Performance assessment of a wastewater treatment plant producing effluent for irrigation in Egypt

A conventional activated sludge treatment facility was the subject of this study. The assessment was directed at determining the characteristics of the raw wastewater, the quality of the treated effluent and the efficiency of the various treatment units. Furthermore, the water quality along the effluent irrigation canal was monitored. The assessment of the quality of the treated effluent for irrigation is based on the guidelines established by the World Health Organization and the Egyptian decree 9/89 for the use of wastewater in agriculture. The results of the study indicated that the concentration of the raw wastewater was considered moderate. The mean values of the COD (Chemical Oxygen Demand), BOD (Biological Oxygen Demand) and total suspended solids (TSS) were around 250, 102 and 142 mg l–1, respectively. This was attributed to the high quantities of wastewater from industrial sources. The overall efficiency of the treatment facility was good. The mean residual COD, BOD and TSS were 25, 8 and 21 mg l–1 and the corresponding percentage removal values were 90, 92 and 85%, respectively. The maximum percentage removal of oil and grease was 84% with a mean residual concentration of 24 mg l–1. The total viable count (22°C and 37°C), faecal coliform and aecal streptococci were reduced by 99.9% compared to only 99.5% for Salmonella. Bacteriological examination of the dried sludge indicated a reduction of nine logs of faecal coliform and faecal streptococci, as compared to thickened sludge. Analysis of the Ni, Cu, Pb and Cr in the dried sludge indicated that their concentrations are within the permissible limits. Zinc exceeded the consent standards by 50%. The results of the analyses of samples collected at the beginning of the irrigation canal indicated insignificant changes from the characteristics of the final effluent. Samples collected at a distance of 2km along the irrigation canal showed mean reductions in the COD and BOD of 28.6 and 47%, respectively, which could be attributed to sedimentation and/or a self-purification effect. An increase in the total nitrogen, total phosphorus and total viable count was also recorded, which could be due to seepage from the agricultural land. From the data available it is evident that the treated wastewater could be used for restricted irrigation. The design and implementation of a monitoring programme is recommended.     

ALLOCATION MODEL FOR IRRIGATION WATER COST: CASE STUDY OF THE NILE VALLEY IN EGYPT1

ABSTRACT: An allocation model for irrigation water cost, based on the Use of Facilities method, is presented. The model is developed for large-scale irrigation systems which may include multipurpose reservoirs, irrigation control works, pump stations and irrigation canals of various orders. The model accounts for the water conveyance losses as well as the water gains in the irrigation canals, and their effects on irrigation cost. It is applied to the irrigation distribution system of the Nile Valley in Egypt, which contains the High Aswan Dam, 16 irrigation structures, 12 pump stations, and numerous irrigation canals. The irrigation water cost at 29 areas representing the Nile Valley is determined.     

Electrochemical treatment of aqueous wastes containing pyrogallol by BDD-anodic oxidation

In this work, the electrochemical oxidation of pyrogallol (1,2,3-trihydroxybenzene) on boron-doped diamond anodes has been studied. The voltammetric results showed that pyrogallol oxidation takes place in the same potential region as that of phenol where the supporting electrolyte is stable. Synthetic wastewaters containing pyrogallol have been treated in a bench-scale electrolysis plant. This plant operates in a discontinuous mode by recirculating the waste continuously through a single-chamber electrochemical flow cell. The complete mineralization of pyrogallol and the electro-generated pollutants is obtained in the electrolytic device. HPLC analyses show the formation of carboxylic acids as the main intermediates. The efficiency of the electrochemical process was found to depend mainly on the pollutant concentration present in the waste and on the applied current density. The high efficiency of this technology can be explained in terms of the direct electro-oxidation at the BDD surface and the oxidation carried out by hydroxyl radicals and other electro-generated oxidants.     

Detection of hazardous pollutants in chrome-tanned leather using locally developed laser-induced breakdown spectrometer

K?z?l?rmak River has been used as Ankara??s drinking water source for approximately 1.5?years. Therefore, this region??s water, sediment, and fish samples are measured for detecting the heavy metals. This is important for the current situation as well as the future in terms of potential impact. The amount of heavy metals in drinking water should be within the limited values; otherwise, the accumulation of heavy metals will cause many problems to living organisms. Especially high levels of arsenic, cadmium, nickel, mercury, etc. are very dangerous to freshwater ecosystems as for human if the water is being use as drinking water. In this study, water, sediment samples, muscle, and gills of three fish species (Capoeta tinca, Capoeta capoeta, Leuciscus cephalus) were analyzed for the presence of heavy metals such as (Al, Fe, As, Cd, Ni, Mn, Se, Si) to determine present accumulation levels and possible toxic effect. The accumulation pattern of heavy metals in the water, sediment, and fish tissue follows the sequence: Si > Fe > Al > Mn > As > Ni > Se > Cd, Fe > Al > Mn > Ni > As > Se > Cd, and Fe > Al > Mn > As > Ni > Si > Cd. In addition, the detected concentrations of heavy metals in the K?z?l?rmak and Delice Rivers are compared with other heavy metal studies in the other main rivers and lakes in Turkey.     

Antitumor effect of copper nanoparticles on human breast and colon malignancies

Environmental Science and Pollution Research - Breast and colon carcinomas are two types of common cancers which lead to cancer-related deaths. Due to their cytotoxic potential against cancer...     

The contribution of mediated oxidation mechanisms in the electrolytic degradation of cyanuric acid using diamond anodes

In this work, the contribution of mediated oxidation mechanisms in the electrolytic degradation of cyanuric acid using boron-doped diamond(BDD) anodes was investigated in different electrolytes. A complete mineralization of cyanuric acid was obtained in Na Cl;however lower degrees of mineralization of 70% and 40% were obtained in Na2SO4 and Na Cl O4, respectively. This can be explained by the nature of the oxidants electrogenerated in each electrolyte. It is clear that the contribution of active chlorine(Cl2, HCl O, Cl O-)electrogenerated from oxidation of chlorides on BDD is much more important in the electrolytic degradation of cyanuric acid than the persulfate and hydroxyl radicals produced by electro-oxidation of sulfate and water on BDD anodes. This could be explained by the high affinity of active chlorine towards nitrogen compounds. No organic intermediates were detected during the electrolytic degradation of cyanuric acid in any the electrolytes, which can be explained by their immediate depletion by hydroxyl radicals produced on the BDD surface. Nitrates and ammonium were the final products of electrolytic degradation of cyanuric acid on BDD anodes in all electrolytes. In addition, small amounts of chloramines were formed in the chloride medium. Low current density(≤ 10 m A/cm2) and neutral medium(p H in the range 6–9) should be used for high efficiency electrolytic degradation and negligible formation of hazardous chlorate and perchlorate.     

Heavy metals availability (Fe, Mn, Zn, Cu and Cr) in Aden Gulf sediments under aerobic and anaerobic conditions

The present study aims to analyse the chemical speciation of heavy metals in relation to aerobic and anaerobic conditions. Two sediment samples (from the Gulf of Aden, Yemen) were incubated under flooded conditions. In particular, the chemical forms of Fe, Mn, Zn, Cu and Cr under the experimental conditions were studied using a sequential chemical extraction method. The pH and Eh of the suspension were measured as critical parameters controlling the fate of the metals in the environment. The results showed that the metals concentration in the different forms varied with time incubation and affected by the variation of redox potential and pH value. Also, the changes in both redox potential (Eh) and pH values had evident effects on heavy metals transformation. It is obvious that the highest redox potential affected the amount of iron and manganese in the oxides form. When the redox potential decreased to-133 and-170 mV, it caused a significant transformation of the Fe-Mn oxide form to the water-soluble and exchangeable fractions. Under anaerobic conditions, the relative percentage of all five metals including the summation of four fractions (the water-soluble and exchangeable, carbonate, oxides and organic fractions) constituted 45-60% of the total amount of iron, 33-50% for manganese, 33-63% for Zn, 63-74% for Cu and 19-43% for Cr. Both zinc and copper among water-soluble and exchangeable fraction were high at the end of incubation period, this accompanied by a significant decrease in the content of the organically bound fraction. In general, the reducing conditions were more favorable for metal bound to water soluble and exchangeable fraction.     

AVS-SEM relationships and potential bioavailability of trace metals in sediments from the Southeastern Mediterranean sea,Egypt

In risk assessment of aquatic sediments, much attention is paid to the difference between acid volatile sulfide (AVS) and simultaneously extracted metals (SEM) as indicators of metal bioavailability. Distribution of AVS and SEM (Cd, Cu, Ni, Pb and Zn) were determined in 20 representative sampling sites collected along the Egyptian Mediterranean coast. Total SEM concentration [ΣSEM] ranged from 0.012 to 0.241 μmoleg^?1. AVS concentrations were much more variable, showing significant spatial variations. The values ranged from 0.015 to 31.326 μmoleg^?1. The different relationships between AVS and SEM to establish mechanical models such as the ratio of ΣSEM and AVS [ΣSEM/AVS], the difference between the ΣSEM and AVS [ΣSEM–AVS], or the organic carbon normalised difference between SEM and AVS [ΣSEM-AVS]/f_oc models were used as parameters to evaluate potential bioavailability. Considering SEM/AVS model, sediments at the Western Harbour, Eastern Harbour, Ras El-Burr, El-Gamil East, and Port Said stations are occasionally toxic, while according to SEM-AVS model, no indication of associated adverse toxic effect would occur at any of the sampling sites. Calculated [ΣSEM-AVS]/f_oc was<130 μmoleg^?1 in the sediments indicating that sediments should pose a low risk of adverse biological effects owing to cadmium, copper, lead, nickel and zinc. Association of adverse effects to aquatic organisms was determined, using the classification of the sediments according to the Sediment Quality Guidelines (SQGs). The marine Threshold Effect Levels (TEL) and Probable Effect Levels (PEL) were used in this work and in order to obtain a more realistic measure of predicted toxicity, mean PEL quotients (PELq) were calculated. The mean PELq calculated for the sampling sites was (0.11–1.5) and categorised as slightly toxic at all stations except Baghoush, Nobarreya and western harbour, which had PELq<0.1 and categorised as non-toxic. The obtained data concluded that the remobility and bioavailability of trace metals contained in surfacial sediments of the Egyptian Mediterranean coastal area are low.     

Fractionation of trace metals (Mn,Zn, Cu,Pb) in Red Sea sediments,Gulf of Aden,Yemen

A sequential extraction technique was applied to estimate the chemical association of Mn, Zn, Cu and Pb in five chemical phases (exchangeable, carbonate, Fe–Mn oxides, organic matter and residual) in sediments of the Gulf of Aden, Yemen. The results indicated that a higher level of Mn was associated with the residual fraction (natural sources) than the non-residual fraction (anthropogenic sources). Zn fractionations revealed that it was associated more with Fe–Mn oxides and organic fractions than exchangeable and carbonate fractions. Most of the Cu was present in the residual form (60–72%) except for in the main port area (zone III), where it was associated with the organic phase (77% of the total Cu content, the organic matter content was 5%). Similarly, most Pb was bound in the residual fraction (56–71%) except the main port area where ～ 62% of the total Pb was bound in non-residual fractions. It was also found that the Pb concentration in the exchangeable fraction was very high compared with other metals. The risk assessment code for the metals showed a low risk for Zn and Cu, but low to medium risk for Mn. Fractionation of Pb showed medium risk at most of the regions except at the eastern area, which revealed a high risk for the aquatic environment.