车内空气中挥发性有机物的研究

采用热脱附-气相色谱/质谱联用法对4辆处于静止状态下的车辆内部空气中挥发性有机物（VOCs）进行了研究,共定性检出了48种有机物,其中C6～C9之间的组分较多;并对VOCs的总浓度进行了定量,1#～4#车分别为1846、2289、1104和3146 μg/m^3;其中BTEX占VOCs总量的20%～30%;车内VOCs浓度与温度及车辆使用年限密切相关.     

超声-过氧化氢-氧化铜组合技术催化氧化水中苯酚

研究了超声-H2O2-CuO组合技术对苯酚的降解效果。考察了苯酚初始浓度、溶液温度及鼓入空气对苯酚去除率的影响。实验结果表明，与未鼓入空气时相比，连续鼓气时苯酚的降解效果较好；初始浓度低，苯酚去除率高；溶液温度从20％上升到55％时，苯酚去除率随温度升高而增大，温度对该过程的影响主要表现为对催化剂的影响而不是对超声作用的影响。高效液相色谱分析表明，苯酚降解的中间产物主要为对苯二酚、邻苯二酚及其他有机小分子物质，最终产物为草酸、二氧化碳和水。     

一种高速反硝化颗粒污泥的培养

以葡萄糖为碳源,在USB反应器内接种好氧活性污泥在40 d内培养出良好的反硝化颗粒污泥.颗粒污泥形成经历了2个阶段:起始阶段,接种的好氧活性污泥中非反硝化菌逐渐衰亡演变为"惰性固体",与原有的固体一起,成为反硝化菌附着生长的载体,与此同时,反硝化菌在载体表面渐渐繁殖,形成细颗粒污泥;随后,反硝化菌在细颗粒污泥表面不断增殖,颗粒长大,发育成为成熟的颗粒污泥.成熟的颗粒污泥密实,表面均为杆状菌,且排列紧密,当污泥床容积负荷为19.1 g N/L·d时,去除率高达98.4%(N).     

活性炭纤维吸附废水中对硝基苯酚及其脱附研究

采用新型高效吸附剂——活性炭纤维吸附废水中对硝基苯酚，对其吸附和脱附影响因素进行了较详细的研究，确定了最佳工艺参数，并对动态吸附一脱附进行了稳定性实验。在最佳的吸附条件下，装填4g活性炭纤维可处理含对硝基苯酚1000mg/L的废水1400mL，出水对硝基苯酚浓度〈2mg／L，达到国家综合污水一级排放标准，活性炭纤维有效吸附量可达349．87mg／g。在最佳脱附条件下，脱附率〉99％，并可从高浓度脱附液中回收对硝基苯酚。稳定性实验表明，吸附-脱附性能稳定，采用活性炭纤维吸附处理对硝基苯酚废水是一种行之有效的处理方法。     

催化湿式氧化中负载型催化剂的稳定性与应用

催化剂在应用过程中必须具有良好的催化活性和稳定性.优化制备的CuO/γ-Al2O3催化剂用于处理高浓度难降解的乳化液废水时具有良好的催化活性,在200℃时反应2 h,TOC去除率为81.3%,比未加催化剂的湿式氧化提高了14.9%.该催化剂对分散兰废水具有更高的活性和稳定性:在220℃反应1.5 h后,COD和TOC去除率分别为68.8%和56.5%,比非催化氧化分别提高了18.7%和18.9%.     

Study on the cytotoxicity of microcystin-LR on cultured cells

The toxicity of purified blue-green algal toxin, microcystin-LR, on permanent cell lines KB, NIH/3T3, H-4-II-E, HeLa, Vero, Hep G2, Caco-2 and HL-60 was studied. Assessment of cell viability using colorimetric 3-(4,5-dimethylthiazol-2-yl)-2,5-diphenyltetrazolium bromide (MTT) assays indicated that purified microcystin-LR induced toxic effect on KB and H-4-II-E cell lines after 96 h incubation at toxin concentrations greater than 18.75 microg/ml. KB cell line was selected for further study when reproducibility, consistency and sensitivity were considered. Significant amounts of lactate dehydrogenase (LDH) were released from KB cells when incubation durations were 72 and 96 h with toxin concentrations of 18.75 microg/ml and higher. Although previous studies suggested that microcystin-LR had no cytotoxic effect on permanent cell lines, LDH release assay performed on KB cells indicated that exposure to microcystin-LR could result in damage to the cell membrane.     

一种新型烟气脱硫技术在燃煤锅炉上的扩大试验

介绍了用硫化碱加TFS添加剂进行燃煤锅炉煤气脱硫并副产硫代硫酸钠的中试成果。     

臭氧-曝气生物滤池处理酸性玫瑰红染料废水

在实验室配制含酸性玫瑰红染料的印染废水，采用臭氧氧化-曝气生物滤池工艺开展处理试验。试验运行结果表明，臭氧氧化处理能提高模拟废水的可生化性，BOD／COD值由原水的0．18上升到0．36。经组合工艺处理后出水COD〈40mg／L，色度40倍以下，SS约50mg／L，处理效果良好。     

超声波技术处理微污染水的实验研究

通过实验,对使用超声波技术处理微污染水的效果、机理进行了初步研究,实验结果表明,超声波对微污染水的细菌和色度去除效果明显,细菌的去除符合一级反应动力学方程,对COD和浊度去除有一定效果,但不显著。结果还发现,水体pH值随时间呈上升趋势。     

Characteristics of molecular weight distribution of dissolved organic matter in bromide-containing water and disinfection by-product formation properties during treatment processes

The characteristics of dissolved organic matter (DOM) and bromide ion concentration have a significant influence on the formation of disinfection by-products (DBPs). In order to identify the main DBP precursors, DOM was divided into five fractions based on molecular weight (MW), trihalomethane formation potential and haloacetic acid formation potential were determined for fractions, and the change in contents of different fractions and total DBPs during treatment processes (pre-chlorination, coagulation, sand filtration, disinfection) were studied. Moreover, the relationship between bromide concentration and DBP generation characteristics in processes was also analyzed. The results showed that the main DBP precursors were the fraction with MW < 1 kDa and fraction with MW 3−10 kDa, and the DBP''s generation ability of lower molecular weight DOM (< 10 kDa) was higher than that of higher molecular weight DOM. During different processes, pre-chlorination and disinfection had limited effect on removing organics but could alter the MW distribution, and coagulation and filtration could effectively remove organics with higher MW. For DBPs, trihalomethanes (THMs) were mainly generated in pre-chlorination and disinfection, while haloacetic acids (HAAs) were mostly generated during pre-chlorination; coagulation and sand filtration had little effect on THMs but resulted in a slight removal of HAAs. In addition, the results of ANOVA tests suggested that molecular sizes and treatment processes have significant influence on DBP formation. With increasing bromide concentration, the brominated DBPs significantly increased, but the bromine incorporation factor in the processes was basically consistent at each concentration.