Clean fuels from municipal solid waste for fuel cell buses in metropolitan areas

Increasing volumes of municipal solid waste (MSW) pose disposal problems for many cities. Costs are rising as landfilling becomes more difficult. The production of clean transportation fuels (methanol or hydrogen) from MSW is one economically and environmentally promising option for dealing with these problems. An attractive feature is that elimination of essentially all air pollutant emissions is inherent in the process. Current and future air emissions standards should be easily met. Methanol or hydrogen used in fuel cell vehicles (FCV) can help address problems of deteriorating urban air quality due to vehicle pollution and heavy dependence of the transport sector on imported petroleum. Buses are initial targets for commercial application of fuel cells. Coupled with FCVs, MSW could become a major transportation energy resource. For example, less than 25% of New York City's MSW supply would be sufficient to produce the methanol or hydrogen needed to fuel the entire city's bus fleet, if the buses were fuel cell powered. Estimated breakeven tipping fees required for hydrogen or methanol from MSW to compete with the cost of these fuels made from natural gas today are $52 to $89/raw tonne MSW for hydrogen and $64 to $104/raw tonne MSW for methanol (in 1991$), depending on the gasification technology considered. For comparison, the average tipping fee today in New York City is $74/tonne (1991$). Because of the high fuel economies expected for fuel cell buses, total lifecycle costs per bus-km could be lower than for conventional diesel-engine buses.     

RESPONSE OF BACTERIA TO THE PRESENCE OF CARBARYL IN WATER. I. RESPONSE OF BACTERIAL INDICATORS VS. RESPONSE OF PATHOGENIC BACTERIAL SPECIES1

ABSTRACT: Escherichia coli, Streptococcus faecalis, Salmonella typhimurium, and Staphylococcus aureus were tested by plate counts and Warburg respirometry to determine effects of the presence of carbaryl in water. E. coli and S. typhimurium were initially stimulated in the presence of the insecticide whereas S. faecalis and S. aureus were inhibited. Over a period of days, all bacteria died off more rapidly in the presence of carbaryl. The implications of these data in regards to bacteriological testing of water quality are discussed.     

Basic hydrologic studies for assessing impacts of flow diversions on riparian vegetation: Examples from streams of the eastern Sierra Nevada,California, USA

As the number of proposals to divert streamflow for power production has increased in recent years, interest has grown in predicting the impacts of flow reductions on riparian vegetation. Because the extent and density of riparian vegetation depend largely on local geomorphic and hydrologic setting, site-specific geomorphic and hydrologic information is needed. This article describes methods for collecting relevant hydrologic data, and reports the results of such studies on seven stream reaches proposed for hydroelectric development in the eastern Sierra Nevada, California, USA. The methods described are: (a) preparing geomorphic maps from aerial photographs, (b) using well level records to evaluate the influence of streamflow on the riparian water table, (c) taking synoptic flow measurements to identify gaining and losing reaches, and (d) analyzing flow records from an upstream-downstream pair of gages to document seasonal variations in downstream flow losses. In the eastern Sierra Nevada, the geomorphic influences on hydrology and riparian vegetation were pronounced. For example, in a large, U-shaped glacial valley, the width of the riparian strip was highly variable along the study reach and was related to geomorphic controls, whereas the study reaches on alluvial fan deposits had relatively uniform geomorphology and riparian strip width. Flow losses of 20% were typical over reaches on alluvial fans. In a mountain valley, however, one stream gained up to 275% from geomorphically controlled groundwater contributions.     

Microbial pyrite removal from hard coal

Thiobacilli may either attack coal-contained pyrite directly or contribute to its oxidation via catalysing the oxidation of ferrous salts by oxygen dissolved in water. The part played by either of the above mechanisms during pyrite removal from hard coals is discussed. This is followed by a review of experiments meant to identify the influence of coal rank, grain size, pyrite genesis and content, on pyrite removal efficiency over time. The paper reports on experiments to determine the seepage rate of the nutritive solution with bacteria, termed “biopulp”, in coal heaps. Investigations into the alteration of coal properties due to pyrite removal are dealt with. Concluding, plant dimensions and the costs of pyrite removal, as derived from two designs of relevant plants, are presented.     

Thio arsenosugars in freshwater mussels from the Danube in Hungary

In contrast to the large body of data on naturally-occurring arsenic compounds in marine organisms, relatively little is known about arsenic speciation in freshwater biota. We report an investigation using HPLC-ICPMS into the arsenic compounds in five species of freshwater mussels collected from five sites from the Danube in Hungary. Total arsenic concentrations in the mussels ranged from 3.8-12.8 mg As kg(-1). The arsenic speciation patterns were broadly similar for mussels representing each of the five species and five sites, but quite different from those reported for marine mussels. The major extractable arsenicals were two oxo arsenosugars (glycerol sugar and phosphate sugar), and their thio analogues (thio glycerol sugar and thio phosphate sugar). Arsenobetaine, usually the major arsenical in marine organisms, was not a significant compound in the freshwater mussels and was detected in only three of the 11 samples. This is the first report of thio arsenosugars in freshwater biota and suggests that these compounds may be common and widespread naturally-occurring arsenicals.     

臭氧和好氧生物法处理污水处理厂出水的纳米过滤浓缩液

城市污水处理厂出水的纳米过滤浓缩液较难直接生物处理。臭氧氧化该浓缩液降低DOC的速度较慢,但是可以有效地破坏该浓缩液中含苯环和有色基团的大分子有机物,显著增加小分子有机物的相对含量,从而增大其可生化降解性能。研究发现臭氧的投量为52mg/L左右时,臭氧化改善该纳米过滤浓缩液的可生化降解性能的效果最佳。     

Composites Produced from Natural Rubber and Chrome-Tanned Leather Wastes: Evaluation of their In Vitro Toxicological Effects for Application in Footwear and Textile Industries

A new composite has been developed from natural rubber and chrome-tanned leather waste for use in footwear and textile industries. The contribution of this material to environmental quality and sustained development should be highligh because chrome tanned leather wastes, a major environmental problem, can be recycled. However, the safety of this new material for human use is questionable, as it is already well reported in the literature that chromium, particularly in its hexavalent oxidation state, can be genotoxic and carcinogenic to living beings. Thus, the aim of this study was to evaluate in vitro biocompatibility of this composite material for possible use in the footwear and textile industries, through cytotoxicity, cell adhesion, and genotoxicity tests. Inductively coupled plasma optical emission spectrometry (ICP-OES) was used to measure both concentrations of total and hexavalent chromium. Based on the findings, it was concluded that the composite exhibits low levels of cytotoxicity and genotoxicity, and possesses favorable properties for initial cell adhesion. Furthermore, it was verified that the composites released low concentrations of chromium and that the predominant species released would be trivalent chromium. The results of the present study open the possibility of the incorporation of solid residues of tanned leather into chromium without necessarily the chromium contained in these residues influences the toxicity and genotoxicity of this new material.     

Trends of PCDD/F and PCB concentrations and depositions in ambient air in Northwestern Germany

Time series of polychlorinated dioxins and furans (PCDD/F) and polychlorinated biphenyls (PCB) in ambient air of a large conurbation in North-Western Germany are presented and analyzed. The trend of PCDD/F concentrations, starting from as early as 1988, shows a pronounced decrease by at least one order of magnitude, demonstrating that the emission reductions were effective. The PCDD/F depositions also have decreased by a factor of 5 since 1992. However, both trends have leveled out since 2005. Time series of PCB concentrations and depositions starting in 1994 show only slight decreases for the concentrations and almost no decrease for the depositions. From the decay rates following first order kinetics, half-lives in the order of 5-15 years for the PCDD/F and 15-31 years for the sum of the six indicator PCB could be calculated, which are much longer than the half-lives estimated from their reactivity towards the OH radical. Apparently, small fresh emissions (PCDD/F), considerable secondary emissions and evaporation from contaminated soils slow down their decay in the atmosphere of big conurbations. Analyzing the decay rates of individual PCB congeners shows that the lower chlorinated and more volatile ones are removed faster than the higher chlorinated congeners, probably via gas phase reactions with the OH radical. It can be concluded from the present study that the input of PCDD/F and PCB into the food chain via the air path will continue for another one or two decades in big conurbations.     

Fog as a Fresh-Water Resource: Overview and Perspectives

The collection of fog water is a simple and sustainable technology to obtain fresh water for afforestation, gardening, and as a drinking water source for human and animal consumption. In regions where fresh water is sparse and fog frequently occurs, it is feasible to set up a passive mesh system for fog water collection. The mesh is directly exposed to the atmosphere, and the foggy air is pushed through the mesh by the wind. Fog droplets are deposited on the mesh, combine to form larger droplets, and run down passing into a storage tank. Fog water collection rates vary dramatically from site to site but yearly averages from 3 to 10 l m⁻² of mesh per day are typical of operational projects. The scope of this article is to review fog collection projects worldwide, to analyze factors of success, and to evaluate the prospects of this technology.