Cosorption of organic chemicals with different properties: their shared and different sorption sites

Complementary sorption of different chemicals was expected and investigating the relationship between the sorption inhibition of primary sorbate (ΔQ(pri)) and sorption of secondary sorbate (Q(sec)) could provide a new angle to understand coadsorption of different chemicals. This study used bisphenol A (BPA) as the primary adsorbate, sulfamethoxazole (SMX) as the competitor, and carbon nanotubes as model adsorbents to study their complementary and competitive adsorption. At low BPA concentrations, the sorption of SMX (Q(sec)) exceeded BPA sorption inhibition (ΔQ(pri)), indicating that these two chemicals complementarily adsorbed on their respectively preferred sorption sites. At high BPA concentrations, higher ΔQ(pri) was observed in comparison to Q(sec), which may be resulted from different packing efficiencies of the adsorbed SMX and BPA. This study emphasized that both competitive and complementary sorption should be discussed in binary sorption system.     

Biodegradation of high molecular weight PAHs using isolated yeast mixtures: application of meta-genomic methods for community structure analyses

Bioaugmentation for the removal of polyaromatic hydrocarbons (PAHs) from wastewater using bacteria and yeasts is considered environment-friendly and a cost-effective technique. The effectiveness of this biodegradation system depends on the stability of inoculated microorganisms and the availability of nutrients. This study is aimed to investigate the removal of high molecular weight (HMW)-PAHs from biologically treated produced water using different biological systems. Three systems, inoculated with activated sludge (AS), the mixture of five yeast strains (MY), and the mixture of AS and the five yeast strains (SY), respectively, were constructed, and their performance for the removal of HMW-PAHs was compared over 10 weeks. The effluent of the biologically treated produced water from an oilfield was used as the influent after chrysene and benzo(a)pyrene were spiked as HMW-PAHs. Polymerase chain reaction-based denaturing gradient gel electrophoresis (PCR-DGGE) and fluorescent in situ hybridization (FISH) techniques were used to examine the changes in the structures and abundances of the bacterial and yeast communities in these three systems. Only SY and MY systems were capable to remove chrysene (90.7 % and 98.5 %, respectively) and benzo(a)pyrene (80.7 % and 95.2 %, respectively). PCR-DGGE analysis confirmed that all of the five yeast strains inoculated remained in the SY and MY systems, while FISH results showed that the relative abundance of yeast in the SY and MY systems (10.6 % to 21.9 %, respectively) were significantly higher than AS system (2.3 % to 7.8 %, respectively). The relative abundances of the catechol 2,3-dioxygenase (C23O) indicated that the copy number ratios of benzene ring cleavage gene C23O in the yeast amended systems were much higher than that in the AS system. In this study, all of the three systems were effective in removing the low molecular weight (LMW)-PAHs, while HMW-PAHs including chrysene and benzo(a)pyrene were efficiently removed by MY and SY systems, not by AS system. The high HMW-PAHs removal in the MY and SY bioaugmentation systems possibly attributed to the inoculation of the mixed yeast culture. By combining the PCR-DGGE results with the FISH analyses, it was found that yeast probably consisting mainly of the five inoculated strains inhabited in the two bioaugmentation systems as a dominant population. The relatively higher performance of the SY system might be attributed to the suspended growth type which permitted a more efficient contact between microbial cells and contaminants. The bioaugmentation systems (SY and MY) were successfully established by inoculating with five nonindigenous yeast strains and demonstrated high performance in removal of HMW-PAHs.     

垃圾渗滤液发酵产氢和产甲烷特性研究

以实际垃圾渗滤液作为厌氧发酵基质,研究了初始pH为7.0、中温(37℃)条件下的发酵产氢、产甲烷特性。结果表明,利用垃圾渗滤液作为基质发酵产氢或甲烷时,氢气的最大累积产量为24.33mL(以每克COD计,下同),甲烷的最大累积产量为91.59mL,产氢发酵在初期存在明显的迟滞期,但是产甲烷发酵不存在明显迟滞期;产氢发酵的液相末端产物中含有大量的挥发性有机酸和乙醇,乙醇、乙酸、丁酸质量浓度分别为487.23、1 175.21、1 225.78mg/L,相比产氢发酵,产甲烷发酵的液相末端产物中乙醇、乙酸、丁酸质量浓度均较低,分别为256.38、106.73、107.42mg/L;产甲烷发酵的最终pH是6.32,接近中性,而产氢发酵的最终pH为4.21,呈明显酸性;产甲烷发酵对COD的去除率(41.78%)高于产氢发酵对COD的去除率(32.14%),可能是产氢发酵液相末端产物中的乙酸能被产甲烷菌利用,而被进一步降解。     

3种植物对Cd污染农田土壤的修复效果比较试验研究

通过盆栽试验研究了3种植物三叶鬼针草(Bidens pilosa L.)、紫茉莉(Mirabilis Jalapa)、中华景天(Sedum polytrich-oides)对上海地区2种质量浓度(1.2、12.0mg/kg)Cd污染农田土壤的修复效果,以探索其在上海地区Cd污染农田土壤修复中应用的可行性。结果表明:2种浓度下,三叶鬼针草对土壤Cd去除效果均最佳,1.2mg/kg处理下盆中土壤Cd质量浓度由原来的1.249 9mg/kg下降到0.861 7mg/kg,降低0.388 2mg/kg,Cd去除率为31.06%;12.0mg/kg处理下三叶鬼针草盆中土壤Cd质量浓度由原来的12.033 2mg/kg下降到10.020 6mg/kg,降低2.012 6mg/kg,Cd去除率为16.73%;紫茉莉和中华景天相比较而言,修复效果均较差。在2种浓度下,3种植物地上部分生物量排序均为三叶鬼针草>中华景天>紫茉莉。因此,建议将三叶鬼针草作为上海地区Cd污染农田土壤修复的优选植物。     

苦土和氧化镁处理氮磷废水的对比研究

分别采用苦土、纯氧化镁为沉淀剂对模拟高浓度氮磷废水(N/P=0.8)进行了脱氮除磷研究,比较了沉淀剂投加量、pH对2种沉淀剂处理氮磷废水的影响,对沉淀产物进行XRD分析,并进行了经济效益比较。结果表明,pH是影响2种沉淀剂处理氮磷废水的主要因素,随着pH的增加,脱氮除磷效果提高,在平衡pH为9～10之间时氮磷处理效果最佳,pH继续增加,由于磷酸镁沉淀的形成使得氨氮去除率降低。此外,处理相同的废水,苦土的最佳投加量要大于纯氧化镁,但是经济效益比较结果表明,以苦土为沉淀剂处理氮磷废水可大大降低处理成本。     

外源Cd对不同利用方式红壤脲酶活性的影响

采用室内培养实验,通过将外源Cd添加到同一母质、全镉含量相近的不同利用方式的红壤中(林地、水稻土和菜园土),研究了外源Cd污染对不同利用方式红壤脲酶活性的影响。结果表明:整个培养过程中,Cd污染对3种红壤脲酶活性都有抑制作用,且随重金属浓度的增强而增强。同剂量Cd污染对3种红壤脲酶活性的抑制效应不同,大小为林地>水稻土>菜园土。实验设定的Cd处理水平下,对林地、水稻土和菜园土脲酶活性产生显著抑制作用(p<0.05)的Cd浓度分别为5、30和50 mg/kg土。     

某矿区土壤和地下水重金属污染调查与评价

为了解湘南某矿区土壤和地下水重金属污染状况,对该矿区东河流域附近重金属污染源进行了调查,同时,对地下水和土壤样品进行了采样分析,结果表明：（1）该矿区东河流域附近的主要污染源有18个,其中有色金属选厂、尾矿库、采矿场和冶炼厂是排放重金属较多的污染源;（2）20个采样点中土壤重金属Pb、Cd、Zn、As和Hg大部分超过国家土壤环境质量标准（GB15618-1995）,综合污染指数P综〉1,该矿区主要的重金属污染元素为Cd、As和Hg,且土壤中Cd、Zn和As的含量两两之间存在着极显著的正线性相关关系;（3）重金属元素在土壤中的纵向迁移不明显,该矿区附近20个采样点的地下水并未受到污染,综合污染指数P综〈1。20个采样点地下水Pb、Cd、Zn、As、Hg浓度均能达到地下水质量标准（GB／T14848．9）中的Ⅲ类标准。     

Degradation of rizazole in water–sediment systems

This study investigated the degradation of rizazole in water-sediment systems (West Lake system, WL; Beijing–Hangzhou Grand Canal system, BG) with two different types of sediments under aerobic and anaerobic conditions. The half-lives of rizazole in the WL water phase (14.59–15.13 d) were similar to those in the BG water phase (15.90–16.46 d). Within 3–7 d, the rizazole concentration in the sediments reached the maximum values, i.e., equilibrium. Rizazole dissipation was faster in the WL sediment phase with higher organic matter content (T_1/2 = 18.99–19.09 d) compared with the BG sediment phase (T_1/2 = 31.08–33.32 d). Rizazole degradation was slightly faster in the West Lake water-sediment system (WL system) (T_1/2 = 17.11–18.05 d) than in the Beijing–Hangzhou Grand Canal water—sediment system (BG system) (T_1/2 = 20.51–25.02 d). The aerobic degradation of rizazole was similar to its anaerobic degradation in the water-sediment system. The findings are useful to understand the behavior of pesticide in environment.     

Quantitative evaluation of environmental risks of flotation tailings from hydrothermal sulfidation–flotation process

Floatation tailings (FT) are the main by-products of the hydrothermal sulfidation–flotation process. FT (FT₁ and FT₂) were obtained by treating two different neutralization sludges (NS) (NS₁ and NS₂). This paper quantitatively evaluated the environmental risks of heavy metals (Zn, Cd, Cu, Pb, and As) in FT versus NS. The total concentration and leaching rates (R ₂) of heavy metals in FT were much lower than those in NS, demonstrating that the hydrothermal sulfidation–flotation process was able to effectively suppress the mobility and leachability of heavy metals. The BCR-three sequence leaching procedure of FT confirmed that all metals were transformed into more stable forms (residue and oxidizable forms) than were found that in NS. The potential ecological risk index indicated that the overall risks caused by heavy metals decreased significantly from 6627.59 and 7229.67 (very serious risk) in NS₁ and NS₂, respectively, to 80.26 and 76.27 (low risk) in FT₁ and FT₂, respectively. According to the risk assessment code, none of the heavy metals in FT posed significant risk to the natural environment except Zn (with low risk). In general, the risk of heavy metals in FT had been well controlled.