Product Guide/1982

Abstract

An efficient venturi scrubber system making use of heterogeneous nucleation and condensational growth of particles was designed and tested to remove fine particles from the exhaust of a local scrubber where residual SiH₄ gas was abated and lots of fine SiO₂ particles were generated. In front of the venturi scrubber, normal-temperature fine-water mist mixes with high-temperature exhaust gas to cool it to the saturation temperature, allowing submicron particles to grow into micron sizes. The grown particles are then scrubbed efficiently in the venturi scrubber. Test results show that the present venturi scrubber system is effective for removing submicron particles. For SiO₂ particles greater than 0.1 μm, the removal efficiency is greater than 80–90%, depending on particle concentration. The corresponding pressure drop is relatively low. For example, the pressure drop of the venturi scrubber is ～15.4 ± 2.4 cm H₂O when the liquid-to-gas ratio is 1.50 L/m³. A theoretical calculation has been conducted to simulate particle growth process and the removal efficiency of the venturi scrubber. The theoretical results agree with the experimental data reasonably well when SiO₂ particle diameter is greater than 0.1 μm.     

The Autothermal Pyrolysis of Waste Tires

Abstract

The growing amount of rubber waste, such as that from tires and cables, has resulted in serious environmental problems. Since rubber waste is not easily biodegradable even after a long period of landfill treatment, material and energy recovery is the preferable alternative to disposal. The potential offered by waste tire pyrolysis for solving both energy and waste treatment problems is widely recognized. Pyrolysis is one method of inducing thermal decomposition without using any oxidizing agent, or using such a limited supply of the agent that oxidization does not proceed to an appreciable extent. The latter may be described as autothermal pyrolysis and will be studied in the present work.

The main objective of this research was to study the operating parameters of autothermal pyrolysis of scrap tires in a laboratory-scale fluidized bed reactor with a 100-cm bed height (10 cm I.D.) and a 100-cm freeboard (25 cm I.D.). Scrap tires were pyrolyzed in a limited oxygen supply, so that the heat for pyrolysis of the scrap tires was provided by combustion of some portion of the scrap tires. The operating parameters evaluated included the effect on the pyrolysis oil products and their relative proportions of (1) the air factor (O.O7–O35); (2) the pyrolysis temperature (370–570 °C); and (3) the catalyst added (zeolite and calcium carbonate). The results show that: (1) the composition of the liquid hydrocarbon obtained is affected significantly by the air factor; (2) the higher operating temperature caused a higher yield of gasoline and diesel; (3) the yield of gasoline increased due to the catalyst zeolite added, and the yield of diesel increased due to the addition of the catalyst calcium carbonate; (4) the principal constituents of gasoline included dipentene and diprene.     

Estimating Maximum Concentrations for Open Path Monitoring Along a Fixed Beam Path

ABSTRACT

Researchers have applied open path optical sensing techniques to a variety of workplace and environmental monitoring problems. Usually these data are reported in terms of a path-average (or path-integrated) concentration. When assessing potential human exposures along a beam path, this path-average value is not always informative, since concentrations along the path can vary substantially from the beam average. The focus of this research is to arrive at a method for estimating the upper-bound in contaminant concentrations over a fixed open beam path. The approach taken here uses a statistical model to estimate an upper-bound concentration based on a combination of the path-average and a measure of the spatial variability computed from point samples along the beam path. Results of computer simulations and experimental testing in a controlled ventilation chamber indicate that the model produced conservative estimates for the maximum concentration along the beam path. This approach may have many applications for open path monitoring in workplaces or wherever maximum concentrations are a concern.     

Application and Evaluation of Two Air Quality Models for Particulate Matter for a Southeastern U.S. Episode

Abstract

The Models-3 Community Multiscale Air Quality (CMAQ) Modeling System and the Particulate Matter Comprehensive Air Quality Model with extensions (PMCAMx) were applied to simulate the period June 29–July 10, 1999, of the Southern Oxidants Study episode with two nested horizontal grid sizes: a coarse resolution of 32 km and a fine resolution of 8 km. The predicted spatial variations of ozone (O₃), particulate matter with an aerodynamic diameter less than or equal to 2.5 μm (PM_2.5), and particulate matter with an aerodynamic diameter less than or equal to 10 μm (PM₁₀) by both models are similar in rural areas but differ from one another significantly over some urban/suburban areas in the eastern and southern United States, where PMCAMx tends to predict higher values of O₃ and PM than CMAQ. Both models tend to predict O₃ values that are higher than those observed. For observed O₃ values above 60 ppb, O₃ performance meets the U.S. Environmental Protection Agency's criteria for CMAQ with both grids and for PMCAMx with the fine grid only. It becomes unsatisfactory for PMCAMx and marginally satisfactory for CMAQ for observed O₃ values above 40 ppb.

Both models predict similar amounts of sulfate (SO₄ ^2?) and organic matter, and both predict SO₄ ^2? to be the largest contributor to PM_2.5. PMCAMx generally predicts higher amounts of ammonium (NH₄ ⁺), nitrate (NO₃ ^?), and black carbon (BC) than does CMAQ. PM performance for CMAQ is generally consistent with that of other PM models, whereas PMCAMx predicts higher concentrations of NO₃ ^?,NH₄ ⁺, and BC than observed, which degrades its performance. For PM₁₀ and PM_2.5 predictions over the southeastern U.S. domain, the ranges of mean normalized gross errors (MNGEs) and mean normalized bias are 37–43% and –33–4% for CMAQ and 50–59% and 7–30% for PMCAMx. Both models predict the largest MNGEs for NO₃ ^? (98–104% for CMAQ, 138–338% for PMCAMx). The inaccurate NO₃ ^? predictions by both models may be caused by the inaccuracies in the ammonia emission inventory and the uncertainties in the gas/particle partitioning under some conditions. In addition to these uncertainties, the significant PM overpredictions by PMCAMx may be attributed to the lack of wet removal for PM and a likely underprediction in the vertical mixing during the daytime.     

Toxicity of zinc oxide nanoparticles in the earthworm, Eisenia fetida and subcellular fractionation of Zn

The extensive use of nanoparticles (NPs) in a variety of applications has raised great concerns about their environmental fate and biological effects. This study examined the impact of dissolved organic matter (DOM) and salts on ZnO NP dispersion/solubility and toxicity to the earthworm Eisenia fetida. To be able to better evaluate the toxicity of NPs, exposure in agar and on filter paper was proposed for enabling a comparison of the importance of different uptake routes. A dose-related increase in mortality was observed in earthworms exposed in agar with almost 100% mortality after 96 h exposure to the highest concentration (1000 mg ZnO/kg agar). Scanning electron microscopy (SEM) showed that the addition of salts enhanced the aggregation of ZnO NPs in agar and consequently affected the dissolution behavior and biological availability of the particles. On filter paper, mortality was the highest at the lowest exposure concentration (50 mg ZnO/L) and seemed to decrease with increasing exposure levels. TEM images of ZnO showed that the solubility and morphology of NPs were changed dramatically upon the addition of humic acids (HA). The subcellular distribution pattern of Zn in earthworms after 96 h exposure in agar and on filter paper showed that the Zn taken up via dietary ZnO particles (from agar) was mainly found in organelles and the cytosol while the Zn accumulated as soluble Zn from filter paper was mainly distributed in cell membranes and tissues. Antioxidant enzymatic activities (SOD, CAT, and GSH-px) were investigated in the worms surviving the toxicity tests. A slight increase of SOD activities was observed at the lowest exposure dose of ZnO (50mg/kg), followed by a decrease at 100mg/kg in the agar cubes. Activities of both CAT and GSH-Px enzymes were not significantly influenced in the worms exposed to agar, although a slight decrease at 500 and 1000 mg ZnO/kg agar was observed. A similar change trend of SOD activities was observed for the earthworms on filter paper, but a significant decrease began at a higher ZnO NP concentration of 500 mg ZnO/L. The use of soil extracts instead of deionized water (DW) to simulate a realistic exposure system significantly reduced the toxicity of the ZnO NPs on filter paper, which increases the predictive power of filter paper toxicity tests for the environmental risk assessment of NPs.     

基于底泥再悬浮试验的太湖水质模拟

为探索浅水湖泊水动力扰动作用对底泥再悬浮影响的规律,在室内矩形水槽内模拟了各种水动力条件下太湖底泥的起动规律,得到了太湖底泥在3种不同起动标准下的起动流速,通过考察上覆水中悬浮物浓度的变化,建立了底泥沉积物再悬浮通量与水体流速的定量化关系。结果表明:太湖底泥在个别动、少量动、普遍动3种标准下的起动流速分别为15、30和40 cm/s,且底泥沉积物再悬浮通量与流速呈现线性正相关关系,再悬浮通量随流速增大而增大,且相关性较好。将该试验结果应用于太湖的水量水质数学模型中,并和太湖实测资料进行了对比,取得了比较满意的效果。该模拟装置能够在室内可控条件下较好地反映太湖沉积物再悬浮特征,对太湖的富营养化治理具有重要意义。     

Analyzing coastal wetland change in the Yancheng National Nature Reserve,China

Coastal zones provide habitat cores and corridors that maintain the diversity of entire landscapes, and they can form the cornerstone elements of regional conservation strategies. Natural environmental driving factors and excessive anthropogenic activities play important roles in coastal wetland change. Many studies have used remote sensing images to map and assess coastal wetland change on local or regional scales. This paper aims to provide insight into coastal wetland change in the Yancheng National Nature Reserve (YNNR) using remote sensing technology and landscape metrics analysis. The results reveal that grass flat and reed areas have significantly decreased, whereas agriculture fields, aquaculture ponds and built-up areas have continuously increased from 1988 to 2006. The spatial pattern of the coastal landscape has become fragmented and heterogeneous under great pressure from rapid economic development and population growth. The wetland changes have important impacts on natural habitat of the red-crowned cranes. The results of this study provide basic information that is required for developing measures toward a sustainable management and conservation of the YNNR.     

The influence of mariculture on mercury distribution in sediments and fish around Hong Kong and adjacent mainland China waters

To study the influence of mariculture on mercury (Hg) speciation and distribution in sediments and cultured fish around Hong Kong and adjacent mainland China waters, sediment samples were collected from six mariculture sites and the corresponding reference sites, 200-300 m away from the mariculture sites. Mariculture activities increased total mercury, organic matter, carbon, nitrogen and sulfur concentrations in the surface sediments underneath mariculture sites, possibly due to the accumulation of unconsumed fish feed and fish excretion. However, methylmercury (MeHg) concentrations and the ratio of MeHg to THg (% MeHg) in sediments underneath mariculture sites were lower than the corresponding reference sites. The % MeHg in sediments was negatively correlated (r = −0.579, p < 0.05) with organic matter (OM) content among all sites, indicating that OM may have inhibited Hg methylation in surface sediments. Three mariculture fish species were collected from each mariculture site, including red snapper (Lutjanus campechanus), orange-spotted grouper (Epinephelus coioides) and snubnose pompano (Trachinotus blochii). The average MeHg concentration in fish muscle was 75 μg kg⁻¹ (wet weight), and the dietary intake of MeHg through fish consumption for Hong Kong residents was 0.37 μg kg⁻¹ week⁻¹, which was lower than the corresponding WHO limits (500 μg kg⁻¹ and 1.6 μg kg⁻¹ week⁻¹).     

Residues and dynamics of pymetrozine in rice field ecosystem

The fate of pymetrozine was studied in rice field ecosystem, and a simple and reliable analytical method for determination of pymetrozine in soil, rice straw, paddy water and brown rice was developed. Pymetrozine residues were extracted from samples, cleaned up by solid phase extraction (SPE) and then determined by high-performance liquid chromatography electrospray ionization tandem mass spectrometry (LC-ESI-MS-MS). The average recovery was 81.2-88.1% from soil, 83.4-88.6% from rice straw, 87.3-94.1% from paddy water and 82.9-85.3% from brown rice. The relative standard deviation (RSD) was less than 15%. The limits of detection (LODs) of pymetrozine calculated as a sample concentration were 0.0003 mg kg⁻¹ (mg L⁻¹) for soil and paddy water, 0.001 mg kg⁻¹ for brown rice and rice straw. The results of kinetics study of pymetrozine residue showed that pymetrozine degradation in water, soil, and rice straw coincided with C = 0.194e^−0.986t, C = 0.044e^−0.099t, and C = 0.988e^−0.780t, respectively; the half-lives were about 0.70 d, 7.0 d and 0.89 d, respectively. The degradation rate of pymetrozine in water was the fastest, followed by rice straw. The highest final pymetrozine residues in brown rice were 0.01 mg kg⁻¹, which was lower than the EU’s upper limit of 0.02 mg kg⁻¹ in rice. Therefore, a dosage of 300-600 g a.i.hm⁻² was recommended, which could be considered as safe to human beings and animals.