Physiological mechanisms of a wetland plant (Echinodorus osiris Rataj) to cadmium detoxification

Environmental Science and Pollution Research - Physiological responses of Echinodorus osiris Rataj plant under cadmium (Cd) stress (5 and 15 mg L?1) were studied by...     

Individual and combined inhibition of phenol and thiocyanate on microbial activity of partial nitritation

This study evaluated the individual and interactive effect of phenol and thiocyanate (SCN⁻) on partial nitritation (PN) activity using batch test and response surface methodology. The IC₅₀ of phenol and SCN⁻ on PN sludge were 5.6 and 351 mg L⁻¹, respectively. The PN sludge was insensitive to phenol and SCN⁻ at levels lower than 1.77 and 43.3 mg L⁻¹, respectively. A regression model equation was developed and validated to predict the relative specific respiration rate (RSRR) of PN sludge exposed to different phenol and SCN⁻ concentrations. In the range of independent variables, the most severe inhibition was observed with a valley value (17%) for RSRR, when the phenol and SCN⁻ concentrations were 4.08 and 198 mg L⁻¹, respectively. An isobole plot was used to judge the combined toxicity of phenol and SCN⁻, and the joint inhibitory effect was variable depending on the composition and concentration of the toxic components. Furthermore, the toxic compounds showed independent effects, which is the most common type of combined toxicity.

     

应用带电检测技术对开关柜早期缺陷的诊断

针对高压开关柜早期局部放电缺陷发现率低,故障信号源定性困难,定位准确率差的问题,结合现场实际案例进行分析,提出了基于暂态低电压、特高频和超声波的带电检测方法及幅值定位法和时差定位法的定位技术。应用结果表明:带电检测技术能够在开关柜早期缺陷诊断中发挥重大作用,并有利于设备状态评价与检修工作的开展。     

Characterization of hard- and softwood biochars pyrolyzed at high temperature

A wide range of waste biomass/waste wood feedstocks abundantly available at mine sites provide the opportunity to produce biochars for cost-effective improvement of mine tailings and contaminated land at metal mines. In the present study, soft- and hardwood biochars derived from pine and jarrah woods at high temperature (700 °C) were characterized for their physiochemical properties including chemical components, electrical conductivity, pH, zeta potential, cation-exchange capacity (CEC), alkalinity, BET surface area and surface morphology. Evaluating and comparing these characteristics with available data from the literature have affirmed the strong dictation of precursor type on the physiochemical properties of the biochars. The pine and jarrah wood feedstocks are mainly different in their proportions of cellulose, hemicellulose and lignin, resulting in biochars with heterogeneous physiochemical properties. The hardwood jarrah biochar exhibits much higher microporosity, alkalinity and electrostatic capacity than the softwood pine. Correlation analysis and principal component analysis also show a good correlation between CEC–BET–alkalinity, and alkalinity–ash content. These comprehensive characterization and analysis results on biochars’ properties from feedstocks of hardwood (from forest land clearance at mine construction) and waste pine wood (from mining operations) will provide a good guide for tailoring biochar functionalities for remediating metal mine tailings. The relatively inert high-temperature biochars can be stored for a long term at mine closure after decades of operations.     

Direct methanol fuel cell bubble removal mechanism using magnetic actuation

This article develops a direct methanol fuel cell (DMFC) with a magnet-actuated bubble removal mechanism. A micro-DC motor is used to control the bubble removal mechanism. The lower magnetic device is operated to extrude a Polydimethylsiloxane (PDMS) runner to compress the liquid fuel in the anode flow channel, forcing the CO₂ bubbles in the runner to flow toward the outlet end. The bubble retention in the anode flow channel is thereby improved, enhancing the cell performance. The proposed mechanism stability and performance and Polymethylmethacrylate (PMMA) runner are also discussed.     

水泥窑共处置废物过程中重金属的流向分布

为了探索水泥窑共处置危险废物过程中重金属流向分布规律,研究了不同温度条件下Cr、As、Pb在煅烧熟料、颗粒物和尾气中的残留率。在900、1 000、1 100、1 200、1 300和1 450℃温度条件下,将添加Cr、As和Pb化学试剂的生料分别进行煅烧,模拟重金属在水泥窑内不同温度带的煅烧过程。结果表明,6个温度条件下,Cr主要分布在熟料中并且呈现不规则变化;颗粒物中的Cr在1 200℃条件下分布量最大,所占比例为32.79%(w);在900℃和1450℃条件下,烟气中的Cr分布量最大,所占比例为0.24%(w)。6个温度条件下As主要分布在熟料中并且1 000~1 450℃条件下稳定在81%~83%之间;在900℃条件下,As在熟料中的残留率最大,所占比例为97%(w);在1450℃条件下,As在尾气中的分布达到最大值,所占比例为0.0023%(w)。6个温度条件下,Pb在熟料中的残留率随着温度升高而逐渐减少,挥发颗粒物中的含量呈现相反的趋势;尾气中Pb的含量随着温度的升高逐渐增加。     

PCBs污染土壤的CaO诱导低温热处理脱氯研究

研究了低温热处理脱氯技术对废弃电容器封存点附近污染土壤中多氯联苯脱氯的效果,考察反应温度、反应时间及CaO添加比例对PCBs去除率、脱氯率的影响以及反应前后土壤中污染物的组分变化。实验土样中PCBs浓度为107.7 mg/g,属于罕见高浓度PCBs污染土壤。当反应温度为400℃、停留时间4h、CaO添加比例为10%,PCBs的去除率为87.7%,脱氯率为85.3%。土壤样品中五氯联苯和四氯联苯反应后含量降低或未检出,部分反应后样品检出一氯联苯和联苯,说明在CaO诱导PCBs低温热处理脱氯反应中存在逐步脱氯/加氢反应途径。     

改性丝瓜络纤维对水体日落黄的吸附特性

采用化学改性的方法将丝瓜络制备为阴离子吸附剂,并将其用于水体日落黄(SY)染料的吸附,分别考察了吸附剂的用量、日落黄染料的初始浓度(C0)、p H值、温度(K)、时间(T)5个因素对吸附效果的影响。通过模拟吸附等温曲线、吸附动力学以及热力学方程并通过比表面积(BET)和红外光谱(FTIR)分析改性丝瓜络吸附染料前后和丝瓜络改性前后的变化情况以此探究其吸附机理。结果表明,p H对吸附效果影响不明显;最大吸附量随温度升高而增大,在298 K温度时最大吸附量达到137 mg/g,是未改性丝瓜络的9.78倍。Langmuir方程拟合吸附过程描述最好,吸附类别为化学吸附。吸附过程符合伪二级动力学,是一个自发和吸热的过程。改性丝瓜络可以有效去除水体中的日落黄染料。     

Fe(Ⅱ)EDTA络合吸收-铁粉还原再生脱除NO性能

利用Fe(Ⅱ)EDTA络合吸收-铁粉间歇还原再生脱除NO并回收氨资源的方法,实验研究了铁粉还原再生Fe(Ⅱ)(NO)EDTA的过程及其影响因素。结果表明,以0.015 mol/L的Fe(Ⅱ)EDTA做吸收剂,在起始p H 5.5、温度323K条件下吸收400×10-6~500×10-6的NO,脱除率95%以上;铁粉还原再生Fe(Ⅱ)(NO)EDTA过程可用缩芯模型阐释;铁粉添加量与搅拌强度直接决定了铁粉质点数量,是影响反应的重要因素;实验中Fe(Ⅱ)(NO)EDTA络合液150 m L,氧气含量为5%时,搅拌速度900 r/min、粒径为0.12 mm的铁粉浓度5.3 g/L、温度353 K、p H=6为最适宜再生条件。     

Concentration and health risk evaluation of heavy metals in market-sold vegetables and fishes based on questionnaires in Beijing,China

Concentrations of heavy metals (As, Cd, Pb, Cu, Ni, Fe, Mn, and Zn) in market vegetables and fishes in Beijing, China, are investigated, and their health risk to local consumers is evaluated by calculating the target hazard quotient (THQ). The heavy metal concentrations in vegetables and fishes ranged from not detectable (ND) to 0.21 mg/kg fresh weight (f.w.) (As), ND to 0.10 mg/kg f.w. (Cd), and n.d to 0.57 mg/kg f.w. (Pb), with average concentrations of 0.17, 0.04, and 0.24 mg/kg f.w., respectively. The measured concentrations of As, Cd, Pb, Cu, Ni, Fe, Mn, and Zn are generally lower than the safety limits given by the Chinese regulation safety and quality standards of agriculture products (GB2762-2012). As, Cd, and Pb contaminations are found in vegetables and fishes. The exceeding standard rates are 19 % for As, 3 % for Cd, and 25 % for Pb. Pb contaminations are found quite focused on the fish samples from traditional agri-product markets. The paper further analyzed the health risk of heavy metals in vegetables and fishes respectively from supermarkets and traditional agri-product markets; the results showed that the fishes of traditional agri-product markets have higher health risk, while the supermarkets have vegetables of higher heavy metal risk, and the supervision should be strengthened in the fish supply channels in traditional agri-product markets.