Diurnal photosynthesis, water use efficiency and light use efficiency of wheat under Mediterranean field conditions

Photosynthesis and transpiration rates of wheat leaves (Triticum aestivum L.) were measured at 30 min intervals under Mediterranean field conditions, using Photosynthesis Monitor system (PM-48M). The dynamics of net photosynthetic rate (P(N)), transpiration rate (E(T)), water use efficiency (WUE), light use efficiency (LUE), stomatal conductance (g(s)), photosynthetically active radiation (PAR), air temperature (T), relative humidity (RH), and atmospheric CO2 concentration (Catm) were quantified at five rainfed wheat sites with the same stages of development (midflowering) along south-to-north and east-to-west transects for eight days in April. Diurnal P(N) (3.6 to 6.6 micromol m(-2) s(-1)), PAR (392 to 564 micromol m2 sec(-1)), LUE (0.006 to 0.015) and WUE (0.0001 to 0.011) did not vary significantly across all five wheat sites (p > 0.05). P(N) and E(T) were strongly coupled and highly correlated with PAR (p < 0.001). Best multiple linear regression (MLR) models accounted for 92% of variations in P(N) as a function of PAR and E(T), and 90% in E(T) as a function of PAR and RH (p < 0.001). P(N) exhibited a peak at mid-morning, and a photosynthetic midday depression under the limiting effects of high evaporative demand. Diurnal variations in WUE and LUE showed a bimodal behavior with the maximum values in early morning and late afternoon. As the impacts of global climate change become increasingly felt, continuous measurements of climate-crop-soil-managementinteractions under natural conditions play a pivotal role not only in exploring changes in ecophysiological properties of strategic crops for food security such as wheat but also in devising preventive and mitigative management practices to ensure sustained agricultural productivity.     

Characterization of soil erosion and its implication to forest management

Forests have traditionally been managed to maximize timber production or economic profit, completely neglecting other forest values. Nowadays, however, forests are being managed for multiple uses. The basic requirement of multiple use forestry is to identify and quantify forest values and to determine management objectives. The priorities of management objectives, however, must be decided. In this study, a model predicting the soil loss for multi objective forest management was developed. The model was based on data from remeasurement of permanent sample plots. The data were gathered from 132 sample plots. Approximately 80% of the observations were used for model development and 20% for validation. The model was designed for even aged and uneven aged forests, as well as for forests with mixed and pure species composition. The explicatory variables in the model were mean diameter and number of trees. All parameter estimates were found highly significant (p < 0.001) in predicting soil loss. The model fit and validation tests were fairly good. The soil loss model presented in this paper was considered to have an appropriate level of reliability. It can be used in the overall multi-objective forest management planning, but, it should be limited to the conditions for which the data were gathered.     

Teil II: Analytik von Toxaphenrückst?nden (UWSF 2/1998)

Zusammenfassung  Die Rückstandsanalytik des Insektizides Toxaphen galt früher als problematisch wegen der gro?en Anzahl an Komponenten mit ?hnlicher Struktur und unterschiedlichem Chlorgehalt. Erschwerend kam hinzu, da? die Zusamensetzung von Toxaphenrückst?nden in Umweltproben sich von der des technischen Standards signifikant unterscheidet. Deshalb war die Quantifizierung einzelner Komponenten früher nicht m?glich. Seit jedoch eine ganze Reihe von Toxaphenkomponenten in ausreichenden Mengen isoliert wurden, von denen einige für Umweltproben repr?sentativ sind, besteht die M?glichkeit, Toxaphenrückst?nde in Umweltkompartimenten zuverl?ssig zu bestimmen. In der letzten Zeit konzentriert sich die Entwicklung vor allem auf die Trennung der chiralen Bestandteile des Gemisches, um anhand der Zusammensetzung der Rückst?nde Verteilungswege und Abbaumechanismen besser identifizieren zu k?nnen.

---

Residue analysis of toxaphene has been difficult because of the complexicity of the technical mixture consisting of a high number of compounds with very similar structure and differing chloro content. Furthermore, the composition of toxaphene in environmental samples varies widely and is normally not like that of the technical mixture. Therefore, quantification of single components in environmental samples was impossible. After the isolation and identification of a great number of components during the last decade, enough standards are available for reliable quantification of toxaphene in all environmental compartments. Recently, most research has been done on the separation of chiral components of toxaphene with a view to identify degradation mechanisms and distribution pathways.

     

The occurrence and environmental effect of persistent organic pollutants (POPs) in Taurus Mountains soils

Purpose  

Persistent organic pollutants (POPs) are of global concern due to their ubiquitous presence and toxicity. The occurence of polychlorinated dibenzo-p-dioxins (PCDDs), -dibenzofurans (PCDFs), co-planar biphenyls (PCBs), hexachlorocyclohexanes (HCH), dichlorodiphenyltrichloroethanes (DDT), and organochlorine pesticides (OCPs) in forest soil collected from Taurus mountains may have adverse effects on the environment and health. The aim of the study was to investigate the outcome and distribution of POPs in the environment and the possible grasshopper effect along an altitude transect from sea level up to nearly 2,000 m a.s.l at a spatial distance of about 60 km in the southeastern Turkish Mediterranean Sea.     

Assessment of imidacloprid toxicity on reproductive organ system of adult male rats

In the current study it was aimed to investigate the toxicity of low doses of imidacloprid (IMI) on the reproductive organ systems of adult male rats. The treatment groups received 0.5 (IMI-0.5), 2 (IMI-2) or 8 mg IMI/kg body weight by oral gavage (IMI-8) for three months. The deterioration in sperm motility in IMI-8 group and epidydimal sperm concentration in IMI-2 and IMI-8 groups and abnormality in sperm morphology in IMI-8 were significant. The levels of testosterone (T) and GSH decreased significantly in group IMI-8 compared to the control group. Upon treatment with IMI, apoptotic index increased significantly only in germ cells of the seminiferous tubules of IMI-8 group when compared to control. Fragmentation was striking in the seminal DNA from the IMI-8 group, but it was much less obvious in the IMI-2 one. IMI exposure resulted in elevation of all fatty acids analyzed, but the increases were significant only in stearic, oleic, linoleic and arachidonic acids. The ratios of 20:4/20:3 and 20:4/18:2 were decreased and 16:1n-9/16:0 ratio was increased. In conclusion, the present animal experiments revealed that the treatment with IMI at NOAEL dose-levels caused deterioration in sperm parameters, decreased T level, increased apoptosis of germ cells, seminal DNA fragmentation, the depletion of antioxidants and change in disturbance of fatty acid composition. All these changes indicate the suppression of testicular function.     

Major air pollutants in Bursa,Turkey: their levels,temporal changes,interactions, and sources

Bursa is one of the largest cities of Turkey and it hosts 17 organized industrial zones. Parallel to the increase in population, rapidly growing energy consumption, and increased numbers of transport vehicles have impacts on the air quality of the city. In this study, regularly calibrated automatic samplers were employed to get the levels of air pollution in Bursa. The concentrations of CH₄ and N-CH₄ as well as the major air pollutants including PM₁₀, PM_2.5, NO, NO₂, NO_x, SO₂, CO, and O₃, were determined for 2016 and 2017 calendar years. Their levels were 1641.62?±?718.25, 33.11?±?5.45, 42.10?±?10.09, 26.41?±?9.01, 19.47?±?16.51, 46.73?±?16.56, 66.23?±?32.265, 7.60?±?3.43, 659.397?±?192.73, and 51.92?±?25.63 µg/m³ for 2016, respectively. Except for O₃, seasonal concentrations were higher in winter and autumn for both years. O₃, CO, and SO₂ had never exceeded the limit values specified in the regulations yet PM₁₀, PM_2.5, and NO₂ had violated the limits in some days. The ratios of CO/NO_x, SO₂/NO_x, and PM_2.5/PM₁₀ were examined to characterize the emission sources. Generally, domestic and industrial emissions were dominated in the fall and winter seasons, yet traffic emissions were effective in spring and summer seasons. As a result of the correlation process between O_x and NO_x, it was concluded that the most important source of O_x concentrations in winter was NO_x and O₃ was in summer.     

Valorization of spent coffee grounds recycling as a potential alternative fuel resource in Turkey: An experimental study

In this study, recycling of spent coffee grounds (SCG) as a potential feedstock for alternative fuel production and compounds of added value in Turkey was assessed. The average oil content was found (≈ 13% w/w). All samples (before and after extraction) were tested for scanning electron microscopy (SEM), differential scanning calorimetry (DSC), thermogravimetric analysis (TGA), X-ray diffraction (XRD), calorific value, surface analysis and porosity, Fourier transform infrared (FT-IR), and elemental analysis to assess their potential towards fuel properties. Elemental analysis indicated that carbon represents the highest percentages (49.59% and 46.42%, respectively), followed by nitrogen (16.7% and 15.5%), hydrogen (6.74% and 6.04%), and sulfur (0.851% and 0.561%). These results indicate that SCG can be utilized as compost, as it is rich in nitrogen. Properties of the extracted oil were examined, followed by biodiesel production. The quality of biodiesel was compared with American Society for Testing and Materials (ASTM) D6751 standards, and all the properties complied with standard specifications. The fatty acid compositions were analyzed by gas chromatography. It was observed that coffee waste methyl ester (CWME) is mainly composed of palmitic (35.8%) and arachidic (44.6%) acids, which are saturated fatty acids. The low degree of unsaturation provides an excellent oxidation stability (10.4 hr). CWME has also excellent cetane number, higher heating value, and iodine value with poor cold flow properties. The studies also investigated blending of biodiesel with Euro diesel and butanol. Following this, a remarkable improvement in cloud and pour points of biodiesel was obtained. Spent coffee grounds after oil extraction is an ideal material for garden fertilizer, feedstock for ethanol, biogas production, and as fuel pellets. The outcome of such research work produces valuable insights on the recycling importance of SCG in Turkey.

Implications: Coffee is a huge industry, and coffee has been widely used due to its refreshing properties. This industry generates large quantities of waste. Therefore, recycling of spent coffee grounds for producing alternative fuels and compounds of added value is crucial. Elemental analysis indicated that coffee waste can be utilized as compost, as it is rich in nitrogen. Coffee waste after oil extraction is an ideal feedstock for ethanol and biogas production, garden fertilizer, and as fuel pellets. The low degree of unsaturation provides excellent oxidation stability. Its biodiesel has also excellent cetane number, higher heating value, and lower iodine value.     

An integrated methodology for the used product selection problem faced by third-party reverse logistics providers

The rise of electronic commerce and the stricter government regulations on the recovery of end-of-life products increased the number of products returned by customers. A company may deal with increasing product returns by developing its own reverse logistic system. However, high fixed costs associated with dedicated reverse logistics equipment and infrastructure force many companies to outsource their reverse logistics operations to third-party reverse logistics providers. One of the important problems faced by third-party reverse logistics providers is the selection of the types of used products to be collected. In this study, a four-phase used product selection methodology is proposed. First, the quantitative and qualitative selection criteria are determined. Then the weights of the criteria are calculated using fuzzy analytic hierarchy process. Next, simulation models are employed to determine the values of quantitative criteria. Finally, technique for order preference by similarity to ideal solution ranks alternative used product types. A numerical example is also provided in order to present the applicability of the proposed methodology.     

Medical waste management in Turkey: A case study of Istanbul

The objective of this study was to analyze the present status of medical waste management in the light of the Medical Waste Control Regulation (MWCR) in Istanbul, the largest city in Turkey. About 17% of the hospitals, 20% of bed capacity, and 54% of private hospitals in Turkey are located in Istanbul. The first regulation about medical waste management in Turkey was published in 1993, and as a candidate state, it was changed in 2005 in accordance with EU Environmental Directives. In this work, a survey of 14 questions about the amount, collection, and temporary storage of medical wastes was applied to 192 hospitals in Istanbul through face-to-face interviews. It was found that the estimated quantity of medical waste from the hospitals is about 22tons/day and the average generation rate is 0.63kg/bed-day. Recyclable materials are collected separately at a rate of 83%. Separate collection of different types of wastes is consistently practiced, but 25% of the hospitals still use inappropriate containers for medical waste collection. Almost 77% of the hospitals use appropriate equipment for the medical waste collection personnel. The percentage of the hospitals that have temporary storage depots is 63%. Medical waste management in Istanbul is carried out by applying the MWCR.     

Detection of fungal development in closed spaces through the determination of specific chemical targets

In addition to the biodegradation problems encountered in buildings, exposure of their occupants to moulds is responsible for numerous diseases: infections (invasive nosocomial aspergillosis), immediate or delayed allergies, food-borne infections and different types of irritation. In this context, the aim of our work has been to determine specific chemical tracers for fungal development on construction materials. More generally, by detecting a specific chemical fingerprint of fungal development, our objective was to propose a microbiological alert system which could control systems and/or procedures for the microbiological treatment of indoor areas.

We therefore characterized the chemical emissions from six types of construction material contaminated artificially by moulds. Chemical fingerprints were established for 19 compounds arising specifically from fungal metabolism: 2-ethylhexanoic acid methyl ester, 1-octen-3-ol, 3-heptanol, 3-methyl-1-butanol, 2-methyl-1-butanol, 1,3-octadiene, 2-(5H)-furanone, 2-heptene, -pinene, 2-methylisoborneol, 4-heptanone, 2-methylfuran, 3-methylfuran, dimethyldisulfide, methoxybenzene, a terpenoid and three sesquiterpenes.

Determining the origin of these compounds and their specific links with a growth substrate or fungal species made it possible to judge the pertinence of choosing these compounds as tracers.

Thus the detecting specific volatile organic compounds emitted as from the second day of fungal growth demonstrated that this approach had the advantage of detecting fungal development both reliably and rapidly before any visible signs of contamination could be detected.