Survey of the occurrence of residues of methyl tertiary butyl ether (MTBE) in Dutch drinking water sources and drinking water

An indicative survey has been carried out in The Netherlands investigating the presence of methyl tertiary butyl ether (MTBE) in drinking water and the corresponding sources. In total, 71 different sites used for the preparation of drinking water in The Netherlands were sampled in two successive seasons in 2001 involving the analysis of 156 samples. (ground water (n = 88), surface water (n = 17), bank filtrate water (n = 6) and drinking water (n = 45)). To combine high sample throughput with high selectivity and sensitivity, off-line purge and trap for sampling and gas chromatography mass spectrometry equipped with an automated thermal desorption sampler (TDS-GC-MS) was selected as the preferred analytical methodology. The developed procedure enabled the analysis of at least 40 samples per day and provided a limit of quantification of 2 ng l(-1). In the first period 63 samples of raw water were analyzed. Concentrations ranged between < 10 ng l(-1) and 420 ng l(-1) with a median concentration below 10 ng l(-1). The second period was focused at the re-sampling of positive locations (MTBE > 10 ng l(-1)) and a few additional drinking water utilities of which both the raw and drinking water of the utilities were analyzed. The median concentration of MTBE in the selected set of drinking water samples was 20 ng l(-1) (n = 45). At one location MTBE was found at a level of 2900 ng l(-1) caused by point source contamination of the ground water (11 900 ng l(-1)). Special attention has been paid to the quality of the results by analyzing all samples in duplicate and the analysis of control samples during each series of analyses.     

Sequential extractions of selenium soils from Stewart Lake: total selenium and speciation measurements with ICP-MS detection

Different techniques have been employed in order to evaluate the most efficient procedure for the extraction of selenium from soil as required for speciation. Selenium contaminated sediments from Stewart Lake Wetland, California were used. A strong acid mineralization of the samples gives quantitative total selenium, which is then used to estimate recoveries for the milder extraction methods. The different extraction methodologies involve the sequential use of water, buffer (phosphate, pH 7) and either acid solution (e.g. HNO3 or HCl) or basic solutions (e.g. ammonium acetate, NaOH or TMAH). Pyrophosphate extraction was also evaluated and showed that selenium was not associated with humic acids. The extractants were subsequently analyzed by size exclusion chromatography (SEC) with UV (254 and 400 nm) and on-line ICP-MS detection; anion exchange chromatography, and ion-pair reversed phase chromatography with ICP-MS detection. For sequential extractions the extraction efficiencies showed that the basic extractions were more efficient than the acidic. The difference between the acidic and the basic extraction efficiency is carried to the sulfite extraction, suggesting that whatever is not extracted by the acid is subsequently extracted by the sulfite. The species identified with the different chromatographies were selenate, selenite, elemental selenium and some organic selenium.     

The occurrence of acid precipitation on the west coast of the United States

Compilation of published and unpublished data shows acid precipitation to be more widespread in the Pacific coastal states than is generally recognized. Although information is scattered and discontinuous, precipitation is definitely acidic in the Los Angeles Basin and north-central california, and in the Puget Sound region in Washington. Acid rain occurrences have been observed in western and eastern Oregon, but data are inadequate for regional generalization. New stations currently being established in Washington and Oregon, largely in resposnse to the recently renewed activity of Mount St. Helens, will greatly facilitate assessment of precipitation acidity in the Northwest.     

Determination of biomass burning emission factors: Methods and results

Biomass burning, in a broad sense, encompasses different burning practices, including open and confined burnings, and different types of vegetation. Emission factors of gaseous or particulate trace compounds are directly dependent both on the fuel type and the combustion process. Emission factors are generally calculated by stoichiometric considerations using the carbon mass balance method, applied either to combustion chamber experiments or to field experiments based on ground-level measurements or aircraft sampling in smoke plumes. There have been a number of experimental studies in the last 10 years to investigate wildfires in tropical, temperate, or boreal regions. This article presents an overview of measurement methods and experimental data on emission factors of reactive or radiatively active trace compounds, including trace gases and particles. It focuses on fires in tropical regions, that is, forest and savanna fires, agricultural burns, charcoal production, use of fuelwood, and charcoal combustion.     

Ammonia uptake by plants

The paper considers the methodology and results of experimental determination of dry deposition and ammonia uptake by isolated plant leaves. Analytical expressions are proposed which allow a transition from rates obtained in an isolated chamber to dry ammonia deposition by standing crops leaves.     

Heavy metals in the SPM of air in the environment surrounding a ferro-alloy industrial plant in India

Prices for ferro-alloys have hardened due to the closure of plants in developed countries on account of increasingly stringent pollution control legislation, resulting in a higher cost of production. A ferro-alloy industry with a capacity of 80000 MT per annum was selected to study the nature of pollution. Because of the objectionable nature of polluting air in and around the plant it was located in a rural area where there was no other industry. The area was agriculturally active and there was no effective control system for this plant.The quality of ambient air around the plant site is discussed in this paper along with the meteorological conditions. The maximum concentration of suspended particulate matter (SPM) was 768 µg/NM³ downwind of the plant, minimum 184 µg/NM³, and the average was more than 446 µg/NM³. The presence of heavy metals, viz. Fe, Mn, Cr and Pb, was also assessed. The concentration of Fe was 50 µg/NM³ downwind and 10 µg/NM³ upwind. The concentration of other metals followed a similar trend.     

Matrix diffusion effects in the cleanup of heterogeneous aquifers

Simple mathematical models are developed to account for the rather slow mass transport of nonaqueous phase liquid (NAPL) into aqueous solution in groundwater during flushing operations. The models are based on the assumption that this bottleneck in the process is associated with diffusion in the aqueous phase in the porous medium from the location of the NAPL drops/ganglia in a region of relatively low permeability out into a region of substantially higher permeability, somewhat analogous to diffusion from a block of porous rock into a nearby fracture, where the fracture system overwhelmingly dominates the overall permeability. The models include batch flushing, flushing in a laboratory column, and a one-dimensional model for flushing by means of a single recovery well.     

Patchy distributions: Optimising sample size

A method for estimating sample size which does not require an a priori definition of desired precision, or the assumption that the population is normally distributed with constant variance, has recently been proposed. This paper discusses this method and presents five modifications which make the method easier to use and reduce the probability of estimating a larger sample size than is actually required. The method is extended and used to estimate the mean abundance of patchily distributed benthic organisms. The technique can be used to guide the design of any environmental sampling programme, be it physical, chemical or biological, where comparisons between times and/or locations are required. Trade-offs between numbers of replicates and numbers of levels/sites are discussed.     

Derivation of Nutrient Guidelines for Streams in Victoria, Australia

Human induced increases to nutrientconcentrations in streams have led to many agenciesdeveloping strategies and criteria for nutrientreduction. National or statewide guidelines aregenerally inappropriate, due to the natural variabilityin stream ecosystems within political boundaries. Thisstudy used an extant aquatic macroinvertebrate-basedregionalisation for the state of Victoria, Australia, asthe basis for defining regions of relatively homogeneousenvironmental character. This enabled the selection ofecologically-based regional reference sites andsubsequent characterisation of the nutrient status ofthese sites. Using an extensive biological and nutrientdata base for streams across the State, we calculated50th and 75th percentile concentrations forreference sites within each region. Using thesepercentiles in conjunction with impact and recoverystudies, we defined nutrient guidelines for each region. Although the nutrient data largely supported thebiological regionalisation, patterns in the nutrient datadid require some minor modifications for the nutrientregions. Relatively unimpacted regions with referencesites in very good-to excellent-condition were assignedguidelines largely based on the 75th percentiles. The more impacted regions, where best availablereference sites were of poorer quality, were assignedguidelines based largely on the 50th percentiles. Professional judgement and known extents of impactsacross each region provided important contributions tothe decision-making process. The derived guidelineconcentrations are comparable to several cited in theliterature and are proposed for use in monitoring,assessment and restoration targets.     

Partitioning of mercury onto suspended sediments in estuaries

Radiochemical partitioning experiments using 203Hg have been undertaken with mixtures of river, seawater and sediment samples taken from three geochemically contrasting UK estuaries: the Plym, Beaulieu and Mersey. Species of dissolved Hg were determined using reversed-phase C18 chelating columns and particulate species were determined by sequential leaching with 1 M NH4OAc and 1 M HCl. Mercury had a high particle reactivity with partition coefficients, KDs, ranging from 10(4) to 5 x 10(5) ml g(-1), depending on salinity, the chemical composition of the end-member waters, and on the physico-chemical characteristics of the sediment. Dissolved organic matter present in the waters (humic substances and/or anthropogenic compounds) was found to be the main factor governing the forms of dissolved Hg and their reactivity. From the spiked 203Hg, up to 95% of the dissolved metal was retained on the C18 columns for the Mersey waters, whereas this fraction was < 60% in the Plym and Beaulieu waters. Quasi-irreversible adsorption of Hg onto particles from each estuary was observed over a time-scale of a few hours and < 20% of total particulate Hg was released by the sequential leach. In this paper, physico-chemical processes are proposed to explain the estuarine behaviour of Hg and the results are discussed in terms of Hg availability in estuarine systems.