氯酚与富里酸的缔合作用

本文用超滤膜方法证实氯酚与富里酸之间存在缔合作用,并计算出表观缔合常数在２．７＊１０＾３－－１２１＊１０＾３ｍｌ．ｇ＾－１范围内。实验结果表明”ＰＨ、富里酸含量,氯酚取代氯原子个数都能够影响Ｋ值的大小。     

应用D412螯合树脂治理含镍电镀废水的研究

本文研究了Ｄ４１２螯合树脂对Ｎｉ（Ⅱ）离子静态和动态的吸收性能,并且研究了使用Ｄ４１２树脂除去和回收电镀废水中镍的最佳条件。     

Sorption of polar and nonpolar aromatic compounds to four surface soils of eastern China

Improved predictions on the fate of organic pollutants in surface environments require a better understanding of the underlying sorption mechanisms that control their uptake by soils. In this study, we monitored sorption of nine aromatic compounds with varying physicochemical properties (hydrophobicity, electron-donor/acceptor ability and polarity), including two polycyclic aromatic hydrocarbons, two chlorobenzenes, two nitroaromatic compounds, dichlobenil, carbaryl and 2,4-dichlorophenol in aqueous suspension of four surface soils of eastern China. The tested soils were characterized with respect to organic carbon (OC) content, black carbon content, mineralogy, morphology and size fraction to assess the role of the diverse soil characteristics in sorption. The results of this study show that not only the solute hydrophobicity and the OC content of soil are important to the retention of organic pollutants, but also the solute molecular structure and the soil nature.     

不同温湿度条件下微米硼的氧化过程研究

目的 探究不同温湿度条件下微米硼的氧化层结构特征。方法 利用高温水浴浸泡处理去除原料微米硼的表面氧化层,然后在恒温恒湿条件下对微米硼进行加速氧化,利用扫描电子显微镜、透射电子显微镜和X射线光电子能谱对加速氧化后硼颗粒的氧化层厚度及组成进行分析,总结表面氧化层结构及成分组成变化规律,揭示温湿度条件下微米硼的氧化机制。结果 微米硼经高温水浴浸泡处理后,表面氧化层去除率达到50%。随着加速氧化时间的延长,硼颗粒氧化层的厚度逐渐增大,由内向外硼颗粒表面可以用B-BxOy-B2O3三层结构来表示,BxOy总是伴随着B2O3同时出现的,且随着氧化反应的进行,颗粒表面BxOy的含量将超过B的含量。结论 不同温湿度条件下微米硼的氧化机制为O2向B颗粒内部单向扩散的反应机制,B先与O2反应,形成低氧化物BxOy,BxOy进而与O2反应生成B2O3。随着氧化层厚度的增加,O2向B颗粒内部扩散的阻力增大,氧化反应速率随之降低。相比湿度的影响,温度的升高可显著加快硼表面氧化层的形成;温度一定时,湿度的增加可促进硼氧化层的形成。     

Global sensitivity analysis of a process-based model for ammonia emissions from manure storage and treatment structures

The development of process-based models to estimate ammonia emissions from animal feeding operations (AFOSs) is sought to replace costly and time-consuming direct measurements. Critical to process-based model development is conducting sensitivity analysis to determine the input parameters and their interactions that contribute most to the variance of the model output. Global and relative sensitivity analyses were applied to a process-based model for predicting ammonia emissions from the surface of anaerobic lagoons for treating and storing manure. The objectives were to compare global sensitivity analysis (GSA) to relative (local) sensitivity analysis (RSA) on a process-based model for ammonia emissions. Based on the first-order coefficient, both GSA and RSA showed the model input parameters in order of importance in process model for ammonia emissions from lagoon surfaces were: (i) pH, (ii) lagoon liquid temperature, (iii) wind speed above the lagoon surface, and (iv) the concentration of ammoniacal nitrogen in the lagoon. The GSA revealed that interactions between model parameters accounted for over two-thirds of the model variance, a result that cannot be achieved using traditional RSA. Also, the GSA showed that parameter interactions involving liquid pH had more impact on the model output variance than the single parameters: (i) temperature, (ii) wind speed, or (iii) total ammoniacal nitrogen. This study demonstrates that GSA provides a more complete analysis of model input parameters and their interactions on the model output compared to RSA. A comprehensive tutorial regarding the application of GSA to a process model is presented.     

隔震:保证建筑物地震安全的最佳选择

<正>几十年地震预报实践说明,地震预报尚未成熟,远未达到实用化,目前仍属于摸索探索阶段。有些地震虽然说可能作预测预报,但即使预报了,对一个大城市而言也不会轻易疏散、停工停产,而且地震发生了城市的物质文明建设照样会遭到严重破坏。换个方式去思维去实践,即把城乡建筑的抗震性能提高了,尤其是住宅建筑和重     

化学还原法回收含银电镀废液中的银

以Na2S2O4为还原剂,采用化学还原法回收某电镀厂含银电镀废液中的银。实验结果表明,在n(Na2S2O4)∶n(Ag+)=2.5、反应温度35℃、废水pH7.5、搅拌速率300r/min的条件下,Ag+回收率达到99.92%。对回收的银粉进行X射线衍射和扫描电子显微镜分析,分析结果表明回收的银粉纯度较高,成球形。     

废纸苯酚液化物合成热固型酚醛树脂

为了提高废纸的附加值,利用废纸苯酚液化物与甲醛在碱性环境中反应,进行热固型酚醛树脂合成实验。通过正交实验确定最优化的树脂化合成工艺为:n(甲醛)∶n(废纸液化物)=2.1,n(氢氧化钠)∶n(废纸液化物)=0.5,合成温度74℃,合成时间3.0h。在此工艺条件下制备的酚醛树脂压制的胶合板达到GB/T9846—2004《人造板及饰面人造板理化性能试验方法》中Ⅰ类胶合板的强度要求。     

疏水改性阳离子聚丙烯酰胺絮凝剂的制备及其絮凝性能

通过水溶液共聚合法,以丙烯酰胺(AM)、丙烯酰氧乙基三甲基氯化铵(DAC)和2-乙烯基吡啶(2-VP)为共聚单体合成了疏水改性阳离子聚丙烯酰胺P(AM-DAC-2VP),并用红外光谱仪和核磁共振光谱仪对其结构进行了表征。实验结果表明:当w(2-VP)为1.0%、w(DAC)为30%、活性污泥pH为5、P(AM-DAC-2VP)加入量为25mg/L时,P(AM-DAC-2VP)对本实验的活性污泥絮凝能力最强,上清液透光率为92.1%;P(AM-DAC-2VP)比同条件下制备的阳离子聚丙烯酰胺P(AM-DAC)具有更好的絮凝效果。     

三元乙丙橡胶超细纤维复合膜的制备及其截留性能

以四氢呋喃和N,N-二甲基甲酰胺为溶剂,配制三元乙丙橡胶(EPDM)纺丝液,通过静电纺丝技术制备了EPDM超细纤维,进而以聚偏氟乙烯(PVDF)微滤膜为基膜制备了EPDM超细纤维复合膜。采用红外光谱(FTIR)和扫描电子显微镜(SEM)对EPDM超细纤维的结构和形态进行了表征。考察了复合膜对苯乙烯废水的截留效果和复合膜通量的变化情况。实验结果表明:EPDM超细纤维具有类似无纺布形式的多孔纤维网状结构,其直径在0.2~2.0μm之间;复合膜在操作压力为0.1MPa的条件下,处理质量浓度为100μg/mL的模拟苯乙烯废水,膜通量约为5.90mL/(cm2.h),苯乙烯去除率可达89.7%。