Chemical composition and hygroscopic properties of size-segregated aerosol particles collected at the Adriatic coast of Slovenia

The chemical composition as well as the water uptake characteristics of aerosols was determined in size-segregated samples collected during November 2002 on the Slovenian coast. Major ions, water-soluble organic compounds (WSOC), short-chain carboxylic acids and trace elements were determined in the water-soluble fraction of the aerosol. Total aerosol black carbon (BC) was measured from filter samples. Our results showed that the origin of air masses is an important factor that controls the variation in the size distribution of the main components. Very high concentrations of WSOC as well as higher concentrations of BC were found under mostly continental influence. Besides the main ionic species (SO4(2-), NH4(+), K+) in the finest size fraction (0.17-0.53 microm), the concentration of NO3(-) was also high. The difference between the two different air mass origins is particularly expressed for Cl-, Na+, Mg2+ and Ca2+ determined in particles larger than 1.6 microm. As expected, a very good correlation was found between Na+ and Cl-. A good correlation was found between sea salt elements and elements of crustal origin (Na+, Cl-, Mg2+, Ca2+, Sr). A good relationship between typical anthropogenic tracers (K, V and Pb) was also observed. The mass growth factors, for all size fractions of aerosols collected under continental influence were very low (maximum 2.23 at 94%, 1.6-5.1 microm), while under marine influence the mass growth factors increased significantly with the particle size. At 97% humidity, the mass growth factors were 6.95 for the size fraction 0.53-1.6 microm and 9.78 for larger particles (1.6-5.1 microm).     

PCDD/Fs in ambient air collected in Zagreb, Croatia

Levels of PCDD/Fs were measured at four different sites in Zagreb, capital of Croatia. Also one sample was taken during spontaneously initiated open fire on a landfill and one sample where garden waste of unknown content was burnt. Over period 1997–2000, 28 samples were collected and levels ranged between 9 and 306 fg I-TEQ m⁻³, except in the sample collected during landfill fire. Air PCDD/F levels in Zagreb at four sites were different and the highest levels were observed in industrial area. Seasonal variation of levels is also evident with higher levels in winter than in summer. Our results show that PCDD/F levels in ambient air collected in Zagreb are at lower end of the published data range. In general, homologue profiles were quite similar for all locations, the concentration of PCDD homologues increased while the concentration of PCDF homologues decreased with increasing degree of chlorination. PCDD/F levels in the landfill fire sample was 13 200 fg I-TEQ m⁻³ which are much higher than levels in garden waste burning sample or in sample collected at industrial site. During landfill fire, the concentration of 2,3,7,8-TCDF becomes even higher than the concentration of OCDF and is equal to the concentration of 1,2,3,4,6,7,8-HpCDF.     

Classification of soil samples according to their geographic origin using gamma-ray spectrometry and principal component analysis

A principal component analysis (PCA) was used for classification of soil samples from different locations in Serbia and Montenegro. Based on activities of radionuclides ((226)Ra, (238)U, (235)U, (40)K, (134)Cs, (137)Cs, (232)Th and (7)Be) detected by gamma-ray spectrometry, the classification of soils according to their geographical origin was performed. Application of PCA to our experimental data resulted in satisfactory classification rate (86.0% correctly classified samples). The obtained results indicate that gamma-ray spectrometry in conjunction with PCA is a viable tool for soil classification.     

40K, 226Ra, 232Th, 238U and 137Cs relationships and behaviour in sedimentary rocks and sediments of a karstic coastal area (Kaštela Bay,Croatia) and related rocks and sediments’ differentiation

Environmental Science and Pollution Research - Natural (40K, 226Ra, 232Th, 238U) and anthropogenic (137Cs) radionuclides in consolidated sedimentary rocks (limestones s.l. and marls) and...     

Cytotoxicity of gamma irradiated aflatoxin B1 and ochratoxin A

Toxicity of gamma irradiated mycotoxins aflatoxin B₁ (AFB₁) and ochratoxin A (OTA) was investigated in vitro. AFB₁ and OTA stock solutions (50?mM, in methanol) were gamma irradiated (5 and 10 kGy) and non-irradiated and irradiated mycotoxins solutions were tested for cytotoxicity on Pk15, HepG2 and SH-SY5Y cell lines (MTT assay, 1–500?μM concentration range; 24?h exposure). Degradation of mycotoxin molecules was examined by liquid chromatography tandem mass spectrometry (HPLC-MS/MS). AFB₁ and OTA radiolytic products were less toxic than the parent mycotoxins to all of the tested cell lines. Gamma irradiation even at 5 kGy had effect on AFB₁ and OTA molecules however, this effect was dependent on chemical structure of mycotoxin. Since gamma irradiation at low dose reduced initial level of both mycotoxins, and gamma irradiated mycotoxins had lower toxicity in comparison to non-irradiated mycotoxins, it can be concluded that gamma irradiation could be used as decontamination method.     

Hydrochemical characteristics of mine waters from abandoned mining sites in Serbia and their impact on surface water quality

Upon completion of exploration and extraction of mineral resources, many mining sites have been abandoned without previously putting environmental protection measures in place. As a consequence, mine waters originating from such sites are discharged freely into surface water. Regional scale analyses were conducted to determine the hydrochemical characteristics of mine waters from abandoned sites featuring metal (Cu, Pb–Zn, Au, Fe, Sb, Mo, Bi, Hg) deposits, non-metallic minerals (coal, Mg, F, B) and uranium. The study included 80 mine water samples from 59 abandoned mining sites. Their cation composition was dominated by Ca²⁺, while the most common anions were found to be SO₄ ^2? and HCO₃ ^?. Strong correlations were established between the pH level and metal (Fe, Mn, Zn, Cu) concentrations in the mine waters. Hierarchical cluster analysis was applied to parameters generally indicative of pollution, such as pH, TDS, SO₄ ^2?, Fe total, and As total. Following this approach, mine water samples were grouped into three main clusters and six subclusters, depending on their potential environmental impact. Principal component analysis was used to group together variables that share the same variance. The extracted principal components indicated that sulfide oxidation and weathering of silicate and carbonate rocks were the primary processes, while pH buffering, adsorption and ion exchange were secondary drivers of the chemical composition of the analyzed mine waters. Surface waters, which received the mine waters, were examined. Analysis showed increases of sulfate and metal concentrations and general degradation of surface water quality.     

Radon diffusion in an anhydrous andesitic melt: a finite difference solution

Radon-222 diffusion in an anhydrous andesitic melt was investigated. The melts were glass discs formed artificially from melted volcanic materials. Solutions of the relevant diffusion equations were done by the explicit finite difference method. Results were compared to analytical solutions reported in the literature and good agreement was found. We have shown that the explicit finite difference method is effective and accurate for solving equations that describe ²²²Rn diffusion in andesitic melts, which is especially important when arbitrary initial and boundary conditions are required.     

Soybean-Oil-Based Polyisocyanurate Rigid Foams

Polyisocyanurate foams were prepared from polymeric 4,4-diphenylmethane diisocyanate (MDI), soy polyol and polypropylene oxide polyol by varying isocyanate index from 110 to 350. The higher isocyanate index produced polyisocyanurate foams with higher thermal stability, improved flame resistance, tensile strength, higher modulus, and higher glass transition. Soy-based foams displayed better thermal stability, lower flammability, higher rigidity (modulus) and higher compression strength than those based on the propylene oxide polyols of the same molecular weight and functionality.     

Influence of the organic complex concentration on adsorption of herbicide in organic modified montmorillonite

This study was undertaken to determine the impact of the organic complex concentration on the adsorption of herbicide (acetochlor) at the surface of the organic modified montmorillonite. In this work, natural montmorillonite from Bogovina (Boljevac municipality, Serbia) was used for organic modification. Cation-exchange capacity of this montmorillonite was determined using a methylene blue method (86 mmol/100 g of clay). Montmorillonite has been modified first with NaCl and then with hexadecyltrimethylammonium bromide (HDTMA-bromide) organic complex. Saturation of cation exchange capacity (CEC) was 50%, 100%, and 150%. Changes in the properties of the inorganic and organic montmorillonite have been examined using the X-ray diffraction, Fourier transform infrared spectroscopy, and batch equilibrium method. Montmorillonite modified with HDTMA-bromide demonstrated higher uptake of the herbicide, compared to the inorganic montmorillonite. Comparing the values Freundlich coefficients in batch equilibrium method, it can be seen that the adsorption of acetochlor decreased in the series: 0.5 CEC HM > 1 CEC HM > 1.5 CEC HM > NaM.