菱镁矿尾矿制备高活性MgO的性能表征

菱镁矿尾矿经预处理后,在一定条件下制备高活性MgO。使用热重-差热分析仪,分析菱镁矿尾矿的分解温度,应用X射线衍射、SEM分析不同煅烧温度、保温时间对MgO晶体结构的影响,并根据Scherrer公式计算MgO晶粒的尺寸。通过电导率仪测定MgO水化电导率,分析不同条件下的MgO活性,探讨煅烧温度、保温时间、颗粒细度与MgO活性之间的关系。结果发现:煅烧温度在1 050℃,保温时间60 min时,菱镁尾矿完全分解,MgO活性最佳;煅烧温度越高,保温时间越长,MgO的活性越差;MgO颗粒细度越小,活性越高。     

林可霉素菌(Streptomyces lincolnensis)利用吡唑酮废水的研究

采用被吡唑酮废液驯化、分离、筛选后的林可霉素菌,并对其在摇瓶上利用吡唑酮废液中的硫酸铵发酵(7 d)生产林可霉素进行了研究。实验结果表明,废液加入培养基体积比都为1∶10,实验1中菌丝代谢和对照比正常,其中还原糖利用最快,在发酵后期为0.24 mg/L,林可霉素起步效价最低为2 100 IU/mL,与对照相比最后发酵效价降低了70 IU/mL;实验2发酵过程pH值偏低,全程为5.86～6.50,氨基氮代谢缓慢为40 mg/100 mL,最后林可霉素效价最低为4 480 IU/mL;实验3中废液在发酵进入48 h中后期的时候补入能促进菌丝体分泌,最后林可霉素为5 180 IU/mL,比对照发酵水平高出8.82%。可见实验3的实验设计有利于林可霉素菌利用吡唑酮废液生产林可霉素,为废物循环利用、变废为宝的可行性作了有意义尝试。     

竹炭-微生物联合法对沼液中氨氮的去除

采用竹炭-微生物联合法,考察了竹炭用量、菌液用量、进水氨氮浓度、pH、DO、HRT等因素对氨氮废水处理效果的影响;同时采用对比实验,初步探讨了竹炭-微生物联合法处理沼液的作用机理。结果表明,竹炭-微生物法去除沼液氨氮的最优条件推荐为:竹炭用量30 g/L,微生物活性液用量3%,pH 7.0～8.0,DO为2 mg/L,HRT为48 h。竹炭-微生物法对沼液氨氮的去除过程可用一级反应动力学模型C=272.56e-0.0148描述,其去除效果来源于竹炭吸附和生物降解的协同作用,协同程度为48.45%。     

旋流分离器油水分离效率的模拟研究

采用计算流体力学的方法,探讨了操作条件和物料特性对旋流分离器分离油水效率的影响。旋流器为单锥双入口,其主直径为50 mm,锥角为5.5°。模拟过程中,采用商业用软件‘Fluent 6.3’中的雷诺应力模型和欧拉多相流模型来模拟不同条件下油水旋流分离器的分离性能。模拟结果表明,对于本研究的油水旋流分离器,最佳的分流比是10%,最佳的油滴浓度是0.5%(V/V)。在最佳的分流比和油滴浓度下,当进口流速为10.46 m/s时,油水旋流分离器可将15μm的油滴去除80%以上,油滴的分离界限粒径d50(50%的分离效率)为9.2μm。在模拟的基础上,用统计软件STATISTICA6.0对分离效率与操作条件和物料特性之间的关系进行拟合。通过拟合式预测的分离效率与实测值相吻合,误差小于15%。     

用含固定化微生物的曝气生物滤池处理炼油厂高浓度废水

采用含固定化微生物的曝气生物滤池(G-BAF)处理炼油厂高浓度废水。当G-BAF池进水COD为298～11 278 mg/L时,出水COD为33.0～94.3 mg/L,COD平均去除率为97%;当G-BAF池进水ρ(NH_3-N)为12.1～188.0 mg/L时,出水ρ(NH_3-N)为0.9～49.4 mg/L,NH_3-N平均去除率为83%。经G-BAF处理后出水水质完全达到GB8978—1996《污水综合排放标准》第二类污染物的二级排放标准。     

Lateral movement of soil fumigants 1,3-dichloropropene and chloropicrin from treated agricultural fields

The soil fumigants 1,3-dichloropropene (1,3-D) and chloropicrin (CP) are often used for controlling soil-borne plant pathogens and parasitic nematodes before reestablishing new vineyards and orchards. To evaluate crop safety and environmental risks with the replant fumigation, four field experiments were performed over 2 yr to examine 1,3-D and CP lateral movement away from the treated fields. Shank injection with or without a virtually impermeable film (V1F) was used in two vineyard fumigation experiments, and spot drip application without tarp cover was used in two orchard experiments. Results showed that 1,3-D and CP gases moved laterally to 6 m from the treated fields when the fumigants were applied by shank injection. The maximum 1,3-D or CP soil gas concentration at 6 m was approximately 10 ng cm(-3) when the fumigated plot was not cover with a tarp. With VIF, the measured maximum concentration increased to approximately 100 ng cm(-3). In the spot drip application, maximum 1,3-D and CP gas concentrations reached approximately 100 ng cm(-3) but at 1.5 m radial distance from the point of fumigant injection.     

Mobility of radium and trace metals in sediments of the Winterbeek: Application of sequential extraction and DGT techniques

For several decades, phosphate ores containing ²²⁶Ra as well as several trace metals have been processed in Belgium to produce calcium phosphate for use in cattle food. The waste water is discharged in two small rivers, the Laak and the Winterbeek.In this study, the levels of ²²⁶Ra and trace metals in surface water and sediments of the Winterbeek were investigated and the mobility of these compounds was assessed using DGT (Diffusive Gradient in Thin Films) and sequential extraction techniques.The concentrations of ²²⁶Ra and trace metals in water and sediment indicate a decreasing trend in inputs to the Winterbeek.The mobility of ²²⁶Ra, assessed by DGT, is related to the reductive mobilization of Fe. The sequential extraction technique shows that at some stations an important fraction of ²²⁶Ra is found to labile sediment phases.Diffusive ²²⁶Ra sediment fluxes, are however, relatively small and have only a minor contribution to the water column concentration of ²²⁶Ra.     

Polybrominated diphenyl ethers and their methoxylated metabolites in anchovy (<Emphasis Type="Italic">Coilia</Emphasis> sp.) from the Yangtze River Delta,China

Background, aim, and scope  

Polybrominated diphenyl ethers (PBDEs) and their metabolites are toxic to animals, and concentrations of the PBDEs metabolites can exceed those of the parent materials. But no information was available on concentrations of PBDEs metabolites in the lower Yangtze River in the region around Jiangsu Province of China, which is heavily urbanized and industrialized area. The aims of this study were to determine whether PBDEs and their methoxylated PBDEs (MeO-PBDEs) were accumulated in Coilia sp. in this area and to investigate the potential sources for these two kinds of brominated organic pollutants.     

Interaction of nano-TiO2 with lysozyme: insights into the enzyme toxicity of nanosized particles

Background, aim, and scope  

Nanomaterials have been used increasingly in industrial production and daily life, but their human exposure may cause health risks. The interactions of nanomaterial with functional biomolecules are often applied as a precondition for its cytotoxicity and organ toxicity where various proteins have been investigated in the past years. In the present study, nano-TiO₂ was selected as the representative of nanomaterials and lysozyme as a representative for enzymes. By investigating their interaction by various instrumentations, the objective is to identify the action sites and types, estimate the effect on the enzyme structure and activity, and reveal the toxicity mechanism of nanomaterial.     

Formation of shaped barium sulfate-dye hybrids: waste dye utilization for eco-friendly treatment of wastewater

Purpose

Owing to the present complexity and difficulty of concentrated dye wastewater treatment, this work aimed to synthesize a reproducible waste-sorbing material for the treatment of wastewater by forming the dye-conjugating complex hybrid.

Methods

The inorganic/organic hybridization was applied to prepare the objective material by immobilizing waster dye-Mordant blue 9 (MB) with barium sulfate (BaSO₄). The composition and pattern of the formed material were determined by spectrometry and characterized by SEM and XRD, and their formation process was clarified. The adsorption of cationic dye-basic blue BO (BB) and copper ion was investigated..

Results

The hybrid of MB alone into growing BaSO₄ formed the pineapple-like particles while that of the MB/BB-conjugating complex was the rhombus material. The adsorption of BB on the MB–BaSO₄ hybrid was probably attributed to ion-pair equilibrium and that of Cu²⁺ may result from the complexation. The treatment of dye and heavy metal wastewaters indicated that the MB hybrid material removed 99.8% BB and 97% Cu²⁺ and the dye-conjugating hybrid with growing BaSO₄ 100% MB, 99.5% BB, and 44% Cu²⁺.

Conclusion

The waste MB–BaSO₄ hybrid material is efficient to treat cationic dye and Cu²⁺ wastewater. The dye-conjugating hybridization method is the first to be advanced for in situ wastewater treatment, and it showed a combined effect for the removal of both organic dyes and heavy metals.