环境地表γ计量率、工频电磁场和射频电场监测实验结果对比分析研究

本文通过两实验室针对环境地表γ计量率、工频电磁场和射频电场仪器对比实验,并对结果进行了统计检验。分析结果表明,两者监测数据无显著差异。     

主成分分析法在煤矿事故统计分析中的应用

为了研究我国煤矿各类事故之间的相互关系,运用主成分分析法对我国煤矿事故数据进行了统计分析,计算得到煤矿事故类型的第一主成分和第二主成分,并进一步分析了煤矿事故的主要类型以及各类事故之间的相互联系,对制定相应的煤矿事故预防措施具有一定的指导作用。     

小回流比条件下污泥浓度分区试验研究

用次毫米过滤（sub-milliFiltration,SMF）组件将生物处理系统内的污泥分为高浓度区和低浓度区,使高浓度区保持大量污泥,强化对有机物的去除,使低浓度区污泥浓度满足膜分离的要求.主要验证了小回流比（R为0.5、1.0、1.5、2.0）条件下污泥浓度分区的效果,考察了采用SMF组件后,系统对COD的去除效果,并将各小回流比条件下A、B两区污泥浓度的理论值和实测值做比较.结果表明,在小回流比条件下可实现污泥浓度分区,低浓度区的MLSS在9 g.L-1以下,高浓度区的MLSS在20 g.L-1以上;系统的COD平均去除率超过90%;A、B两区MLVSS的理论值与实测值具有相关性.     

UAFB-缺氧-好氧MBR组合工艺处理生活污水效能研究

为了同时达到从生活污水中回收能源性气体和深度处理生活污水的目的,试验采用升流式厌氧污泥固定床(up-flowanaerobic fixed bed,UAFB)-缺氧-好氧膜生物反应(membrane bioreactor,MBR)组合工艺处理生活污水.试验重点研究了组合工艺对生活污水的处理效能,包括能源性气体的产生效能、对污染物质的处理效能以及对污泥浓度的控制.UAFB-缺氧-好氧MBR组合工艺在温度20℃、厌氧HRT为3 h、缺氧HRT为3 h、好氧HRT为3.5 h的条件下运行,甲烷气体的产生量为1.55L/d,COD去除率为93.28%,NH 4+-N去除率为90.60%,UAFB出水VFAs总量54.74 mg/L,TN去除率为45.51%.试验发现,组合工艺可以长期维持反应器内较低的污泥浓度,大大减小了剩余污泥的处理量,在一定程度上实现了污泥减量化,同时较低的污泥浓度有利于缓解膜污染.     

生物沸石对吡啶、喹啉的降解与吸附作用

探讨了通过生物沸石的降解及吸附作用,解决吡啶、喹啉及转化产物NH 4+-N的污染问题.结果表明,生物沸石中的吡啶降解菌Shinella zoogloeoides BC026及喹啉降解菌Pseudomonas sp.BW003能有效去除吡啶、喹啉,同时转化后的NH 4+-N也能被天然沸石或改性沸石所吸附.尽管改性沸石吸附能力不如天然沸石,但其表面能更有效附着微生物,在实际工程应用上更具前景.     

祁连山高山草甸土壤CO2通量的时空变化及其影响分析

采用Li-6400便携式光合作用测量系统连接Li-6400-09土壤呼吸室,在2004年生长季节对祁连山高山草甸土壤CO₂通量沿海拔梯度进行了野外定位试验,统计分析了水热因子及根系生物量对高山草甸土壤CO₂通量特征的可能影响.结果表明,土壤CO₂通量存在明显的空间变化规律, 沿海拔梯度土壤CO₂通量随着海拔梯度的增加而逐渐减小,其变异系数逐渐增加;就日变化而言,土壤CO₂通量晚间维持在较低水平,02：00～06：00最低,在07：00～08：30开始升高,11：00～16：00达到峰值,16：00～18：30开始下降,整个过程呈单峰曲线.土壤CO₂通量的日平均值介于(0.56±0.32) ～ (2.53±0.76) μmol·(m²·s)^-1.从季节变化来看,土壤CO₂通量均以夏秋季较高,春冬季排放量较低,7～8月份达到最大值［4.736 μmol·(m²·s)^-1］,6月与9月份次之,5月与10月份基本一致,整个生长过程总的变化趋势呈单峰曲线形式.高山草甸土壤CO₂通量在植物生长季与10 cm土壤温度、土壤含水量、根系生物量都存在不同程度的正相关关系,表明高山草甸土壤CO₂通量的空间变异主要受温度、水分和植物根系的综合影响.     

基于部分湿式氧化法的污泥资源化研究

介绍了部分湿式氧化法的基本原理,指出COD去除率是判断是否部分湿式氧化的重要指标。用高压反应釜进行污泥处理,在一定的温度、压力和适合氧气量的条件下,考察了COD去除率、有机物降解率、pH值、过滤性能等随反应时间的变化。试验结果表明,通过控制反应时间,可以实现污泥的部分湿式氧化。考察了污泥经过部分湿式氧化后产物的性质,包括颗粒分布、有机物含量、养分含量和重金属等项目,分析结果表明,产物具有良好的资源化前景。     

Mobilities and leachabilities of heavy metals in sludge with humus soil

Chemical forms of Zn, Ni, Cu, and Pb in municipal sewage sludge were investigated by adding humus soil to sludge and by performing sequential extraction procedures. In the final sludge mixtures, Zn and Ni were mainly found in Fe/Mn oxide-bound (F3) and organic matter/sulfide-bound (F4) forms. For Zn, exchangeable (F1), carbonate-bound (F2), and F3 forms were transformed to F4 and residual forms (F5). For Ni, F1 and F2 forms were transformed to F1, F2, and F3 forms. Both Cu and Pb were strongly associated with the stable forms F4 and F5. For Cu, F2 and F3 forms were major contributors, while for Pb, F3 and F4 forms were major contributors to F5. Humus soil dosage and pH conditions in the sludge were strongly correlated with the forms of heavy metals. Five forms were used to evaluate metal mobilities in the initial and final sludge mixtures. The mobilities of the four heavy metals studied decreased after 28 days. The metal mobilities in the final sludge mixtures were ranked in the following order: Ni > Zn > Cu = Pb. Leaching tests showed that the mobilities of Zn and Ni in lower pH conditions (pH 4) were higher than those in higher pH conditions (pH 8).     

Adsorptive property of Cu^2＋-loaded montmorillonite clays for Escherichia coli K_（88） in vitro

The Cu²⁺-loaded montmorillonite clays (MMT-Cu) may be a good material for the adsorbed and eliminated pathogenic bacteria from aqueous solution.     

Effect of C/N ratio, aeration rate and moisture content on ammonia and greenhouse gas emission during the composting

Gaseous emission (N₂O, CH₄ and NH₃) from composting can be an important source of anthropogenic greenhouse gas and air pollution. A laboratory scale orthogonal experiment was conducted to estimate the effects of C/N ratio, aeration rate and initial moisture content on gaseous emission during the composting of pig faeces from Chinese Ganqinfen system. The results showed that about 23.9% to 45.6% of total organic carbon (TOC) was lost in the form of CO₂ and 0.8% to 7.5% of TOC emitted as CH₄. Most of the nitrogen was lost in the form of NH₃, which account for 9.6% to 32.4% of initial nitrogen. N₂O was also an important way of nitrogen losses and 1.5% to 7.3% of initial total nitrogen was lost as it. Statistic analysis showed that the aeration rate is the most important factor which could affect the NH₃ (p = 0.0189), CH₄ (p = 0.0113) and N₂O (p = 0.0493) emissions significantly. Higher aeration rates reduce the CH₄ emission but increase the NH₃ and N₂O losses. C/N ratio could affect the NH₃ (p = 0.0442) and CH₄ (p = 0.0246) emissions significantly, but not the N₂O. Lower C/N ratio caused higher NH₃ and CH₄ emissions. The initial moisture content can not influence the gaseous emission significantly. Most treatments were matured after 37 days, except a trial with high moisture content and a low C/N ratio.