Response to environmental flows in the Lower Tarim River, Xinjiang, China: an ecological interpretation of water-table dynamics

Increased water-dependent development and utilization have led to significant environmental and hydrological degradation of the Tarim River in western China and its dependent ecosystems. Between the 1950s and 1970s, 350 km of the lower reaches were drained and between 1960 and 1980 the water-table fell from between −2 and −3 m to between −8 and −10 m. Subsequently, riparian ecosystems were seriously degraded. In 2000, the Chinese government launched a program to restore the lower reaches of the river. Four environmental flows of 1034×10⁶ m³ were released from 2000 to 2002. This paper interprets and discusses the ecological significance of changes following the releases and identifies the relationship between water-table dynamics and vegetation responses. Short-term objectives for river restoration are proposed with possible monitoring parameters suggested.     

高压管汇磁致伸缩导波缺陷检测模拟研究

针对高压管汇导波缺陷检测问题,基于磁致伸缩效应,借助COMSOL有限元仿真软件,建立高压管汇直管段的导波缺陷检测模型,探究导波的激励条件及缺陷检测效果,分析不同参数对缺陷附近磁感应强度分布的影响。研究结果表明:在频率为10 kHz的正弦电流信号激励下,可产生沿管道轴向传播的T（0,1）模态导波,并能辨别缺陷处的回波信号。改变缺陷的尺寸参数时,缺陷附近的磁感应强度随着缺陷深度增加呈增大趋势,随轴向宽度增加呈减小趋势,不同形状的缺陷对应的磁感应强度存在一定的差异;改变激励条件,磁感应强度均随激励电流、激励频率的增加呈不断增加趋势。     

缺氧—好氧—催化臭氧氧化工艺处理石化厂含盐废水

采用缺氧—好氧—催化臭氧氧化工艺处理某石化厂的含盐废水。实验结果表明：在进水COD为200~350 mg/L的条件下,经生化处理后的出水COD稳定在50~60 mg/L,COD去除率稳定在75%左右;在臭氧投加量为4.5 g/L、V（催化剂Ⅱ）∶V（废水）=1.5∶1的条件下,进行连续催化臭氧氧化后出水COD稳定在20 mg/L以下,COD去除率大于70%,满足DB 61/224—2011《黄河流域（陕西段）污水综合排放标准》。表征结果显示,催化剂表面含有铜元素,比表面积为250.815 m²/g,吸水率为60.9%,经过滤可去除废水中残留的催化剂。     

膜分离—变压吸附耦合工艺处理催化剂载体生产废气

采用膜分离—变压吸附耦合工艺处理DQ催化剂载体生产过程产生的高浓度挥发性有机物（VOCs）废气。实验结果表明：在进气正己烷和非甲烷总烃的质量浓度分别为95 000~212 000 mg/m³和100 000 ~220 000 mg/m³、渗余侧压力0.25 MPa、渗透侧真空度0.09 MPa、进气流量15 Nm³/h的条件下,膜分离单元对废气中正己烷及非甲烷总烃的平均去除率分别为97.88%和97.29%;变压吸附单元对正己烷及非甲烷总烃的平均去除率分别为99.35%和99.33%;整套装置对正己烷及非甲烷总烃的平均总去除率分别为99.99%和99.98%。平均正己烷回收率达95.56%。处理后废气中非甲烷总烃质量浓度小于70 mg/ m³,达到北京市DB 11/ 447—2007 《炼油与石油化学工业大气污染物排放标准》的一级指标。     

Fabrication and performance of PET mesh enhanced cellulose acetate membranes for forward osmosis

Polyethylene terephthalate mesh(PET) enhanced cellulose acetate membranes were fabricated via a phase inversion process. The membrane fabrication parameters that may affect the membrane performance were systematically evaluated including the concentration and temperature of the casting polymer solution and the temperature and time of the evaporation, coagulation and annealing processes. The water permeability and reverse salt flux were measured in forward osmosis(FO) mode for determination of the optimal membrane fabrication conditions. The optimal FO membrane shows a typical asymmetric sandwich structure with a mean thickness of about 148.2 μm. The performance of the optimal FO membrane was tested using 0.2 mol/L Na Cl as the feed solution and 1.5 mol/L glucose as the draw solution. The membrane displayed a water flux of 3.47 L/(m2·hr) and salt rejection of95.48% in FO mode. While in pressure retarded osmosis(PRO) mode, the water flux was4.74 L/(m2·hr) and salt rejection 96.03%. The high ratio of water flux in FO mode to that in PRO mode indicates that the fabricated membrane has a lower degree of internal concentration polarization than comparable membranes.     

呼吸性粉尘浓度测定值的采用与统计

通过对刘冲矿大量测试数据的解析，论证了矿山各工人群呼吸性粉尘浓度对数值遵从正态分布规律，并在此基础上提出了工人群呼吸性粉尘浓度测定值的采用与统计应遵循的原则和方法，对正确推行呼吸性粉尘监测新技术具有重要意义。     

夏季城市大气O3浓度影响因素及其相关关系

利用2003年夏季济南市区近地面大气O₃、相关前体物和气象因素等观测数据,研究了O₃浓度的分布特征及时间变化规律,分析了7月份O₃与NO、NO₂和CO等前体物及太阳辐射和气温气象条件的相关性.结果表明,济南市区夏季O₃污染比较严重,观测期间各污染物O₃、NO、NO₂、NO_x和CO浓度都相对较高,昼间O₃与各前体物的浓度呈较好的负相关关系,与太阳辐射具有非常明显的相关性,而与气温的相关性不明显.根据以上分析结果,利用回归分析方法,建立了昼间O₃浓度与前体物、气象因子之间的相关模式,结果表明O₃浓度的计算值与观测值符合性较好.     

多壁碳纳米管对土壤微生物的生态毒理效应

以多壁碳纳米管为研究对象,从生化作用、酶活性、微生物数量和群落结构4个方面系统评估其对土壤微生物的影响.设置两组实验,分别为碳纳米管组和对照组.对于碳纳米管组,按1 mg碳纳米管·g-1土的浓度将多壁碳纳米管与土样均匀混合,对照组中不加入多壁碳纳米管.定期(每28 d)取样测定两组土壤中的各项生态毒理指标.近5个月的实验结果显示,不同指标对多壁碳纳米管的响应不同.土壤呼吸作用初期受抑制但后期恢复,氨化作用初期被促进但后期被抑制,脱氢酶活性发生增强和抑制两次波动,荧光素二乙酸酯酶活性在整个实验期间一直被抑制,微生物量出现先减少后增加再减少的规律,群落结构在实验初期和后期均有较大变化.总体上,多壁     

不同温度下约束钢梁的落锤冲击响应分析

研究不同温度和冲击荷载作用下约束钢梁的动力响应问题。利用通用非线性有限元分析程序ANSYS/LS-DYNA,分别模拟了两端固支、一端固支一端轴向弹簧约束的钢梁在不同温度下受到落锤冲击时的动力响应。在温度荷载和冲击荷载联合作用下,分析了位移响应、撞击力时程曲线及冲量等的温度效应。通过撞击力时程曲线分析得出最大撞击力随温度的变化趋势与欧洲规范EC3给出的不同温度下的钢材的屈服强度折减系数的变化趋势相似,钢梁跨中的横向位移随着温度的升高而增加。还分析了高温和冲击荷载联合作用下落锤的撞击速度、不同的质量—速度组合、横向加劲肋对钢梁的变形的影响。     

Measurement and identification of relative poverty level of pastoral areas: an analysis based on spatial layout

Environmental Science and Pollution Research - Pastoral areas are the key difficulty in China’s pursuit of common prosperity and a key region for China to build the northern ecological safety...