Fe-MCM-41催化氧化2,4-二氯苯氧乙酸

采用水热法合成了Fe-MCM-41中孔分子筛,紫外、红外及XRD表征显示铁离子已进入中孔分子筛骨架。以H2O2为氧化剂形成类Fenton试剂,实验结果表明,在催化剂加入量为1 g/L、H2O2体积分数为6%、pH为4、反应时间为10h、反应温度为35℃的条件下,处理质量浓度为50 mg/L的2,4-D废水的降解率达94.95%。宏观动力学研究显示,该反应近似为一级反应,反应速率常数、表观活化能分别为0.21667 min-1和26.65 kJ/mol。     

进水水质成分改变引发的污泥粘性膨胀及控制

在研究强化SBR工艺除污性能时,由于可溶性淀粉投加导致进水水质成分发生改变,污泥沉降性能在短时间内迅速恶化,污泥出现大量的粘液。镜检发现,大量指状菌胶团异常增殖且丝状菌的数量也逐渐减少。实验结果表明,系统膨胀属于污泥粘性膨胀。停止可溶性淀粉和提高主反应池的DO浓度,污泥粘性膨胀并未得到恢复,但污泥粘液逐渐消失。粘液消失后,通过模拟前期进水水质成分和缩短泥龄,污泥粘性膨胀得以控制,污泥沉降性能在短时间内恢复。实验还研究了污泥粘性膨胀对污染物去除性能的影响。     

稠油火驱开采技术节能减排效果分析

火驱作为稠油热采的有效接替技术,与注蒸汽开采技术相比,具有采收率高,能耗低,CO_2排放少的优势。文章从火驱驱油机理特征阐述了火驱与注蒸汽技术的不同点,从燃料开采能耗、热效率、注入剂资源、数据对比四个方面分析火驱比注蒸汽热效率高,无燃料开采成本,能耗是注蒸汽的50%;从CO_2气体排放方式和排放量对比可知,火驱能够减少温室气体排放,为油田节能减排、环保生产起到积极作用。     

事故状态下污染物排放对水环境影响的预测研究

对辽河油田欢喜岭采油厂在事故状态下污染物排放对大凌河水域环境的影响进行预测研究。计算了洪水淹没、油罐冒顶泄漏、油井井喷泄漏、联合站泄漏、管道泄漏、暴雨径流带走落地油等16种情景下对该河流水质的影响情况,并建立数学模型,进行情景模拟。研究结果表明,事故状态下对大凌河水质影响的次序由大到小依次为:洪水淹没、油罐冒顶泄漏、油井井喷泄漏、联合站泄漏、管道泄漏、暴雨径流。     

Immobilization of non-point phosphorus using stabilized magnetite nanoparticles with enhanced transportability and reactivity in soils

Laboratory batch and column experiments were conducted to investigate the immobilization of phosphorus (P) in soils using synthetic magnetite nanoparticles stabilized with sodium carboxymethyl cellulose (CMC-NP). Although CMC-stabilized magnetite particles were at the nanoscale, phosphorus removal by the nanoparticles was less than that of microparticles (MP) without the stabilizer due to the reduced P reactivity caused by the coating. The P reactivity of CMC-NP was effectively recovered when cellulase was added to degrade the coating. For subsurface non-point P pollution control for a water pond, it is possible to inject CMC-NP to form an enclosed protection wall in the surrounding soils. Non-stabilized “nanomagnetite” could not pass through the soil column under gravity because it quickly agglomerated into microparticles. The immobilized P was 30% in the control soil column, 33% when treated by non-stabilized MP, 45% when treated by CMC-NP, and 73% when treated by both CMC-NP and cellulase.     

Adsorption of arsenic(V) by iron-oxide-coated diatomite (IOCD)

Purposes and aims  

Economically efficient methods for removing arsenic from the drinking water supply are urgently needed in many parts of the world. Iron oxides are known to have a strong affinity for arsenic in water. However, they are commonly present in the forms of fine powder or floc, which limits their utility in water treatment. In this study, a novel granular adsorbent, iron-oxide-coated diatomite (IOCD), was developed and examined for its adsorption of arsenic from water.     

废弃中药渣催化热解制取生物油的研究

利用热重分析仪(TGA)对植物类中药渣的热解特性进行了研究,用Coats-Redfern积分法计算了其热解动力学参数,得出中药渣热解反应符合一级反应动力学方程,其活化能较低,为36.0kJ/mol。考察了热解温度对气体、液体、固体产物的影响,在723K时,液体产物生物油产率最高,为39%。以介孔分子筛SBA-15以及分别负载Al、Sn、Ni、Cu和Mg的SBA-15作为催化剂,研究催化热解对气体、液体、固体产率及生物油组分的影响。研究表明,Al-SBA-15的催化效果较好,液体产率最高,为36%;采用元素分析仪和热值测定仪,得到用Al-SBA-15作为催化剂时生物油的氧质量分数最低,低位热值最高。用GC/MS对生物油组分的分析结果表明,添加Al-SBA-15后,热解产物中脂肪族和芳香族化合物增加,而含氧化合物减少。     

生物法-人工湿地组合工艺处理小城镇混合污水研究

为适应小城镇污水处理高效、低耗、管理简单的要求,开展了生物法(水解酸化/生物接触氧化)-人工湿地组合工艺(A/BCO-CW)处理小城镇片区混合污水的研究。结果表明,A/BCO系统在停留时间为3～6 h条件下,对悬浮物和有机物有高的去除效率,COD、BOD5和TSS去除率分别达到63.1%、67.7%和66.2%,避免了人工湿地堵塞和提高处理效率,减少了所需湿地面积44%。全年运行结果表明,在0.30～0.59 m/d水力负荷率下,垂直流-表面流-水平潜流人工湿地组合系统对COD、BOD5和TSS平均去除负荷达9.4、5.1和7.2 g/(m2.d)(42%、71.2%和85.2%);COD、BOD5去除速率常数为74.6±12.1 m/y、166±30.5 m/y,这些数值均处于文献中k值范围的高量程内。A/BCO-人工湿地系统对COD、BOD5和TSS具有好的处理效果,出水水质能够稳定达到《地表水环境质量标准》(GB 3838-2002)的IV类水标准,2种处理方法有效组合起来,所开发的低成本、高效率、可持续运行的城镇废水处理组合系统,将会在实际应用尤其是高有机负荷污水处理中发挥良好效用。     

藻类打捞对水体营养循环的影响及其生态效果研究

富营养化水体中的藻华是氮磷的富集器,太湖打捞藻样中的总氮、总磷、游离磷及有机物含量分别为98.87g/kg、3.25 g/kg、0.21 g/kg和95.65%。在底泥中沉降藻类的矿质化周期随着温度的升高而缩短;且其向上覆水中释放氮、磷的强度具有随水温升高而增强的趋势。但在水层厚/底泥比不同的区域,这种营养物释放强度又存在显著的差异。实验证明,藻类的打捞是一种人工延长食物链去除氮磷等污染物的有效方法。     

Characterization of plutonium in deep-sea sediments of the Sulu and South China Seas

Anthropogenic Pu isotopes are important geochemical tracers for sediment studies. Their distributions and sources in the water columns as well as the sediments of the North Pacific have been intensively studied; however, information about Pu in the Southeast Asian seas is limited. To study the isotopic composition of Pu, and thus to identify its sources, we collected sediment core samples in the South China Sea and the Sulu Sea during the KH-96-5 Cruise of the R/V Hakuho Maru. We analysed the activities of ^239+240Pu and the atom ratios of ²⁴⁰Pu/²³⁹Pu using isotope dilution sector-field inductively coupled plasma mass spectrometry (SF-ICP-MS). The ²⁴⁰Pu/²³⁹Pu atom ratios in the sediments of both areas (inventory weighted mean: 0.251 for the South China Sea and 0.280 for the Sulu Sea) were higher than the global fallout value (0.178 ± 0.019), suggesting the existence of Pu from the Pacific Proving Grounds in the North Pacific. Low inventories of ^239+240Pu in sediments were observed in the South China Sea (3.75 Bq/m²) and the Sulu Sea (1.38 Bq/m²). Most of the Pu input is still present in the water column. Scavenging and benthic mixing processes were considered to be the main processes controlling the distribution of Pu in the deep-sea sediments of both study areas.