Field Evaluation of DRAINMOD 5.1 Under a Cold Climate: Simulation of Daily Midspan Water Table Depths and Drain Outflows1

Abstract: The hydrologic performance of DRAINMOD 5.1 was assessed for the southern Quebec region considering freezing/thawing conditions. A tile drained agricultural field in the Pike River watershed was instrumented to measure tile drainage volumes. The model was calibrated using water table depth and subsurface flow data over a two‐year period, while another two‐year dataset served to validate the model. DRAINMOD 5.1 accurately simulated the timing and magnitude of subsurface drainage events. The model also simulated the pattern of water table fluctuations with a good degree of accuracy. The R² between the observed and simulated daily WTD for calibration was >0.78, and that for validation was 0.93. The corresponding coefficients of efficiency (E) were >0.74 and 0.31. The R² and E values for calibration/validation of subsurface flow were 0.73/0.48 and 0.72/0.40, respectively. DRAINMOD simulated monthly subsurface flow quite accurately (E > 0.82 and R² > 0.84). The model precisely simulated daily/monthly drain flow over the entire year, including the winter months. Thus DRAINMOD 5.1 performed well in simulating the hydrology of a cold region.     

Optimization of membrane-based CO2-removal from natural gas using simple models considering both pressure and temperature effects

Simple models for permeability and selectivity variations of the CO₂/CH₄ system in 6FDA-2,6-DAT membrane have been derived that include both temperature and pressure effects simultaneously in a single equation. The proposed models were used in MATLAB, for a membrane-based CO₂-removal process design for natural gas sweetening. The effects of the following factors on design parameters were examined: feed temperature, feed pressure and permeate pressure. The effect of permeate pressure was found to be very significant in the optimization process. In order to reduce hydrocarbon losses to below 2%, a two-stage membrane process was modeled and simulated in MATLAB, and the extent of desired hydrocarbon recovery was shown to be crucial in the optimization process. It has also been shown that there exist minima for the total required area of the two-stage membrane-based process, and as the CO₂ load increases in the feed, the position of these minima shift to higher values of methane loss.     

Incorporating organizational factors into probabilistic risk assessment of complex socio-technical systems: Principles and theoretical foundations

The current generation of Probabilistic Risk Analysis (PRA), particularly those for technical systems, does not include an explicit representation of the possible impacts of organization and management on the safety performance of equipment and personnel. There are a number of technical challenges in developing a predictive model of organizational safety performance. There is a need for a widely accepted and theoretically sound set of principles on which models of organizational influences could be developed and validated. As a result of a multidisciplinary effort, this paper explores the feasibility of developing such principles and proposes a set of principles for organizational safety risk analysis. Then, as a realization of the proposed modeling principles, a safety risk framework, named Socio-Technical Risk Analysis (SoTeRiA), is developed. SoTeRiA formally integrates the technical system risk models with the social (safety culture and safety climate) and structural (safety practices) aspects of safety prediction models, and provides a theoretical basis for the integration. A systematic view of safety culture and safety climate leaves an important gap in modeling complex system safety risk, and SoTeRiA, describing the relationship between these two concepts, bridges this gap. The framework explicitly recognizes the relationship among constructs at multiple levels of analysis, and extends the PRA framework to include the effects of organizational factors in a more comprehensive and defensible way.     

Heavy metal contamination from mining sites in South Morocco: Monitoring metal content and toxicity of soil runoff and groundwater

The aim of the present work is the assessment of metal toxicity in runoff, in their contaminated soils and in the groundwater sampled from two mining areas in the region of Marrakech using a microbial bioassay MetPLATE™. This bioassay is based on the specific inhibition of the β-galactosidase enzyme of a mutant strain of Escherichia coli, by the metallic pollutants. The stream waters from all sampling stations in the two mines were all very toxic and displayed percent enzyme inhibition exceeding 87% except SWA₄ and SWB₁ stations in mine C. Their high concentrations of copper (Cu) and zinc (Zn) confirm the acute toxicity shown by MetPLATE. The pH of stream waters from mine B and C varied between 2.1 and 6.2 and was probably responsible for metal mobilization, suggesting a problem of acid mine drainage in these mining areas. The bioassay MetPLATE™ was also applied to mine tailings and to soils contaminated by the acidic waters. The results show that the high toxicity of these soils and tailings was mainly due to the relatively concentration of soluble Zn and Cu. The use of MetPLATE™ in groundwater toxicity testing shows that, most of the samples exhibited low metal toxicity (2.7–45.5% inhibition) except GW3 of the mine B (95.3% inhibition during the wet season and 82.9% inhibition during the dry season). This high toxicity is attributed to the higher than usual concentrations of Cu (189 μg Cu l⁻¹) and Zn (1505 μg Zn l⁻¹). These results show the potential risk of the contamination of different ecosystems situated to the vicinity of these two metalliferous sites. The general trend observed was an increase in metal toxicity measured by the MetPLATE with increasing total and mobile metal concentrations in the studied matrices. Therefore, the MetPLATE bioassay is a reliable and fast bioassay to estimate the metals toxicity in the aquatic and solids samples.     

Comparative study of the sensitivity to cadmium of two populations of Gambusia affinis from two different sites

This study aims to demonstrate the influence of animals' origin on their sensitivity toward heavy metals. For this purpose, we compared LC(50) of cadmium in two populations of Gambusia affinis captured in two geographically isolated environments in the east of Tunisia; Oued El Gsil in the city of Monastir (S2) and Oued Chenini in the region of Gabes (S1). Although physicochemical parameters of the water (pH, dissolved oxygen and salinity) are similar in the two studied sites, cadmium concentrations in water, sediments and fish tissues from S1 are significantly higher (P < 0.01) than those from S2, 48-h and 96-h LC(50) of the (S1) population are significantly higher than those from S2. In the same way, the offspring of the polluted site (S1) population exhibit 48-h and 96-h LC(50) values much higher than those of the reference site (S2) population. These results show that the population of the Gabes region is more resistant to cadmium than that of the Monastir region and that this resistance could have a genetic basis. These results indicate the influence of the origin of animals that has to be taken into account not only in laboratory toxicity tests, but also in field ecotoxicological studies.     

Spatiotemporal changes of landscape pattern in response to deforestation in Northeastern Turkey: a case study in Rize

Recognition and understanding of landscape dynamics as a historical legacy of disturbances are necessary for sustainable management of forest ecosystems. This study analyzes spatial and temporal changes in land use and forest cover patterns in a typical mountain forest area in Rize Forest Enterprise of the Northeastern part of Turkey. The area is investigated by evaluated the temporal changes of spatial structure of forest conditions through spatial analysis of forest cover type maps from 1984 and 2007 using GIS and FRAGSTATS. The quantative evidences presented here showed that there were drastic changes in the temporal and spatial dynamics of land use/forest cover. As an overall change between 1984 and 2007, there was a net decrease of 2.30% in total forested areas. On one hand, productive forest areas decreased 12,506 ha, on the other hand, degraded forest areas increased 14,805 ha. In examining the changes of crown closure and development stages of forest ecosystem during the study period, the forest stand area with medium crown closures increased. Regenerated area increased while the other development stages were left to grow to mature development stages in the period. These results regarding to crown closure and development stage showed that forest quality has increased but total forest areas decreased. This is partially due to out-migration of rural population in Rize and Cayeli towns. In terms of spatial configuration, analysis of the metrics revealed that landscape structure in Study area had changed substantially over the 23-year study period, resulting in fragmentation of the landscape as indicated by the large patch numbers and the smaller mean patch sizes due to heavy timber subtraction, illegal cutting, and uncontrolled stand treatments.     

Assessment of environmental radioactivity for Batman, Turkey

The province of Batman, located in southern Anatolia, has a population of approximately 500,000. To our knowledge, there exists no information regarding the environmental radioactivity in this province. Therefore, gamma activity measurements in soil, building materials and water samples and an indoor radon survey have been carried out in the Batman province. The mean activity concentrations of the natural radionuclides (²²⁶Ra, ²³²Th and ⁴⁰K) and a fission product (¹³⁷Cs) were 35 ± 8, 25 ± 10, 274 ± 167 and 12 ± 7 Bq kg^???1, respectively, in the soil samples. The concentrations of ²²⁶Ra, ²³²Th and ⁴⁰K in the selected building materials ranged from 18 to 48 Bq kg^???1, 8 to 49 Bq kg^???1 and 68 to 477 Bq kg^???1, respectively. All the calculated radium equivalent (Ra_eq) activity values of the building material samples are lower than the limit of 370 Bq kg^???1, equivalent to a γ-dose of 1.5 mSv year^???1. The activity concentrations of ²²⁶Ra, ²³²Th and ⁴⁰K in tap waters collected from the study area were determined with mean specific activity concentrations of 42 ± 15, 35 ± 9 and 524 ± 190 mBq L^???1, respectively. Indoor radon measurements were made at 95 dwellings in Batman using a CR-39 detector. The radon concentration levels were found to vary from 23 to 145 Bq m^???3. The arithmetic mean of the measured radon concentration levels was found to be 84 Bq m^???3 with a standard deviation value of 23 Bq m^???3. The measurement results obtained in this study did not significantly differ from those taken in other parts of the country. The data generated in this study can be used to determine whether the Batman province is in a normal or high background radiation area and provides a valuable database for future estimations of the impact of radioactive pollution.     

Spatial analysis and facility characteristics of outdoor recreational areas in Istanbul

This article reports the results of a study that explored whether outdoor recreational areas are sufficient in Istanbul in terms of their surface area and facility characteristics. All the municipalities in 32 subprovinces of Istanbul were sent a survey in 2007 and asked to prepare a list of their outdoor recreational areas including their names, addresses, size, and facilities. All the data collected from the municipalities were used to create a GIS-based inventory by using GIS and remote sensing. As the study revealed, the outdoor recreational areas in Istanbul are far behind meeting the recreational needs of the residents in terms of area per person and facility characteristics. There are 2,470 areas which were dedicated to outdoor recreational activities in Istanbul. Total surface area of all these outdoor recreational areas is 19,2 sq kilometers; this means 1.52 m² recreational area per person in the city. This value is very low when compared to that of many cities in Europe and USA. As the study also revealed, the majority of outdoor recreational areas in Istanbul are poor in facility. Majority of the existing outdoor recreational areas are small and do not provide the public with many opportunities to engage in different outdoor activities. A more sustainable and efficient recreational plan is needed in Istanbul to meet the various recreational needs of its residents.     

Assessment of natural radiation exposure levels and mass attenuation coefficients of lime and gypsum samples used in Turkey

The activity concentrations of ²²⁶Ra, ²³²Th, and ⁴⁰K in lime and gypsum samples used as building materials in Turkey were measured using gamma spectrometry. The mean activity concentrations of ²²⁶Ra, ²³²Th, and ⁴⁰K were found to be 38 ± 16, 20 ± 9, and 156 ± 54 Bq kg^???1 for lime and found to be 17 ± 6, 13 ± 5, and 429 ± 24 Bq kg^???1 for gypsum, respectively. The radiological hazards due to the natural radioactivity in the samples were inferred from calculations of radium equivalent activities (Ra_eq), indoor absorbed dose rate in the air, the annual effective dose, and gamma and alpha indices. These radiological parameters were evaluated and compared with the internationally recommended limits. The experimental mass attenuation coefficients (μ/ρ) of the samples were determined in the energy range 81–1,332 keV. The experimental mass attenuation coefficients were compared with theoretical values obtained using XCOM. It is found that the calculated values and the experimental results are in good agreement.     

Determination of total Cr in wastewaters of Cr electroplating factories in the I.organize industry region (Kayseri, Turkey) by ICP-AES

The wastewater pollution in industrial areas is one of the most important environmental problems. Heavy metal pollution, especially chromium pollution in the wastewater sources from electroplating, dyeing, and tannery, has affected the life on earth. This pollution can affect on all ecosystems and human health directly or by food chain. Therefore, the determination of total chromium in this study is of great importance. In this study, accurate, rapid, sensitive, selective, simple, and low-cost technique for the direct determination of total Cr in wastewater samples collected from the some Cr electroplating factories in March 2008 by inductively coupled plasma-atomic emission spectrometry has been developed. The analysis of a given sample is completed in about 15 min by this technique applied. As the result of the chromium analysis, the limit of quantification for the total Cr were founded to be over the limit value (0.05 mg L^???1; WHO, EPA, TSE 266, and inland water quality classification) as 1,898.78 ± 0.34 mg/L at station 1 and 3,189.02 ± 0.56 mg/L at station 2. The found concentration of total Cr has been determined to be IV class quality water according to the inland water classification. In order to validate the applied method, recovery studies were performed.