关于内蒙古河套灌区面源污染防治的几点建议

河套灌区的主体为后套平原,总土地面积为1万平方公里,主要为黄河冲积平原。由于化肥、农药的大量使用,致使河套地区地表水体和地下水氮、磷普遍超标。本文针对河套面源污染问题,提出了几点防治措施。     

山东半岛典型海湾中烷基酚及双酚A的分布特征

烷基酚和双酚A是环境中最常见的内分泌干扰物。本研究对烟台四十里湾和套子湾以及青岛胶州湾表层海水中的壬/辛基酚(NP/OP)、壬/辛基酚单聚氧乙烯醚(NP1EO/OP1EO)以及双酚A(BPA)的浓度水平进行分析,结果显示:NP和NP1EO是最主要的污染物,河口和港口是海湾中污染物浓度最高的区域。总体而言,四十里湾中各污染物的浓度最高,其次为胶州湾,套子湾最低,与国内其他海湾区域相比,污染状况处于中等水平。相对于2005年,胶州湾水体中的烷基酚浓度明显降低。文章同时分析了几个湾的主要入海河流河水样品以及烟台污水处理厂出厂水样,发现污水处理厂出水是烟台四十里湾烷基酚的主要来源。在三个海湾中,烷基酚的分布主要受河流输入、生活污水排放和港口经济活动影响,同时,洋流和潮汐的稀释作用对污染物分布有明显影响。     

基于ASP.NET的安全信息管理系统

安全信息管理系统主要包括对安全信息数据的收集、存储、加工处理、传递和利用等功能.本文主要阐述了B/S结构的特点,以及一种全新的Web开发技术ASP.NET在安全信息管理系统中的应用.这使在Web上对安全信息数据进行增、删、改、查操作成为可能,对防止事故发生,减少由事故造成的损失,提高企业的安全管理水平等具有重要的现实意义.     

水产品中甲氰菊酯残留的ELISA快速检测

为快速检测水产品中甲氰菊酯的残留,应用水溶性碳化二亚胺(EDC)法将甲氰菊酸与牛血清白蛋白(BSA)和卵清蛋白(OVA)偶联,合成了甲氰菊酯的人工免疫抗原和包被抗原.免疫抗原经紫外扫描和聚丙烯酰胺电泳验证构建成功,用此抗原免疫试验兔子,获得了甲氰菊酯的多克隆抗体.经检测,抗体对甲氰菊酯具有较好的特异性和灵敏性.在此基础上建立了水产品中甲氰菊酯残留的间接ELISA检测法.理想的甲氰菊酯-OVA包被抗原质量浓度为1.6 mg/L,酶标二抗(羊抗兔IgG-HRP)的稀释度为1∶1000,多抗的稀释度为1∶3 200,最适检测范围为20～200 μg/kg,在实际样品检测时的最低检出限为20 μg/kg,接近或达到气相色谱法的测定水平,但检测速度大大提高,可在3 h内完成近百个样品的分析,适合甲氰菊酯的快速检测.     

黑藻吸附Cu2+机制研究

生物吸附法是一种经济有效的去除废水中有害重金属离子的方法.以黑藻(Hydrilla verticillata)干样为生物吸附材料,研究了黑藻对水体中Cu<'2+>等温吸附的基本特征,并通过测定吸附前后溶液离子浓度变化以及pH值、基团屏蔽对Cu<'2+>吸附的影响,结合红外光谱技术,从静电吸附作用、离子交换作用、基团作用...     

外加淀粉酶预处理污泥厌氧发酵产氢研究

通过外加淀粉酶预处理剩余污泥,考察了淀粉酶对污泥的破解效果,研究了接种产氢菌(Enterococcus sp.LG1)和未接种产氢菌两种状况下,污泥厌氧发酵产氢效果,并与相应温度(60℃)热预处理污泥的发酵产氢效果进行对比,同时分析探讨了污泥发酵产氢过程中底物和pH值的变化.结果表明,淀粉酶预处理污泥4h后水解效果最佳...     

脱水污泥等温干燥特性实验研究及回归分析

利用热重差热分析仪（DTG）对脱水污泥进行干燥实验,测定干燥参数和干燥条件对脱水污泥等温干燥特性的影响,研究了3个温度水平（85℃,100℃,120℃）,5个空气流速（10mL/min,20mL/min,40mL/min,50mL/min,70mL/min）和3个升温速率（15℃/min,20℃/min,40℃/min）。结果表明,样品的干燥速率随着终温的升高、升温速率和空气流速的增大而加快。脱水污泥的干燥过程主要分为加速、恒速和降速3个阶段,且降速干燥段在整个干燥过程中所占的比例较大。其干燥数学模型符合Page方程,经拟合得到 。验证表明,拟合方程算得的MR值与实验结果比较接近。该模型方程可用于描述城市污水污泥的干燥。     

Kinetics of enzymatic unhairing by protease in leather industry

In leather industry, unhairing is a heavy pollution operation. The conventional lime-sulfide process produces a large amount of sulfide which is toxic to health and difficult to dispose. Moreover, conventional lime-sulfide process leads to the destruction of the hair causing increased COD, BOD and TDS loads in the effluent. As an alternative method, enzymatic unhairing is a promising clean technology. The main utilized enzyme preparations are proteases.There are many reports about enzymatic unhairing, most of which are qualitative. The kinetics of enzymatic unhairing by protease was discussed in this article. It will provide useful information to enzymatic unhairing. In our research, by analysis of the concentrations of released total protein in enzyme bath during protease unhairing, the good linearity between released total protein and square root of time (min^1/2) was obtained at the initial stage. The good linearity suggests that enzymatic unhairing by protease is a diffusion-controlled process at the initial stage. The analysis of kinetics of released saccharides also confirms the same conclusion. On the other hand, the same characteristics between the kinetics of released saccharides and that of released total protein further confirms that it is the hydrolysis of core protein by protease that leads to the degradation of proteoglycans and the release of protein and saccharides. However, in our tests, the kinetics of released collagen indicates that the injury to skin took place in 3-6 h. Therefore, it’s necessary to control the time of protease unhairing within an appropriate limit.     

Mobilities and leachabilities of heavy metals in sludge with humus soil

Chemical forms of Zn, Ni, Cu, and Pb in municipal sewage sludge were investigated by adding humus soil to sludge and by performing sequential extraction procedures. In the final sludge mixtures, Zn and Ni were mainly found in Fe/Mn oxide-bound (F3) and organic matter/sulfide-bound (F4) forms. For Zn, exchangeable (F1), carbonate-bound (F2), and F3 forms were transformed to F4 and residual forms (F5). For Ni, F1 and F2 forms were transformed to F1, F2, and F3 forms. Both Cu and Pb were strongly associated with the stable forms F4 and F5. For Cu, F2 and F3 forms were major contributors, while for Pb, F3 and F4 forms were major contributors to F5. Humus soil dosage and pH conditions in the sludge were strongly correlated with the forms of heavy metals. Five forms were used to evaluate metal mobilities in the initial and final sludge mixtures. The mobilities of the four heavy metals studied decreased after 28 days. The metal mobilities in the final sludge mixtures were ranked in the following order: Ni > Zn > Cu = Pb. Leaching tests showed that the mobilities of Zn and Ni in lower pH conditions (pH 4) were higher than those in higher pH conditions (pH 8).     

改性膨润土处理污水处理厂二级出水的实验研究

研究基于再生水回灌地下、补充地下水水源的目的,使用河南信阳某膨润土厂生产的钠基膨润土,通过酸改性、铝柱撑改性和微波-硫酸亚铁改性制得三种改性膨润土,用于处理城市污水处理厂的二级出水.实验结果显示,经XRD衍射分析可知,三种方法制备的改性膨润土,其矿物结构都有不同程度上的变化,膨润土层间距都较膨润土原矿有所增大,可见其改...