Nylon recovery from carpet waste through pyrolysis under the presence of zinc oxide and the roll-milling treatment

Recycling of carpet waste is not extensively carried out because of its complex combination of materials. A representative type of carpet consists of three layers: nylon fibers, adhesives, and backing materials made of poly(vinyl chloride), PVC. Thermal treatment of carpet waste, thus, leads to the emission of hazardous chlorinated compounds. In the present work, we have employed the one-directional thermal treatment of the backing materials under the presence of zinc oxide, which promotes the thermal degradation of PVC. Nylon fibers could be effectively recovered by the consequent milling treatment from the brittle backing materials. The influence of process parameters, such as pyrolysis temperature and reaction time, on the separation efficiency is discussed.     

Field monitoring of volatile organic compounds using passive air samplers in an industrial city in Japan

Highly portable, sensitive, and selective passive air samplers were used to investigate ambient volatile organic compound (VOC) levels at multiple sampling sites in an industrial city, Fuji, Japan. We determined the spatial distributions of 27 species of VOCs in three campaigns: Mar (cold season), May (warm season), and Nov (mild season) of 2004. In all campaigns, toluene (geometric mean concentration, 14.0microg/m3) was the most abundant VOC, followed by acetaldehyde (4.76microg/m3), and formaldehyde (2.58microg/m3). The spatial distributions for certain VOCs showed characteristic patterns: high concentrations of benzene and formaldehyde were typically found along major roads, whereas high concentrations of toluene and tetrachloroethylene (PCE) were usually found near factories. The spatial distribution of PCE observed was extremely consistent with the diffusion pattern calculated from Pollutant Release and Transfer Register data and meteorological data, indicated that passive air samplers are useful for determining the sources and distributions of ambient VOCs.     

Thermodynamic behavior of rare metals in the melting process of municipal solid waste (MSW) incineration residues

This study aims to identify the thermodynamic behavior of rare metal elements during the melting process of municipal solid waste incineration residues. The fate of several selected rare metal elements was investigated using two approaches: experimental and thermodynamic equilibrium calculation at two actual melting plants. The results revealed that Ag, Bi, Ga, Ge, In, Pd, Sb, Te, and Tl are readily volatilized as chloride and/or gaseous forms and then condensed in melting furnace fly ash. On the other hand, Cr, Ni, Ta, V, and Zr tend to mostly remain in molten slag. Sn is volatilized as SnS (g) under reducing conditions while volatilization is suppressed under oxidizing conditions. Thermodynamically, total volatilization of Mn as MnCl2 (g) occurred with highly available chlorine under oxidizing conditions. However, at the actual plants, only a small proportion was volatilized. As for Co, Mo, and W, no volatilization occurred at the actual plants although the calculations suggest that these elements can form volatile metal chloride and volatilize. Non-equilibrium and heterogeneity of the actual plant melting furnace could explain the discrepancy. This study provided a good qualitative view of the behavior of rare metals in the melting process, but further investigation is required to produce a more accurate simulation and to resolve the discrepancy.     

Estrogen equivalent concentration of 13 branched para-nonylphenols in three technical mixtures by isomer-specific determination using their synthetic standards in SIM mode with GC-MS and two new diasteromeric isomers

Thirteen isomers of branched para-nonylphenols (para-NP) in three technical mixtures were isomer-specifically determined using their synthesized standards by SIM of structurally specific ions, m/z 135, 149 or 163 with GC–MS. Of the 13 isomers, four isomers, 4-(2,4-dimethylheptan-4-yl)phenol, 4-(4-methyloctan-4-yl)phenol, 4-(3-ethyl-2-methylhexan-2-yl)phenol (3E22NP) and 4-(2,3-dimethylheptan-2-yl)phenol synthesized for their determinations were first used as standard substances. The 13 isomers in the technical mixtures individually occurred at mass percent portion of more than 2%. The total mass percent portions in the mixtures from Tokyo Chemical Industry (TCI), Aldrich, and Fluka covered with 89 ± 2%, 75 ± 4% and 77 ± 2%, respectively. The abundance of 4-(3,6-dimethylheptan-3-yl)phenol in the three mixtures was the largest with 11.1 ± 2% to 9.9 ± 0.3%, while that of 4-(2-methyloctan-2-yl)phenol was the smallest with 2.9 ± 0.3% to 3.0 ± 0.2%. Additionally, structures of four new isomers of more than 1% portion present in a technical mixture were elucidated as two pairs of diastereomeric isomers: two types of 4-(3,4-dimethylheptan-4-yl)phenol (344NP) and those of 4-(3,4-dimethylheptan-3-yl)phenol (343NP). By estrogenic assay of 13 isomers with yeast estrogen screen system, the activity of 3E22NP was the highest, while that of 4-(3-methyloctan-3-yl)phenol was the least. Their relative activities to that of 3E22NP were individually calculated. Estrogenic equivalent concentrations of the three technical mixtures were predictively evaluated. The ratio of the EEC to the conventional concentration, total mass percent portions of the 13 isomers in technical mixtures were 0.208 for TCI, 0.206 for Aldrich and 0.205 for Fluka. The predicted estrogenic activity of measured concentration of para-NP in technical mixtures was approximately 5-fold greater than the measured estrogen agonist activity.     

Separation, synthesis and estrogenic activity of 4-nonylphenols: two sets of new diastereomeric isomers in a commercial mixture

Two sets of new diastereomeric 4-nonylphenol (NP) isomers [4-(3,4-dimethylheptan-4-yl)phenol (344NP, NP-J, L) and 4-(3,4-dimethylheptan-3-yl)phenol (343NP, NP-K, P)] were separated from a commercial NP mixture. The mixture of these diastereomers was synthesized at the same time by a single Friedel-Crafts reaction of 3,4-dimethyl-4-heptanol and phenol, and the mixture was separated into individual NPs by HPLC equipped with Hypercarb column. For the first time, in this study the stereostructure-estrogenic activity relationship of NP diastereomers was investigated. The NP isomers (NP-L and NP-P) having the beta-methyl group over the benzene ring were found to be 2-4 times more estrogenic than their diastereomers (NP-J and NP-K). In the case of the other set of diastereomer [4-(3,5-dimethylheptan-3-yl)phenol, (353NP, NP-E, G)] containing gamma-methyl group in the molecule, the gamma-methyl proton signal (delta 0.49) in the more estrogenic isomer (NP-G) also appeared in a higher field than the corresponding methyl signal (delta 0.76) of the less estrogenic isomer (NP-E).     

Assessment of current status of zinc in wastewater treatment plants to set effluent standards for protecting aquatic organisms in Japan

New environmental standards for protecting aquatic organisms for zinc (e.g., 0.03 mg/L) in surface waters were set in Japan in 2003. Although wastewater effluent might be one of the major pathways of zinc to public water bodies in Japan, current status of concentration of zinc in wastewater effluent was not clear due to higher detection limits (e.g., 0.5 mg/L) than the level required by the new regulations. This study aims at assessing current status of zinc in wastewater effluent in Japan to revise wastewater effluent standards for protecting aquatic organisms. Survey of zinc in wastewater treatment plants (WWTPs) was carried out in Japan in 2005, setting the detection limits at least 0.01 mg/L. The results of the survey suggested the difficulty to remove zinc (especially dissolved zinc) with conventional activated sludge treatment if concentration of zinc in influent was relatively low. And it was suggested that high concentration of dissolved zinc might be derived from some industries discharging high concentration of zinc. The concentration of zinc in wastewater influent without industrial discharges was about 0.1 mg/L which might be lower than that in wastewater from industries discharging high concentration of zinc. Finally, effluent standards for point sources including WWTPs to public water bodies were set at 2 mg/L in 2006. Based on the results of the survey that it was difficult to remove dissolved zinc discharged from industries at WWTPs, the effluent standards from industries to sewerage were set at the same value of the effluent standards from WWTPs to public water bodies.     

An estimate of the conversion rates of SO2 to SO2-4 and NO2 to HNO3+ NO3- for the evaluation air pollution in Beijing

The conversion rates of SO₂ to SO^2-₄ and NO₂ to HNO₃₊NO₃- are estimated from the field-data obtained in Beijing in summer, 1988. The results show that the conversion rate of NO₂ is about four times as much as that of SO₂; The conversion rates have a diurnal variation in a day. On the average, the rate of SO₂ is estimated to be 4.7% h^-1 during the daytime and 3.4% h^-1 during the nighttime. Similarly, the rate of NO₂ is estimated to be 17.2% h^-1 and 12% h^-1 respectively.     

Effects of wastewater disinfection on waterborne bacteria and viruses.

Wastewater disinfection is practiced with the goal of reducing risks of human exposure to pathogenic microorganisms. In most circumstances, the efficacy of a wastewater disinfection process is regulated and monitored based on measurements of the responses of indicator bacteria. However, inactivation of indicator bacteria does not guarantee an acceptable degree of inactivation among other waterborne microorganisms (e.g., microbial pathogens). Undisinfected effluent samples from several municipal wastewater treatment facilities were collected for analysis. Facilities were selected to provide a broad spectrum of effluent quality, particularly as related to nitrogenous compounds. Samples were subjected to bench-scale chlorination and dechlorination and UV irradiation under conditions that allowed compliance with relevant discharge regulations and such that disinfectant exposures could be accurately quantified. Disinfected samples were subjected to a battery of assays to assess the immediate and long-term effects of wastewater disinfection on waterborne bacteria and viruses. In general, (viable) bacterial populations showed an immediate decline as a result of disinfectant exposure; however, incubation of disinfected samples under conditions that were designed to mimic the conditions in a receiving stream resulted in substantial recovery of the total bacterial community. The bacterial groups that are commonly used as indicators do not provide an accurate representation of the response of the bacterial community to disinfectant exposure and subsequent recovery in the environment. UV irradiation and chlorination/dechlorination both accomplished measurable inactivation of indigenous phage; however, the extent of inactivation was fairly modest under the conditions of disinfection used in this study. UV irradiation was consistently more effective as a virucide than chlorination/dechlorination under the conditions of application, based on measurements of virus (phage) diversity and concentration. Taken together, and when considered in conjunction with previously published research, the results of these experiments illustrate several important limitations of common disinfection processes as applied in the treatment of municipal wastewaters. In general, it is not clear that conventional disinfection processes, as commonly implemented, are effective for control of the risks of disease transmission, particularly those associated with viral pathogens. Microbial quality in receiving streams may not be substantially improved by the application of these disinfection processes; under some circumstances, an argument can be made that disinfection may actually yield a decrease in effluent and receiving water quality. Decisions regarding the need for effluent disinfection must account for site-specific characteristics, but it is not clear that disinfection of municipal wastewater effluents is necessary or beneficial for all facilities. When direct human contact or ingestion of municipal wastewater effluents is likely, disinfection may be necessary. Under these circumstances, UV irradiation appears to be superior to chlorination in terms of microbial quality and chemistry and toxicology. This advantage is particularly evident in effluents that contain appreciable quantities of ammonia-nitrogen or organic nitrogen.     

Prediction of physico-chemical properties for PCs/DFs using the UNIFAC model with an alternative approximation for group assignment

The original-type UNIFAC model was used to predict the environmentally important physico-chemical properties of PCDDs/DFs, such as aqueous solubility, Henry's law constant, and 1-octanol/water partition coefficient, through the UNIFAC-derived infinite dilution activity coefficient. In this application, we suggest an alternative approximation that the aromatic ether group AC-O in PCDD/DF molecules is replaced with the aliphatic ether group CH-O, because the AC-O group is not available in the conventional UNIFAC model. With this approximation, the ability of the UNIFAC model to predict those properties was examined by comparing with experimental data. The UNIFAC model provided comparatively good estimation results. From these results, it is shown that the alternative approximation is useful for the UNIFAC estimation of physico-chemical properties for PCDDs/DFs. Furthermore, the predicted solubilities of 2,3,7,8-T4CDD and O8CDD in organic solvents and the co-solvency effect on solubility of PCDDs in methanol/water mixture indicate that the UNIFAC calculation presented here could well predict the physico-chemical properties of PCDDs/DFs in various solution conditions.     

Effect of dissolved humic matters on the leachability of PCDD/F from fly ash--laboratory experiment using Aldrich humic acid

The effect of dissolved humic matters (DHM) on the leachability of polychlorinated dibenzo-p-dioxins and polychlorinated dibenzofurans (PCDD/F) in fly ash was studied theoretically and in laboratorial condition to verify the previous results for pilot and field experiment of incineration residues landfill. In theoretical review, it was shown that DHM could influence the actual solubility and leachability of PCDD/F. The higher concentration of DHM showed the higher leachability of PCDD/F. In the leaching test, three different DHM concentrations and pHs of solutions were adopted to fly ash samples imaging the various characteristics of municipal solid waste leachate. It was proved experimentally that the leachability of PCDD/F increased with increasing DHM concentration in all pH conditions. The highest leachability was shown at the highest pH. Isomer distribution patterns of PCDD/F in all leachates were similar in all pH conditions. It backed up the distribution theory of PCDD/F between DHM and water.