石化企业用火作业管理难点和管控措施浅析

针对石化企业用火作业背后隐藏的高风险,分析了目前石化企业用火管理方面存在的问题,提出了"两减一提"硬核管控用火,细化用火职责,建立过程管控责任清单,现场用火过程动态监督检查,多种方式提升安全技能等具体管控措施。     

低温干式接头密封失效泄漏扩散数值模拟

针对低温干式接头密封失效造成甲烷泄漏的情况,采用CFD软件FLACS对LNG气化后的泄漏扩散过程进行数值模拟,对甲烷扩散过程的浓度分布及云团扩散速度进行研究,并分析了泄漏过程中可燃气体云团量的变化情况。结果表明:LNG泄漏后迅速气化扩散,40 s后各监测浓度维持稳定;最远扩散距离约40 m,气体扩散总范围最长直径约70 m,扩散最高处大约1.5 m; 120 s内LNG泄漏量为30 kg,气化后天然气体积为42.3 m~3,可燃气体云团量为140 m~3;LNG泄漏吸收空气中的热量,在地面形成流动层,贴近地面浓度高,远离地面浓度低,随着高度上升气体的可燃爆炸危险区域逐步缩小。     

Potential applications of porous organic polymers as adsorbent for the adsorption of volatile organic compounds

Volatile organic compounds (VOCs) with high toxicity and carcinogenicity are emitted from kinds of industries, which endanger human health and the environment. Adsorption is a promising method for the treatment of VOCs due to its low cost and high efficiency. In recent years, activated carbons, zeolites, and mesoporous materials are widely used to remove VOCs because of their high specific surface area and abundant porosity. However, the hydrophilic nature and low desorption rate of those materials limit their commercial application. Furthermore, the adsorption capacities of VOCs still need to be improved. Porous organic polymers (POPs) with extremely high porosity, structural diversity, and hydrophobic have been considered as one of the most promising candidates for VOCs adsorption. This review generalized the superiority of POPs for VOCs adsorption compared to other porous materials and summarized the studies of VOCs adsorption on different types of POPs. Moreover, the mechanism of competitive adsorption between water and VOCs on the POPs was discussed. Finally, a concise outlook for utilizing POPs for VOCs adsorption was discussed, noting areas in which further work is needed to develop the next-generation POPs for practical applications.     

Recovery elemental sulfur from calcium sulfide prepared by red gypsum in sulfuric acid wastewater treatment

Journal of Material Cycles and Waste Management - Red gypsum comes from TiO2 production industry by sulfate method, which comes from the low acidic liquid stream treatment using lime or limestone....     

Fabrication of PVA/GO Nanofiber Films by Electrospinning: Application for the Adsorption of Cu2+ and Organic Dyes

Journal of Polymers and the Environment - In recent years, the treatment of water pollution has been a challenging and far-reaching topic. In order to improve the adsorption performance of...     

A Highly Efficient Adsorbent Based on Starch-Graphene Oxide Architecture for Scavenging Aqueous Pb(II): Isotherms,Kinetics, Thermodynamics and Interaction Mechanism

Journal of Polymers and the Environment - Heavy metal pollution stems from the modern industry is a severe environmental problem. In this work, a highly efficient adsorbent based on starch-graphene...     

以污水流行病学监测广西某市12个污水处理厂服务区域精神活性物质的消耗量

精神活性物质滥用和使用量逐年递增正成为社会稳定、环境健康新的关注点。准确地估算某一地区这类化合物的消耗总量是管理这类物质的关键。本研究对中国广西某市12个污水处理厂(wastewater treatment plants,WWTPs)服务区域中的8种精神活性物质消耗量进行了调查。首先,采用固相萃取-液相色谱-串联质谱法测定了广西某市12个WWTPs进水中8种精神活性物质的浓度,检测到在<方法检测(method detection limit,MDL)至170.9 ng·L^-1范围内的5种精神活性物质。然后,依据污水流行病学(wastewater-based epidemiology,WBE)进行消耗量反算。结果表明,氯胺酮(ketamine,KET)、吗啡(morphine,MOR)、冰毒(methamphetamine,METH)、摇头丸(3,4-methylenedioxymethamphetamine,MDMA)是主要检出的精神活性物质,平均消耗量分别为682.4、167.8、44.6、11.3 mg·d^-1·1000inh^-1;而可卡因(cocaine,COC)、苯甲酰爱康宁(benzoylecgonine,BE)、甲卡西酮(methcathinone,MC)没有被检出。对WWTPs进水中精神活性物质的残留进行分析,估算这些物质在特定区域的消耗量,为防控风险提供支持。     

The interception effect of heavy metals in different types of Chinese fir plantations

Environmental Geochemistry and Health - The aim of this research is to investigate the interception effect of heavy metals, such as zinc (Zn), copper (Cu), lead (Pb), arsenic (As), and cadmium (Cd)...     

Influence of extracellular polymeric substances from activated sludge on the aggregation kinetics of silver and silver sulfide nanoparticles

• The NPs aggregation in the electrolyte solution is consistent with the DLVO theory. • In NaNO₃ and low Ca(NO₃)₂, EPS alleviates the NPs aggregation by steric repulsion. • In high Ca(NO₃)₂, EPS accelerates the NPs aggregation by exopolysaccharide bridging. • Ag₂S NPs have stronger stability compared with Cit-Ag NPs in aqueous systems. Extracellular polymeric substances (EPS) in activated sludge from wastewater treatment plants (WWTPs) could affect interactions between nanoparticles and alter their migration behavior. The influence mechanisms of silver nanoparticles (Ag NPs) and silver sulfide nanoparticles (Ag₂S NPs) aggregated by active EPS sludge were studied in monovalent or divalent cation solutions. The aggregation behaviors of the NPs without EPS followed the Derjaguin-Landau-Verwey-Overbeek (DLVO) theory. The counterions aggravated the aggregation of both NPs, and the divalent cation had a strong neutralizing effect due to the decrease in electrostatic repulsive force. Through extended DLVO (EDLVO) model analysis, in NaNO₃ and low-concentration Ca(NO₃)₂ (<10 mmol/L) solutions, EPS could alleviate the aggregation behaviors of Cit-Ag NPs and Ag₂S NPs due to the enhancement of steric repulsive forces. At high concentrations of Ca(NO₃)₂ (10‒100 mmol/L), exopolysaccharide macromolecules could promote the aggregation of Cit-Ag NPs and Ag₂S NPs by interparticle bridging. As the final transformation form of Ag NPs in water environments, Ag₂S NPs had better stability, possibly due to their small van der Waals forces and their strong steric repulsive forces. It is essential to elucidate the surface mechanisms between EPS and NPs to understand the different fates of metal-based and metal-sulfide NPs in WWTP systems.     

Mechanistic insight into the biofilm formation and process performance of a passive aeration ditch (PAD) for decentralized wastewater treatment

• A Passive Aeration Ditch was developed to treat decentralized wastewater. • A model was developed to describe the process performance. • A high C/N ratio facilitates microbial growth but nitrification deteriorates. • A high salinity decreases both organic and nitrogen contaminants removal. Decentralized wastewater containing elevated salinity is an emerging threat to the local environment and sanitation in remote coastal communities. Regarding the cost and treatment efficiencies, we propose a passive aeration ditch (PAD) using non-woven polyester fabric as a feasible bubbleless aerator and biofilm carrier for wastewater treatment. Consideration has been first given to PAD’s efficacy in treating saline decentralized wastewater, and then to the impact of chemical oxygen demand-to-nitrogen (C/N) ratio and salinity on biofilm formation. A multispecies model incorporating the salinity effect has been developed to depict the system performance and predict the microbial community. Results showed that the PAD system had great capacity for pollutants removal. The biofilm thickness increased at a higher C/N ratio because of the boost of aerobic heterotrophs and denitrifying bacteria, which consequently improved the COD and total nitrogen removal. However, this led to the deterioration of ammonia removal. Moreover, while a higher salinity benefited the biofilm growth, the contaminant removal efficiencies decreased because the salinity inhibited the activity of aerobic heterotrophs and reduced the abundance of nitrifying bacteria inside the biofilm. Based on the model simulation, feed water with salinity below 2% and C/N ratio in a range of 1 to 3 forms a biofilm that can reach relatively high organic matter and ammonia removal. These findings not only show the feasibility of PAD in treatment of saline decentralized wastewater, but also offer a systematic strategy to predict and optimize the process performance.