北京市潮白河再生水补水河段水质时空变异

城市河道是城市再生水利用的主要载体,而人工湿地是城市再生水河道补水前主要的水质净化方式.为了解再生水补水与人工湿地对再生水补水段水质的影响,选取北京市潮白河再生水补水河段作为研究对象,利用聚类分析、判别分析及因子分析等方法对不同季节水体的水质情况进行分析.结果表明:研究区内水体氮磷污染严重,其中TN污染表现为NO₃--N、NO₂--N和NH₄+-N的混合型污染.聚类分析结果表明,水质在季节尺度上表现为丰水期（6-9月）和枯水期（2月、3月、5月和12月）两大类;在空间尺度上受再生水补水和湿地净化的影响表现为显著的空间差异性.判别分析结果表明,再生水补给对河道水质的影响无显著季节差异,湿地净化功能在丰水期和枯水期差异较大且丰水期湿地的净化效果最为明显.因子分析结果表明,再生水作为城市河道的补充水源,一方面对河道中的F-、Chl-a等起到稀释作用,另一方面使得水体中的N、P及离子含量增加;丰水期湿地的净化作用使水体中氮磷等有机营养物质含量及ρ（TDS）等显著降低.      

采用巯基捕收剂稳定化处理垃圾焚烧飞灰中的重金属

研究了3种巯基捕收剂,二乙基二硫代氨基甲酸钠（乙硫氮）、乙基黄原酸钾（乙基黄药）和二丁基二硫代磷酰铵（丁铵黑药）,对垃圾焚烧飞灰中重金属的稳定化效果。3种巯基捕收剂的用量均为62.5μmol?g-1飞灰。扫描电镜观察发现,飞灰经稳定化处理后,巯基捕收剂均匀地覆盖于飞灰晶体表面,使矿物晶体棱角变得模糊。利用酸浸提程序（TCLP法）和水浸提程序（水平振荡法）评价飞灰中重金属Cu、Pb、Cd、Cr和Zn的浸出毒性。在0.1mol?L-1醋酸浸提条件下,与Na2S相比,巯基捕收剂对Cu和Pb的稳定化效果较好,其中乙硫氮对Cu的稳定化比率接近100%,丁铵黑药对Pb的稳定化比率达到69.2%;在水浸提条件下,乙硫氮、乙基黄药和丁铵黑药对5种重金属的稳定化比率分别为72.6%、73.5%和76.8%,显著高于Na2S处理（52.4%）。三种巯基捕收剂对5种重金属亲和力的强弱顺序大致为Cu＞Pb＞Cr＞Cd＞Zn,并且超过60%的巯基捕收剂与酸可浸提重金属离子发生了螯合沉淀反应。重金属-巯基捕收剂絮凝物在中性和碱性条件下（pH>6）比较稳定,在酸性条件下（pH<6）可发生部分溶解。为获得较好的重金属稳定化效果,维持稳定化飞灰的高酸缓冲容量十分重要。     

DSA类电极催化降解硝基苯动力学及机理的研究

用新兴的电化学催化系统,以特殊工艺自制的DSA类电极作阳极,对模拟硝基苯废水进行了降解处理,得出了该试验范围内的最佳条件,降解过程符合一级反应模型.根据分析,推测硝基苯分子主要先被阴极产生的H还原为亚硝基苯、苯胺等,然后再扩散到阳极附近被HO*氧化为偶氮苯、氧化偶氮苯等,最后进一步氧化开环,生成苯基丁二酸等酸类物质以至二氧化碳,同时硝基苯分子也可以直接在阳极附近得到氧化生成2-硝基苯酚.最后,对硝基苯的降解途径进行了描述.      

气-固复合粉体在高原地区灭火性能的试验研究

为满足高原地区低压低氧环境对火灾防治的特殊需求,在拉萨进行模拟试验,研究由溴氟丙烯和13X沸石所组成的气-固复合粉体灭火剂对汽油火的灭火性能,并与平原地区的合肥的灭火效果进行对比。试验结果表明,在拉萨低压低氧的环境下,复合粉体灭火剂对汽油火具有很好的灭火性能。在同样的试验条件下,其灭火时间和灭火剂用量比合肥减少20%以上,说明该复合粉体灭火剂在高原地区有很好的适用性。     

城市轨道交通突发大客流协同应急决策研究

为研究城市轨道交通突发大客流下的客流控制应急决策的制定与调整,对城市轨道交通客流特征进行分析,将协同矩阵与多目标规划理论运用到突发大客流下多车站协同客流控制应急决策研究中。在协同车站间路网拓扑结构的基础上,提出分别考虑各车站协同与不协同、协同车站加入或退出、协同车站评价标准变化等情况下,初始应急决策的制定与动态方案调整方法。研究结果表明:使用该方法能够表达城市轨道交通车站间协同作业的各种状态,实现突发客流冲击情况下的路网多车站动态协同应急决策的制定与动态调整,可为城市轨道交通网络化协同作业理论与方法的研究提供参考。     

氯化镁复配硫酸铝混凝性能及絮体特性

在研究氢氧化镁混凝特性的基础上,复配氯化镁和硫酸铝作为混凝剂,以高岭土配水水样为研究对象,运用iPDA在线监测技术对混凝过程絮体形成进行监测,探讨了单独使用氯化镁和硫酸铝以及二者复配使用的混凝效果和絮体特性,确定复配使用的各种条件。结果表明,对于浊度20 NTU,pH 11.5的高岭土配水水样,氯化镁、硫酸铝最佳投加量分别为7.2 mg/L(Mg2+计)和3 mg/L(Al3+计);硫酸铝跟氯化镁复配使用时,先投加硫酸铝,间隔30 s后投加氯化镁,混凝效果较好;在镁离子最佳投加量7.2 mg/L时,铝和镁最佳质量比在1∶3~1∶2之间;镁铝复配时其FI值明显大于单独作用时,即絮体尺寸大小:二者复配硫酸铝氯化镁,而且复配条件下Zeta电位值在零电势左右浮动,浮动范围小,更利于聚集沉淀;镁铝复配时发生了协同效应,弥补了单独使用氯化镁混凝过程的不足。     

Tree bark as a passive air sampler to indicate atmospheric polybrominated diphenyl ethers (PBDEs) in southeastern China

The different barks were sampled to discuss the influence of the tree species, trunk circumference, and bark thickness on the accumulation processes of polybrominated diphenyl ethers (PBDEs) from air into the bark. The results of different PBDE concentrations indicated that barks with a thickness of 0–3 mm collected from weeping willow, Camphor tree, and Masson pine, the trunk circumferences of which were 100 to 150 cm, were better PBDEs passive samplers. Furthermore, tree bark and the corresponding air samples were collected at Anji (AJ), Hangzhou (HZ), Shanghai (SH), and Wenling (WL) to investigate the relationship between the PBDE concentrations in bark and those in air. In addition, the significant correlation (r ²?=?0.906; P?<?0.05) indicated that atmospheric PBDEs were the principle source for the accumulation of PBDEs in the barks. In this study, the log K _BA (bark–air partition coefficient) of individual PBDE congeners at the four sites were in the range from 5.69 to 6.79. Finally, the total PBDE concentration in WL was 5 to 20 times higher than in the other three cities. The result indicated that crude household workshops contributed a heavy amount of PBDEs pollution to the environment, which had been verified by the spatial distribution of PBDEs levels in barks collected at Wenling (range, 26.53–1317.68 ng/g dw). The good correlation between the PBDE concentrations in the barks and the air samples and the variations of the PBDE concentrations in tree barks collected from different sites reflected that the bark could be used as a passive sampler to indicate the atmospheric PBDEs.     

Variations in the Emissions of Volatile Organic Compounds from the Toner for a Specific Photocopier

ABSTRACT

A laboratory thermal desorption apparatus was used to measure emissions from a number of nominally identical photocopier toners—manufactured to meet the specifications of one specific model copier—when these toners were heated to fuser temperature (180-200 °C). The objective was to assess how potential volatile organic compound (VOC) emissions from the toner for a given copier can vary, depending upon the production run and the supplier. Tests were performed on a series of toner (and associated raw polymer feedstock) samples obtained directly from a toner manufacturer, representing two production runs using a nonvented extrusion process, and on toner cartridges purchased from two local retailers, representing three different production lots (histories unknown). The results showed that the retailer toners consistently had up to 350% higher emissions of some major compounds (expressed as |ig of compound emit-ted/g of toner), and up to 100% lower emissions of others, relative to the manufacturer toners (p ≤ 0.01). The manufacturer toners from one production run had emissions of certain compounds, and of total VOCs, that were modestly higher (13-18%) than those from the other run (p ≤ 0.01). The emission differences between the retailer and manufacturer toners are probably due to differences     

管道结构对氢/空预混气体爆炸特性影响研究

为研究管道结构对氢-空预混气体爆炸特性影响,采用实验与数值模拟相结合的方法,分析不同管道结构内氢-空预混气体燃爆时火焰传播进程、爆炸压力、湍流动能变化及流场分布.结果表明:90°弯管对氢-空预混气体爆炸强度增强作用明显高于T型分岔管和直管.火焰阵面在结构突变处褶皱变形较明显,并出现大尺度强湍流和涡团,气团脉动速度与湍流...