Comparative study on performances of a heat-pipe PV/T system and a heat-pipe solar water heating system

The heat-pipe solar water heating (HP-SWH) system and the heat-pipe photovoltaic/thermal (HP-PV/T) system are two practical solar systems, both of which use heat pipes to transfer heat. By selecting appropriate working fluid of the heat-pipes, these systems can be used in the cold region without being frozen. However, performances of these two solar systems are different because the HP-PV/T system can simultaneously provide electricity and heat, whereas the HP-SWH system provides heat only. In order to understand these two systems, this work presents a mathematical model for each system to study their one-day and annual performances. One-day simulation results showed that the HP-SWH system obtained more thermal energy and total energy than the HP-PV/T system while the HP-PV/T system achieved higher exergy efficiency than the HP-SWH system. Annual simulation results indicated that the HP-SWH system can heat the water to the available temperature (45°C) solely by solar energy for more than 121 days per year in typical climate regions of China, Hong Kong, Lhasa, and Beijing, while the HP-PV/T system can only work for not more than 102 days. The HP-PV/T system, however, can provide an additional electricity output of 73.019 kWh/m², 129.472 kWh/m², and 90.309 kWh/m² per unit collector area in the three regions, respectively.     

Depth-dependence and monthly variability of charophyte biomass production: consequences for the precipitation of calcium carbonate in a shallow <Emphasis Type="Italic">Chara</Emphasis>-lake

The month-to-month variability of biomass and CaCO₃ precipitation by dense charophyte beds was studied in a shallow Chara-lake at two depths, 1 and 3 m. Charophyte dry weights (d.w.), the percentage contribution of calcium carbonate to the dry weight and the precipitation of CaCO₃ per 1 m² were analysed from May to October 2011. Physical-chemical parameters of water were also measured for the same sample locations. The mean dry weight and calcium carbonate precipitation were significantly higher at 1 m than at 3 m. The highest measured charophyte dry weight (exceeding 2000 g m^?2) was noted at 1 m depth in September, and the highest CaCO₃ content in the d.w. (exceeding 80 % of d.w.) was observed at 3 m depth in August. The highest CaCO₃ precipitation per 1 m² exceeded 1695 g at 1 m depth in August. Significant differences in photosynthetically active radiation (PAR) were found between 1 and 3 m depths; there were no significant differences between depths for other water properties. At both sampling depths, there were distinct correlations between the d.w., CaCO₃ content and precipitation and water properties. In addition to PAR, the water temperature and magnesium and calcium ion concentrations were among the most significant determinants of CaCO₃ content and d.w. The results show that light availability seems to be the major factor in determining charophyte biomass in a typical, undisturbed Chara-lake. The study results are discussed in light of the role of charophyte vegetation in whole ecosystem functioning, with a particular focus on sedimentary processes and the biogeochemical cycle within the littoral zone.     

Alginate beads containing water treatment residuals for arsenic removal from water—formation and adsorption studies

Water treatment residuals (WTRs) produced in large quantities during deironing and demanganization of infiltration water, due to high content of iron and manganese oxides, exhibit excellent sorptive properties toward arsenate and arsenite. Nonetheless, since they consist of microparticles, their practical use as an adsorbent is limited by difficulties with separation from treated solutions. The aim of this study was entrapment of chemically pretreated WTR into calcium alginate polymer and examination of sorptive properties of the obtained composite sorbent toward As(III) and As(V). Different products were formed varying in WTR content as well as in density of alginate matrix. In order to determine the key parameters of the adsorption process, both equilibrium and kinetic studies were conducted. The best properties were exhibited by a sorbent containing 5 % residuals, formed in alginate solution with a concentration of 1 %. In slightly acidic conditions (pH 4.5), its maximum sorption capacity was 3.4 and 2.9 mg g^?1 for As(III) and As(V), respectively. At neutral pH, the adsorption effectiveness decreased to 3.3 mg As g^?1 for arsenites and to 0.7 mg As g^?1 for arsenates. The presence of carboxylic groups in polymer chains impeded in neutral conditions the diffusion of anions into sorbent beads; therefore, the main rate-limiting step of the adsorption, mainly in the case of arsenates, was intraparticle diffusion. The optimal condition for simultaneous removal of arsenates and arsenites from water by means of the obtained composite sorbent is slightly acidic pH, ensuring similar adsorption effectiveness for both arsenic species.     

Heterogeneous UV/Fenton degradation of bisphenol A catalyzed by synergistic effects of FeCo2O4/TiO2/GO

A new method for bisphenol A (BPA) degradation in aqueous solution was developed. The characteristics of BPA degradation in a heterogeneous ultraviolet (UV)/Fenton reaction catalyzed by FeCo₂O₄/TiO₂/graphite oxide (GO) were studied. The properties of the synthesized catalysts were characterized using scanning electron microscopy, X-ray diffraction, and vibrating sample magnetometry. FeCo₂O₄ and TiO₂ were grown as spherical shape, rough surface, and relatively uniform on the surface of GO (FeCo₂O₄/TiO₂/GO). Batch tests were conducted to evaluate the effects of the initial pH, FeCo₂O₄/TiO₂/GO dosage, and H₂O₂ concentration on BPA degradation. In a system with 0.5 g L⁻¹ of FeCo₂O₄/TiO₂/GO and 10 mmol L⁻¹ of H₂O₂, approximately 90 % of BPA (20 mg L⁻¹) was degraded within 240 min of UV irradiation at pH 6.0. The reused FeCo₂O₄/TiO₂/GO catalyst retained its activity after three cycles, which indicates that it is stable and reusable. The heterogeneous UV/Fenton reaction catalyzed by FeCo₂O₄/TiO₂/GO is a promising advanced oxidation technology for treating wastewater that contains BPA.

     

Influence of filtration velocity on DON variation in BAF for micropolluted surface water treatment

Biological aerated filters (BAFs) are widely used for the treatment of micropolluted surface water. However, the biological process produces dissolved organic nitrogen (DON), which, as precursors of nitrogenous disinfection by-products, pose potential threats to drinking water safety. Therefore, to control DON in BAF effluent, it is necessary to study the influence of BAF operation parameters on DON production. In this study, the influence of filtration velocity in a BAF on DON production was investigated. Under different filtration velocity (0.5, 2, and 4 m/h) conditions, profiles of DON concentrations along the media layer were measured. The profile at a filtration velocity of 0.5 m/h showed a decreasing trend, and the ones under filtration velocities of 2 and 4 m/h fluctuated in a small range (from 0.1 to 0.4 mg/L). Moreover, the relatively high filtration velocities of 2 and 4 m/h resulted in a lower level of DON concentration. Additionally, 3D excitation-emission matrix fluorescence spectroscopy was used to characterize DON. It is found that the patterns of DON at a relatively high filtration velocity condition (4 m/h) were obviously different from the ones under low filtration velocity conditions (0.5 and 2 m/h).     

Effects of aeration frequency on leachate quality and waste in simulated hybrid bioreactor landfills

Research has been conducted to investigate the effects of daily aeration frequency on leachate quality and waste settlement in simulated hybrid landfill bioreactors. Four laboratory-scale reactors were constructed and operated for about 10 months to simulate different bioreactor operations, including one anaerobic bioreactor and three hybrid bioreactors with different aeration frequencies (one, two, and four times per day). Chemical oxygen demand (COD) and biochemical oxygen demand (BOD₅) reduced more than 96% of the initial concentrations in all aerated bioreactors. The differences of COD and BOD₅ reductions among tested aeration frequencies were relatively small. For ammonia nitrogen, the higher aeration frequency (two or four times per day) resulted in the quicker reduction. Overall, the concentrations of heavy metals (Cr, Co, Cu, Mn, Ni, and Zn) decreased over time except Cd and Pb. The reduction of redox-sensitive metal concentrations (Mn, Co, Ni, and Cu) was greater in aerated bioreactors than in anaerobic bioreactor. Settlement of municipal solid waste (MSW) was enhanced with higher frequency of aeration events (four times per day).

Implications: In recent years, hybird bioreactor landfill technology has gained a lot of attention. Appropriate aeration rate is crucial for hybrid bioreactor operation, but few studies have been done and different results were obtained. Research was conducted to investigate the effects of daily aeration frequency on leachate quality and waste settlement. Results indicated that aeration can effectively accelerate waste stabilization and remove organic carbon concentration and total nitrogen in the leachate.     

Conditions for the development of anaerobic digestion technologies using the organic fraction of municipal solid waste: perspectives for Poland

This article outlines problems related to the location of facilities designed to treat the organic fraction of municipal solid waste (OFMSW). Anaerobic digestion (AD) facilities are investigated as a treatment option, while taking into account the aspects of renewable energy generation. This research has been spurred on by the relationship between waste management, energy generation issues and spatial planning procedures. The analysis is focused on urban and semi-urban areas of medium and large cities. One of the most difficult issues associated with siting of waste processing plants is its integration with local infrastructures, avoiding conflicts and negative environmental impacts at the same time. This research aims to analyse possible locations for AD plants fuelled by OFMSW in Poland. Based on the experience gained from other countries and lessons learnt from the analysis of existing facilities in Europe, conditions for the location of this type of waste treatment plants have been defined, with the focus on economic, environmental and social issues. Most likely, the results of the multicriteria decision analysis for siting of municipal solid waste AD plants (M-BIST tool) could be transferred to other countries, especially those with a comparable GDP level and a similar framework for a waste management system.     

Decoupling of nonferrous metal consumption from economic growth in China

Nonferrous metal is an important basis material for the development of the national economy, and its consumption directly affects economic development. It has great significance in the effective utilization of nonferrous metals, development of an environment-friendly society, and investigation of the decoupling of nonferrous metal consumption and GDP growth. The decoupling indicators for nonferrous metal consumption and GDP growth (D _r) in China from 1995 to 2010 were calculated in this study, and the results were analyzed. A productive model based on BP neural network was established. Then, the decoupling indicators for nonferrous metal consumption and GDP growth in China for the period of 2011–2020 were predicted. For the period of 1995–2010, the annual average decoupling indicators were <1 for copper, aluminum, zinc, lead, and nickel, except for tin, which was 0.21. The analysis showed that the decoupling of nonferrous metal consumption and GDP growth is in a less optimistic situation to copper, aluminum, zinc, lead, and nickel in China from 1995 to 2010. The annual average decoupling indicator for tin was 0.21, which indicates relative decoupling. For the period of 2011–2020, the predicted decoupling indicators for copper, aluminum, zinc, lead, nickel, and tin were between 0 and 1. This finding indicates the implementation of relative decoupling. However, the total consumption of nonferrous metals did not decouple from GDP growth.     

Correlations between physicochemical properties of PAHs and their distribution in soil, moss and reindeer dung at Ny-Ålesund of the Arctic

Concentrations of 16 polycyclic aromatic hydrocarbons (PAHs) in soil, moss and reindeer dung collected at Ny-Ålesund of the Arctic were measured to investigate their accumulation trends and distribution in the three compartments. Compared with the other regions, the proportions of 2 + 3 ring PAHs to the total PAHs were higher, whereas the proportions of 5 + 6 ring PAHs were lower in the three compartments at Ny-Ålesund. Significant log/log-linear relationship was observed between the sub-cooled liquid vapor pressure and the soil/moss quotient (Q_SM). The relation was similar to the relationship between the gas/particle partition coefficient (K_P) and of PAHs, implying Q_SM would be a “mirror image” of K_P. Excellent log/log-linear relationships were observed between Q_SM and K_OA as well as between the moss/dung quotient (Q_MD) and K_OW. The results presented here indicate the physicochemical properties are suitable for characterizing the distribution of PAHs in soil, moss and reindeer dung.