以及SS的去除效果,最终选取PAC作为混凝剂。采用PAC和聚丙烯酰胺(PAM)作为复合混凝剂,对其去除效果做进一步研究,并确定了最佳投加量及pH值。实验结果表明,在PAC投加量25mg/L,PAM投加量0.5 mg/L,pH为8条件下,混凝效果最佳。磷、COD、SS去除率可分别达到90.1%、53.3%和88.2%,对应的出水质量浓度分别为0.41、26.8和2 mg/L。     

无硫膨胀石墨的制备及吸油性能

通过单因子实验考察了无硫膨胀石墨制备过程中氧化剂及插层剂用量、氧化反应及插层反应时间、氧化反应及插层反应温度对无硫膨胀石墨膨胀体积的影响。通过正交实验确定了制备无硫膨胀石墨的最优条件是:石墨(g)∶浓硝酸(mL)∶30%H2O2(mL)∶乙酸酐(mL)=1∶2.25∶0.25∶0.6,在30℃条件下氧化反应60 min,加入插层剂后在60℃条件下插层反应90 min,此条件无硫膨胀石墨的膨胀体积达317 mL/g使用XPS、FT-IR、XRD和SEM对无硫膨胀石墨进行了表征并对其吸油性能和再生性能进行了研究。结果表明,所制备无硫膨胀石墨对原油和柴油的最大吸附量分别为66.3 g/g和62.7 g/g。吸附原油后的无硫膨胀石墨抽滤再生后首次再生率为49.1%,原油的回收率为64.5%。     

Investigations on mobility of carbon colloid supported nanoscale zero-valent iron (nZVI) in a column experiment and a laboratory 2D-aquifer test system

Nanoscale zero-valent iron (nZVI) has recently gained great interest in the scientific community as in situ reagent for installation of permeable reactive barriers in aquifer systems, since nZVI is highly reactive with chlorinated compounds and may render them to harmless substances. However, nZVI has a high tendency to agglomerate and sediment; therefore it shows very limited transport ranges. One new approach to overcome the limited transport of nZVI in porous media is using a suited carrier colloid. In this study we tested mobility of a carbon colloid supported nZVI particle “Carbo-Iron Colloids” (CIC) with a mean size of 0.63 μm in a column experiment of 40 cm length and an experiment in a two-dimensional (2D) aquifer test system with dimensions of 110?×?40?×?5 cm. Results show a breakthrough maximum of 82 % of the input concentration in the column experiment and 58 % in the 2D-aquifer test system. Detected residuals in porous media suggest a strong particle deposition in the first centimeters and few depositions in the porous media in the further travel path. Overall, this suggests a high mobility in porous media which might be a significant enhancement compared to bare or polyanionic stabilized nZVI.