Inputs of chemicals from recreational activities into the Norwegian coastal zone

Wastewater treatment works effluent is often considered to be one of the most important point sources of a wide range of anthropogenic contaminants to aquatic systems, however, this paper discusses other potential sources. With the aim of establishing the important sources of UV filters, insect repellent and biocides to the aquatic environment, samples were collected from sites with direct (bathing areas and marinas) and indirect (sites receiving wastewater effluent) human influences. Sunscreens containing UV filters are used in large volumes during the summer months and often applied shortly before a person enters the water for swimming activities. The results presented here demonstrate that washing directly from the skin is an important point source of 4 UV filters to the Oslofjord. The insect repellent, diethyl toluamide, was also measured and it was concluded that washing from the skin was not such an important point source into the fjord. Concentrations of the biocide Irgarol 1051 were also measured and were elevated in the small boat marina and surrounding enclosed area. This work demonstrates that man recreational water-based activities are a diffuse source of some contaminants into coastal and fjord environments and this study provides an initial assessment of the levels being released.     

Distribution of antifouling biocides in California marinas

Antifouling biocides are used to prevent the settlement and growth of organisms on submerged surfaces. Irgarol 1051 is currently among the most widely used organic booster biocides worldwide. This study reports Irgarol 1051, its major metabolite M1 (aka GS26575), and diuron concentrations found in selected California marinas. Seasonal water samples (n = 46) were collected during the summer and fall of 2006 from eleven marinas throughout Southern and Northern California. The samples were extracted using solid phase extraction and analysed utilizing liquid chromatography tandem mass spectrometry (LC-MS-MS) with electrospray ionization. All three compounds were detected in all samples, representing a 100% frequency of occurrence and indicating widespread use around the sampled marinas. Irgarol concentrations ranged from 12 to 712 ng L(-1) (average 102 ng L(-1)), M1 concentrations were 1-217 ng L(-1) (average 31 ng L(-1)), and diuron concentrations were 5-27 ng L(-1) (average 13 ng L(-1)). In general, concentrations of both Irgarol (15-712 ng L(-1)) and M1 (1-217 ng L(-1)) were greater in samples collected during the summer, corresponding to the peak of the boating season. The detected diuron concentrations in most cases were greater for fall samples (7-27 ng L(-1)), and probably represented a combination of non-agricultural (rights of way) and agricultural applications of diuron in California. The maximum Irgarol concentration detected in California marinas in summer 2006 (712 ng L(-1)) was five times greater than the Irgarol concentration suggested as the plant toxicity benchmark (136 ng L(-1)). Twenty three percent of samples from California marinas in this study exceeded this benchmark, suggesting that detected Irgarol concentrations may be high enough to cause changes in phytoplankton communities in the sampled marinas.     

Spatial variation in soil carbon in the organic layer of managed boreal forest soil—implications for sampling design

We studied within-site spatial variation of the carbon stock in the organic layer of boreal forest soil. A total of 1,006 soil samples were taken in ten forest stands (five Scots pine stands and five Norway spruce stands). Our results indicate that the spatial autocorrelation disappears at a distance of 75-225 cm. This spatial autocorrelation should be taken into account in the sampling design by locating the sampling points at adequate intervals. With a sample size of over 20-30 samples per site, additional soil samples do not notably improve the precision of the site mean estimate. An adequate sample size is dependent on the purpose of sampling and on the site-specific soil variation. Our results on the dependence between sample size and precision of the mean estimates can be applied in designing efficient soil monitoring in boreal coniferous forests.     

Global warming mitigation potential of biogas plants in India

Biogas technology, besides supplying energy and manure, provides an excellent opportunity for mitigation of greenhouse gas (GHG) emission and reducing global warming through substituting firewood for cooking, kerosene for lighting and cooking and chemical fertilizers. A study was undertaken to calculate (1) global warming mitigation potential (GMP) and thereby earning carbon credit of a family size biogas plant in India, (2) GMP of the existing and target biogas plants in the country and (3) atmospheric pollution reduction by a family size biogas plant. The GMP of a family size biogas plant was 9.7 t CO(2) equiv. year( - 1) and with the current price of US $10 t( - 1) CO(2) equiv., carbon credit of US $97 year( - 1) could be earned from such reduction in greenhouse gas emission under the clean development mechanism (CDM). A family size biogas plant substitutes 316 L of kerosene, 5,535 kg firewood and 4,400 kg cattle dung cake as fuels which will reduce emissions of NOx, SO(2), CO and volatile organic compounds to the atmosphere by 16.4, 11.3, 987.0 and 69.7 kg year( - 1), respectively. Presently 3.83 million biogas plants are operating in the country, which can mitigate global warming by 37 Mt CO(2) equiv. year( - 1). Government of India has a target of installing 12.34 million biogas plants by 2010. This target has a GMP of 120 Mt CO(2) equiv. year( - 1) and US $1,197 million as carbon credit under the CDM. However, if all the collectible cattle dung (225 Mt) produced in the country is used, 51.2 million family size biogas plants can be supported which will have a GMP of 496 Mt of CO(2) equiv. year( - 1) and can earn US $4,968 million as carbon credit. The reduction in global warming should encourage policy makers to promote biogas technology to combat climate change and integration of carbon revenues will help the farmers to develop biogas as a profitable activity.     

Multivariate statistical study of seasonal variation of BTEX in the surface water of Savitri River

Volatile organic compounds (VOCs) analysis was carried out for the surface water of the Savitri river during the period of June 2005 to June 2007. BTEX compounds (Benzene, Toluene, Xylene & Ethyl benzene) were analyzed by using micro extraction technique (Purge & Trap). Concentrations of these BTEX compounds were ranging from 0.1 to 1.5 ppm during sampling period. Higher concentrations of BTEX were found at sampling location VI. Concentration of ethyl benzene was very low as compare to other compounds. However, the concentration of benzene was very high. Seasonal variations in conc. of BTEX compounds were observed and higher concentration was detected during the summer season. Salting-out effect had given higher quantification values. In PCA and PFA, the component loading for all the variables are positively correlated. Death of fishes was observed in the river that is indication of severe pollution problem.     

Statistical approaches for hydrogeochemical characterization of groundwater in West Delhi, India

Parametric statistical approaches, correlations and multiple linear regressions were used to develop models for the interpretation of hydrogeochemical parameters in the Western part of Delhi state, India. The hydrogeochemical parameters indicated that the groundwater quality is not safe for consumption. The water is moderately saline and the salinity level is increasing over time. There is also the problem of nitrate pollution. The correlation between electrical conductivity (EC) and other water quality parameters except potassium (K(+)), nitrate (NO(3)(-)) and bicarbonate (HCO(3)(-)) is significantly positive and Ca(++)+ Mg(++)/Na(+)+ K(+) is significantly negative. In predicting EC, the multiple R(2) values of 0.996 and 0.985 indicate that 99.6% and 98.5% variability in the observed EC could be ascribed to the combined effect of Na(+), HCO(3)(-), Cl(-), SO(4)(--), NO(3)(-) and Ca(++)+ Mg(++) for the year of 2005 and 2006 respectively. Out of 99.6% of the variability in EC in 2005, 51.2% was due to Cl(-) alone, and 8.5%, 12.5%, 6.1%, 14.7% and 6.7% were due to Na(+), HCO(3)(-), SO(4)(--), NO(3)(-) and Ca(++) + Mg(++). Similarly in 2006, out of 98.5% of the variability in EC, 48.5% was due to Cl(-) alone, and 10.4%, 12.7%, 5.3%, 17.2% and 4.4% were due to Na(+), HCO(3)(-), SO(4)(--), NO(3)(-) and Ca(++)+ Mg(++). The analysis shows that a good correlation exists between EC, Cl(-) and SO(4)(--) either individually or in combination with other ions and the multiple regression models can predict EC at 5% level of significance.     

A comparison of techniques to sample salamander assemblages along highland streams of Maryland

Amphibians may be useful indicators of biological condition in small streams so determining which sampling technique maximizes encounters at the least cost and at the optimal time of year is important. Area constrained surveys (ACS), used by the Maryland Biological Stream Survey, were tested against cover board surveys, drift fences with pitfall and funnel traps, quadrat leaf litter searches, and leaf litter bags. Sixteen, 100 m-long sites were established in headwater streams in the Savage River State Forest in Garrett County, Maryland. Each technique was randomly assigned to a 25 m stream section within each overall sampling site, and sites were sampled once each month from May to October (2005) with additional sampling in March and April (2006). Area constrained surveys yielded means of 2.7 taxa and 14.9 total individuals per sampling visit, which was significantly higher than the yield of all other methods in all months except October and March, when yields were low for all techniques. Area constrained surveys were also significantly more cost-effective per taxon and per individual compared to all other methods. September produced the most taxa and individuals, October and March produced the least, and yields for April through August were similar to September. We employed removal sampling at four sites in April 2006, but abundance could not be estimated because a significant linear decrease in the accumulated catch versus catch per unit effort did not occur for three of the sites.     

Utilization of statistics based classification approach to investigate water supply profile of Turkey

In the paper water supply profile of Turkey was examined. In this scope, the questionnaire survey conducted by Turkish Statistical Institute in 2004 to investigate annual amount of water abstracted to drinking water networks by type of resources in 81 provinces was evaluated. In the questionnaire, sources were grouped under five categories as spring, (artificial) lake, river, reservoir and well. Due to the complex and multivariate characteristics of the data sets, to replace a large collection of variables with a smaller number of factors the statistical method "factor analysis" was performed. Results revealed that, water supply systems in the country were mainly governed by groundwater sources (well and/or spring). However, in the northeastern part of the country, rivers were allocated for drinking water supply. On the other hand, reservoir dependent cities were densely located in Marmara, Central Anatolia and Southeast Anatolia Regions. This study showed that statistics based classification methods assist decision makers to extract information from multidimensional complex data sets representing environmental conditions.     

Predicting the biological condition of streams: use of geospatial indicators of natural and anthropogenic characteristics of watersheds

We developed and evaluated empirical models to predict biological condition of wadeable streams in a large portion of the eastern USA, with the ultimate goal of prediction for unsampled basins. Previous work had classified (i.e., altered vs. unaltered) the biological condition of 920 streams based on a biological assessment of macroinvertebrate assemblages. Predictor variables were limited to widely available geospatial data, which included land cover, topography, climate, soils, societal infrastructure, and potential hydrologic modification. We compared the accuracy of predictions of biological condition class based on models with continuous and binary responses. We also evaluated the relative importance of specific groups and individual predictor variables, as well as the relationships between the most important predictors and biological condition. Prediction accuracy and the relative importance of predictor variables were different for two subregions for which models were created. Predictive accuracy in the highlands region improved by including predictors that represented both natural and human activities. Riparian land cover and road-stream intersections were the most important predictors. In contrast, predictive accuracy in the lowlands region was best for models limited to predictors representing natural factors, including basin topography and soil properties. Partial dependence plots revealed complex and nonlinear relationships between specific predictors and the probability of biological alteration. We demonstrate a potential application of the model by predicting biological condition in 552 unsampled basins across an ecoregion in southeastern Wisconsin (USA). Estimates of the likelihood of biological condition of unsampled streams could be a valuable tool for screening large numbers of basins to focus targeted monitoring of potentially unaltered or altered stream segments.     

Selection and application of a rainbow trout toxicity testing procedure for screening Sacramento River Watershed, California samples

A number of procedures have been developed to assess toxic effects on the early life stages of salmonid fish. In this study 13 rainbow trout embryo development relatively short-term (7 to 90 day) procedures were reviewed. Three 7-day methods from the published literature and three modifications developed at AQUA-Science (A-S) were evaluated in the laboratory. Based on that evaluation, A-S methods were selected for screening surface water samples (A-S 1) collected in the Sacramento River watershed (California) and for conducting toxicity identification evaluations (TIE) to identify cause(s) of toxicity. Test control performance, test sensitivity, and reference toxicant response variability in the A-S 1 were superior to those in commonly used freshwater toxicity testing methods. The incidence of Sacramento River watershed samples resulting in a notable decrease in embryo development was very low. Of 260 samples screened only 16 (6%) resulted in statistically significant inhibition of embryo development. Of the 16 toxic samples, nine caused minimal (less than 20% abnormal development) and four marginal (less than 30%) toxicity. Samples collected from the agriculture-dominated Colusa Basin Drain and rangeland/forest-dominated Battle Creek on June 16, 2005 caused significant toxicity. TIE procedures indicated that cationic chemicals were the primary cause of toxicity. Metals analysis did not reveal concentrations sufficient to inhibit embryo development, so the most probable cause of toxicity in the two samples was cationic chemicals (perhaps surfactants?) or metals that were not included in the analytical screening.