Effects of biodiesel made from swine and chicken fat residues on carbon monoxide,carbon dioxide,and nitrogen oxide emissions

The effects of two alternative sources of animal fat-derived biodiesel feedstock on CO₂, CO, NO_x tailpipe emissions as well as fuel consumption were investigated. Biodiesel blends were produced from chicken and swine fat waste (FW-1) or floating fat (FW-2) collected from slaughterhouse wastewater treatment processes. Tests were conducted in an unmodified stationary diesel engine operating under idling conditions in attempt to simulate slow traffic in urban areas. Significant reductions in CO (up to 47% for B100; FW-2) and NO_x (up to 20% for B5; FW-2 or B100; FW-1) were attained when using biodiesel fuels at the expense of 5% increase in fuel consumption. Principal component analysis (PCA) was performed to elucidate possible associations among gas (CO₂, CO, and NO_x) emissions, cetane number and iodine index with different sources of feedstock typically employed in the biodiesel industry. NO_x, cetane number and iodine index were inversely proportional to CO₂ and biodiesel concentration. High NO_x emissions were reported from high iodine index biodiesel derived especially from forestry, fishery and some agriculture feedstocks, while the biodiesel derived from animal sources consistently presented lower iodine index mitigating NO_x emissions. The obtained results point out the applicability of biodiesel fuels derived from fat-rich residues originated from animal production on mitigation of greenhouse gas emissions. The information may encourage practitioners from biodiesel industry whilst contributing towards development of sustainable animal production.

Implications: Emissions from motor vehicles can contribute considerably to the levels of greenhouse gases in the atmosphere. The use of biodiesel to replace or augment diesel can not only decrease our dependency on fossil fuels but also help decrease air pollution. Thus, different sources of feedstocks are constantly being explored for affordable biodiesel production. However, the amount of carbon monoxide (CO), carbon dioxide (CO₂), and/or nitrogen oxide (NO_x) emissions can vary largely depending on type of feedstock used to produce biodiesel. In this work, the authors demonstrated animal fat feasibility in replacing petrodiesel with less impact regarding greenhouse gas emissions than other sources.     

Chromium Analysis at a Ferrochrome Smelter,a Chemical Plant and a Refractory Brick Plant

Techniques were developed to sample and analyze the Cr content of participate samples with emphasis on determining the concentration of the carcinogen Cr⁺⁶. Cr⁺⁶ is extracted to alkaline solution and analyzed colorimetrically. Residual particles are extracted with acid solution to remove soluble Cr⁺³, which is determined by atomic absorption spectrometry. This methodology was tested on samples from three diverse types of sources: a ferrochrome smelter, a chemical plant, and a refractory brick plant. Identical quadruplicate samples were collected to determine accuracy and precision of the collection and analysis procedures, and extraction of Cr⁺⁶ and Cr⁺³. A statistical analysis revealed that the precision of Cr⁺⁶ analysis is comparable to that of the particulate mass determination. The stability of Cr⁺⁶ In particulate form and in solution was determined. Size resolved particulate samples were collected to determine the particle size versus the Cr⁺⁶ content. At the ferrochrome smelter and the chemical plant the majority of the Cr⁺⁶ was contained in the respirable particles. The accuracy and completeness of the chemical methods employed were verified by neutron activation analysis, x-ray photoelectron spectroscopy, and scanning electron microscopyenergy dispersive x-ray analysis.     

Quantifying changes to historic fish habitat extent on north coast NSW floodplains,Australia

Global degradation of coastal ecosystems is influencing the provision of ecosystem services, including fisheries maintenance services. Degradation of the Australian coastal zone and its resources following European occupation has been recognised for some time. This includes the loss of ecologically important coastal wetlands, which have strong trophic and habitat links to fisheries. In NSW, structural flood mitigation works are a principle driver of the decline of coastal wetlands; however, little action has been taken to quantify the extent of decline due to limited information of the pre-European settlement extent of coastal wetlands. We use spatial data sets in GIS to quantify prime fish habitat and calculate the loss of fish habitat for the large coastal floodplains of northern NSW, which are significant contributors to the commercial and recreational fisheries of NSW. The technique is validated by comparison with early maps of wetland distribution. We identified pre-European distribution of available fish habitat of approximately 477,000 ha, of which 87,000 ha was identified as prime fish habitat. Approximately 62,000 ha of prime fish habitat was impacted by drainage of the coastal floodplains in association with flood mitigation works which intensified in the mid-1950s and were largely completed by 1971, equating to a loss of approximately 72 % of prime fish habitat. The declining value of the ecosystem services provided by prime fish habitat following drainage is likely to be substantial. Some actions have taken place to restore the functions of this habitat although significant opportunities remain to reverse this decline through management actions that restore natural drainage and reinstate tidal exchange. These actions become even more important as pressures on coastal wetlands increase with climate change and associated sea-level rise.     

Evaluation of cumulative PCB exposure estimated by a job exposure matrix versus PCB serum concentrations

Although polychlorinated biphenyls (PCBs) have been banned in many countries for more than three decades, exposures to PCBs continue to be of concern due to their long half-lives and carcinogenic effects. In National Institute for Occupational Safety and Health studies, we are using semiquantitative plant-specific job exposure matrices (JEMs) to estimate historical PCB exposures for workers (n?=?24,865) exposed to PCBs from 1938 to 1978 at three capacitor manufacturing plants. A subcohort of these workers (n?=?410) employed in two of these plants had serum PCB concentrations measured at up to four times between 1976 and 1989. Our objectives were to evaluate the strength of association between an individual worker’s measured serum PCB levels and the same worker’s cumulative exposure estimated through 1977 with the (1) JEM and (2) duration of employment, and to calculate the explained variance the JEM provides for serum PCB levels using (3) simple linear regression. Consistent strong and statistically significant associations were observed between the cumulative exposures estimated with the JEM and serum PCB concentrations for all years. The strength of association between duration of employment and serum PCBs was good for highly chlorinated (Aroclor 1254/HPCB) but not less chlorinated (Aroclor 1242/LPCB) PCBs. In the simple regression models, cumulative occupational exposure estimated using the JEMs explained 14–24 % of the variance of the Aroclor 1242/LPCB and 22–39 % for Aroclor 1254/HPCB serum concentrations. We regard the cumulative exposure estimated with the JEM as a better estimate of PCB body burdens than serum concentrations quantified as Aroclor 1242/LPCB and Aroclor 1254/HPCB.     

Engaging stakeholders in an adaptation process: governance and institutional arrangements in heat-health policy development in Adelaide, Australia

Record breaking heat waves have been recorded in Adelaide, Australia in recent years and climate change would likely increase the frequency, duration and severity of heat waves. This paper describes the governance and institutional arrangements during the development of an adaptation strategy (herein referred to as heat-health policy) for heat waves in Adelaide, Australia. In-depth, semi-structured interviews were conducted between June and August 2011 among 18 stakeholders who were involved in the participatory process during the development of the heat-health policy. Informed consent was obtained and interviews were recorded, transcribed verbatim and the data analysed using framework analysis. Interview data were supplemented by data gathered through a review of documents associated with the process. The results found that the process of developing the heat-health policy was initiated by the state government and comprised of stakeholders from both the state and non-state sectors. There was a high level of leadership and political commitment demonstrated during the process, given that the different players wanted a policy to be in place before any future heat wave. A Steering Committee was established that provided coordination and oversight in addition to the Emergency Management Act within the state which provided the legislative framework during the heat-health policy development process. Although the decision-making authority was controlled by a controlled by a public institution, to a larger extent, there was collaborative decision-making by virtue of the context in which the heat-health policy was developed. An assurance mechanism established during the process was among the factors that ensured accountability during the participatory process. Overall, the development of the heat-health policy in Adelaide was largely successful, attributed to the extent of political commitment from the state government and the sound institutional and legislative framework that facilitated the process. Good governance and institutional arrangements provide the enabling environment, the structures, systems and resources that would facilitate the development of adaptation strategies such as heat-health policies.     

Use of Small-area Data to Support a Community Agenda in Boston Chinatown

Boston Chinatown is a community that grapples with a constant pressure from the downtown area to build new and larger buildings. The effort to preserve the residential aspect of Chinatown has used data analysis in recent years by forming partnerships with academics. This has allowed for more sophisticated studies of traffic injuries, scientific surveys of residents about environmental health, the measurement of noise levels and the construction of physical and electronic mapping of data. While not the only factor contributing to the community's efforts to question the role of development, these data have added useful tools that reduce, but do not eliminate, the disparity between what the community brings to discussions about the environmental impact of development and what the developers have at their disposal.     

IMPERVIOUSNESS: A PERFORMANCE MEASURE OF A DELAWARE WATER RESOURCE PROTECTION AREA ORDINANCE1

ABSTRACT: The New Castle County Resource Protection Area Technical Advisory Committee (RPATAC) requested that the University of Delaware utilize impervious cover estimates to evaluate the performance of the Water Resource Protection Area (WRPA) ordinance. This 1991 ordinance was the first in Delaware to protect the quantity and quality of drinking water supplies by limiting new development in WRPAs ‐ such as areas of ground water recharge, wellhead protection, drainage above reservoirs (reservoir watersheds), and limestone aquifers ‐ to a maximum 20 percent impervious cover. The research used geographic information system (GIS) techniques to evaluate the effectiveness of the ordinance in attaining its objective. The analysis indicated that 138 new developments were proposed in WRPAs since the ordinance was approved in 1991. The composite impervious cover of the 231 square kilometers of WRPAs in New Castle County is 15 percent, less than the 20 percent code requirement, ranging from 7 percent in recharge areas to 41 percent in several wellhead protection areas. To further protect drinking water supplies, the study results indicate, New Castle County should discourage code variances for applications in the more developed WRPAs, those where impervious cover already exceeds 20 percent, and should acquire parks and open space to protect the healthier WRPAs where impervious cover is currently less than 20 percent.