Evaluation of airborne particulate matter and metals data in personal,indoor and outdoor environments using ED-XRF and ICP-MS and co-located duplicate samples

Factors and sources affecting measurement uncertainty associated with monitoring metals in airborne particulate matter (PM) were investigated as part of the Windsor, Ontario Exposure Assessment Study (WOEAS). The assessment was made using co-located duplicate samples and a comparison of two analytical approaches: ED-XRF and ICP-MS. Sampling variability was estimated using relative percent difference (RPD) of co-located duplicate samples. The comparison of ICP-MS and ED-XRF results yields very good correlations (R² ≥ 0.7) for elements present at concentrations that pass both ICP-MS and ED-XRF detection limits (e.g. Fe, Mn, Zn, Pb and Cu). PM concentration ranges (median, sample number) of 24-h indoor PM₁₀ and personal PM₁₀ filters, and outdoor PM_2.5 filters were determined to be 2.2–40.7 (11.0, n = 48) μg m^?3, 8.0–48.3 (11.9, n = 48) μg m^?3, and 17.1–42.3 (21.6, n = 18) μg m^?3, respectively. The gravimetric analytical results reveal that the variations in PM mass measurements for same-day sampling are insignificant compared to temporal or spatial variations: 92%, 100% and 96% of indoor, outdoor and personal duplicate samples, respectively, pass the quality criteria (RPD ≤ 20%). Uncertainties associated with ED-XRF elemental measurements of S, Ca, Mn, Fe and Zn for 24-h filter samples are low: 78%–100% of the duplicate samples passed the quality criteria. In the case of 24-h filter samples using ICP-MS, more elements passed the quality criteria due to the lower detection limits. These were: Li, Na, K, Ca, Si, Al, V, Fe, Mn, Co, Cu, Mo, Ag, Zn, Pb, As, Mg, Sb, Sn, Sr, Th, Ti, Tl, and U. Low air concentrations of metals (near or below instrumental detection limits) and/or inadvertent introduction of metal contamination are the main causes for excluding elements based on the pass/fail criteria. Uncertainty associated with elemental measurements must be assessed on an element-by-element basis.     

Converging hazard assessment of gold nanoparticles to aquatic organisms

The gold nanoparticles (Au-NPs) are being increasingly used because of their huge diversity of applications, and consequently, elevated levels in the environment are expected. However, due to their physico-chemical properties and functionalization a high variety of Au-NPs can be found, and complete toxicological information for each type of Au-NPs still lacks, and even, the toxicological information for the same species is sometimes contradictory. Therefore, hazard assessment should be done case by case. Hence, the objective of this study was to obtain ecotoxicological information of the same Au-NPs in aquatic organisms and to find a rationale for Au-NPs toxicity. For such a purpose, bare and hyaluronic acid capped Au-NPs (12.5 nm) along with Au-NPs bulk material were tested on freshwater algae, Daphnia and zebrafish. Results showed that while gold nanoparticles were found to be harmless to the tested organisms, the soluble gold showed to be toxic to algae and Daphnia, with an LC₅₀ between 1 and 2 mg L⁻¹. Comparing our results with those gathered in the literature, it appears that a common hazard assessment of Au-NPs on the studied organisms can be elucidated.     

Ecosystem services and hydroelectricity in Central America: modelling service flows with fuzzy logic and expert knowledge

Because ecosystem services are generally not produced and used in the same place, their assessment should consider the flows of services from ecosystems to users. These flows depend on the characteristics and spatial distribution of ecosystems and users, the spatial relationships between them, and the presence of filters or barriers between ecosystems and users. The objective of this paper is to map the ecosystem services provided to the Costa Rican and Nicaraguan hydroelectric sectors, which are crucial sectors for national sustainable development and depend directly on hydrological ecosystem services. The paper presents an approach for modelling the flows of multiple services from diverse ecosystems to diverse users through different kinds of filters in a landscape. The approach uses expert knowledge and fuzzy numbers to handle uncertainties. The analyses for Costa Rica and Nicaragua show how the approach helps identify priority areas for the conservation and restoration of forests for the services they provide to the hydroelectric sector. As such, it is a useful tool for defining spatially targeted policies for the conservation of ecosystem services and for involving the users of ecosystem services in ecosystem management.     

Land-cover changes in and around a National Park in a mountain landscape in the Pyrenees

The current state of Mediterranean mountain areas has been driven by two main factors: intense traditional human activity and the dynamics of the ecosystem itself. In this study, we examine land-cover changes in a National Park in the Pyrenees mountains (NE Iberian Peninsula), which was designated a protected area 55 years ago. First, we have analyzed spatio-temporal changes in land-cover pattern and forest dynamics from 1957 to 2005. During this period, land-cover dynamics consisted of two main processes: (i) expansion of the forest area and (ii) increasing cover of forests already present in 1957. To analyze the role of the conservation level of the park, we have also compared the results obtained within the park with those of unprotected, peripheral areas. In the two areas with different protection level, dense forests increased throughout the period because of the reduction in forestry activities. The peripheral area showed a higher rate of forest-cover change from 1957 to 2005 compared to the National Park. This higher increase in forest cover in the peripheral area could be related to a higher proportion in the National Park of screes and rocky areas and to the decline and transformation of forest activities in these peripheral, lower elevation areas.     

Adsorption of As(III) on chitosan-Fe-crosslinked complex (Ch-Fe)

It was reported the adsorption of As(III) on the surface of the chitosan-Fe-crosslinked complex. Theoretical correlation of the experimental equilibrium adsorption data for As(III)/Ch-Fe system is best explained by the non-linearized form Langmuir-Freundlich isotherm model. At optimum conditions, pH 9.0, the maximum adsorption capacity, calculated using the Langmuir-Freundlich isotherm model was 13.4 mg g⁻¹. The adsorption kinetics of As(III) onto Ch-Fe are described by the pseudo-first-order kinetic equation. The results of the Mössbauer spectroscopy showed that there is no redox process on the surface of the adsorbent.     

The endocrine disrupting potential of sediments from the Upper Danube River (Germany) as revealed by in vitro bioassays and chemical analysis

Introduction  

The present study was part of a comprehensive weight-of-evidence approach with the goal of identifying potential causes for the declines in fish populations, which have been observed during the past decades in the Upper Danube River.     

Carry-over of dietary organochlorine pesticides, PCDD/Fs, PCBs, and brominated flame retardants to Atlantic salmon (Salmo salar L.) fillets

Information on carry-over of contaminants from feed to animal food products is essential for appropriate human risk assessment of feed contaminants. The carry-over of potentially hazardous persistent organic pollutants (POPs) from feed to fillet was assessed in consumption sized Atlantic salmon (Salmo salar). Relative carry-over (defined as the fraction of a certain dietary POP retained in the fillet) was assessed in a controlled feeding trial, which provided fillet retention of dietary organochlorine pesticides (OCPs), dioxins (PCDD/Fs), polychlorinated biphenyls (PCBs), and brominated flame retardants (BFRs). Highest retention was found for OCPs, BFRs and PCBs (31-58%), and the lowest retentions were observed for PCDD/Fs congeners (10-34%). National monitoring data on commercial fish feed and farmed Atlantic salmon on the Norwegian market were used to provide commercially relevant feed-to-fillet transfer factors (calculated as fillet POP level divided by feed POP level), which ranged from 0.4 to 0.5, which is a factor 5-10 times higher than reported for terrestrial meat products. For the OCP with one of the highest relative carry-over, toxaphene, uptake and elimination kinetics were established. Model simulations that are based on the uptake and elimination kinetics gave predicted levels that were in agreement with the measured values. Application of the model to the current EU upper limit for toxaphene in feed (50 μg kg⁻¹) gave maximum fillet levels of 22 μg kg⁻¹, which exceeds the estimated permissible level (21 μg kg⁻¹) for toxaphene in fish food samples in Norway.     

Partitioning behaviour of perfluorinated alkyl contaminants between water, sediment and fish in the Orge River (nearby Paris, France)

This paper reports on the partitioning behaviour of 15 perfluorinated compounds (PFCs), including C₄-C₁₀ sulfonates and C₅-C₁₄ carboxylic acids, between water, sediment and fish (European chub, Leuciscus cephalus) in the Orge River (nearby Paris). Total PFC levels were 73.0 ± 3.0 ng L⁻¹ in water and 8.4 ± 0.5 ng g⁻¹ in sediment. They were in the range 43.1-4997.2 ng g⁻¹ in fish, in which PFC tissue distribution followed the order plasma > liver > gills > gonads > muscle. Sediment-water distribution coefficients (log K_d) and bioaccumulation factors (log BAF) were in the range 0.8-4.3 and 0.9-6.7, respectively. Both distribution coefficients positively correlated with perfluoroalkyl chain length. Field-based biota-sediment accumulation factors (BSAFs) are also reported, for the first time for PFCs other than perfluorooctane sulfonate. log BSAF ranged between −1.3 and 1.5 and was negatively correlated with the perfluoroalkyl chain length in the case of carboxylic acids.     

Distribution patterns of plants explained by human movement behaviour

Distribution patterns of plants are affected by human activities such as creation, destruction or modification of habitats. However, another important question is to what extent humans shape plant distributions by acting as dispersal vectors. In order to answer this question we developed a simulation model for the spread of plant species between human settlements. This was done on the basis of extensive sociological and ecological data on a regional scale. With regard to the sociological data, human movement behaviour defined the amount of exchange between the settlements. Gardening types represented the potential habitat in our model. The ecological data was derived from a vegetation survey carried out in 2003, which was a repeat of a survey between 1974 and 1981 along the same transects. From these surveys, we studied the distributions of 13 species in 67 settlements. In our model, the earlier survey provided the data for the initial distribution. The simulated pattern was consequently compared with the distribution pattern in 2003. In the model, dispersal kernels based on patterns of human movement between settlements led to a better match with the distribution patterns than a null model simulating pure distance dependent dispersal for all species. This was statistically significant for seven of the thirteen species. A striking result was that alien species seem to benefit more from human dispersal than native species. We emphasize the importance of the sociological data on human movement behaviour in parameterizing our regional scale model. This study provides quantitative evidence on the impact of human movement behaviour on the distribution of plant species in suburban areas.