Monitoring of the booster biocide dichlofluanid in water and marine sediment of Greek marinas

Dichlofluanid (N-dichlorofluoromethylthio-N'-dimethyl-N-phenylsulphamide) is used as booster biocide in antifouling paints. The occurrence of dichlofluanid and its metabolite DMSA (N'-dimethyl-N-phenyl-sulphamide) was monitored in seawater and marine sediment from three Greek marinas. Seawater and sediment samples were collected at three representative positions and one suspected hotspot in each marina and shipped to the laboratory for chemical analysis. As part of the project, an analytical method had been developed and validated. Furthermore, some additional experiments were carried out to investigate the potential contribution of paint particle bound dichlofluanid on the total concentration in the sediment. As expected, given its known high hydrolytic degradation rate, no detectable concentrations of dichlofluanid were measured in any of the seawater samples. DMSA was detected in seawater samples at very low concentrations varying from <3 ng l(-1) (LOD) to 36 ng l(-1). During method validation, it had already been demonstrated that dichlofluanid is unstable in sediment and can therefore only be determined as its metabolite DMSA. In a separate experiment, in which marine sediment was spiked with artificial paint particles containing dichlofluanid and then analysed according to the validated method, it was demonstrated that if there is any dichlofluanid originating from paint particles, this would be determined as DMSA. No DMSA was detected in any of the sediment samples. It could therefore be concluded that there were no significant concentrations of dichlofluanid in the sediment samples.     

Enhanced experimental flexibility and control in ecotoxicological mesocosm experiments--a new outdoor and indoor pond and stream system

Scope The German Federal Environmental Agency has put into operation a new modular mesocosm system consisting of eight outdoor and eight indoor ponds and streams in order to investigate fate and effects of chemicals and municipal wastewater in aquatic ecosystems. General design and special characteristics are given to demonstrate the wide range of possibilities for experimental research. - General design. Each of the 16 streams with riffle and pool sections can be varied in length up to 106 m. The streams can be run as circular or flow-through systems at a flow velocity of 0.02 to 0.6 m/s. Physico-chemical standard parameters are measured on-line. The 16 ponds, which can be connected to the stream systems, are equipped with drainage and pore water-sampling devices for simulating processes in the littoral zone including influent and effluent ground water flow. Perspectives Since the highly flexible and controllable construction also allows treating a wide range of hydrological and ecological experiments external institutions are invited to submit proposals.     

Influence of pre-treatment step on PAHs analyses in contaminated soils

There is no specific standardization for the pre-treatment of a soil sample for PAHs analyses. The ISO/FDIS 14507 method for soil quality gives a guidance for sample pre-treatment before measurement of organic contaminants in soil. It refers to cryogenic crushing which is not so easy to carry out. So, analysts lead to develop in house methods which can be very different from a laboratory to another and can involve deviations in the pollution quantification. This study has explored different ways of drying, grinding and sieving in order to determine the influence of the soil sample handling on the measured pollutant concentration. It appears that the influence of pre-treatment depends on the soil nature and on the PAHs distribution. As a conclusion, it is advised "light" drying ways like air drying or drying at 40 degrees C in a drying oven instead of more "drastic" ways (freeze-drying, cryogenic crushing) which can induce some losses. Crushing and sieving are also recommended for more reproducible measures.     

A lysimeter experiment to investigate the leaching of veterinary antibiotics through a clay soil and comparison with field data

Pharmaceuticals used in livestock production may be present in manure and slurry as the parent compound and/or metabolites. The environment may therefore be exposed to these substances due to the application of organic fertilisers to agricultural land or deposition by grazing livestock. For other groups of substances that are applied to land (e.g. pesticides), preferential flow in clay soils has been identified as an extremely important mechanism by which surface water pollution can occur. This lysimeter study was therefore performed to investigate the fate of three antibiotics from the sulphonamide, tetracycline and macrolide groups in a clay soil. Only sulphachloropyridazine was detected in leachate and soil analysis at the end of the experiment showed that almost no antibiotic residues remained. These data were analysed alongside field data for the same compounds to show that soil tillage which breaks the connectivity of macropores formed over the summer months, prior to slurry application, significantly reduces chemical mobility.     

Biohydrogen production through fermentation using liquid swine manure as substrate

In this paper, continuous production of hydrogen through fermentation with liquid swine manure as substrate was researched using a semi-continuously fed fermenter (8 L in total volume and 4 L in working volume). The pH and temperature for the fermenter were controlled at 5.3 +/- 0.1 and 35 +/- 1 degrees C, respectively, throughout the experiment. Three hydraulic retention times (16, 20, and 24 h) were investigated for their impact on the efficiency and performance of the fermenter in terms of hydrogen yields. The results indicate that hydraulic retention time (HRT) has a strong influence on the fermenter performance. An increasing HRT would increase the variation in hydrogen concentration in the offgas. To produce hydrogen with a fairly consistent concentration, the HRT of the fermenter should not exceed 16 h, which, however, did not appear to be short enough to control methanogenesis because the offgas still contained about 5% methane. When methane content in the offgas exceeded 2%, an inverse linear relationship between hydrogen and methane was observed with a correlation coefficient of 0.9699. To increase hydrogen content in the offgas, methane production has to be limited to below 2%. Also, keeping oxygen content in the fermenter below 1.5% would increase the hydrogen concentration to over 15%. The product to substrate ratio was found to be around 50% for the fermenter system studied, evidenced by the observation that for every 6 liters of manure fermented, 3 liters of pure hydrogen were produced, which was significant and encouraging.     

The Clean Development Mechanism and Sustainable Development in China's Electricity Sector

Abstract

The Clean Development Mechanism, a flexibility mechanism contained in the Kyoto Protocol, offers China an important tool to attract investment in clean energy technology and processes into its electricity sector. The Chinese electricity sector places centrally in the country's economy and environment, being a significant contributor to the acid rain and air pollution problems that plague many of China's cities and regions, and therefore a focus of many related energy and environmental policies. China's electricity sector has also been the subject of a number of economic analyses that have showed that it contains the highest potential for clean energy investment through the Clean Development Mechanism of any economic sector in China. This mechanism, through the active participation from investors in more industrialized countries, can help alleviate the environmental problems attributable to electricity generation in China through advancing such technology as wind electricity generation, clean coal technology, high efficient natural gas electricity generation, or utilization of coal mine methane. In this context, the Clean Development Mechanism also compliments a range of environmental and energy policies which are strategizing to encourage the sustainable development of China's economy.     

Health effects of oxidants

Oxidants of significance to human health include ozone, nitrogen dioxide, and peroxyacetylnitrate. All of these compounds are involved in complex photochemical reactions which makes quantification and prediction of their individual health effects difficult. Ozone causes trauma to lung tissues and interferes with enzyme systems in the lungs and other tissues causing a broad range of symptoms. Measurable health impacts can occur at concentrations as low as 390 μg/m³. Acute effects of ozone exposure are reversible at normal urban concentrations (80–120 μg/m³). A special problem of concern, however, is increased susceptibility to infectious diseases contracted through the lungs. Nitrogen dioxide also causes trauma to lung tissues and interferes with enzyme systems. Measurable impacts can occur at concentrations as low as 100 μg/m³, but recovery is rapid and it is not known whether repeated exposures at this level have cumulative effects or predispose the lungs to permanent damage. Chronic exposure of laboratory animals to higher nitrogen dioxide levels can cause emphysema-like conditions and reduction in resistance to respiratory infection. Epidemiological studies of children in houses with gas stoves confirm the finding of reduced resistance to respiratory infection. The U.S. EPA estimates that health effects may occur in young children exposed to concentrations in excess of 280 to 560 μg/m³ one-hour average. These concentrations occur routinely in houses having gas stoves. Peroxyacetylnitrate is a powerful eye irritant in photochemical smog. Other health effects are similar to those of ozone, but less important because of the relatively low concentrations of this pollutant compared to other oxidants.     

Dietary PBDE intake: a market-basket study in Belgium

A food market-basket, representative for the general Belgian population, containing various meat, fish and dairy food products, was assembled and analysed for its polybrominated diphenyl ether (PBDE) content. Additionally, fast food samples were also investigated. Based on the measured PBDE levels, an average daily dietary intake estimate of PBDEs was calculated. Of all foods analysed, fish had the highest average sum of PBDE levels (BDEs 28, 47, 99, 100, 153, 154, and 183; 460 pg/g ww), followed by dairy products and eggs (260 pg/g ww), fast food (86 pg/g ww) and meat products (70 pg/g ww). One fresh salmon filet had the highest total concentration of PBDEs (2360 pg/g ww), whereas levels in steak and chicken breast were the lowest of all foods analysed. BDE 209 was never found above LOQ in any food. PBDE intake calculations were based on the average daily food consumption in Belgium and were estimated between 23 and 48 ng/day of total PBDEs (lower and upper bound). This value is in accordance with what was previously reported for diets from geographical distinct areas, such as Canada, Finland, Spain, Sweden and the UK. Although it is only a minor constituent of the Belgian diet, fish is the major contributor to the total daily PBDE-intake (around 40%) due to the high PBDE levels in this type of food. Although low contaminated, meat products account for around 30% of the total dietary intake of PBDEs. Dairy products and eggs contribute to a lesser degree (less than 30%).     

Polybrominated diphenyl ether in the East Asian environment: a critical review

Polybrominated diphenyl ethers (PBDEs) have been extensively used as flame retardants in consumer goods. Sufficient evidence shows that PBDEs have been rapidly accumulating in the environment worldwide. In Asia, deca-bromodiphenyl ether has been produced and used in large quantities, while penta-BDE has largely ceased in the mid-1990s. This paper summarizes and critically reviews the status of PBDE pollution in East Asia, with emphases on the comparisons with Europe and North America and the interpretation of the differences. In general, the concentrations of PBDEs in atmosphere, sludge, human and biological samples of East Asia are comparable to or lower than those in Europe and North America. However, in the sediments of waters near densely populated and heavily industrialized areas, PBDE levels are among the highest ever reported in the literature. In Japan and China, concentrations of PBDEs in sediment cores showed an increasing trend for the past 20-30 years. Also, PBDEs levels in human breast milk in Japan increased about 10-fold in the past 20 years. The presence of PBDEs in fur seal has increased about 150-fold in 1994 than that in 1972. Regional and inter-continental transport cannot be confirmed due to insufficient information. However, the detection of a number of PBDE congeners in a pristine lake on the Qinghai-Tibet Plateau may be an evidence of their long-range transport.