Changes in air saturation and air-water interfacial area during surfactant-enhanced air sparging in saturated sand

Reduction in the surface tension of groundwater, prior to air sparging for removal of volatile organic contaminant from aquifer, can greatly enhance the air content and the extent of influence when air sparging is implemented. However, detailed information on the functional relationship between water saturation, air-water contact area induced by air sparging and the surface tension of water has not been available. In this study, the influence of adding water-soluble anionic surfactant (sodium dodecyl benzene sulfonate) into groundwater before air sparging on the air-water interfacial area and water saturation was investigated using a laboratory-scale sand packed column. It was found that water saturation decreases with decreasing surface tension of water until it reaches a point where this trend is reversed so that water saturation increases with further decrease in the surface tension. The lowest water saturation of 0.58 was achieved at a surface tension of 45.4 dyn/cm, which is considered as the optimum surface tension for maximum de-saturation for the initially water-saturated sand used in this study. The air-water contact area generated in the sand column due to air sparging was measured using a gaseous interfacial tracer, n-decane, and was found to monotonically increase with decreasing water saturation. The results of this study provide useful design information for surfactant-enhanced air sparging removal of volatile contaminants from aquifers.     

Quality assured measurements of animal building emissions: gas concentrations

Comprehensive field studies were initiated in 2002 to measure emissions of ammonia (NH3), hydrogen sulfide (H2S), carbon dioxide (CO2), methane (CH4), nonmethane hydrocarbons (NMHC), particulate matter <10 microm in diameter, and total suspended particulate from swine and poultry production buildings in the United States. This paper focuses on the quasicontinuous gas concentration measurement at multiple locations among paired barns in seven states. Documented principles, used in air pollution monitoring at industrial sources, were applied in developing quality assurance (QA) project plans for these studies. Air was sampled from multiple locations with each gas analyzed with one high quality commercial gas analyzer that was located in an environmentally controlled on-farm instrument shelter. A nominal 4 L/min gas sampling system was designed and constructed with Teflon wetted surfaces, bypass pumping, and sample line flow and pressure sensors. Three-way solenoids were used to automatically switch between multiple gas sampling lines with > or =10 min sampling intervals. Inside and outside gas sampling probes were between 10 and 115 m away from the analyzers. Analyzers used chemiluminescence, fluorescence, photoacoustic infrared, and photoionization detectors for NH3, H2S, CO2, CH4, and NMHC, respectively. Data were collected using personal computer-based data acquisition hardware and software. This paper discusses the methodology of gas concentration measurements and the unique challenges that livestock barns pose for achieving desired accuracy and precision, data representativeness, comparability and completeness, and instrument calibration and maintenance.     

Evaluation of the persistence of micropollutants through pure-oxygen activated sludge nitrification and denitrification.

The persistence of pharmaceuticals, hormones, and household and industrial chemicals through a pure-oxygen activated sludge, nitrification, denitrification wastewater treatment facility was evaluated. Of the 125 micropollutants that were tested in this study, 55 compounds were detected in the untreated wastewater, and 27 compounds were detected in the disinfected effluent. The persistent compounds included surfactants, fire-retardant chemicals, pesticides, fragrance compounds, hormones, and one pharmaceutical. Physical-chemical properties of micropollutants that affected partitioning onto wastewater solids included vapor pressure and octanol-water partition coefficients.     

Effects of ultraviolet radiation and contaminant-related stressors on arctic freshwater ecosystems

Climate change is likely to act as a multiple stressor, leading to cumulative and/or synergistic impacts on aquatic systems. Projected increases in temperature and corresponding alterations in precipitation regimes will enhance contaminant influxes to aquatic systems, and independently increase the susceptibility of aquatic organisms to contaminant exposure and effects. The consequences for the biota will in most cases be additive (cumulative) and multiplicative (synergistic). The overall result will be higher contaminant loads and biomagnification in aquatic ecosystems. Changes in stratospheric ozone and corresponding ultraviolet radiation regimes are also expected to produce cumulative and/or synergistic effects on aquatic ecosystem structure and function. Reduced ice cover is likely to have a much greater effect on underwater UV radiation exposure than the projected levels of stratospheric ozone depletion. A major increase in UV radiation levels will cause enhanced damage to organisms (biomolecular, cellular, and physiological damage, and alterations in species composition). Allocations of energy and resources by aquatic biota to UV radiation protection will increase, probably decreasing trophic-level productivity. Elemental fluxes will increase via photochemical pathways.     

HCHs and DDTs in sediment-dwelling animals from the Yangtze Estuary, China

HCHs and DDTs in sediment-dwelling animals including mollusks and crabs from the Yangtze Estuary were determined by GC-ECD. Levels of t-HCH were in the range of 1.2-5.5 ng g(-1) and averaged 3.5 ng g(-1) in mollusks, while t-DDT concentrations ranged from 26.0 to 68.8 ng g(-1), with a mean of 34.5 ng g(-1). In crabs t-HCH concentrations varied from 2.0 to 25.7 ng g(-1) and averaged 13.8 ng g(-1), whereas the concentrations of t-DDT were in the range of 1.5-24.8 ng g(-1) with a mean value of 5.9 ng g(-1). The HCHs and DDTs levels depend on geographical position and sources, showing the high levels at fresh water area in the estuary, such as XP, CM and LHK sites, and lower at brackish water area, such as FX site, and little difference between species. Results also indicate there was no significant relationship between t-HCH (t-DDT) concentrations and lipid contents both in mollusks and crabs because of non-equilibrium state under a specific estuarine dynamics; smaller individuals accumulated more HCHs and DDTs than larger individuals of mollusks at LHK site, showing different uptake rate for these pesticides; moreover, HCHs and DDTs levels were lower in female crab bodies than male crab bodies suggesting that the release of spawning. BSAFs (Biota- Sediment Accumulation Factors) from sediment-dwelling animals for HCHs and DDTs show a significant "one high with two low" and "one low with two high" effect in the Yangtze Estuary.     

Modelling the extra and intracellular uptake and discharge of heavy metals in Fontinalis antipyretica transplanted along a heavy metal and pH contamination gradient

Samples of the aquatic bryophyte Fontinalis antipyretica Hedw. were transplanted to different sites with the aim of characterizing the kinetics of the uptake and discharge of heavy metals in the extra and intracellular compartments. The accumulation of metals in extracellular compartments, characterized by an initial rapid accumulation, then a gradual slowing down over time, fitted perfectly to a Michaelis-Menten model. The discharge of metals from the same compartment followed an inverse linear model or an inverse Michaelis-Menten model, depending on the metal. In intracellular sites both uptake and discharge occurred more slowly and progressively, following a linear model. We also observed that the acidity of the environment greatly affected metal accumulation in extracellular sites, even when the metals were present at relatively high concentrations, whereas the uptake of metals within cells was much less affected by pH.     

Tributyltin partitioning in sediments: effect of aging

The effect of aging on the solid/pore-water partitioning and desorption behaviour of tributyltin (TBT) in sediments was examined. Three sediment samples with contrasting physical and chemical properties were spiked with 10 mg/kg TBT and aged under sterile conditions for periods of time ranging from 1 to 84 days. Aging had a negligible effect on partitioning and desorption behaviour in a sandy sample with very low organic carbon content (0.2% w/w). In contrast, for samples with larger amounts of organic carbon (2.6% and 4.8% w/w), aging caused substantial increases in TBT sorption. For these samples, apparent distribution coefficients (KD,app) obtained from sequential 2 h desorption experiments also exhibited a twofold increase between spiked sediments subjected to aging for 1 day and 84 days. This study demonstrates that aging effects may be an important aspect of TBT fate in contaminated sediments.     

Anthropogenic metal enrichment of snow and soil in north-eastern European Russia

Trace metal composition of winter snowpack, snow-melt filter residues and top-soil samples were determined along three transects through industrial towns in the Usa basin, North-East Russia: Inta, Usinsk and Vorkuta. Snow was analysed for Ag, Al, As, Ba, Cd, Co, Cr, Cu, Mn, Ni, Pb, Sr and Zn using ICP-MS (Ca and K by F-AAS for Vorkuta only), pH and acidity/alkalinity. Filter residues were analysed for: Al, Ba, Ca, Cd, Cu, K, Mg, Mn, Ni, Pb, Sr and Zn using F-AAS and GF-AAS; top-soil samples were analysed for Ba, Cu, Mg, Mn, Na, Ni, Pb, Sr, Zn using F-AAS. Results indicate elevated concentrations of elements associated with alkaline combustion ash around the coal mining towns of Vorkuta and Inta. There is little evidence of deposition around the gas and oil town of Usinsk. Atmospheric deposition in the vicinity of Vorkuta, and to a lesser extent Inta, added significantly to the soil contaminant loading as a result of ash fallout. Acid deposition was associated with pristine areas whereas alkaline combustion ash near to emission sources more than compensated for the acidity caused by SO2.     

Macrobenthic community in the Douro estuary: relations with trace metals and natural sediment characteristics

The relationship between macrobenthic community structure and natural characteristics of sediment and trace metal contamination were studied in the lower Douro estuary (Portugal, NW, Iberian Peninsula), using an innovative threefold approach (SQG, Sediment Quality Guidelines), metal normalization to Fe, and macrobenthic community structure. This study allowed detection of a clear signature of anthropogenic contamination, in terms of Zn, Cu, Pb, and Cr in the north bank of the estuary, which experiences high urban pressure. Using the SQG approach, metal concentrations above ERM (effects range-median) were observed only at one sampling station, but several stations had levels above ERL (effects range-low). The macrobenthic community had a low diversity, with only 19 species found in the entire estuarine area, dominated by opportunistic species. The granulometric distribution of the sediments (estimated from the combination of organic matter, Fe and Al) seemed to be the major structuring factor for the communities, establishing the natural macrobenthic distribution pattern. The metals (Zn, Cu, Pb, and Cr) seemed to act as a disturbing factor over the natural distribution, with deleterious consequences for the macrobenthic communities.