增强信心不辱使命--记全国安全生产工作会议

2002年1月15日至16日,全国安全生产工作会议在北京西郊宾馆召开。国务院副总理、国务院安全生产委员会主任吴邦国为大会做了批示:2002年安全生产任务更十分艰巨悄有松懈,安全事故又会大幅度上升。大会安排了新闻发布会,国家安全生产监督管理局局长张宝明、副局长闪淳昌等领导同志回答了记者提问。     

《地震学刊》的刊徽设计

提出了刊徽设计的原则和要求。所设计的《地震学刊》的刊徽是个由经纬网格所构成的公转着的地球。经纬网格由ＳＪ两个字母和两条细线所组成。ＳＪ为《地震学刊》英文名和江苏的汉语拼音名的缩写。Ｓ表示大地震所激发的地球自由振动的一阶振型；两条细线既表示经线，又表示地球自由振动的基振型。     

China''''s CDM Policies and Their Development Implications:Major Concerns for CDM Implementation

Most CDM (Clean Development Mechanism) opportunities exist in some large industrializing developing countries. For instance, China is estimated to take 48% of the world potential for CDM project activities. In reality, however, the share by China over the CDM projects registered and CDM projects in the pipeline is less than 10% as of Auguest 2005. This paper will examine the reasons behind, as reflected in China's CDM policies. Further investigation will be made into the use of these policies to boost the country's sustainable development, the sustainable development implications and effects of these policies. In addition, it is noted that incompatibility of some other Chinese laws and policies can be responsible for the low level and slow pace of CDM implementation in China and some suggestions are offered for promoting CDM project activities in China. There also exist barriers at the international level that impedes implementation of CDM project activities. A conclusion is drawn that CDM policies in a developing country like China aim mainly at promotion of sustainable development and to a lesser extent the generation of CERs.     

Operating condition influences on PCDD/Fs emissions from sinter pot tests with hot flue gas recycling

This study was designed to clarify the influence of operating conditions on the formation and emissions of polychlorinated-pdibenzodioxins and dibenzofurans (PCDD/Fs) from a sintering process with hot flue gas recycling. A pilot scale sinter pot with simulated flue gas recycling was developed, and four key operational parameters, including temperature, oxygen content of the simulated waste flue gas, the coke rate of the sintering mixture, and the quicklime quality, were selected for exploring PCDD/Fs formation. The results showed that the temperature of the recycled flue gas had a major affect on PCDD/Fs formation, and a high temperature could significantly increase their formation during sintering. A clear linear correlation between the temperature of recycling flue gas and PCDD/Fs emission (r = 0.93) was found. PCDD/Fs could be reduced to a certain extent by decreasing the level of oxygen in the recycled flue gas, while sintering quality was unchanged. The coke rate had no significant influence on the formation of PCDD/Fs, but the quality of quicklime used in the sintering mixture could affect not only the amount of PCDD/Fs emissions but also the sintering productivity. Compared with a benchmark sinter pot test, PCDD/Fs emissions markedly decreased with improvements to quicklime quality. However, the reduction in PCDD/Fs emissions realized by using high-quality quicklime was limited by the temperature of the inlet gas. The highest reduction achieved was 51% compared with conventional quicklime when the temperature of the inlet gas was 150°C.     

Rapid decolorization of Acid Orange II aqueous solution by amorphous zero-valent iron

Some problems including low treatment capacity, agglomeration and clogging phenomena, and short working life, limit the application of pre-treatment methods involving zero-valent iron (ZVI). In this article, ZVI was frozen in an amorphous state through a melt-spinning technique, and the decolorization effect of amorphous ZVI on Acid Orange II solution was investigated under varied conditions of experimental variables such as reaction temperature, ribbon dosage, and initial pH. Batch experiments suggested that the decolorization rate was enhanced with the increase of reaction temperature and ribbon dosage, but decreased with increasing initial solution pH. Kinetic analyses indicated that the decolorization process followed a first order exponential kinetic model, and the surface-normalized decolorization rate could reach 2.09 L/(m². min) at room temperature, which was about ten times larger than any previously reported under similar conditions. Recycling experiments also proved that the ribbons could be reused at least four times without obvious decay of decolorization rate and efficiency. This study suggests a tremendous application potential for amorphous ZVI in remediation of groundwater or wastewater contaminated with azo dyes.     

Three-dimensional hydrodynamic and water quality model for TMDL development of Lake Fuxian, China

Lake Fuxian is the largest deep freshwater lake in China. Although its average water quality meets Class I of the China National Water Quality Standard (CNWQS), i.e., GB3838-2002, monitoring data indicate that the water quality approaches the Class II threshold in some areas. Thus it is urgent to reduce the watershed load through the total maximum daily load (TMDL) program. A three-dimensional hydrodynamic and water quality model was developed for Lake Fuxian, simulating flow circulation and pollutant fate and transport. The model development process consists of several steps, including grid generation, initial and boundary condition configurations, and model calibration processes. The model accurately reproduced the observed water surface elevation, spatiotemporal variations in temperature, and total nitrogen (TN), total phosphorus (TP), and chemical oxygen demand (COD) concentrations, suggesting a reasonable numerical representation of the prototype system for further TMDL analyses. The TMDL was calculated using two interpretations of the water quality standards for Class I of the CNWQS based on the maximum instantaneous surface and annual average surface water concentrations. Analysis of the first scenario indicated that the TN, TP and COD loads should be reduced by 66%, 68% and 57%, respectively. Water quality was the highest priority; however, local economic development and cost feasibility for load reduction can pose significant issues. In the second interpretation, the model results showed that, under the existing conditions, the average water quality meets the Class I standard and therefore load reduction is unnecessary. Future studies are needed to conduct risk and cost assessments for realistic decision-making.     

AMBBR工艺处理城市污水

通过对厌氧移动床生物膜反应器处理南方热带亚热带地区城市生活污水的试验研究,采用好氧-厌氧两个阶段进行挂膜试验以缩短挂膜时间,探讨了水力停留时间(HRT)、pH值、填料填充率对反应器处理效果的影响。试验结果表明:在HRT为12 h,进水ρ(COD)为300 mg/L,ρ(氨氮)为15 mg/L,50%的填料填充率,pH=7的工艺条件下,装置对COD去除率为51.2%,对氨氮去除率为40.8%,对TN去除率为38.1%。     

玻璃熔窑烟气脱硝技术探讨

结合玻璃熔窑烟气排放的特点,阐述了国内外玻璃熔窑烟气脱硝技术,湿法脱硝、选择性催化还原法(SCR)、选择性非催化还原法(SNCR)及其优缺点。探讨了SCR脱硝技术在玻璃熔窑烟气脱硝的运用,并给出了工程实例,最后提出了一些建议。     

水泥炉窑SNCR及SCR烟气脱硝技术比较

通过分析水泥炉窑氮氧化物(NOx)生成机理、脱除技术以及国内外水泥炉窑脱硝现状并结合我国具体情况,探讨适合我国的水泥炉窑切实可行脱硝技术,为"十二五"期间我国水泥炉窑开展烟气脱硝整治工作提供技术性方向。     

调水工程生态补偿的分阶段推进战略

水质安全是调水工程顺利实施的关键,为此调水区背负巨大的调水工程的外部经济成本和社会发展代价,必须通过生态补偿政策进行内部化,然而调水工程涉及的范围广、时间长、利益主体多、资金投入大,难以通过一种手段或者现有某种方式建立长效的生态补偿机制。文章从调水工程生态补偿政策建立的目标、标准、责任分担与利益共享、补偿方式角度分析了生态补偿现状及存在的问题,提出了调水工程生态补偿的分阶段推进战略总体思路与实施构想,重点分析了各阶段生态补偿政策的制定标准和要求,为中线调水工程生态补偿政策制定提供了技术支持。